Rossana Bona
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Rossana Bona has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
A. Poggiu
10 shared publicationsF. Pinna
9 shared publicationsP. Marini
8 shared publicationsM. Tamponi
7 shared publicationsC. Marchioni
Azienda Ospedaliero Universitaria, Sassari, Italy
3 shared publicationsAngela Poggiu
Medical Physics Unit, ASL Sassari, Via Enrico de Nicola, Sassari 07100, Italy
2 shared publications
Latest Publications
- Open Access
- 16 May 2023
- Published by MDPI AG in Tomography
- Vol. 9 (3) , 1019-1028
Coronary Computed Tomography Angiography with Deep Learning Image Reconstruction: A Preliminary Study to Evaluate Radiation Exposure Reduction
Coronary computed tomography angiography (CCTA) is a medical imaging technique that produces detailed images of the coronary arteries. Our work focuses on the optimization of the prospectively ECG-triggered scan technique, which delivers the radiation efficiently only during a fraction of the R–R interval, matching the aim of reducing radiation dose in this increasingly used radiological examination. In this work, we analyzed how the median DLP (Dose-Length Product) values for CCTA of our Center decreased significantly in recent times mainly due to a notable change in the technology used. We passed from a median DLP value of 1158 mGy·cm to 221 mGy·cm for the whole exam and from a value of 1140 mGy·cm to 204 mGy·cm if considering CCTA scanning only. The result was obtained through the association of important factors during the dose imaging optimization: technological improvement, acquisition technique, and image reconstruction algorithm intervention. The combination of these three factors allows us to perform a faster and more accurate prospective CCTA with a lower radiation dose. Our future aim is to tune the image quality through a detectability-based study, combining algorithm strength with automatic dose settings.
- 16 May 2023
- Published by MDPI AG in Tomography
- Vol. 9 (3) , 1019-1028
Open AccessCoronary Computed Tomography Angiography with Deep Learning Image Reconstruction: A Preliminary Study to Evaluate Radiation Exposure Reduction
Coronary computed tomography angiography (CCTA) is a medical imaging technique that produces detailed images of the coronary arteries. Our work focuses on the optimization of the prospectively ECG-triggered scan technique, which delivers the radiation efficiently only during a fraction of the R–R interval, matching the aim of reducing radiation dose in this increasingly used radiological examination. In this work, we analyzed how the median DLP (Dose-Length Product) values for CCTA of our Center decreased significantly in recent times mainly due to a notable change in the technology used. We passed from a median DLP value of 1158 mGy·cm to 221 mGy·cm for the whole exam and from a value of 1140 mGy·cm to 204 mGy·cm if considering CCTA scanning only. The result was obtained through the association of important factors during the dose imaging optimization: technological improvement, acquisition technique, and image reconstruction algorithm intervention. The combination of these three factors allows us to perform a faster and more accurate prospective CCTA with a lower radiation dose. Our future aim is to tune the image quality through a detectability-based study, combining algorithm strength with automatic dose settings.
- 1 December 2018
- Published by Elsevier in Physica Medica
- Vol. 56, 277
360. Paramed MR Open installation: Customized quality assurance protocol and safety issues
- 1 December 2018
- Published by Elsevier in Physica Medica
- Vol. 56, 277
360. Paramed MR Open installation: Customized quality assurance protocol and safety issues
- 1 December 2018
- Published by Elsevier in Physica Medica
- Vol. 56, 252-253
310. A radiomics analysis process using free software platforms: Our experience in Sassari
- 1 December 2018
- Published by Elsevier in Physica Medica
- Vol. 56, 252-253
310. A radiomics analysis process using free software platforms: Our experience in Sassari
- 1 December 2018
- Published by Elsevier in Physica Medica
- Vol. 56, 137-138
120. Electron density calibration curve for Philips Brilliance Big Bore CT for radiotherapy: HU stability and comparison with Varian default curve
- 1 December 2018
- Published by Elsevier in Physica Medica
- Vol. 56, 137-138
120. Electron density calibration curve for Philips Brilliance Big Bore CT for radiotherapy: HU stability and comparison with Varian default curve
- 1 December 2018
- Published by Elsevier in Physica Medica
- Vol. 56, 142-143
127. Voluntary Breath Hold (VBH) technique versus free breath standard technique (FB), in radiotherapy treatment of left side breast cancer. First results in our center
- 1 December 2018
- Published by Elsevier in Physica Medica
- Vol. 56, 142-143
127. Voluntary Breath Hold (VBH) technique versus free breath standard technique (FB), in radiotherapy treatment of left side breast cancer. First results in our center
- 1 December 2018
- Published by Elsevier in Physica Medica
- Vol. 56, 225
266. Multicentric evaluation of AGD (Average Glandular Dose) on 4 mammography units: Need to standardize?
- 1 December 2018
- Published by Elsevier in Physica Medica
- Vol. 56, 225
266. Multicentric evaluation of AGD (Average Glandular Dose) on 4 mammography units: Need to standardize?
- 1 December 2018
- Published by Elsevier in Physica Medica
- Vol. 56, 224-225
265. Optimization of a three-phase computed tomography urography (CTU) protocol with retrospective and prospective study
- 1 December 2018
- Published by Elsevier in Physica Medica
- Vol. 56, 224-225
265. Optimization of a three-phase computed tomography urography (CTU) protocol with retrospective and prospective study
- 24 June 2016
- Published by Wiley in Medical Physics
- Vol. 43 (7) , 4435-4446
A new form of the calibration curve in radiochromic dosimetry. Properties and results
Purpose: This work describes a new form of the calibration curve for radiochromic dosimetry that depends on one fit parameter. Some results are reported to show that the new curve performs as well as those previously used and, more importantly, significantly reduces the dependence on the lot of films, the film orientation on the scanner, and the time after exposure. Methods: The form of the response curve makes use of the net optical densities ratio against the dose and has been studied by means of the Beer–Lambert law and a simple modeling of the film. The new calibration curve has been applied to EBT3 films exposed at 6 and 15 MV energy beams of linear accelerators and read-out in transmission mode by means of a flatbed color scanner. Its performance has been compared to that of two established forms of the calibration curve, which use the optical density and the net optical density against the dose. Four series of measurements with four lots of EBT3 films were used to evaluate the precision, accuracy, and dependence on the time after exposure, orientation on the scanner and lot of films. Results: The new calibration curve is roughly subject to the same dose uncertainty, about 2% (1 standard deviation), and has the same accuracy, about 1.5% (dose values between 50 and 450 cGy), as the other calibration curves when films of the same lot are used. Moreover, the new calibration curve, albeit obtained from only one lot of film, shows a good agreement with experimental data from all other lots of EBT3 films used, with an accuracy of about 2% and a relative dose precision of 2.4% (1 standard deviation). The agreement also holds for changes of the film orientation and of the time after exposure. Conclusions: The dose accuracy of this new form of the calibration curve is always equal to or better than those obtained from the two types of curves previously used. The use of the net optical densities ratio considerably reduces the dependence on the lot of films, the landscape/portrait orientation, and the time after exposure. This form of the calibration curve could become even more useful with new optical digital devices using monochromatic light.
- 24 June 2016
- Published by Wiley in Medical Physics
- Vol. 43 (7) , 4435-4446
A new form of the calibration curve in radiochromic dosimetry. Properties and results
Purpose: This work describes a new form of the calibration curve for radiochromic dosimetry that depends on one fit parameter. Some results are reported to show that the new curve performs as well as those previously used and, more importantly, significantly reduces the dependence on the lot of films, the film orientation on the scanner, and the time after exposure. Methods: The form of the response curve makes use of the net optical densities ratio against the dose and has been studied by means of the Beer–Lambert law and a simple modeling of the film. The new calibration curve has been applied to EBT3 films exposed at 6 and 15 MV energy beams of linear accelerators and read-out in transmission mode by means of a flatbed color scanner. Its performance has been compared to that of two established forms of the calibration curve, which use the optical density and the net optical density against the dose. Four series of measurements with four lots of EBT3 films were used to evaluate the precision, accuracy, and dependence on the time after exposure, orientation on the scanner and lot of films. Results: The new calibration curve is roughly subject to the same dose uncertainty, about 2% (1 standard deviation), and has the same accuracy, about 1.5% (dose values between 50 and 450 cGy), as the other calibration curves when films of the same lot are used. Moreover, the new calibration curve, albeit obtained from only one lot of film, shows a good agreement with experimental data from all other lots of EBT3 films used, with an accuracy of about 2% and a relative dose precision of 2.4% (1 standard deviation). The agreement also holds for changes of the film orientation and of the time after exposure. Conclusions: The dose accuracy of this new form of the calibration curve is always equal to or better than those obtained from the two types of curves previously used. The use of the net optical densities ratio considerably reduces the dependence on the lot of films, the landscape/portrait orientation, and the time after exposure. This form of the calibration curve could become even more useful with new optical digital devices using monochromatic light.
- 1 February 2016
- Published by Elsevier in Physica Medica
- Vol. 32, 54
Gafchromic EBT3 calibration: A new curve type reducing the dependence on films lot
- 1 February 2016
- Published by Elsevier in Physica Medica
- Vol. 32, 54
Gafchromic EBT3 calibration: A new curve type reducing the dependence on films lot
- 1 February 2016
- Published by Elsevier in Physica Medica
- Vol. 32, 110-111
Radiometabolic therapy with 131I for hyperthyroidism from Graves' disease. First experiences in Sassari Hospital
- 1 February 2016
- Published by Elsevier in Physica Medica
- Vol. 32, 110-111
Radiometabolic therapy with 131I for hyperthyroidism from Graves' disease. First experiences in Sassari Hospital