Cuixia Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Cuixia Wang has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- Chao Zhang
School of Water Conservancy and Transportation/Yellow River Laboratory/Underground Engineering Research Institute Zhengzhou University Zhengzhou China
3 shared publications Chao Zhang
2 shared publicationsJian Liang
2 shared publicationsLei Wang
2 shared publicationsWang Pan
2 shared publicationsWeiliang Gao
2 shared publications
Latest Publications
- 8 October 2026
- Published by Wiley in Polymer Composites
Modifications of Fiber Surface and Resin Matrix on Enhancing Interfacial Strength of UV ‐ CIPP Materials
Ultraviolet‐cured‐in‐place‐pipe (UV‐CIPP) technology is widely used for trenchless rehabilitation of urban pipelines. However, the multilayered liner structure is prone to debonding and delamination due to weak interfacial bonding between fibers and the resin matrix. To address this issue, microdroplet pull‐out tests were conducted on glass fiber/UV‐curable resin systems to investigate the effects of fiber surface silanization and resin matrix filler modification on interfacial properties. The surface morphology, roughness, and chemical composition of glass fibers were characterized by scanning electron microscopy (SEM), atomic force microscopy (AFM), and x‐ray photoelectron spectroscopy (XPS). Three‐point bending tests were performed on laminated specimens to validate the translation of microscale interfacial improvements to macroscopic bending performance. The preferred curing parameters were determined as 150 s and 60 mW/cm 2 . For the three strategies, interfacial shear strength (IFSS) exhibited a non‐monotonic trend with increasing modification extent. KH560 treatment for 9 h yielded a maximum IFSS of 20.63 ± 1.63 MPa among the silane‐modified groups, accompanied by an increase in surface roughness Ra from 0.273 to 0.396 nm, as revealed by AFM, and successful silane grafting, as confirmed by XPS. For resin matrix modification, the preferred MgO content was 3.5 wt%, achieving an IFSS of 20.80 ± 1.88 MPa, while the preferred nano‐SiO 2 content was 3 wt%, achieving an IFSS of 22.70 ± 1.39 MPa. The bending tests confirmed that enhanced interfacial bonding translated into improved flexural performance, with the ranking of reinforcing effectiveness consistent with the microscale results.
- 8 October 2026
- Published by Wiley in Polymer Composites
Modifications of Fiber Surface and Resin Matrix on Enhancing Interfacial Strength of UV ‐ CIPP Materials
Ultraviolet‐cured‐in‐place‐pipe (UV‐CIPP) technology is widely used for trenchless rehabilitation of urban pipelines. However, the multilayered liner structure is prone to debonding and delamination due to weak interfacial bonding between fibers and the resin matrix. To address this issue, microdroplet pull‐out tests were conducted on glass fiber/UV‐curable resin systems to investigate the effects of fiber surface silanization and resin matrix filler modification on interfacial properties. The surface morphology, roughness, and chemical composition of glass fibers were characterized by scanning electron microscopy (SEM), atomic force microscopy (AFM), and x‐ray photoelectron spectroscopy (XPS). Three‐point bending tests were performed on laminated specimens to validate the translation of microscale interfacial improvements to macroscopic bending performance. The preferred curing parameters were determined as 150 s and 60 mW/cm 2 . For the three strategies, interfacial shear strength (IFSS) exhibited a non‐monotonic trend with increasing modification extent. KH560 treatment for 9 h yielded a maximum IFSS of 20.63 ± 1.63 MPa among the silane‐modified groups, accompanied by an increase in surface roughness Ra from 0.273 to 0.396 nm, as revealed by AFM, and successful silane grafting, as confirmed by XPS. For resin matrix modification, the preferred MgO content was 3.5 wt%, achieving an IFSS of 20.80 ± 1.88 MPa, while the preferred nano‐SiO 2 content was 3 wt%, achieving an IFSS of 22.70 ± 1.39 MPa. The bending tests confirmed that enhanced interfacial bonding translated into improved flexural performance, with the ranking of reinforcing effectiveness consistent with the microscale results.
- 14 June 2026
- Published by Elsevier in Construction and Building Materials
- Vol. 537
A multi-physics modeling of chloride ions ingress and transport in rubber concrete
- 14 June 2026
- Published by Elsevier in Construction and Building Materials
- Vol. 537
A multi-physics modeling of chloride ions ingress and transport in rubber concrete
- Open Access
- 23 August 2024
- Published by Elsevier in Polymer Testing
- Vol. 138, 108554
Water transport mechanism and performance evaluation in polyurethane materials: A state-of-the-art review
- 23 August 2024
- Published by Elsevier in Polymer Testing
- Vol. 138, 108554
Open AccessWater transport mechanism and performance evaluation in polyurethane materials: A state-of-the-art review
- 10 May 2022
- Published by Wolters Kluwer Health in Zhonghua Yi Xue Yi Chuan Xue Za Zhi = Zhonghua Yixue Yichuanxue Zazhi = Chinese Journal of Medical Genetics
- Vol. 39 (5) , 534-536
[A rare case of dicentric ring chromosome and derivative ring chromosome Chimera].
Utilize high-resolution chromosome analysis and microarray detection to determine the genetic etiology of infertility of a 32-year old female patient. The peripheral blood of the patient was cultured for high-resolution chromosome G and C banding karyotype analysis, and then 750K SNP-Array chip detection was performed. Karyotype analysis results showed that the patient's karyotype was 45,XX,-13 [7]/46,XX,r(13) (p13q34) [185]/46,XX,dic r(13;13)(p13q34;p13q34) [14]/ 47,XX,+der(13;13;13;13) (p13q34;p13q34;p13q34; p13q34), dic r(13;13) [1]/ 46,XX [3]. The microarray results showed that the patient had a 3.3 Mb deletion in the 13q34 segment of chromosome 13, which may be related to infertility. Infertility of the patient reported in this article may be related to the deletion of chromosome segment (13q34-qter).
- 10 May 2022
- Published by Wolters Kluwer Health in Zhonghua Yi Xue Yi Chuan Xue Za Zhi = Zhonghua Yixue Yichuanxue Zazhi = Chinese Journal of Medical Genetics
- Vol. 39 (5) , 534-536
[A rare case of dicentric ring chromosome and derivative ring chromosome Chimera].
Utilize high-resolution chromosome analysis and microarray detection to determine the genetic etiology of infertility of a 32-year old female patient. The peripheral blood of the patient was cultured for high-resolution chromosome G and C banding karyotype analysis, and then 750K SNP-Array chip detection was performed. Karyotype analysis results showed that the patient's karyotype was 45,XX,-13 [7]/46,XX,r(13) (p13q34) [185]/46,XX,dic r(13;13)(p13q34;p13q34) [14]/ 47,XX,+der(13;13;13;13) (p13q34;p13q34;p13q34; p13q34), dic r(13;13) [1]/ 46,XX [3]. The microarray results showed that the patient had a 3.3 Mb deletion in the 13q34 segment of chromosome 13, which may be related to infertility. Infertility of the patient reported in this article may be related to the deletion of chromosome segment (13q34-qter).
- 1 January 2009
- Published by Springer Nature
- p. 1665-1672
Study on the Fuzzy Comprehensive Classification of Occupational Injury Risk in Road Transport Enterprises
- 1 January 2009
- Published by Springer Nature
- p. 1665-1672
Study on the Fuzzy Comprehensive Classification of Occupational Injury Risk in Road Transport Enterprises