Clara Lavita Angelina
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Clara Lavita Angelina has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Hsuan-Ting Chang
National Yunlin University of Science and Technology
2 shared publications - Tsung-Chun Lee
Taipei Medical University Shuang Ho Hospital
2 shared publications Aan Febriansyah
Department of Electronic Engineering, Politeknik Manufaktur Negeri Bangka Belitung
1 shared publication- Ali Rospawan
Department of Electrical Engineering, National Chung Hsing University, Taichung, Taiwan
1 shared publication - Cendra Devayana Putra
Information Systems Study Program, Universitas Negeri Surabaya - Indonesia, Indonesia
1 shared publication Dedy Ramdhani Harahap
Department of Mechanical Design Engineering, Politeknik Manufaktur Negeri Bangka Belitung
1 shared publication
Latest Publications
- Open Access
- 31 July 2026
- Published by National Research and Innovation Agency in Journal of Mechatronics, Electrical Power, and Vehicular Technology
- Vol. 17 (1) , 194-205
Adaptive PID control using TSK elliptic fuzzy and static feedforward for observable disturbance rejection in industrial heating ovens
This paper presents an advanced control strategy aimed at accelerating the temperature recovery time in industrial heating ovens, particularly in response to observable disturbances such as periodic door openings. The proposed method combines a Takagi-Sugeno-Kang (TSK) elliptic fuzzy-based adaptive proportional-integral-derivative (PID) control with a static feedforward (FF) control strategy. The TSK elliptic fuzzy system models the input-output dynamics and adaptively adjusts the PID gains, allowing the controller to respond effectively to varying system conditions. The static feedforward control is designed to specifically counteract the measurable disturbances to shorten recovery time and improve stability. The strategy is validated through both simulation and experiment on a low-cost STM32 microcontroller. Compared with a conventional PID controller, it reduced the RMSE by 32.27 % and the ISE by 54.13 %, together with a recovery time shortened by approximately 72 s, reflecting the faster disturbance recovery achieved by the static feedforward action. Experimental results confirmed these findings, with a higher feedforward gain further reducing the temperature drop and accelerating recovery. The proposed technique offers a reliable and practical solution for practitioners in managing similar disturbance patterns in industrial settings.
- 31 July 2026
- Published by National Research and Innovation Agency in Journal of Mechatronics, Electrical Power, and Vehicular Technology
- Vol. 17 (1) , 194-205
Open AccessAdaptive PID control using TSK elliptic fuzzy and static feedforward for observable disturbance rejection in industrial heating ovens
This paper presents an advanced control strategy aimed at accelerating the temperature recovery time in industrial heating ovens, particularly in response to observable disturbances such as periodic door openings. The proposed method combines a Takagi-Sugeno-Kang (TSK) elliptic fuzzy-based adaptive proportional-integral-derivative (PID) control with a static feedforward (FF) control strategy. The TSK elliptic fuzzy system models the input-output dynamics and adaptively adjusts the PID gains, allowing the controller to respond effectively to varying system conditions. The static feedforward control is designed to specifically counteract the measurable disturbances to shorten recovery time and improve stability. The strategy is validated through both simulation and experiment on a low-cost STM32 microcontroller. Compared with a conventional PID controller, it reduced the RMSE by 32.27 % and the ISE by 54.13 %, together with a recovery time shortened by approximately 72 s, reflecting the faster disturbance recovery achieved by the static feedforward action. Experimental results confirmed these findings, with a higher feedforward gain further reducing the temperature drop and accelerating recovery. The proposed technique offers a reliable and practical solution for practitioners in managing similar disturbance patterns in industrial settings.
- Open Access
- 11 June 2024
- Published by Universitas Airlangga in Darmabakti Cendekia: Journal of Community Service and Engagements
- Vol. 6 (1)
INCREASING SCHOLARSHIP OPPORTUNITIES IN TAIWAN: TIPS AND TRICKS
Background: COVID-19 has significantly impacted education, resulting in low acceptance rates at universities in Taiwan and Indonesia. These low acceptance rates contribute to a shortage of human resources, which could have far-reaching consequences for the economy, education, health, and political stability. Nations with limited human capital may become dependent on foreign labor to meet their workforce needs, leading to local unemployment and heightened competition between local and foreign workers. Therefore, investing heavily in education and training is crucial. Objective: To address this issue, community services have been conducted in Indonesia to provide students with information on scholarships and technical strategies. Method: The community services were organized in several steps, including preparation, planning, implementation, and evaluation. Results: The effectiveness of the event was assessed through pre-test and post-test questionnaires. Conclusion: Through a series of scholarship webinars, it was observed that knowledge and awareness about scholarships increased, providing students with greater opportunities for securing scholarships.
- 11 June 2024
- Published by Universitas Airlangga in Darmabakti Cendekia: Journal of Community Service and Engagements
- Vol. 6 (1)
Open AccessINCREASING SCHOLARSHIP OPPORTUNITIES IN TAIWAN: TIPS AND TRICKS
Background: COVID-19 has significantly impacted education, resulting in low acceptance rates at universities in Taiwan and Indonesia. These low acceptance rates contribute to a shortage of human resources, which could have far-reaching consequences for the economy, education, health, and political stability. Nations with limited human capital may become dependent on foreign labor to meet their workforce needs, leading to local unemployment and heightened competition between local and foreign workers. Therefore, investing heavily in education and training is crucial. Objective: To address this issue, community services have been conducted in Indonesia to provide students with information on scholarships and technical strategies. Method: The community services were organized in several steps, including preparation, planning, implementation, and evaluation. Results: The effectiveness of the event was assessed through pre-test and post-test questionnaires. Conclusion: Through a series of scholarship webinars, it was observed that knowledge and awareness about scholarships increased, providing students with greater opportunities for securing scholarships.
- Open Access
- 29 March 2023
- Published by MDPI AG in Diagnostics
- Vol. 13 (7) , 1289
Deep-Learning-Enabled Computer-Aided Diagnosis in the Classification of Pancreatic Cystic Lesions on Confocal Laser Endomicroscopy
Accurate classification of pancreatic cystic lesions (PCLs) is important to facilitate proper treatment and to improve patient outcomes. We utilized the convolutional neural network (CNN) of VGG19 to develop a computer-aided diagnosis (CAD) system in the classification of subtypes of PCLs in endoscopic ultrasound-guided needle-based confocal laser endomicroscopy (nCLE). From a retrospectively collected 22,424 nCLE video frames (50 videos) as the training/validation set and 11,047 nCLE video frames (18 videos) as the test set, we developed and compared the diagnostic performance of three CNNs with distinct methods of designating the region of interest. The diagnostic accuracy for subtypes of PCLs by CNNs with manual, maximal rectangular, and U-Net algorithm-designated ROIs was 100%, 38.9%, and 66.7% on a per-video basis and 88.99%, 73.94%, and 76.12% on a per-frame basis, respectively. Our per-frame analysis suggested differential levels of diagnostic accuracy among the five subtypes of PCLs, where non-mucinous PCLs (serous cystic neoplasm: 93.11%, cystic neuroendocrine tumor: 84.31%, and pseudocyst: 98%) had higher diagnostic accuracy than mucinous PCLs (intraductal papillary mucinous neoplasm: 84.43% and mucinous cystic neoplasm: 86.1%). Our CNN demonstrated superior specificity compared to the state-of-the-art for the classification of mucinous PCLs (IPMN and MCN), with high specificity (94.3% and 92.8%, respectively) but low sensitivity (46% and 45.2%, respectively). This suggests the complimentary role of CNN-enabled CAD systems, especially for clinically suspected mucinous PCLs.
- 29 March 2023
- Published by MDPI AG in Diagnostics
- Vol. 13 (7) , 1289
Open AccessDeep-Learning-Enabled Computer-Aided Diagnosis in the Classification of Pancreatic Cystic Lesions on Confocal Laser Endomicroscopy
Accurate classification of pancreatic cystic lesions (PCLs) is important to facilitate proper treatment and to improve patient outcomes. We utilized the convolutional neural network (CNN) of VGG19 to develop a computer-aided diagnosis (CAD) system in the classification of subtypes of PCLs in endoscopic ultrasound-guided needle-based confocal laser endomicroscopy (nCLE). From a retrospectively collected 22,424 nCLE video frames (50 videos) as the training/validation set and 11,047 nCLE video frames (18 videos) as the test set, we developed and compared the diagnostic performance of three CNNs with distinct methods of designating the region of interest. The diagnostic accuracy for subtypes of PCLs by CNNs with manual, maximal rectangular, and U-Net algorithm-designated ROIs was 100%, 38.9%, and 66.7% on a per-video basis and 88.99%, 73.94%, and 76.12% on a per-frame basis, respectively. Our per-frame analysis suggested differential levels of diagnostic accuracy among the five subtypes of PCLs, where non-mucinous PCLs (serous cystic neoplasm: 93.11%, cystic neuroendocrine tumor: 84.31%, and pseudocyst: 98%) had higher diagnostic accuracy than mucinous PCLs (intraductal papillary mucinous neoplasm: 84.43% and mucinous cystic neoplasm: 86.1%). Our CNN demonstrated superior specificity compared to the state-of-the-art for the classification of mucinous PCLs (IPMN and MCN), with high specificity (94.3% and 92.8%, respectively) but low sensitivity (46% and 45.2%, respectively). This suggests the complimentary role of CNN-enabled CAD systems, especially for clinically suspected mucinous PCLs.