Dirk Hufschmidt
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Dirk Hufschmidt has a total of 78 co-authors. Here are the top co-authors by number of shared publications:
- Asuncion Fernandez
Instituto de Ciencia de Materiales de Sevilla (CSIC-Univ. Sevilla), Avda. Américo Vespucio 49, 41092-Sevilla, Spain
6 shared publications - Vanda Godinho
CSIC US, Inst Ciencia Mat Sevilla ICMS, Avda Americo Vespucio 49, E-41092 Seville, Spain
4 shared publications - Francisco Javier Ferrer
Centro Nacional de Aceleradores (CSIC‐US) Avda. Thomas A. Edison 7 41092 Seville Spain
3 shared publications - Maria Carmen Jimenez de Haro
Instituto de Ciencia de Materiales de Sevilla
3 shared publications - Jennifer López-Viejobueno
AEGORA Research Group, Facultad de Ciencias Matemáticas, Universidad Complutense de Madrid , Plaza de Ciencias, 3, 28040, Madrid
2 shared publications - José Avila
Synchrotron SOLEIL, L’Orme des Merisiers
2 shared publications
Latest Publications
- 17 March 2025
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 134 (11) , 112701
First Measurement of a Weak -Process Reaction on a Radioactive NucleusThis Letter reports on the first cross-section measurements for the ^{94}Sr(α,n)^{97}Zr and ^{86}Kr(α,n)^{89}Sr reactions. In particular, our measurement of ^{94}Sr(α,n)^{97}Zr is the first weak r-process reaction cross section obtained using a radioactive ion beam. This experiment was enabled by the use of novel solid helium targets, comprised of silicon thin films with high helium incorporation obtained via a sputtering technique. Yield measurements were performed at center-of-mass energies of 10.4 and 9.0 MeV for the ^{86}Kr(α,n)^{89}Sr reaction, and 9.9 MeV for ^{94}Sr(α,n)^{97}Zr, extending into the respective Gamow energy windows for a temperature of 5 GK. Reactions were uniquely identified by prompt γ rays detected in coincidence with heavy ions selected by a recoil mass spectrometer. The obtained cross sections are smaller than predicted for both reactions. In the case of ^{94}Sr(α,n)^{97}Zr, the reaction rate found here is lowered by an order of magnitude at temperatures below 5 GK, which is expected to impact the predicted abundance of ruthenium, a signature weak r-process element.
- 17 March 2025
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 134 (11) , 112701
First Measurement of a Weak -Process Reaction on a Radioactive NucleusThis Letter reports on the first cross-section measurements for the ^{94}Sr(α,n)^{97}Zr and ^{86}Kr(α,n)^{89}Sr reactions. In particular, our measurement of ^{94}Sr(α,n)^{97}Zr is the first weak r-process reaction cross section obtained using a radioactive ion beam. This experiment was enabled by the use of novel solid helium targets, comprised of silicon thin films with high helium incorporation obtained via a sputtering technique. Yield measurements were performed at center-of-mass energies of 10.4 and 9.0 MeV for the ^{86}Kr(α,n)^{89}Sr reaction, and 9.9 MeV for ^{94}Sr(α,n)^{97}Zr, extending into the respective Gamow energy windows for a temperature of 5 GK. Reactions were uniquely identified by prompt γ rays detected in coincidence with heavy ions selected by a recoil mass spectrometer. The obtained cross sections are smaller than predicted for both reactions. In the case of ^{94}Sr(α,n)^{97}Zr, the reaction rate found here is lowered by an order of magnitude at temperatures below 5 GK, which is expected to impact the predicted abundance of ruthenium, a signature weak r-process element.
- Open Access
- 21 April 2024
- Published by MDPI AG in Nanomaterials
- Vol. 14 (8) , 727
Synergistic Effect of He for the Fabrication of Ne and Ar Gas-Charged Silicon Thin Films as Solid Targets for Spectroscopic Studies
Sputtering of silicon in a He magnetron discharge (MS) has been reported as a bottom-up procedure to obtain He-charged silicon films (i.e., He nanobubbles encapsulated in a silicon matrix). The incorporation of heavier noble gases is demonstrated in this work with a synergistic effect, producing increased Ne and Ar incorporations when using He–Ne and He–Ar gas mixtures in the MS process. Microstructural and chemical characterizations are reported using ion beam analysis (IBA) and scanning and transmission electron microscopies (SEM and TEM). In addition to gas incorporation, He promotes the formation of larger nanobubbles. In the case of Ne, high-resolution X-ray photoelectron and absorption spectroscopies (XPS and XAS) are reported, with remarkable dependence of the Ne 1s photoemission and the Ne K-edge absorption on the nanobubble’s size and composition. The gas (He, Ne and Ar)-charged thin films are proposed as “solid” targets for the characterization of spectroscopic properties of noble gases in a confined state without the need for cryogenics or high-pressure anvils devices. Also, their use as targets for nuclear reaction studies is foreseen.
- 21 April 2024
- Published by MDPI AG in Nanomaterials
- Vol. 14 (8) , 727
Open AccessSynergistic Effect of He for the Fabrication of Ne and Ar Gas-Charged Silicon Thin Films as Solid Targets for Spectroscopic Studies
Sputtering of silicon in a He magnetron discharge (MS) has been reported as a bottom-up procedure to obtain He-charged silicon films (i.e., He nanobubbles encapsulated in a silicon matrix). The incorporation of heavier noble gases is demonstrated in this work with a synergistic effect, producing increased Ne and Ar incorporations when using He–Ne and He–Ar gas mixtures in the MS process. Microstructural and chemical characterizations are reported using ion beam analysis (IBA) and scanning and transmission electron microscopies (SEM and TEM). In addition to gas incorporation, He promotes the formation of larger nanobubbles. In the case of Ne, high-resolution X-ray photoelectron and absorption spectroscopies (XPS and XAS) are reported, with remarkable dependence of the Ne 1s photoemission and the Ne K-edge absorption on the nanobubble’s size and composition. The gas (He, Ne and Ar)-charged thin films are proposed as “solid” targets for the characterization of spectroscopic properties of noble gases in a confined state without the need for cryogenics or high-pressure anvils devices. Also, their use as targets for nuclear reaction studies is foreseen.
- Open Access
- 19 March 2024
- Published by MDPI AG in Preprints.org
Synergistic Effect of He for the Fabrication of Ne and Ar Gas-Charged Silicon Thin Films as Solid Targets for Spectroscopic Studies
: Sputtering of silicon in a Helium magnetron discharge (MS) has been reported as a bottom-up procedure to obtain He-charged silicon films (i.e. He nanobubbles encapsulated in a silicon matrix). The incorporation of heavier noble gases is demonstrated in this work with a synergistic effect producing increased Ne and Ar incorporations when using He-Ne and He-Ar gas mixtures in the MS process. Microstructural and chemical characterizations are reported by ion beam analysis (IBA) and scanning and transmission electron microscopies (SEM and TEM). In addition to gas incorporation, helium promotes the formation of larger nanobubbles. For the case of Ne high resolution X-ray photoelectron and absorption spectroscopies (XPS and XAS) are reported with remarkable dependence of the Ne 1s photoemission and the Ne K-edge absorption on the nanobubbles size and composition. The gas (He, Ne, Ar) charged thin films are proposed as “solid” targets for the characterization of spectroscopic properties of noble gases in a confined state without the need for cryogenics or high-pressure anvils devices. Also their use as targets for nuclear reaction studies is foreseen.
- 19 March 2024
- Published by MDPI AG in Preprints.org
Open AccessSynergistic Effect of He for the Fabrication of Ne and Ar Gas-Charged Silicon Thin Films as Solid Targets for Spectroscopic Studies
: Sputtering of silicon in a Helium magnetron discharge (MS) has been reported as a bottom-up procedure to obtain He-charged silicon films (i.e. He nanobubbles encapsulated in a silicon matrix). The incorporation of heavier noble gases is demonstrated in this work with a synergistic effect producing increased Ne and Ar incorporations when using He-Ne and He-Ar gas mixtures in the MS process. Microstructural and chemical characterizations are reported by ion beam analysis (IBA) and scanning and transmission electron microscopies (SEM and TEM). In addition to gas incorporation, helium promotes the formation of larger nanobubbles. For the case of Ne high resolution X-ray photoelectron and absorption spectroscopies (XPS and XAS) are reported with remarkable dependence of the Ne 1s photoemission and the Ne K-edge absorption on the nanobubbles size and composition. The gas (He, Ne, Ar) charged thin films are proposed as “solid” targets for the characterization of spectroscopic properties of noble gases in a confined state without the need for cryogenics or high-pressure anvils devices. Also their use as targets for nuclear reaction studies is foreseen.
- Open Access
- 28 March 2023
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 301
Microstructural characterization and thermal stability of He charged amorphous silicon films prepared by magnetron sputtering in helium
- 28 March 2023
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 301
Open AccessMicrostructural characterization and thermal stability of He charged amorphous silicon films prepared by magnetron sputtering in helium
- Open Access
- 7 September 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (9) , 2326
Pd-C Catalytic Thin Films Prepared by Magnetron Sputtering for the Decomposition of Formic Acid
Formic acid is an advantageous liquid organic hydrogen carrier. It is relatively nontoxic and can be synthesized by the reaction of CO2 with sustainable hydrogen or by biomass decomposition. As an alternative to more widely studied powdery catalysts, supported Pd-C catalytic thin films with controlled nanostructure and compositions were newly prepared in this work by magnetron sputtering on structured supports and tested for the formic acid decomposition reaction. A two-magnetron configuration (carbon and tailored Pd-C targets) was used to achieve a reduction in Pd consumption and high catalyst surface roughness and dispersion by increasing the carbon content. Activity and durability tests were carried out for the gas phase formic acid decomposition reaction on SiC foam monoliths coated with the Pd-C films and the effects of column width, surface roughness and thermal pre-reduction time were investigated. Activity of 5.04 molH2·gPd−1·h−1 and 92% selectivity to the dehydrogenation reaction were achieved at 300 °C for the catalyst with a lower column width and higher carbon content and surface roughness. It was also found that deactivation occurs when Pd is sintered due to the elimination of carbon and/or the segregation and agglomeration of Pd upon cycling. Magnetron sputtering deposition appears as a promising and scalable route for the one-step preparation of Pd-C catalytic films by overcoming the different deposition characteristics of Pd and C with an appropriate experimental design.
- 7 September 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (9) , 2326
Open AccessPd-C Catalytic Thin Films Prepared by Magnetron Sputtering for the Decomposition of Formic Acid
Formic acid is an advantageous liquid organic hydrogen carrier. It is relatively nontoxic and can be synthesized by the reaction of CO2 with sustainable hydrogen or by biomass decomposition. As an alternative to more widely studied powdery catalysts, supported Pd-C catalytic thin films with controlled nanostructure and compositions were newly prepared in this work by magnetron sputtering on structured supports and tested for the formic acid decomposition reaction. A two-magnetron configuration (carbon and tailored Pd-C targets) was used to achieve a reduction in Pd consumption and high catalyst surface roughness and dispersion by increasing the carbon content. Activity and durability tests were carried out for the gas phase formic acid decomposition reaction on SiC foam monoliths coated with the Pd-C films and the effects of column width, surface roughness and thermal pre-reduction time were investigated. Activity of 5.04 molH2·gPd−1·h−1 and 92% selectivity to the dehydrogenation reaction were achieved at 300 °C for the catalyst with a lower column width and higher carbon content and surface roughness. It was also found that deactivation occurs when Pd is sintered due to the elimination of carbon and/or the segregation and agglomeration of Pd upon cycling. Magnetron sputtering deposition appears as a promising and scalable route for the one-step preparation of Pd-C catalytic films by overcoming the different deposition characteristics of Pd and C with an appropriate experimental design.