Vedanth Sharma
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Vedanth Sharma has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Kentaro Hara
Department of Aeronautics and Astronautics, Stanford University 1 , Stanford, California 94305
3 shared publications - Yusuke Yamashita
Institute of Space and Astronautical Science, Japan Aerospace Exploration Agency, Sagamihara-city, Japan
2 shared publications - Andrei Smolyakov
University of Saskatchewan
1 shared publication - Jean Pierre Boeuf
Université de Toulouse, Toulouse INP, CNRS, LAPLACE, Toulouse, France
1 shared publication - Meghraj Sengupta
Lawrence Livermore National Laboratory , Livermore, California 94551
1 shared publication - Mikhail Tyushev
Department of Physics and Engineering Physics, University of Saskatchewan 1 , Saskatoon, Saskatchewan S7N 5E2
1 shared publication
Latest Publications
- Open Access
- 1 November 2025
- Published by AIP Publishing in Physics of Plasmas
- Vol. 32 (11)
Anode plasma formation and expansion in pulsed high-voltage diodes
Plasma formation and expansion in pulsed high-voltage diodes are investigated using a relativistic one-dimensional particle-in-cell Monte Carlo collision simulation. A 600 kV pulsed DC voltage applied across a 1 cm anode–cathode gap over 100 ns generates quasineutral plasma near the cathode during ramp-up, which subsequently expands toward the anode. A relativistic space-charge-limited (SCL) electron beam is extracted from the expanding cathode plasma front and collected at the anode, resulting in neutral desorption (both stimulated and thermal) from the electrode surface. In the present model, a fraction of the neutrals desorbed from the anode is ionized, producing anode plasma. The simulations show that the current within the gap is initially SCL due to cathode plasma expansion, which later transitions to a bipolar SCL flow as the anode plasma forms. The results demonstrate that anode plasma formation plays an important role in establishing bipolar flow when thermal desorption dominates over stimulated desorption. The extracted current in the simulation is consistent with the relativistic SCL bipolar flow theory, which depends on the electron and ion currents, as well as the distance between the anode and cathode plasma fronts.
- 1 November 2025
- Published by AIP Publishing in Physics of Plasmas
- Vol. 32 (11)
Open AccessAnode plasma formation and expansion in pulsed high-voltage diodes
Plasma formation and expansion in pulsed high-voltage diodes are investigated using a relativistic one-dimensional particle-in-cell Monte Carlo collision simulation. A 600 kV pulsed DC voltage applied across a 1 cm anode–cathode gap over 100 ns generates quasineutral plasma near the cathode during ramp-up, which subsequently expands toward the anode. A relativistic space-charge-limited (SCL) electron beam is extracted from the expanding cathode plasma front and collected at the anode, resulting in neutral desorption (both stimulated and thermal) from the electrode surface. In the present model, a fraction of the neutrals desorbed from the anode is ionized, producing anode plasma. The simulations show that the current within the gap is initially SCL due to cathode plasma expansion, which later transitions to a bipolar SCL flow as the anode plasma forms. The results demonstrate that anode plasma formation plays an important role in establishing bipolar flow when thermal desorption dominates over stimulated desorption. The extracted current in the simulation is consistent with the relativistic SCL bipolar flow theory, which depends on the electron and ion currents, as well as the distance between the anode and cathode plasma fronts.
- Open Access
- 6 August 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (5)
Kinetic modeling of cathode plasma formation and expansion in a pulsed high-voltage anode–cathode gap
A one-dimensional (1D), relativistic, particle-in-cell Monte Carlo collision (PIC–MCC) model is developed to study cathode plasma formation and expansion in pulsed, high-voltage diodes. The 1D PIC–MCC simulation model accounts for physical processes, such as Fowler–Nordheim field emission with field enhancement, Coulomb collisions, and electron–neutral collisions (e.g., electron-impact ionization), assuming a neutral gas layer of atomic hydrogen due to outgassing near the cathode surface. A Langevin approach is used to simulate Coulomb collisions for both electron–ion and electron–electron collisions in the presence of a drift velocity between electrons and ions. A pulsed DC voltage of 600 kV is applied to a 1 cm anode–cathode gap over 100 ns, which generates a quasineutral plasma density near the cathode that expands toward the anode, similar to a moving shock front. The extracted current agrees with the relativistic space charge limited theory. The cathode plasma expansion rate is found to be approximately 1.83 cm/μs, which is consistent with experimental observations. In the simulation, the impact of Coulomb collisions is also assessed, showing that the expansion rate is slower if Coulomb collisions are neglected due to the lack of thermalization processes that lead to lower plasma temperature. Additionally, stochastic bursts of current spikes are observed depending on the simulation conditions. Current spikes have been observed in experiments, and their associated mechanism is discussed.
- 6 August 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (5)
Open AccessKinetic modeling of cathode plasma formation and expansion in a pulsed high-voltage anode–cathode gap
A one-dimensional (1D), relativistic, particle-in-cell Monte Carlo collision (PIC–MCC) model is developed to study cathode plasma formation and expansion in pulsed, high-voltage diodes. The 1D PIC–MCC simulation model accounts for physical processes, such as Fowler–Nordheim field emission with field enhancement, Coulomb collisions, and electron–neutral collisions (e.g., electron-impact ionization), assuming a neutral gas layer of atomic hydrogen due to outgassing near the cathode surface. A Langevin approach is used to simulate Coulomb collisions for both electron–ion and electron–electron collisions in the presence of a drift velocity between electrons and ions. A pulsed DC voltage of 600 kV is applied to a 1 cm anode–cathode gap over 100 ns, which generates a quasineutral plasma density near the cathode that expands toward the anode, similar to a moving shock front. The extracted current agrees with the relativistic space charge limited theory. The cathode plasma expansion rate is found to be approximately 1.83 cm/μs, which is consistent with experimental observations. In the simulation, the impact of Coulomb collisions is also assessed, showing that the expansion rate is slower if Coulomb collisions are neglected due to the lack of thermalization processes that lead to lower plasma temperature. Additionally, stochastic bursts of current spikes are observed depending on the simulation conditions. Current spikes have been observed in experiments, and their associated mechanism is discussed.
- Open Access
- 1 April 2025
- Published by AIP Publishing in Physics of Plasmas
- Vol. 32 (4)
Electron Monte Carlo simulations of single- and dual-frequency RF breakdown
Electron Monte Carlo (E-MC) simulations are performed to investigate single- and dual-frequency radio frequency (RF) breakdown for nitrogen. The E-MC simulation accounts for electron-induced secondary electron emission (SEE) and ion-induced electron emission (IIEE). For single-frequency RF breakdown at 27.12 MHz, the breakdown voltages obtained from the E-MC model agree with experimental data when accounting for SEE, inelastic reflection, and elastic reflection. In addition, the effects of anisotropic scattering for electron-neutral collisions on RF breakdown are evaluated. For dual-frequency RF breakdown at 2 MHz and 27.12 MHz, the high-frequency (HF) breakdown voltages, VHF, are obtained when applying fixed low-frequency (LF) voltages, i.e., VLF=283 V and 509 V. The dual-frequency breakdown curve, i.e., VHF, obtained from the simulations is in good agreement with experimental data, showing that IIEE is important in a wide range of pressures, and electron elastic reflection plays an important role in the low pressure regime. The phase lag of electron incident flux to the electrodes with respect to the voltage waveform is analyzed to show the importance of electron emission mechanisms for single- and dual-frequency RF breakdown.
- 1 April 2025
- Published by AIP Publishing in Physics of Plasmas
- Vol. 32 (4)
Open AccessElectron Monte Carlo simulations of single- and dual-frequency RF breakdown
Electron Monte Carlo (E-MC) simulations are performed to investigate single- and dual-frequency radio frequency (RF) breakdown for nitrogen. The E-MC simulation accounts for electron-induced secondary electron emission (SEE) and ion-induced electron emission (IIEE). For single-frequency RF breakdown at 27.12 MHz, the breakdown voltages obtained from the E-MC model agree with experimental data when accounting for SEE, inelastic reflection, and elastic reflection. In addition, the effects of anisotropic scattering for electron-neutral collisions on RF breakdown are evaluated. For dual-frequency RF breakdown at 2 MHz and 27.12 MHz, the high-frequency (HF) breakdown voltages, VHF, are obtained when applying fixed low-frequency (LF) voltages, i.e., VLF=283 V and 509 V. The dual-frequency breakdown curve, i.e., VHF, obtained from the simulations is in good agreement with experimental data, showing that IIEE is important in a wide range of pressures, and electron elastic reflection plays an important role in the low pressure regime. The phase lag of electron incident flux to the electrodes with respect to the voltage waveform is analyzed to show the importance of electron emission mechanisms for single- and dual-frequency RF breakdown.
- Open Access
- 1 March 2023
- Published by AIP Publishing in Physics of Plasmas
- Vol. 30 (3)
Azimuthal structures and turbulent transport in Penning discharge
Azimuthal structures in cylindrical Penning discharge are studied with a 2D3V radial–azimuthal PIC/MCC model with the axial magnetic field. The discharge is self-consistently supported by ionization due to the axial injection of electrons. It is shown that the steady-state discharge can be supported in two different regimes with different types of observed azimuthal structures. The transition between the regimes is controlled by the mechanism of the energy input to the discharge. In the first regime (low energy of the injected electrons), with the pronounced m = 1 spoke activity, the power input is dominated by the energy absorption due to the radial current and self-consistent electric field. In the other regime (higher energy of the injected electrons), with prevalent small-scale m > 1 spiral structures, and the lower values of the anomalous transport, the total energy deposited to the discharge is lower and is mostly due to the direct input of the kinetic energy from the axial electron beam. We show that the large (m = 1) spoke and small-scale structures occur as a result of Simon–Hoh and lower hybrid instabilities driven by the electric field, density gradient, and collisions.
- 1 March 2023
- Published by AIP Publishing in Physics of Plasmas
- Vol. 30 (3)
Open AccessAzimuthal structures and turbulent transport in Penning discharge
Azimuthal structures in cylindrical Penning discharge are studied with a 2D3V radial–azimuthal PIC/MCC model with the axial magnetic field. The discharge is self-consistently supported by ionization due to the axial injection of electrons. It is shown that the steady-state discharge can be supported in two different regimes with different types of observed azimuthal structures. The transition between the regimes is controlled by the mechanism of the energy input to the discharge. In the first regime (low energy of the injected electrons), with the pronounced m = 1 spoke activity, the power input is dominated by the energy absorption due to the radial current and self-consistent electric field. In the other regime (higher energy of the injected electrons), with prevalent small-scale m > 1 spiral structures, and the lower values of the anomalous transport, the total energy deposited to the discharge is lower and is mostly due to the direct input of the kinetic energy from the axial electron beam. We show that the large (m = 1) spoke and small-scale structures occur as a result of Simon–Hoh and lower hybrid instabilities driven by the electric field, density gradient, and collisions.