Rene Asomoza
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Rene Asomoza has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Yuriy Kudriavtsev
Departamento Ingeniería Eléctrica—SEES, Cinvestav—IPN, Av. Instituto Politécnico Nacional 2508, San Pedro Zacatenco, Delegación Gustavo A. Madero, Mexico City 07360, Mexico
8 shared publications - Konstantin Dmitrievich Moiseev
Физико-технический институт им. А.Ф. Иоффе РАН, Санкт-Петербург, Россия
2 shared publications - Ramón Peña Sierra
Center for Research and Advanced Studies of the National Polytechnic Institute, Mexico
2 shared publications A. Poplavsky
1 shared publicationAlexander Merkulov
CINVESTAV-IPN, Apdo. Postal 14-740, 07000 Mexico, D.F., Mexico
1 shared publication- Angelica Guadalupe Hernandez
Universidad Autónoma del Estado de Hidalgo
1 shared publication
Latest Publications
- Open Access
- 31 August 2026
- Published by Sociedad Mexicana de Ciencia y Tecnologia de Superficies y Materiales A.C. in Superficies y Vacío
- Vol. 39, 260801
Universal system of gases and vapors composition measurement at atmospheric pressure based on quadrupole mass spectrometer
This paper describes a system that measures gases at atmospheric pressure using a residual gas analyzer with a quadrupole mass spectrometer. A specially designed gas introduction system made it possible to measure gas mixtures at pressures slightly above and below atmospheric pressure. Additionally, the system can measure gases released when heating liquid and solid samples. Quantitative analyses of gas mixtures can be carried out with good accuracy, with detection limits down to the ppm level.
- 31 August 2026
- Published by Sociedad Mexicana de Ciencia y Tecnologia de Superficies y Materiales A.C. in Superficies y Vacío
- Vol. 39, 260801
Open AccessUniversal system of gases and vapors composition measurement at atmospheric pressure based on quadrupole mass spectrometer
This paper describes a system that measures gases at atmospheric pressure using a residual gas analyzer with a quadrupole mass spectrometer. A specially designed gas introduction system made it possible to measure gas mixtures at pressures slightly above and below atmospheric pressure. Additionally, the system can measure gases released when heating liquid and solid samples. Quantitative analyses of gas mixtures can be carried out with good accuracy, with detection limits down to the ppm level.
- 7 March 2026
- Published by Elsevier in Ceramics International
- Vol. 52 (27) , 55328-55337
Study of blistering effects in V-group semiconductor films
- 7 March 2026
- Published by Elsevier in Ceramics International
- Vol. 52 (27) , 55328-55337
Study of blistering effects in V-group semiconductor films
- 5 October 2024
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 35 (28) , 1-14
Study of photocatalytic activity of Al+ and In+ implanted rutile TiO2 crystals: methyl orange and methylene blue degradation
- 5 October 2024
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 35 (28) , 1-14
Study of photocatalytic activity of Al+ and In+ implanted rutile TiO2 crystals: methyl orange and methylene blue degradation
- Open Access
- 24 July 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 41 (5)
Response to “Comment on ‘Restoration of the original depth distribution from the SIMS profile using the depth resolution function in framework of RMR model’” [J. Vac. Sci. Technol. B 41, 024003 (2023)]
In the paper under discussion,1 we critically reviewed the basic assumptions made in developing the Mixing-Roughness-Information Depth (MRI) model2 and found th
- 24 July 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 41 (5)
Open AccessResponse to “Comment on ‘Restoration of the original depth distribution from the SIMS profile using the depth resolution function in framework of RMR model’” [J. Vac. Sci. Technol. B 41, 024003 (2023)]
In the paper under discussion,1 we critically reviewed the basic assumptions made in developing the Mixing-Roughness-Information Depth (MRI) model2 and found th
- 1 March 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 41 (2) , 024003
Restoration of the original depth distribution from experimental SIMS profile using the depth resolution function in framework of RMR model
In this paper, the problem of depth profiling analysis of nanoscale heterostructures containing doped delta layers and quantum wells using the SIMS method is considered. Based on computer simulation data and previously obtained experimental data, we demonstrated that the RMR model most accurately and completely describes the redistribution of the analyzed element in ultrathin layers that occurs during ion sputtering. A comparative analysis of the surface roughness–ion mixing–recoil implantation (RMR) model with MRI (mixing-roughness-information depth) and UDS (up-and-down slope) models proposed by Hoffman and Dowsett, respectively, was performed. It was shown that the introduction into the MRI model of a parameter describing some layer of constant thickness, in which the components of the analyzed layer and matrix elements are uniformly mixed, is not quite justified. It is concluded that during depth profiling of a monoatomic layer, the center of mass of this layer shifts away from the surface, as predicted by the RMR model, rather than toward the surface, as predicted by the MRI model. It is found that preferential sputtering does not affect the experimental depth distribution of elements obtained by the SIMS method.
- 1 March 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 41 (2) , 024003
Restoration of the original depth distribution from experimental SIMS profile using the depth resolution function in framework of RMR model
In this paper, the problem of depth profiling analysis of nanoscale heterostructures containing doped delta layers and quantum wells using the SIMS method is considered. Based on computer simulation data and previously obtained experimental data, we demonstrated that the RMR model most accurately and completely describes the redistribution of the analyzed element in ultrathin layers that occurs during ion sputtering. A comparative analysis of the surface roughness–ion mixing–recoil implantation (RMR) model with MRI (mixing-roughness-information depth) and UDS (up-and-down slope) models proposed by Hoffman and Dowsett, respectively, was performed. It was shown that the introduction into the MRI model of a parameter describing some layer of constant thickness, in which the components of the analyzed layer and matrix elements are uniformly mixed, is not quite justified. It is concluded that during depth profiling of a monoatomic layer, the center of mass of this layer shifts away from the surface, as predicted by the RMR model, rather than toward the surface, as predicted by the MRI model. It is found that preferential sputtering does not affect the experimental depth distribution of elements obtained by the SIMS method.
- 1 November 2021
- Published by Elsevier in Solid State Ionics
- Vol. 371, 115754
Comparative analysis of corrosion of borosilicate glasses in water vapor
- 1 November 2021
- Published by Elsevier in Solid State Ionics
- Vol. 371, 115754
Comparative analysis of corrosion of borosilicate glasses in water vapor
- Open Access
- 1 January 2017
- Published by Ioffe Institute Russian Academy of Sciences in Журнал технической физики
- Vol. 51 (5) , 579
Отрицательный отжиг в кремнии при высоковольтной имплантации натрия
Отрицательный отжиг в кремнии при высоковольтной имплантации натрия
- 1 January 2017
- Published by Ioffe Institute Russian Academy of Sciences in Журнал технической физики
- Vol. 51 (5) , 579
Open AccessОтрицательный отжиг в кремнии при высоковольтной имплантации натрия
Отрицательный отжиг в кремнии при высоковольтной имплантации натрия
- 10 July 2008
- Published by Elsevier in Applied Surface Science
- Vol. 255 (4) , 1423-1426
SIMS depth profiling analysis of halogens in CdTe/CdS/TSO solar cells using Cs2M+ cluster ions
- 10 July 2008
- Published by Elsevier in Applied Surface Science
- Vol. 255 (4) , 1423-1426
SIMS depth profiling analysis of halogens in CdTe/CdS/TSO solar cells using Cs2M+ cluster ions
- 2 September 2002
- Published by AIP Publishing in Applied Physics Letters
- Vol. 81 (10) , 1785-1787
Spinodal decomposition range of InxGa1−xNyAs1−y alloys
Spinodal decomposition range of In x Ga 1−x N y As 1−y quaternary alloys as the result of the strain and coherency strain energies, transformations of the bonds, and a lattice mismatch between the GaAs substrate and an alloy is described. The alloys are considered in the strictly regular approximation. The strain energy is presented in the valence-force field model. The spinodal decomposition temperatures of In x Ga 1−x N y As 1−y alloys are demonstrated up to 1000 °C. It is shown that nitrogen dramatically increases the temperature of the coherent spinodal.
- 2 September 2002
- Published by AIP Publishing in Applied Physics Letters
- Vol. 81 (10) , 1785-1787
Spinodal decomposition range of InxGa1−xNyAs1−y alloys
Spinodal decomposition range of In x Ga 1−x N y As 1−y quaternary alloys as the result of the strain and coherency strain energies, transformations of the bonds, and a lattice mismatch between the GaAs substrate and an alloy is described. The alloys are considered in the strictly regular approximation. The strain energy is presented in the valence-force field model. The spinodal decomposition temperatures of In x Ga 1−x N y As 1−y alloys are demonstrated up to 1000 °C. It is shown that nitrogen dramatically increases the temperature of the coherent spinodal.
- 1 October 2001
- Published by Elsevier in Journal of Crystal Growth
- Vol. 231 (4) , 458-465
Crystallization of the AIIIxBIII1−xCV alloys from the supercooled liquid solutions
- 1 October 2001
- Published by Elsevier in Journal of Crystal Growth
- Vol. 231 (4) , 458-465
Crystallization of the AIIIxBIII1−xCV alloys from the supercooled liquid solutions