Alijah Mohd Aris
Alijah Mohd Aris has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Khor Bee Chin
Indah Water Konsortium Sdn. Bhd., Kuala Lumpur 60000, Malaysia
2 shared publications - Adeline Seak May Chua
Department of Chemical Engineering, Faculty of Engineering Universiti Malaya Kuala Lumpur Malaysia
1 shared publication - Ahmad Rafizan Mohamad Daud
School of Chemical Engineering, College of Engineering, Universiti Teknologi MARA, 40450 Shah Alam, Selangor, Malaysia
1 shared publication - Chew Lee Leong
Sustainable Process Engineering Centre (SPEC), Department of Chemical Engineering, Faculty of Engineering, Universiti Malaya, Kuala Lumpur 50603, Malaysia
1 shared publication - Mohamad Fairus Rabuni
Sustainable Process Engineering Centre (SPEC), Department of Chemical Engineering, Faculty of Engineering, Universiti Malaya, Kuala Lumpur 50603, Malaysia
1 shared publication - Mohibah Musa
Faculty of Chemical Engineering, Universiti Teknologi MARA (UiTM), Shah Alam 40450, Selangor, Malaysia
1 shared publication
Latest Publications
- Open Access
Pilot Study of Oxic–Anoxic Process under Low Dissolved Oxygen for Nitrogen Removal from Low COD/N Tropical Wastewater
Conventionally, nitrification in biological nitrogen removal (BNR) requires high dissolved oxygen (DO) concentrations (>2 mg L−1), making the process energy intensive. Recent studies have shown that efficient ammonium removal and energy reduction can be realized by operating the nitrification at low DO concentrations (−1). In this study, the low-DO oxic anoxic (low-DO OA) process was operated in a pilot-scale sequencing batch reactor (SBR) over 218 days to evaluate the feasibility of nitrogen removal from low chemical oxygen demand-to-nitrogen ratio (COD/N) tropical municipal wastewater. The results revealed that the low-DO OA process attained high removal efficiency for ammonium (97%) and total nitrogen (TN) (80%) under an average DO concentration of 0.6 mg L−1. The effective TN removal efficiency is attributed to the occurrence of simultaneous nitrification–denitrification (SND) under low DO conditions. Further batch tests revealed that slowly biodegradable COD (sbCOD) in tropical wastewater can support denitrification in the post-anoxic phase, resulting in a high TN removal rate. Compared with high DO concentrations (2 mg L−1), low DO conditions achieved 10% higher TN removal efficiency, with similar ammonium and COD removal efficiency. This study is crucial in promoting the energy efficiency and sustainability of wastewater treatment plants treating low COD/N wastewater.
Open AccessPilot Study of Oxic–Anoxic Process under Low Dissolved Oxygen for Nitrogen Removal from Low COD/N Tropical Wastewater
Conventionally, nitrification in biological nitrogen removal (BNR) requires high dissolved oxygen (DO) concentrations (>2 mg L−1), making the process energy intensive. Recent studies have shown that efficient ammonium removal and energy reduction can be realized by operating the nitrification at low DO concentrations (−1). In this study, the low-DO oxic anoxic (low-DO OA) process was operated in a pilot-scale sequencing batch reactor (SBR) over 218 days to evaluate the feasibility of nitrogen removal from low chemical oxygen demand-to-nitrogen ratio (COD/N) tropical municipal wastewater. The results revealed that the low-DO OA process attained high removal efficiency for ammonium (97%) and total nitrogen (TN) (80%) under an average DO concentration of 0.6 mg L−1. The effective TN removal efficiency is attributed to the occurrence of simultaneous nitrification–denitrification (SND) under low DO conditions. Further batch tests revealed that slowly biodegradable COD (sbCOD) in tropical wastewater can support denitrification in the post-anoxic phase, resulting in a high TN removal rate. Compared with high DO concentrations (2 mg L−1), low DO conditions achieved 10% higher TN removal efficiency, with similar ammonium and COD removal efficiency. This study is crucial in promoting the energy efficiency and sustainability of wastewater treatment plants treating low COD/N wastewater.
- Open Access
Hydrothermal Carbonization of Sewage Sludge into Solid Biofuel: Influences of Process Conditions on the Energetic Properties of Hydrochar
Hydrothermal carbonization (HTC) is an attractive, green technology for the management of sewage sludge. In this study, low-value secondary sewage sludge was subjected to an HTC treatment in a 1 L batch hydrothermal reactor and transformed into a high-energy-density hydrochar under varying HTC conditions (temperature of 150–300 °C, carbonization time of 30–150 min and a solid loading of 10–30%). The resulting hydrochar fuel characteristics were analyzed for ultimate and proximate analyses, functional group composition and energetic parameters. It was found that the hydrochar yield decreased with the increasing HTC temperature and reaction time, primarily due to the loss of organic volatile matter and functional groups. Under the optimum conditions of 150 °C, 30 min of carbonization time and 30% solid loading, 80.56% of the hydrochar was recovered, providing a maximum energy yield of 90.32% and a high heating value of 18.49 MJ/kg. Compared to the raw sewage sludge (H/C ratio of 2.67 and O/C ratio of 0.51), the hydrochar also had lower H/C and O/C atomic ratios of 1.42 and 0.18, respectively. The results suggest that significant dehydration and decarboxylation during the HTC treatment of sewage sludge have resulted in the formation of carbonaceous hydrochar with energetic properties close to the sub-bituminous coals.
Open AccessHydrothermal Carbonization of Sewage Sludge into Solid Biofuel: Influences of Process Conditions on the Energetic Properties of Hydrochar
Hydrothermal carbonization (HTC) is an attractive, green technology for the management of sewage sludge. In this study, low-value secondary sewage sludge was subjected to an HTC treatment in a 1 L batch hydrothermal reactor and transformed into a high-energy-density hydrochar under varying HTC conditions (temperature of 150–300 °C, carbonization time of 30–150 min and a solid loading of 10–30%). The resulting hydrochar fuel characteristics were analyzed for ultimate and proximate analyses, functional group composition and energetic parameters. It was found that the hydrochar yield decreased with the increasing HTC temperature and reaction time, primarily due to the loss of organic volatile matter and functional groups. Under the optimum conditions of 150 °C, 30 min of carbonization time and 30% solid loading, 80.56% of the hydrochar was recovered, providing a maximum energy yield of 90.32% and a high heating value of 18.49 MJ/kg. Compared to the raw sewage sludge (H/C ratio of 2.67 and O/C ratio of 0.51), the hydrochar also had lower H/C and O/C atomic ratios of 1.42 and 0.18, respectively. The results suggest that significant dehydration and decarboxylation during the HTC treatment of sewage sludge have resulted in the formation of carbonaceous hydrochar with energetic properties close to the sub-bituminous coals.