Serena Barone
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Serena Barone has a total of 58 co-authors. Here are the top co-authors by number of shared publications:
- Mariaelena Fedi
INFN Sezione di Firenze, Sesto Fiorentino (Fi), Italy
3 shared publications - Alessandro Bombini
Istituto Nazionale di Fisica Nucleare, Sezione di Firenze
2 shared publications Emma Cantisani
Institute of Heritage Science, National Research Council of Italy
2 shared publicationsLucia Liccioli
National Institute of Nuclear Physics, Unit of Florence
2 shared publications- Lucia Liccioli
National Institute of Nuclear Physics, Via Bruno Rossi 1, Sesto Fiorentino, 50019 Firenze, Italy
2 shared publications - Marta Magalini
Istituto Nazionale di Fisica Nucleare, Sezione di Torino
2 shared publications
Latest Publications
- Open Access
- 24 September 2026
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 68 (5) , 1085-1100
Multi-analytical procedure for radiocarbon dating of Pozzolana mortars from public buildings in Pompeii
Roman mortars were typically composed of an air-hardening lime mixed with materials exhibiting pozzolanic behaviour (e.g., pozzolana or cocciopesto), which conferred hydraulic properties to the material. So far, many characterizations of pozzolanic mortars have been carried out, revealing their complexity. The feasibility of radiocarbon dating for such mortars remains debated, with published data even suggesting that it may not be a viable method. There is currently no comprehensive study establishing a correlation between analytical characterization results and the causes of unreliable radiocarbon dating. We have recently proposed a characterization procedure which is directly applied to the sample to be dated to allow identifying the origin of calcite. In this study, the same procedure is applied to pozzolana mortars. Samples were selected from public monuments in the Forum of Pompeii, including the Eumachia Building, the Temple of Genius Augusti, the Tabularium and the Temple of Apollo. Following the procedure, powders from binders or lumps were analyzed using XRPD, OM-CL, ATR-FTIR, micro-Raman, SEM-EDS techniques to identify the origin of calcite. The CO 2 from selected inorganic fractions of the mortar samples was extracted by dissolution with H 3 PO 4 and then converted into graphite for subsequent measurements by accelerator mass spectrometry (AMS) using the so-called Lilliput graphitization line at INFN-LABEC in Florence. For five out of characterized fifty-three samples, the mortar shows mineralogical, petrographic, and geochemical characteristics which are suitable for dating. Two samples indeed yield ages consistent with the archaeological phases. The remaining samples appeared older than expected, highlighting the critical role of the nature of the material and its influence on dating results.
- 24 September 2026
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 68 (5) , 1085-1100
Open AccessMulti-analytical procedure for radiocarbon dating of Pozzolana mortars from public buildings in Pompeii
Roman mortars were typically composed of an air-hardening lime mixed with materials exhibiting pozzolanic behaviour (e.g., pozzolana or cocciopesto), which conferred hydraulic properties to the material. So far, many characterizations of pozzolanic mortars have been carried out, revealing their complexity. The feasibility of radiocarbon dating for such mortars remains debated, with published data even suggesting that it may not be a viable method. There is currently no comprehensive study establishing a correlation between analytical characterization results and the causes of unreliable radiocarbon dating. We have recently proposed a characterization procedure which is directly applied to the sample to be dated to allow identifying the origin of calcite. In this study, the same procedure is applied to pozzolana mortars. Samples were selected from public monuments in the Forum of Pompeii, including the Eumachia Building, the Temple of Genius Augusti, the Tabularium and the Temple of Apollo. Following the procedure, powders from binders or lumps were analyzed using XRPD, OM-CL, ATR-FTIR, micro-Raman, SEM-EDS techniques to identify the origin of calcite. The CO 2 from selected inorganic fractions of the mortar samples was extracted by dissolution with H 3 PO 4 and then converted into graphite for subsequent measurements by accelerator mass spectrometry (AMS) using the so-called Lilliput graphitization line at INFN-LABEC in Florence. For five out of characterized fifty-three samples, the mortar shows mineralogical, petrographic, and geochemical characteristics which are suitable for dating. Two samples indeed yield ages consistent with the archaeological phases. The remaining samples appeared older than expected, highlighting the critical role of the nature of the material and its influence on dating results.
- 4 July 2026
- Published by Springer Nature
- p. 70-83
dGanX: a Python Library to Generate MA-XRF Raw Data Out of RGB Images via a Distributed Computing Approach
- 4 July 2026
- Published by Springer Nature
- p. 70-83
dGanX: a Python Library to Generate MA-XRF Raw Data Out of RGB Images via a Distributed Computing Approach
- 4 July 2026
- Published by Springer Nature
- p. 3-15
A Pipeline to Generate Synthetic Dataset for Ceramic Fragments Recognition and Pairing
- 4 July 2026
- Published by Springer Nature
- p. 3-15
A Pipeline to Generate Synthetic Dataset for Ceramic Fragments Recognition and Pairing
- 11 June 2025
- Published by Springer Nature in Archaeological and Anthropological Sciences
- Vol. 17 (7) , 1-23
An integrated archaeological and anthropological approach to investigating human sacrifice among Etruscans
- 11 June 2025
- Published by Springer Nature in Archaeological and Anthropological Sciences
- Vol. 17 (7) , 1-23
An integrated archaeological and anthropological approach to investigating human sacrifice among Etruscans
- Open Access
- 13 February 2024
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 66 (6) , 1493-1506
CHARACTERIZATION AND SELECTION OF MORTAR SAMPLES FOR RADIOCARBON DATING IN THE FRAMEWORK OF THE MODIS2 INTERCOMPARISON: TWO COMPARED PROCEDURES
For several decades, many efforts have been dedicated to enhancing the accuracy of mortar radiocarbon dating and evaluating the reliability of the results concerning the typology of the examined specimens. Several assumptions that are fundamental for the application of the method may be in many cases not fulfilled, such as (a) complete primary limestone dissociation during calcination, (b) efficient separation of geogenic carbon contained in calcareous aggregates, (c) short carbonation time, and (d) absence of secondary calcite. Many laboratories all over the world have proposed different methods to select suitable fractions of mortar.The first intercomparison attempt, involving eight international laboratories, was organized in 2016 aiming at comparing and statistically treating the results obtained on the same materials by different laboratories with their own characterization and pre-treatment methods (Hajdas et al. 2017; Hayen et al. 2017). Following this first step, a new intercomparison experiment was proposed and set up in 2018 during the Mortar Dating International Meeting (Bordeaux, FR). A new set of three mortar samples was chosen, taking care of the selection of standardized materials (homogeneity, known mineralogical composition, absence of exogenous inclusions, known expected age).This work describes the results of two research teams involved in the intercomparison. The samples were characterized, selected, and dated depending on each laboratory strategy. The results stress the importance of the characterization of the raw material is to better understand the mineralogical and petrographical composition of the samples. Such information can support the choice of the most appropriate strategy for the extraction of CO2 and then for data interpretation.
- 13 February 2024
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 66 (6) , 1493-1506
Open AccessCHARACTERIZATION AND SELECTION OF MORTAR SAMPLES FOR RADIOCARBON DATING IN THE FRAMEWORK OF THE MODIS2 INTERCOMPARISON: TWO COMPARED PROCEDURES
For several decades, many efforts have been dedicated to enhancing the accuracy of mortar radiocarbon dating and evaluating the reliability of the results concerning the typology of the examined specimens. Several assumptions that are fundamental for the application of the method may be in many cases not fulfilled, such as (a) complete primary limestone dissociation during calcination, (b) efficient separation of geogenic carbon contained in calcareous aggregates, (c) short carbonation time, and (d) absence of secondary calcite. Many laboratories all over the world have proposed different methods to select suitable fractions of mortar.The first intercomparison attempt, involving eight international laboratories, was organized in 2016 aiming at comparing and statistically treating the results obtained on the same materials by different laboratories with their own characterization and pre-treatment methods (Hajdas et al. 2017; Hayen et al. 2017). Following this first step, a new intercomparison experiment was proposed and set up in 2018 during the Mortar Dating International Meeting (Bordeaux, FR). A new set of three mortar samples was chosen, taking care of the selection of standardized materials (homogeneity, known mineralogical composition, absence of exogenous inclusions, known expected age).This work describes the results of two research teams involved in the intercomparison. The samples were characterized, selected, and dated depending on each laboratory strategy. The results stress the importance of the characterization of the raw material is to better understand the mineralogical and petrographical composition of the samples. Such information can support the choice of the most appropriate strategy for the extraction of CO2 and then for data interpretation.
- Open Access
- 24 March 2023
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 65 (2) , 323-334
RADIOCARBON DATING OF STRAW FRAGMENTS IN THE PLASTERS OF ST. PHILIP CHURCH IN ARCHAEOLOGICAL SITE HIERAPOLIS OF PHRYGIA (DENIZLI, TURKEY)
Absolute dating of plasters and mortars clearly represents a key information to study important structures and buildings that may have undergone a difficult story starting from their construction. This is for instance the case of the architectures in the archaeological site of Hierapolis (Denizli, Turkey). However, when discussing about the possibility to apply radiocarbon (14C) dating, in this site the presence of different sources of contaminants, due to the geological and geochemical conditions and to the used raw materials, prevents the binder dating. As an alternative, we thus decided to focus on the small fragments of straw that had been used as additives in the mortar/plaster matrices. The fragments were identified, selected and dated using a 14C experimental set-up specifically optimized for microgram-sized samples. The obtained results were satisfying, even though the measured 14C ages also pointed out some possible criticalities in dating such small samples collected from a carbonaceous matrix.
- 24 March 2023
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 65 (2) , 323-334
Open AccessRADIOCARBON DATING OF STRAW FRAGMENTS IN THE PLASTERS OF ST. PHILIP CHURCH IN ARCHAEOLOGICAL SITE HIERAPOLIS OF PHRYGIA (DENIZLI, TURKEY)
Absolute dating of plasters and mortars clearly represents a key information to study important structures and buildings that may have undergone a difficult story starting from their construction. This is for instance the case of the architectures in the archaeological site of Hierapolis (Denizli, Turkey). However, when discussing about the possibility to apply radiocarbon (14C) dating, in this site the presence of different sources of contaminants, due to the geological and geochemical conditions and to the used raw materials, prevents the binder dating. As an alternative, we thus decided to focus on the small fragments of straw that had been used as additives in the mortar/plaster matrices. The fragments were identified, selected and dated using a 14C experimental set-up specifically optimized for microgram-sized samples. The obtained results were satisfying, even though the measured 14C ages also pointed out some possible criticalities in dating such small samples collected from a carbonaceous matrix.
- 1 February 2020
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
- Vol. 465, 19-23
Towards micro-samples radiocarbon dating at INFN-LABEC, Florence
- 1 February 2020
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
- Vol. 465, 19-23
Towards micro-samples radiocarbon dating at INFN-LABEC, Florence