XZXiaohan Zhai

Xiaohan Zhai

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Xiaohan Zhai has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Compact Polarization and Pattern Diversity Antenna with Enhanced Azimuthal Gain for Vehicular Communications

    by Xiaohan Zhai, Jiaxin Kuang, Lei Zhu

    A compact tri-polarized antenna providing both polarization and pattern diversity is proposed in this article. The antenna integrates a vertically polarized omnidirectional radiator with enhanced azimuthal gain for vehicle-to-vehicle (V2V) communication and a pair of orthogonal dipoles with ±45° polarizations for vehicle-to-base station communication. Unlike conventional omnidirectional antennas that rely on collinear arrays to improve gain, the proposed omnidirectional element employs a cylindrical cavity surrounded by eight parasitic open cavities acting as magnetic dipoles. By carefully optimizing the coupling between the cylindrical cavity and the parasitic elements, a field-interference-based beam-shaping mechanism is realized, resulting in elevation beamwidth compression and azimuthal gain enhancement without increasing antenna height. The proposed omnidirectional radiator achieves an impedance bandwidth of 5.8–6.2 GHz and an azimuth-plane gain enhancement of 2.5 dB. Subsequently, a compact dual-band dual-polarized dipole antenna covering 1.7–1.9 GHz and 3.2–4.1 GHz is integrated atop the omnidirectional radiator to support vehicular LTE and sub-6 GHz 5G-NR communication. The overall antenna size is only 0.37λL × 0.37λL × 0.11λL (λL is the wavelength at the lowest operating frequency), and the port-to-port isolation exceeds 28 dB. Simulated and measured results are in good agreement. The feasibility on metallic platforms is demonstrated, confirming the proposed design a promising solution for compact vehicular communications.

  • Open Access

    Gain Improvement of a Low-Profile Horizontally Polarized Omnidirectional Antenna Using a Parasitic Loop

    by Xiaohan Zhai, Lei Zhu, Jiaxin Kuang

    Conventional horizontally polarized omnidirectional (HPO) antennas typically achieve gain enhancement by employing vertically stacked array configurations, which compress the beamwidth at the cost of increased height. To address this limitation, this article presents a low-profile HPO antenna that achieves gain enhancement without increasing its height. The key innovation lies in introducing a parasitic large loop around the primary loop antenna. By carefully controlling the amplitude and phase relationship of the currents in both loops, their radiation patterns cancel each other in undesired directions while maintaining the maximum radiation direction in the azimuth plane, effectively narrowing the main beam and improving directivity. To implement this concept, series-fed dipole subarrays based on pin-loaded double-sided parallel stripline (DSPSL) are employed to realize the loop structures and establish the required current distribution. Ultimately, a complete HPO antenna, configured as a ring array of four such subarrays, is designed and experimentally validated. Experimental results demonstrate that, compared to a conventional HPO antenna with no parasitic loop, the proposed antenna achieves a 60° beamwidth reduction in the elevation plane and an average gain improvement of 2.2 dB in the azimuth plane, while maintaining excellent omnidirectional radiation and a compact low-profile structure.

  • A Low-Profile Vertically Polarized Patch Antenna With Wideband Omnidirectional Radiation Based on Triple Resonant Modes

    by Xiaohan Zhai, Lei Zhu, Qianwen Liu

    In this letter, a low-profile, center-fed circular microstrip patch antenna (CMPA) is proposed. Under the concurrent operation of TM 01 , TM 02 and TM 03 resonant modes of a single CMPA, the vertically polarized (VP) omnidirectional radiation can be achieved in a wide bandwidth. Initially, the radiation mechanism and the far-field calculation of the TM0n mode of such a CMPA are investigated to demonstrate that the undesired radiation nulls of the higher modes can be removed by reducing the electrical length at resonance. To this end, a group of transverse slots is etched on the patch to lower the resonant frequency (f 03 ) and thus remove the radiation nulls from the TM 03 mode. After that, two groups of shorting pins are introduced to raise the resonant frequencies of TM 01 mode (f01) and TM 02 mode (f 02 ) in proximity to f 03 , respectively. By combining the three resonant modes, the final design offers a wide bandwidth of 2.9–3.9 GHz (29.4% in fraction) and a low profile of 0.034 times one free-space wavelength. Measurements evidently confirm its high efficiency, low cross-polarization and stable VP omnidirectional radiation pattern over the entire operating band, making this antenna suitable for applications with full signal coverage in the 5G N78 band.


  • A Low-Profile Dual-Polarized Omnidirectional Antenna for WLAN/UWB Applications

    by Sen Yan, Xiaohan Zhai, Hongwei Ren, Jiahao Zhang

    A novel ultrawideband (UWB) dual-polarized omnidirectional antenna with a low profile has been proposed for wireless local area networks (WLAN) and UWB applications. The antenna is comprised of two components: a vertically polarized (VP) sheet-like tapered monopole and a horizontally polarized (HP) tightly coupled circular connected array with Vivaldi antennas. The HP structure functions as the metal ground of the VP structure to overcome match deterioration when the HP structure is placed near to the metal ground of the VP structure. This design results in a low profile of only 0.08 λmin for the dual-polarized antenna ( λmin represents the wavelength at the lowest frequency within the working band). The antenna provides an overlapped bandwidth of 2.4-10.6 GHz (126%) and an isolation greater than 20 dB within the band. Meanwhile, high efficiency and uniform omnidirectional radiation patterns with a gain variation of less than 3 dB in the horizontal plane are obtained. These appealing properties enable the antenna an ideal choice for UWB applications and wireless communication systems.


  • A Low-Profile Broadband Dual-Polarized Omnidirectional Antenna for LTE Applications

    by Xiaohan Zhai, Sen Yan, Buyun Wang, Jiahao Zhang

    In this letter, a broadband dual-polarized antenna with a very low profile and omnidirectional gain patterns is designed for 1.7-2.7 GHz Long Term Evolution (LTE) mobile communications. The designed antenna is constituted by a miniaturized tapered monopole for vertical polarization (VP) and four planar dipoles arranged in a ring for horizontal polarization (HP). The HP antenna is used as the metal ground of the VP antenna, which can avoid the feeding intersection and solve the problem of impedance matching degradation when distance between the HP antenna and the metal ground of the VP antenna is close. By sharing the partial structure, the designed antenna achieves a compact size of 110 mm × 110 mm × 13 mm and an extremely low height of 0.07 λ min ( λ min is the free-space wavelength at the minimum operating frequency). The design achieves an overlapping bandwidth of 45% (1.7-2.7 GHz) with an isolation higher than 20 dB. High efficiency, low cross polarization and good omnidirectivity in the horizontal plane are obtained. The designed antenna is fabricated and measured, and it performs a great consistency between the simulation and measurement.