Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Inmaculada Casaucao has a total of 35 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Embedded neural control: An online learning strategy for a buck converter

    by Fabio Corti, Matteo Intravaia, Marco Bindi, Inmaculada Casaucao, Gabriele Maria Lozito, Alicia Triviño, Alberto Reatti

  • Open Access

    LCC-S vs. LCC-LCC: Efficient Wireless Charging for Underwater Drones Under Seawater Conditions

    by Inmaculada Casaucao, Alicia Triviño

    Battery autonomy is one of the main factors limiting the endurance of autonomous underwater vehicles (AUVs). Conventional charging through electrical connectors is inconvenient in marine environments since connectors are exposed to corrosion and usually require manual intervention or docking procedures. Inductive wireless power transfer (WPT) avoids these drawbacks, although the conductive nature of seawater introduces additional effects, such as eddy current losses and parasitic capacitance between the coils. These effects modify the resonance conditions of the compensation network and, in turn, reduce the transfer efficiency. This paper presents the design and experimental assessment of an inductive charger for a commercial and specific underwater drone operating under seawater conditions. A square coil geometry, selected to match the available installation area on the vehicle, was analysed together with two compensation networks (LCC-S and LCC-LCC) and two coil designs with 20 and 25 turns. Based on an analytical characterisation, their performance was evaluated for different coil separations and operating temperatures. Among the analysed configurations, the LCC-S topology with 25 turns provided the best compromise between efficiency and tolerance to gap variations. A laboratory prototype was subsequently built and tested in saline water with NaCl concentrations of 2%, 3%, and 4%, reaching an efficiency close to 87% at 266 W. These results confirm that the proposed design is suitable for underwater wireless charging under representative marine salinity conditions.

  • Open Access

    Effects of Salinity in an Inductive Wireless Charger for Autonomous Underwater Vehicles

    by Inmaculada Casaucao, Alicia Triviño, Ruth Cueto

    The charging methods of Autonomous Underwater Vehicles (AUVs) are evolving according to the battery autonomy requirements. One of the main solutions to solve this issue is wireless charging. However, in inductive wireless chargers, the seawater salinity can lead to different effects during the charging process, such as the appearance of parasitic capacitances between the power coils or the generation of eddy currents. Additionally, the average salinity is 3.7%, however, the value can vary according to the location of the environment under study. In this contribution, it is important to analyse, first, the equivalent circuit of an inductive wireless charger in seawater, considering the effects of salinity. Then, the effect of the seawater salinity concentration in self-inductance, resistance and efficiency are studied. In this case, an experimental comparative analysis with 6 different values of salinity is performed. With this analysis, it can be concluded that increasing salinity leads to a slight reduction in efficiency. However, this drop does not exceed 2% in the desired power range (from 100 W to 500 W) for a variation between 3% and 6% of salinity, so it can be verified that the operation of the charger is suitable for different underwater environments.

  • Open Access

    ZVS–ZCS-Supported Control for V2G Wireless Charging

    by Inmaculada Casaucao, Marcelo Llomplat, Alicia Trivino

  • Open Access

    Double-Sided LCC V2G Inductive Link With Four-Quadrant Control for an EV SAE J2954-Compliant Charger

    by Inmaculada Casaucao, Alicia Triviño

    Electric vehicles (EVs) have a high impact on power systems, since the demand peaks they generate can cause instabilities in the electricity grid. One of the technologies that are proposed to alleviate this impact is Vehicle-to-Grid (V2G) strategies, which could be implemented in conductive charger and in advanced equipment such as wireless charging. V2G combined with adjustable power levels (in the charging and discharging processes) adds flexibility to the grid. The aim of this paper is the definition of a V2G control wireless system working in V2G 4-quadrants, where any combination of active and reactive power is possible. In this way, the EVs with wireless charging can participate in multiple ancillary services, beyond the traditional approach to comply with power quality requirements. The main contribution of this work is that a SAE J2954-compliant EV charger has been considered, where it is included a double-sided LCC compensation topology due to its popularity. To do so, analytical studies, simulations and experimental validations up to 500 W have been carried out. The final results highlight the feasibility of this system in eight operation modes, achieving an overall efficiency higher than $90~\%$ .


  • Effects of salinity in an inductive wireless charger for Autonomous Underwater Vehicles

    by Inmaculada Casaucao, Alicia Triviño

    The charging methods of Autonomous Underwater Vehicles (AUVs) are evolving according to the battery autonomy requirements. One of the main solutions to solve this issue is wireless charging. However, in inductive wireless charger, the seawater salinity can lead to different effects during the charging process, such as the appearance of parasitic capacitances between the power coils. The average value of this salinity is 3.7 %. However, the value can vary according to the location of the environment under study. In this contribution, we aim to analyse the effect of the seawater salinity in a circuit that has been designed to neglect the effects of the parasitic capacitance. In this case, an experimental comparative analysis with 6 different values of salinity is performed. With this analysis, it can be concluded that with a higher salinity value, the efficiency slightly drops compared to the ideal case. However, this drop does not exceed 2 % in the desired power range (from 100 W to 500 W), so it can be verified that the operation of the charger is suitable for different underwater environments.


  • Open Access

    Coils Optimisation to Avoid Parasitic Capacitance Effects in an Inductive Wireless Charger for Underwater Vehicles

    by Inmaculada Casaucao, Alejandro Linares, Alicia Triviño

    The integration of inductive charging technology in electric vehicles has aroused the interest of researchers in recent years. Specifically, one of the growing areas is wireless charging in Autonomous Underwater Vehicles (AUVs). In this environment, the effects of seawater in wireless power transmission should be carefully studied. Specifically, one of the effects that should be analysed is the appearance of parasitic capacitances (Ce) between the power coils due to the high conductivity of seawater. The parasitic capacitance, together with the power converters switching losses and the resistive and inductive losses, can lead to a drop in efficiency during the charging process. The main objective of this contribution is to find the optimal solution to avoid the effects of Ce during the coils design, thus simplifying the process and making it equivalent to an air-based solution. To do so, different design criteria have been defined with a comparative analysis among different topologies proposed. Specifically, we have studied the variations of voltage, current, and efficiency caused by the Ce. Additionally, a comparison between Series-Series (SS) and LCC–Series (LCC–S) compensation systems has been considered, studying the system efficiency and maximum current values found on the circuit. The results of these studies have been verified through experimental validations, where the design and implementation of the elements that constitute the inductive charger have been performed. This validation has demonstrated the possibility of neglecting the effects of Ce by optimising the coil’s design.


  • Compensation topologies for inductive-resonant chargers in underwater vehicles

    by Inmaculada Casaucao, Alejandro Linares, Alicia Triviño

    With the rise of Autonomous Underwater Vehicles (AUVs), the research related to their charging technology has increased. One of the solutions proposed to address issues such as vehicle autonomy is the use of wireless charging, which avoids the need for the vehicle to leave the water to charge. Among the available technologies, resonant inductive charging is the most widely used for this type of application due to its good performance. One of the main elements used by this technology, in addition to a pair of coupled coils, is the compensation system, among which the SS and LCC-S, consisting of capacitors and coils, stand out. Furthermore, it should be noted that, in a real prototype, the final values of the components may be slightly different due to the internal tolerance of the manufacturers. Thus, this contribution aims to study which compensation system is optimal for this application, considering both the efficiency of the system in each compensation, as well as the final efficiency by analysing the behaviour of the circuit in a 5 % tolerance range of the components. The results of this analysis show that the most suitable compensation is the LCC-S, with which efficiency values of 80 % can be achieved, and where variations in the theoretical values of the components do not have a great effect.

  • A redesigning process for applying PTS theory in an existing drone WPT charging system

    by José Ruiz, Alicia Triviño, Inmaculada Casaucao

    In recent times, wireless power transfer (WPT) systems based on the parity-time symmetry (PTS) principle have been the subject of numerous studies specifically targeting drone battery charging. Both coupled mode theory (CMT) and electric circuit theory (ECT) have been applied to determine the directing equations that rule the operating point of these systems into the exact parity-time symmetric (PTS) region. This guarantees the benefits of constant efficiency and output power against the variations of the mutual inductance through the airgap between the coupled coils. Most of these studies focus on proving the theory without really checking the viability of the implementation of their particular solution on a real practical system. In this work, we analyze how to redesign a wireless charging based on Reflected Load Theory (RLT) to adjust to the PTS theory. Particularly, we analyze a system composed of a drone and its WPT charging platform. The present paper reexamines these approaches proposing the representation of the equations as limit curves that graphically show operating regions where the system parameters meet the established design requirements.