Nurdiyantoro Putra Prasetya
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Nurdiyantoro Putra Prasetya has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Budi Purnama
Sebelas Maret University
4 shared publications - Kusumandari Kusumandari
SCOPUS ID: 55005967600, h-index : 3), Physics Department, Universitas Sebelas Maret
2 shared publications - Nur Aji Wibowo
Department of Physics, Universitas Kristen Satya Wacana, Jl. Diponegoro No. 52-60, Salatiga, 50711, Indonesia
2 shared publications Utari
2 shared publicationsAdiana Musadewi
Physics Department, Faculty of Mathematics and Natural Sciences, Universitas Sebelas Maret, Jl. Ir. Sutami 36A, Kentingan, Jebres, Surakarta 57126, Indonesia
1 shared publicationAgus Supriyanto
1 shared publication
Latest Publications
- 30 October 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (30) , 62554-62570
Strain lattice induced magnetism in yttrium substituted cobalt ferrite and their Congo-red dye-removal properties
- 30 October 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (30) , 62554-62570
Strain lattice induced magnetism in yttrium substituted cobalt ferrite and their Congo-red dye-removal properties
- Open Access
- 1 January 2025
- Published by Wiley in Journal of Nanotechnology
- Vol. 2025 (1)
Characteristic Improvement of Reduced Graphene Oxide From Battery Waste Synthesized Using Modified Hummer’s Method
In this study, the reduced graphene oxide (rGO) using the modified Hummers method from battery waste materials has been successfully carried out. The results obtained were compared with the conventional Hummers method. XRD analysis showed that the characteristic peaks of graphene oxide (GO) were reduced to rGO using both the conventional and modified Hummers methods. The results of the UV‐vis analysis also revealed that the absorption peak of the rGO sample showed a shift toward a longer wavelength, located between 200 and 270 nm, compared to GO. The FTIR results showed that the intensity of all oxygen‐containing functional groups was reduced in rGO (the presence of several spectral peaks and functional groups after reduction), thus confirming the successful reduction of GO using both the modified and conventional Hummers methods. The Raman spectroscopy results showed that the defects in rGO using the modified Hummers method were smaller than those in rGO using the conventional Hummers method. This can be seen from the results of the D‐band and G‐band intensity ratios ( I D / I G ), which were 1.108 and 1.292 in rGO using the modified and conventional Hummers methods, respectively. SEM analysis shows morphological changes indicating changes in graphite to GO and then to rGO. The EDX results obtained are also reinforced by the increase in carbon elements (84.21% = conventional rGO and 82.80% = modified rGO) and a decrease in oxygen elements in all methods for rGO. These findings suggest that the modified Hummers method, which utilizes environmentally friendly chemicals instead of hazardous ones (convention Hummers method), is a viable approach for converting battery waste into rGO applications. Additionally, the oxygen content produced by the modified Hummers method is higher than that of the conventional Hummers method.
- 1 January 2025
- Published by Wiley in Journal of Nanotechnology
- Vol. 2025 (1)
Open AccessCharacteristic Improvement of Reduced Graphene Oxide From Battery Waste Synthesized Using Modified Hummer’s Method
In this study, the reduced graphene oxide (rGO) using the modified Hummers method from battery waste materials has been successfully carried out. The results obtained were compared with the conventional Hummers method. XRD analysis showed that the characteristic peaks of graphene oxide (GO) were reduced to rGO using both the conventional and modified Hummers methods. The results of the UV‐vis analysis also revealed that the absorption peak of the rGO sample showed a shift toward a longer wavelength, located between 200 and 270 nm, compared to GO. The FTIR results showed that the intensity of all oxygen‐containing functional groups was reduced in rGO (the presence of several spectral peaks and functional groups after reduction), thus confirming the successful reduction of GO using both the modified and conventional Hummers methods. The Raman spectroscopy results showed that the defects in rGO using the modified Hummers method were smaller than those in rGO using the conventional Hummers method. This can be seen from the results of the D‐band and G‐band intensity ratios ( I D / I G ), which were 1.108 and 1.292 in rGO using the modified and conventional Hummers methods, respectively. SEM analysis shows morphological changes indicating changes in graphite to GO and then to rGO. The EDX results obtained are also reinforced by the increase in carbon elements (84.21% = conventional rGO and 82.80% = modified rGO) and a decrease in oxygen elements in all methods for rGO. These findings suggest that the modified Hummers method, which utilizes environmentally friendly chemicals instead of hazardous ones (convention Hummers method), is a viable approach for converting battery waste into rGO applications. Additionally, the oxygen content produced by the modified Hummers method is higher than that of the conventional Hummers method.
- Open Access
- 18 October 2023
- Published by BCREC Publishing Group in Bulletin of Chemical Reaction Engineering & Catalysis
- Vol. 18 (4) , 582-592
Lanthanum-substituted Cobalt Ferrite Established by the Co-precipitation Process: Annealing Temperature Adjustment of Structural, Magnetic, and Dye Removal Characteristics
Co-precipitation process was used for the synthesis of lanthanum-substituted cobalt ferrite nanoparticles at several annealing temperatures (Ta), i.e., 200 °C, 300 °C, and 400 °C, for 5 h. XRD spectral depicted that the produced nanoparticles sample indicates a single phase of fcc inverse spinel conforming to ICDD No 22-1086. The crystallite size (D) calculation at the strongest peaks shows the increase in enhancing the Ta i.e., 18.99 nm, 19.90 nm, and 23.21 nm for 200 °C, 300 °C, and 400 °C, respectively. The FTIR results showed absorption band at the tetrahedral site, v1 ~575 cm−1 and the octahedral site, v2 ~474 cm−1. The absorption bands indicate that the lanthanum ions have successfully replaced the Fe3+ cations in the original cobalt ferrite structure. According to the hysteresis loop, the coercive field's (HC) magnitude falls from 700 Oe down to 550 Oe as Ta increases. This result is consistent with the anisotropy constant which decreased from 0.77×104 erg/cm3 to 0.56×104 erg/cm3. The obtained nanoparticles also showed superior performance (much larger than 95%) for dye removal of Congo red. Copyright © 2023 by Authors, Published by BCREC Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).
- 18 October 2023
- Published by BCREC Publishing Group in Bulletin of Chemical Reaction Engineering & Catalysis
- Vol. 18 (4) , 582-592
Open AccessLanthanum-substituted Cobalt Ferrite Established by the Co-precipitation Process: Annealing Temperature Adjustment of Structural, Magnetic, and Dye Removal Characteristics
Co-precipitation process was used for the synthesis of lanthanum-substituted cobalt ferrite nanoparticles at several annealing temperatures (Ta), i.e., 200 °C, 300 °C, and 400 °C, for 5 h. XRD spectral depicted that the produced nanoparticles sample indicates a single phase of fcc inverse spinel conforming to ICDD No 22-1086. The crystallite size (D) calculation at the strongest peaks shows the increase in enhancing the Ta i.e., 18.99 nm, 19.90 nm, and 23.21 nm for 200 °C, 300 °C, and 400 °C, respectively. The FTIR results showed absorption band at the tetrahedral site, v1 ~575 cm−1 and the octahedral site, v2 ~474 cm−1. The absorption bands indicate that the lanthanum ions have successfully replaced the Fe3+ cations in the original cobalt ferrite structure. According to the hysteresis loop, the coercive field's (HC) magnitude falls from 700 Oe down to 550 Oe as Ta increases. This result is consistent with the anisotropy constant which decreased from 0.77×104 erg/cm3 to 0.56×104 erg/cm3. The obtained nanoparticles also showed superior performance (much larger than 95%) for dye removal of Congo red. Copyright © 2023 by Authors, Published by BCREC Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).
- Open Access
- 17 May 2023
- Published by Elsevier in Kuwait Journal of Science
- Vol. 50 (4) , 575-579
Sodium-hydroxide molarities influence the structural and magnetic properties of strontium-substituted cobalt ferrite nanoparticles produced via co-precipitation
- 17 May 2023
- Published by Elsevier in Kuwait Journal of Science
- Vol. 50 (4) , 575-579
Open AccessSodium-hydroxide molarities influence the structural and magnetic properties of strontium-substituted cobalt ferrite nanoparticles produced via co-precipitation
- Open Access
- 1 March 2023
- Published by IOP Publishing in Materials Research Express
- Vol. 10 (3) , 036102
Cation trivalent tune of crystalline structure and magnetic properties in coprecipitated cobalt ferrite nanoparticles
CoFe2O4, CoBi0.1Fe1.9O4, CoLa0.1Fe1.9O4, and CoAl0.1Fe1.9O4 nanoparticles were successfully synthesized by the coprecipitation method. After annealing at 700 °C for 5 h, the x-ray Diffractometer results confirm that a single phase of cobalt ferrite-based nanoparticles is obtained, which is suitable for ICDD 22-1086. The addition of Bi3+, La3+ and Al3+ ions to the cobalt ferrite nanoparticles modified the crystallite size and lattice constant. Trivalent metal cation substitution tunes the crystallite size which has also been confirmed by measuring the grains with Scanning Electron Microscope images. In the Far Transform Infra-Red curve, the addition of metal ions (Bi3+, La3+, and Al3+) to cobalt ferrite nanoparticles resulted in absorption peaks at the tetrahedral and octahedral sites without any additional absorption peaks. The VSM results showed that saturation magnetization decreased drastically in the presence of trivalent non-magnetic cations, which confirms the replacement of Fe3+ by trivalent non-magnetic cations. The kOe order of the coercive field was obtained in this experiment. The largest coercive field of the cobalt ferrite nanoparticles was obtained with the addition of La3+ ions, i.e. 3.67 kOe suggest to support both Jahn-Teller effect and strain-induced magnetism.
- 1 March 2023
- Published by IOP Publishing in Materials Research Express
- Vol. 10 (3) , 036102
Open AccessCation trivalent tune of crystalline structure and magnetic properties in coprecipitated cobalt ferrite nanoparticles
CoFe2O4, CoBi0.1Fe1.9O4, CoLa0.1Fe1.9O4, and CoAl0.1Fe1.9O4 nanoparticles were successfully synthesized by the coprecipitation method. After annealing at 700 °C for 5 h, the x-ray Diffractometer results confirm that a single phase of cobalt ferrite-based nanoparticles is obtained, which is suitable for ICDD 22-1086. The addition of Bi3+, La3+ and Al3+ ions to the cobalt ferrite nanoparticles modified the crystallite size and lattice constant. Trivalent metal cation substitution tunes the crystallite size which has also been confirmed by measuring the grains with Scanning Electron Microscope images. In the Far Transform Infra-Red curve, the addition of metal ions (Bi3+, La3+, and Al3+) to cobalt ferrite nanoparticles resulted in absorption peaks at the tetrahedral and octahedral sites without any additional absorption peaks. The VSM results showed that saturation magnetization decreased drastically in the presence of trivalent non-magnetic cations, which confirms the replacement of Fe3+ by trivalent non-magnetic cations. The kOe order of the coercive field was obtained in this experiment. The largest coercive field of the cobalt ferrite nanoparticles was obtained with the addition of La3+ ions, i.e. 3.67 kOe suggest to support both Jahn-Teller effect and strain-induced magnetism.