Manisha Verma
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Manisha Verma has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Sanjeeta Rani
University of Delhi
6 shared publications - Sunita Hooda
Polymer Research Laboratory, Department of Chemistry, Acharya Narendra Dev College (University of Delhi), Govindpuri, Kalkaji, New Delhi, 110019, India
4 shared publications - Laishram Saya
University of Delhi
3 shared publications Sunita Hooda
3 shared publications- Priti Goyal
University of Delhi
2 shared publications - Akshat Dharmani1 shared publication
Latest Publications
- Open Access
- 30 April 2026
- Published by Elsevier in SSRN Electronic Journal
Green Engineered Magnetic Guar Gum blended CuO Nanocomposite for High-Performance Adsorptive Sequestration of Ciprofloxacin and Levofloxacin
The synthesis of Fe3O4 loaded guar gum blended with CuO (MGG/CuO), is reported in this paper. A two-step synthesis process was adopted that starts with plant-mediated synthesis of CuO nanoparticles employing neem leaf extract followed by MGG/CuO via a facile co-precipitation approach. Analytical techniques like XRD, FTIR, HRTEM, FESEM, EDAX, BET, TGA, pHZPC and VSM analysis were used to identify the nanocomposite. The material's ability to adsorb ciprofloxacin and levofloxacin, two members belonging to the fluoroquinolone group of antibiotics, from aqueous medium was then examined. The Lagergren's pseudo-second-order model and Langmuir isotherm model were witnessed as the kinetic and isotherm models that can most accurately describe the adsorption behavior for both. However, there was a noticeable variation in the kinetic behavior, with CPX having a K2 value of 0.00113 and LVX having a far lower value (K2= 0.00085). Calculations from Langmuir isotherm data exhibited a much higher adsorption potential with a qmax value of 416.66 mg g-1 toward CPX while LVX showed inferior adsopriton with a qmax of 312.5 mg g-1. According to thermodynamics studies, both LVX and CPX exhibit spontaneous adsorption with an exergonic behavior, which is confirmed by negative values of ΔGo, and ΔHo as well as an increase in ΔSo, which is again significantly higher in the case of CPX than in the case of LVX. The primary interacting forces that are predicted to contribute substantially to the adsorption are hydrogen bonding, hydrophobic interactions, metal-ligand coordination, pore filling, and columbic/electrostatic interactions.
- 30 April 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessGreen Engineered Magnetic Guar Gum blended CuO Nanocomposite for High-Performance Adsorptive Sequestration of Ciprofloxacin and Levofloxacin
The synthesis of Fe3O4 loaded guar gum blended with CuO (MGG/CuO), is reported in this paper. A two-step synthesis process was adopted that starts with plant-mediated synthesis of CuO nanoparticles employing neem leaf extract followed by MGG/CuO via a facile co-precipitation approach. Analytical techniques like XRD, FTIR, HRTEM, FESEM, EDAX, BET, TGA, pHZPC and VSM analysis were used to identify the nanocomposite. The material's ability to adsorb ciprofloxacin and levofloxacin, two members belonging to the fluoroquinolone group of antibiotics, from aqueous medium was then examined. The Lagergren's pseudo-second-order model and Langmuir isotherm model were witnessed as the kinetic and isotherm models that can most accurately describe the adsorption behavior for both. However, there was a noticeable variation in the kinetic behavior, with CPX having a K2 value of 0.00113 and LVX having a far lower value (K2= 0.00085). Calculations from Langmuir isotherm data exhibited a much higher adsorption potential with a qmax value of 416.66 mg g-1 toward CPX while LVX showed inferior adsopriton with a qmax of 312.5 mg g-1. According to thermodynamics studies, both LVX and CPX exhibit spontaneous adsorption with an exergonic behavior, which is confirmed by negative values of ΔGo, and ΔHo as well as an increase in ΔSo, which is again significantly higher in the case of CPX than in the case of LVX. The primary interacting forces that are predicted to contribute substantially to the adsorption are hydrogen bonding, hydrophobic interactions, metal-ligand coordination, pore filling, and columbic/electrostatic interactions.
- 10 March 2026
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 30 (5) , 1-20
Energy-efficient magnetite-chitosan/GO nanocomposites: structural, dielectric, and conductivity analysis for sustainable energy solutions
- 10 March 2026
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 30 (5) , 1-20
Energy-efficient magnetite-chitosan/GO nanocomposites: structural, dielectric, and conductivity analysis for sustainable energy solutions
- Open Access
- 30 November 2025
- Published by Asian Publication Corporation in Asian Journal of Chemistry
- Vol. 37 (12) , 3183-3190
Thermo-Electrical Performance of Ferrite-Doped Chitosan Nanocomposites Modified with Graphene Oxide
The growing demand for renewable, multifunctional materials has spurred interest in nanocomposites for energy, biomedical and environmental uses. In this study, magnetic chitosan (MCS) and magnetic chitosan–graphene oxide (MCS/GO) nanocomposites were synthesized via a simple coprecipitation method. The structural, thermal and electrochemical properties were analyzed using XRD, FESEM-EDAX, TGA and impedance spectroscopy. XRD confirmed nanocrystalline phases (7.6 nm) with uniform magnetite dispersion in the polymer–GO matrix. TGA showed a residual mass of ~88% at 800 ºC for MCS/GO, indicating high thermal stability. Impedance analysis showed easier charge movement through the bulk at higher frequencies; both resistance and reactance decreased with temperature, confirming thermally activated transport. The activation energy (~168 meV) indicates efficient GO-assisted carrier hopping, making MCS/GO nanocomposites promising for energy-efficient sensors, solid-state batteries and thermally stable electronic devices.
- 30 November 2025
- Published by Asian Publication Corporation in Asian Journal of Chemistry
- Vol. 37 (12) , 3183-3190
Open AccessThermo-Electrical Performance of Ferrite-Doped Chitosan Nanocomposites Modified with Graphene Oxide
The growing demand for renewable, multifunctional materials has spurred interest in nanocomposites for energy, biomedical and environmental uses. In this study, magnetic chitosan (MCS) and magnetic chitosan–graphene oxide (MCS/GO) nanocomposites were synthesized via a simple coprecipitation method. The structural, thermal and electrochemical properties were analyzed using XRD, FESEM-EDAX, TGA and impedance spectroscopy. XRD confirmed nanocrystalline phases (7.6 nm) with uniform magnetite dispersion in the polymer–GO matrix. TGA showed a residual mass of ~88% at 800 ºC for MCS/GO, indicating high thermal stability. Impedance analysis showed easier charge movement through the bulk at higher frequencies; both resistance and reactance decreased with temperature, confirming thermally activated transport. The activation energy (~168 meV) indicates efficient GO-assisted carrier hopping, making MCS/GO nanocomposites promising for energy-efficient sensors, solid-state batteries and thermally stable electronic devices.
- 6 December 2024
- Published by Elsevier in Chemosphere
- Vol. 369, 143906
Assessment of multifunctional activity of graphene oxide and guar gum-based nanomaterials against Aedes aegypti
- 6 December 2024
- Published by Elsevier in Chemosphere
- Vol. 369, 143906
Assessment of multifunctional activity of graphene oxide and guar gum-based nanomaterials against Aedes aegypti
- Open Access
- 1 October 2023
- Published by IOP Publishing in Materials Research Express
- Vol. 10 (10) , 105011
Structural, electrical and dielectric properties of ZnFe2O4/Cu2S 3D heterostructures
This work reports the fabrication of zinc ferrite-copper sulphide (ZnFe2O4/Cu2S) 3D heterostructures and subsequent investigation of the spectroscopic behaviour of various electrical parameters like conductivity, impedance and dielectric loss. The study reveals a non-monotonic behaviour of the real component of impedance (Z’), while the imaginary component of impedance (Z’) exhibits a temperature-dependent relaxation frequency, with an estimated activation energy (E a ) of 220.13 meV. The dc conductivity (σ dc ) measurements reveal the semiconducting nature of the sample and a transition from a ferrimagnetic to a paramagnetic behaviour is reported at the Curie temperature of 327 K. In case of ac conductivity (σ ac ), Jonscher’s power law σ ac = Aω n is followed and the exponent n is found to lie in the range 0.679–0.735 at different temperatures, which is best fitted into a polynomial of degree six. The temperature variation of n is suggestive of the overlapping large polaron tunnelling (OLPT) model. Further, ac activation energy (E ac ) is also calculated, which is found to be smaller than the dc activation energy (E dc ), indicating electron hopping between Fe3+ and Fe2+ ions. The numerically computed staying time (τ) of electrons in Fe3+/Fe2+ ionic sites varies with frequency as well as with temperature, ranging from 10−6s to 10−19s. A significant decrease in dielectric loss (tanδ) to the tune of 99% (from 75 at ∼100 Hz to 0.89 at ∼1 MHz) is reported at room temperature. In the present scenario, when smart materials like spinel ferrites have garnered significant attention for their promising magnetic and electric properties, our studies of the ZnFe2O4/Cu2S 3D heterostructures may provide immense possibilities for tailored applications in various electromagnetic applications.
- 1 October 2023
- Published by IOP Publishing in Materials Research Express
- Vol. 10 (10) , 105011
Open AccessStructural, electrical and dielectric properties of ZnFe2O4/Cu2S 3D heterostructures
This work reports the fabrication of zinc ferrite-copper sulphide (ZnFe2O4/Cu2S) 3D heterostructures and subsequent investigation of the spectroscopic behaviour of various electrical parameters like conductivity, impedance and dielectric loss. The study reveals a non-monotonic behaviour of the real component of impedance (Z’), while the imaginary component of impedance (Z’) exhibits a temperature-dependent relaxation frequency, with an estimated activation energy (E a ) of 220.13 meV. The dc conductivity (σ dc ) measurements reveal the semiconducting nature of the sample and a transition from a ferrimagnetic to a paramagnetic behaviour is reported at the Curie temperature of 327 K. In case of ac conductivity (σ ac ), Jonscher’s power law σ ac = Aω n is followed and the exponent n is found to lie in the range 0.679–0.735 at different temperatures, which is best fitted into a polynomial of degree six. The temperature variation of n is suggestive of the overlapping large polaron tunnelling (OLPT) model. Further, ac activation energy (E ac ) is also calculated, which is found to be smaller than the dc activation energy (E dc ), indicating electron hopping between Fe3+ and Fe2+ ions. The numerically computed staying time (τ) of electrons in Fe3+/Fe2+ ionic sites varies with frequency as well as with temperature, ranging from 10−6s to 10−19s. A significant decrease in dielectric loss (tanδ) to the tune of 99% (from 75 at ∼100 Hz to 0.89 at ∼1 MHz) is reported at room temperature. In the present scenario, when smart materials like spinel ferrites have garnered significant attention for their promising magnetic and electric properties, our studies of the ZnFe2O4/Cu2S 3D heterostructures may provide immense possibilities for tailored applications in various electromagnetic applications.
- Open Access
- 21 August 2023
- Published by LUKASIEWICZ Research Network - Industrial Chemistry Research Institute in Polimery
- Vol. 68 (7-8) , 386-395
Novel multicomponent functionalized biopolymers with enhanced thermal and dielectric properties
A new functionalized biopolymer was obtained by adding ethylenediaminetetraacetic acid to chitin and magnetite nanoparticles (Fe3O4). Thermogravimetric analysis was performed, and dielectric properties were examined. The obtained biopolymer showed better thermal stability, as evidenced by a higher onset temperature. The activation energy calculated using imaginary impedance data and Nyquist plots was found to be consistent. Moreover, the dielectric permittivity decreased rapidly with increasing frequency. At high frequencies, there was no dependence of dielectric loss on temperature and frequency. The obtained biopolymer can be used in many applications such as microwave devices, deflection yoke, high-frequency capacitors, sensors, etc.
- 21 August 2023
- Published by LUKASIEWICZ Research Network - Industrial Chemistry Research Institute in Polimery
- Vol. 68 (7-8) , 386-395
Open AccessNovel multicomponent functionalized biopolymers with enhanced thermal and dielectric properties
A new functionalized biopolymer was obtained by adding ethylenediaminetetraacetic acid to chitin and magnetite nanoparticles (Fe3O4). Thermogravimetric analysis was performed, and dielectric properties were examined. The obtained biopolymer showed better thermal stability, as evidenced by a higher onset temperature. The activation energy calculated using imaginary impedance data and Nyquist plots was found to be consistent. Moreover, the dielectric permittivity decreased rapidly with increasing frequency. At high frequencies, there was no dependence of dielectric loss on temperature and frequency. The obtained biopolymer can be used in many applications such as microwave devices, deflection yoke, high-frequency capacitors, sensors, etc.
- 22 March 2023
- Published by Springer Nature in Journal of Low Temperature Physics
- Vol. 211 (3-4) , 138-155
Enhancement of Carrier Mobility and Bandgap in Plastically Deformed Bi Single Crystal
- 22 March 2023
- Published by Springer Nature in Journal of Low Temperature Physics
- Vol. 211 (3-4) , 138-155
Enhancement of Carrier Mobility and Bandgap in Plastically Deformed Bi Single Crystal
- Open Access
- 13 February 2023
- Published by Arts and Science Press Pte. Ltd. in Applied Chemical Engineering
- Vol. 6 (1) , 59-67
Complex dielectric-impedance spectroscopic studies of magnetite added chitin biopolymer
Complex dielectric-impedance spectroscopic studies of magnetite added chitin biopolymer
- 13 February 2023
- Published by Arts and Science Press Pte. Ltd. in Applied Chemical Engineering
- Vol. 6 (1) , 59-67
Open AccessComplex dielectric-impedance spectroscopic studies of magnetite added chitin biopolymer
Complex dielectric-impedance spectroscopic studies of magnetite added chitin biopolymer