RYRen Yang

Ren Yang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ren Yang has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Radial Displacement Measurement Method in Bearingless Slice Motor Through Eddy Current Displacement Sensors Positioned on the Underside of the Rotor

    by Ren Yang, Zeqiang He, Naohiro Sugita, Tadahiko Shinshi

    Bearingless slice motors (BELSM) employing active radial positioning control and passive stabilization in the axial and tilt directions are widely utilized in medical and industrial applications. Conventionally, the radial displacement of a BELSM is measured by arranging eddy current displacement (ECD) sensors either outside or inside the rotor to detect its radial movement. However, this sensor placement method either increases the rotor’s height because of an additional sensor target or occupies the inner space because of the sensor holder. To address this issue, we propose the mounting of ECD sensors on the underside of the inner edge of the rotor for radial displacement measurements. However, formulating the radial displacement from the sensor outputs is challenging because of complex sensor nonlinearities and the effects of axial movement and tilt. To resolve this problem, we propose the usage of seven ECD sensor placements and establish relationships between the sensor outputs and radial displacement. Initially, displacement estimation based on the polynomial fitting method is proposed, however, it results in unacceptable measurement errors owing to sensor calibration errors. Subsequently, a neural network (NN) method is proposed, which exhibits good linearity within ±150 μm and a measurement bandwidth of up to 200 Hz. The NN is further implemented into the displacement feedback system, enabling magnetic suspension startup and rotation with a radial displacement measurement error controlled within 16 μm within 1700 rpm. Diverse and large datasets, coupled with an increased number of sensors can substantially enhance measurement accuracy.


  • Open Access

    Low-Cost and Compact Disposable Extracorporeal Centrifugal Blood Pump Utilizing a Homopolar Bearingless Switched Reluctance Slice Motor

    by Ren Yang, Zeqiang He, Naohiro Sugita, Tadahiko Shinshi

    The high biocompatibility and high durability of disposable extracorporeal centrifugal blood pumps (CBPs) utilizing magnetic bearing or bearingless motor technology make them perfect for supporting cardiopulmonary circulation for patients. However, the rotor incorporated in the disposable unit typically uses high-cost and environmentally-unfriendly rare-earth permanent magnets (PMs), leading to economic and environmental issues. This paper proposes a centrifugal blood pump with a PM-free impeller/rotor in the disposable pump head utilizing a 12/8 bearingless switched reluctance slice motor (BELSRM). Two axial-magnetized PM rings and two iron rings are mounted symmetrically above and below the tips of the stator poles. The biased magnetic flux generated by the PM rings forms a closed vertical magnetic circuit (homopolar flux circuit) with a PM-free rotor, providing high passive stiffness and large positioning forces independent of the rotor angle. A three-dimensional (3D) finite element analysis (FEA) model was used to evaluate the rotor support stiffness, the current-force coefficient, and the rotational torque. A prototype bearingless slice motor (BELSM) and a disposable pump head with a diameter of 50 mm PM-free impeller/rotor were fabricated. The radial magnetic levitation and the rotation were actively controlled by displacement and speed feedback control systems, respectively. A mock circulatory loop filled with 40wt% aqueous glycerol solution was set to evaluate the performance of the proposed CBP. The CBP provided a maximum flow rate of 4.59 L/min and a maximum head pressure of 214.5 mmHg at 2300 rpm and 2400 rpm, respectively.