Andreas Billiani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Andreas Billiani has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Boštjan Genorio
Faculty of Chemistry and Chemical Technology, University of Ljubljana, Ljubljana, Slovenia
2 shared publications - Michaela Roschger
Institute of Chemical Engineering and Environmental Technology, TU Graz, 8010, Austria
2 shared publications - Selestina Gorgieva
Faculty of Mechanical Engineering, University of Maribor, Smetanova ulica 17, 2000 Maribor, Slovenia
2 shared publications - Sigrid Wolf
Institute of Chemical Engineering and Environmental Technology, Graz University of Technology, Inffeldgasse 25/C, 8010 Graz, Austria
2 shared publications - Viktor Hacker
Institute of Chemical Engineering and Environmental Technology, TU Graz, 8010, Austria
2 shared publications - Kurt Mayer
Institute of Chemical Engineering and Environmental Technology, Graz University of Technology, Inffeldgasse 25/C, 8010 Graz, Austria
1 shared publication
Latest Publications
- Open Access
- 2 June 2023
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 8 (23) , 20845-20857
Study on Commercially Available Membranes for Alkaline Direct Ethanol Fuel Cells
This study provides a comparison of different commercially available low-cost anion exchange membranes (AEMs), a microporous separator, a cation exchange membrane (CEM), and an anionic-treated CEM for their application in the liquid-feed alkaline direct ethanol fuel cell (ADEFC). Moreover, the effect on performance was evaluated taking two different modes of operation for the ADEFC, with AEM or CEM, into consideration. The membranes were compared with respect to their physical and chemical properties, such as thermal and chemical stability, ion-exchange capacity, ionic conductivity, and ethanol permeability. The influence of these factors on performance and resistance was determined by means of polarization curve and electrochemical impedance spectra (EIS) measurements in the ADEFC. In addition, the influence of two different commercial ionomers on the structure and transport properties of the catalyst layer and on the performance were analyzed with scanning electron microscopy, single cell tests, and EIS. The applicability barriers of the membranes were pointed out, and the ideal combinations of membrane and ionomer for the liquid-feed ADEFC achieved power densities of approximately 80 mW cm-2 at 80 °C.
- 2 June 2023
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 8 (23) , 20845-20857
Open AccessStudy on Commercially Available Membranes for Alkaline Direct Ethanol Fuel Cells
This study provides a comparison of different commercially available low-cost anion exchange membranes (AEMs), a microporous separator, a cation exchange membrane (CEM), and an anionic-treated CEM for their application in the liquid-feed alkaline direct ethanol fuel cell (ADEFC). Moreover, the effect on performance was evaluated taking two different modes of operation for the ADEFC, with AEM or CEM, into consideration. The membranes were compared with respect to their physical and chemical properties, such as thermal and chemical stability, ion-exchange capacity, ionic conductivity, and ethanol permeability. The influence of these factors on performance and resistance was determined by means of polarization curve and electrochemical impedance spectra (EIS) measurements in the ADEFC. In addition, the influence of two different commercial ionomers on the structure and transport properties of the catalyst layer and on the performance were analyzed with scanning electron microscopy, single cell tests, and EIS. The applicability barriers of the membranes were pointed out, and the ideal combinations of membrane and ionomer for the liquid-feed ADEFC achieved power densities of approximately 80 mW cm-2 at 80 °C.
- Open Access
- 28 March 2023
- Published by International Association of Physical Chemists (IAPC) in Journal of Electrochemical Science and Engineering
- Vol. 13 (5) , 783-793
Electrode configurations study for alkaline direct ethanol fuel cells
The direct electrochemical conversion of ethanol, a sustainable fuel, is an alternative sustainable technology of the future. In this study, membrane electrode assemblies with different electrode configurations for an alkaline direct ethanol fuel cell were fabricated and tested in a fuel cell device. The configurations include a catalyst-coated substrate (CCS), a catalyst-coated membrane (CCM), and a mixture of these two fabrication options. Two different anion exchange membranes were used to perform a comprehensive analysis. The fabricated CCSs and CCMs were characterized with single cell measurements, electrochemical impedance spectroscopy and scanning electron microscopy. In addition, the swelling behavior of the membranes in alkaline solution was investigated in order to obtain information for CCM production. The results of the experimental electrochemical tests show that the CCS approach provides higher power densities (42.4 mW cm-2) than the others, regardless of the membrane type.
- 28 March 2023
- Published by International Association of Physical Chemists (IAPC) in Journal of Electrochemical Science and Engineering
- Vol. 13 (5) , 783-793
Open AccessElectrode configurations study for alkaline direct ethanol fuel cells
The direct electrochemical conversion of ethanol, a sustainable fuel, is an alternative sustainable technology of the future. In this study, membrane electrode assemblies with different electrode configurations for an alkaline direct ethanol fuel cell were fabricated and tested in a fuel cell device. The configurations include a catalyst-coated substrate (CCS), a catalyst-coated membrane (CCM), and a mixture of these two fabrication options. Two different anion exchange membranes were used to perform a comprehensive analysis. The fabricated CCSs and CCMs were characterized with single cell measurements, electrochemical impedance spectroscopy and scanning electron microscopy. In addition, the swelling behavior of the membranes in alkaline solution was investigated in order to obtain information for CCM production. The results of the experimental electrochemical tests show that the CCS approach provides higher power densities (42.4 mW cm-2) than the others, regardless of the membrane type.