KSKanwar Barjinder Singh

Kanwar Barjinder Singh

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Kanwar Barjinder Singh has a total of 34 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Long-term integrated nitrogen management: effects on crop productivity, soil properties, and carbon sequestration potential of a rainfed maize-wheat cropping system in Punjab, India

    by Mohammad Amin Bhat, Mj Singh, Abrar Yousuf, Anil Khokhar, Parminder Singh Sandhu, Kanwar Barjinder Singh, Balwinder Singh Dhillon, Randeep Singh, Priya P. Gurav, S. Kundu, et al.


  • Synergistic Impact of Surface and Subsurface Drip Fertigation and Irrigation Scheduling on the Water Use and Productivity of a Basmati Rice–Wheat Cropping System

    by Ruchi Goyal, K. B. Singh, A. S. Brar

    Increasing water scarcity and nutrient demand requires efficient irrigation and nutrient management for sustaining the productivity of the basmati rice–wheat cropping system. This study assessed the impacts of two irrigation methods (surface [DI] and subsurface drip irrigation [SDI]), four irrigation schedules (I 15% , I 25% , I 35% and I 45% , i.e., 15%, 25%, 35% and 45% depletion of available water) and two nitrogen doses (100% and 75% of the recommended dose), in comparison with the control (flood irrigation with a 100% recommended dose of nitrogen). Compared with the control, the SDI N 100 I 15% , SDI N 100 I 25% , DI N 100 I 15% and DI N 100 I 25% achieved statistically comparable grain yield and yield attributes, with higher water productivity by 10%, 12%, 6% and 9% (pooled from 2021 to 2022 and 2022 to 2023) and irrigation water savings of 185, 255, 145 and 220 mm, respectively, in wheat and basmati rice from 2021 to 2022 and 225, 300, 175 and 265 mm, respectively, in wheat and basmati rice from 2022 to 2023. Furthermore, the highest economic water productivity was recorded in the SDI N 100 I 15% treatment (17.03 INR m −3 pooled) over the control (16.61 INR m −3 pooled) in the basmati rice–heat system. These findings highlight the potential of precision irrigation strategies in enhancing water productivity without compromising yield in the basmati rice–wheat system.


  • Impact of the Timing of First Irrigation and Subsequent Irrigation Schedules on Direct‐Seeded Furrow‐Irrigated Basmati Rice: Crop Growth, Productivity, Water Balance and Profitability

    by Diljeet Kaur, Angrej Singh, Vinay Kumar Sindhu, Kanwar Barjinder Singh

    Addressing food security and water scarcity calls for the cultivation of rice with improved productivity while minimizing water use. To assess the impact of planting techniques and irrigation schedules on the grain yield and water productivity of direct‐seeded basmati rice (DSBR), a 2‐year field experiment was conducted. This study tested whether (1) broad beds (90:30 cm) would increase water productivity and yield compared with conventional beds (37.5:30 cm) and (2) delaying the first irrigation and optimizing schedules would improve water efficiency without reducing yield. A split‐plot design was used with planting techniques (conventional and broad beds) and the timing of the first irrigation (7 and 14 DAS) in the main plots, whereas subsequent irrigation schedules ( IW / ET c values of 1.50, 1.75 and 2.0) were tested in the subplots. The results revealed that increasing the bed width did not significantly impact yield. Delaying the first irrigation saved 59 mm (5%) of water and reduced deep drainage by 107 mm (9%) without affecting yield or actual ET. Subsequent irrigation scheduling at IW / ET c ratios of 1.75 and 2.0 increased the grain yield by 10%–15% compared with 1.50 IW / ET c . Nonetheless, an IW / ET c of 1.75 saved approximately 17% of the irrigation water compared with an IW / ET c of 2.0, reducing the cultivation cost by US$ 30.2–43.8 ha −1 while maintaining a similar grain yield.


  • Open Access

    Effect of Different Tillage and Residue Management Options on Soil Water Transmission and Mechanical Behavior

    by Vicky Singh, Rajeev Kumar Gupta, M. S. Kahlon, A. S. Toor, K. B. Singh, Nadhir Al-Ansari, Mohamed A. Mattar

    Understanding the variability in the mechanical and hydrological soil characteristics resulting from diverse tillage and residue management practices is essential for evaluating the adoption of conservation strategies to preserve soil’s physical well-being. Zero-tillage techniques combined with residue retention or incorporation have gained widespread recognition for their capacity to conserve soil and water resources, reduce energy consumption, and enhance soil quality and environmental sustainability. Nevertheless, the choice of tillage and residue management options may vary depending on the geographical locations and specific soil conditions. To assess the impacts of four distinct tillage and residue management approaches, a two-year experiment (2020–2021 and 2021–2022) was conducted: T1: conventional tillage followed by wheat sowing after the removal of rice straw (CT-RS); T2: zero tillage with wheat sowing using a Happy Seeder while retaining rice straw (ZT+RS); T3: conventional tillage followed by wheat sowing after rice straw incorporation using a reversible mouldboard plough (CT+RS); T4: minimum tillage with wheat sowing using a Super Seeder with rice straw incorporation (MT+RS); the effects were recorded on the physical soil properties. Our findings indicate that zero tillage combined with residue retention (T2) had a positive influence on various physical soil attributes. Notably, significant differences were observed among the tillage and residue management options, particularly in terms of the bulk density with T1 exhibiting the highest values and the lowest being in T2, whereas the soil penetration resistance was lowest in T3 compared to T1. In the case of T3, sandy loam and clay loam soils had the highest measured saturated hydraulic conductivity values, measuring 5.08 and 4.57 cm h−1 and 4.07 and 3.73 cm h−1, respectively. Furthermore, T2 (zero tillage with residue retention) demonstrated the highest mean weight diameter (MWD) and maximum water stable aggregate. These results collectively underscore the positive effects of adopting zero tillage and retaining residue (T2) on soil structure and quality, particularly concerning the mechanical and hydrological soil properties.


  • Open Access

    Interactive Effects of Nitrogen Application and Irrigation on Water Use, Growth and Tuber Yield of Potato under Subsurface Drip Irrigation

    by Amanpreet Kaur, Kanwar Barjinder Singh, Rajeev Kumar Gupta, Abed Alataway, Ahmed Z. Dewidar, Mohamed A. Mattar

    Potatoes are a high-value crop with a shallow root system and high fertilizer requirements. The primary emphasis in potato production is minimizing nitrogen-leaching losses from the shallow root zone through fertigation. Therefore, a field experiment was conducted for two consecutive years, 2018–2019 2019–2020 to assess the effect of nitrogen and irrigation amount and frequency on tuber yield, water balance components and water productivity of potatoes under surface and subsurface drip irrigation. The experiment was laid out in a split-plot design with three nitrogen levels (187.5 kg N ha−1 (N1), 150 kg N ha−1 (N2) and 112.5 kg N ha−1 (N3)) in main plots and six irrigation levels in the subsurface (drip lines were laid at 20 cm depth) and one surface drip in subplots. Irrigation scheduling was based on 100% of cumulative pan evaporation at an alternate (I1) and two-day interval (I2), 80% of cumulative pan evaporation at an alternate (I3) and two-day interval (I4), 60% of cumulative pan evaporation at an alternate (I5) and two-day interval (I6) and 80% of cumulative pan evaporation at alternate days with surface drip (I7). Our results showed that potato transpiration was higher in N1 and N2 compared to N3, while soil evaporation was higher in N3 over N1 and N2. Irrigation regimes I5 and I6 had lower transpiration than I1, I2, I3 and I7, while I7 had more soil evaporation than I1, I2 and I3. Leaf area index (LAI), dry matter accumulation (DMA), root mass density (RMD) and tuber yield in N1 and N2 were at par but significantly higher than N3. The LAI and DMA were statistically at par in I1, I2 and I3 but significantly higher than recommended irrigation (I7). Tuber yield was statistically at par in I1, I2, I3 and I7 but I3 and I7 saved 20% irrigation water compared to I1 and I2. On the other hand, real water productivity (WPET) under N1 and N2 were comparable in I3 and I4 but significantly higher than recommended practice (I7) as pooled evapotranspiration (ET) and soil evaporation (E) in I7 were 19.5 and 20.6 mm higher, respectively, than in I3. Among interactive treatment combinations, N1I1, N1I2, N1I3, N1I7, N2I1, N2I2 and N2I3 recorded the highest tuber yields without any significant differences among them. Treatment N2I3 saved 20% nitrogen and irrigation water compared to all other combinations. Water productivity in N1 and N2 was comparable in I3 and I4 but significantly higher than recommended practice (I7).


  • Effect of Tillage for Rice Residue Management on Physical Properties of Soil

    by Malkit Singh, K.B Singh

    The present study was conducted in wheat to study effect of four tillage practices viz mold board plowing to a depth of 25 cm followed by rotavator (PT25 + R), mold board plowing to a depth of 14 cm followed by rotavator (PT14 + R), zero tillage with happy seeder (ZT) and conventional practices of 2 discing + 2 cultivator followed by planking (CT) along with irrigation scheduling on soil physical properties for two consecutive years (2016–17 and 2017–18). Soil bulk density, mean weight diameter, water stable aggregates and organic carbon were significantly higher in ZT by 5.74%, 75.24%, 77.11% and 10.5% respectively compared to PT25 + R. Soil moisture retention was also significantly higher in ZT than all other tillage practices at 0.1 to 15 bar matic potential in 0–7.5, 7.5–15, 15–22.5 and 22.5–30 cm soil depths. Final infiltration rate was significantly higher in PT25 + R, PT14 + R and CT than ZT by 79%, 36% and 15% respectively. Cumulative infiltration was also significantly higher in PT25 + R, PT14 + R and CT than ZT by 71.7%, 33.0% and 15.6% respectively. Saturated hydraulic conductivity was significantly higher in PT25 + R than ZT by 72.5% and 81.7% in 0–7.5 and 7.5–15 cm layer respectively. Similarly unsaturated hydraulic conductivity was significantly higher in PT25 + R than ZT in both soil depths.


  • Effect of Variability in Climate and Irrigation Regimes on Evapo-transpiration and Water Use in Spring Maize

    by K B Singh

    A simple soil water balance approach was used to estimate actual evapotranspiration of spring maize under variable irrigation regimes for two years on loamy sand soil in a semi arid, subtropical region of north India. Moisture stress to crop was created through three irrigation regimes (irrigation water/open pan evaporation ratio of 1.2 (I1.2), 0.9 (I0.9) I0.9 and 0.6 (I0.6)). Depending upon the changes in climate, year 2007 was hot and dry (9.5 cm less rainfall) compared to 2008. During dry season cumulative actual evapotranspiration was greater than the potential evapotranspiration by 14.4 and 6.6 per cent under I1.2 and I0.9 irrigation regimes, respectively. However under I0.6 cumulative actual evapotranspiration was lower than potential evapotranspiration by 3.6 per cent. In wet season cumulative actual evapotranspiration was increased by 14.9, 10.8 and 4.7 per cent under I1.2, I0.9 and I0.6 irrigation regimes, respectively over potential evapotranspiration. During wet season irrigation regime I0.9 was at par with I1.2 in water use efficiency (WUE) thus, more helpful in saving irrigation water. However during dry season irrigation regime I1.2 was beneficial for increasing WUE through increased grain yield. Rainfall favoured the crop growth and grain yield through lowering air temperature and reducing evaporation and recharging soil water storage. Crop coefficients were increased exponentially with leaf area index (LAI) in all treatments and the variability in crop coefficient was more during dry season compared to wet season.

  • Open Access

    Soil water balance and response of spring maize (Zea mays) to mulching and differential irrigation in Punjab

    by K.B. Singh, S.K Jalota, R.K. Gupta

    A field experiment was conducted during 2007 and 2008 at Ludhiana, to study the effect of paddy straw mulch- ing (0 and 6 t/ha) and irrigation regimes (irrigation water/open pan evaporation ratio 1.2 (I ), 0.9 (I ) and 0.6 (I )) 1.2 0.9 0.6 on performance of spring maize (Zea mays L.) Mulching significantly increased mean seasonal soil-moisture stor- age and transpiration during both years with overall pooled values of 122.2 and 38.7 mm for soil-moisture storage and 566.5 and 549.2 mm for seasonal transpiration under mulching and no mulching treatments respectively. Mean seasonal soil-moisture storage and transpiration were significantly more under I and I treatments than 1.2 0.9 I during both years. However, during both years mulching significantly reduced mean seasonal soil evaporation 0.6 compared with no-mulching. Mulching and irrigation significantly increased leaf-area index (LAI) of spring maize. During both seasons, mulching significantly increased grain yield, yield attributes and water-use efficiency (WUE) of spring maize over no-mulching with overall mean grain yield values of 4.96 and 4.22 t/ha and WUE values of 8.76 and 7.64 kg/ha/mm under mulching and no-mulching treatments respectively. Significantly higher grain yield and WUE were also observed under I over I irrigation treatment. 1.2 0.6