Lalit Kumar Sahoo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Lalit Kumar Sahoo has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Chinmay Basu
Saha Institute of Nuclear Physics, 1/AF, Bidhannagar, Kolkata-700064, India
6 shared publications - Dipali Basak
Saha Institute of Nuclear Physics, 1/AF, Bidhannagar, Kolkata-700064, India
4 shared publications - Jagannath Datta
Analytical Chemistry Division, Bhabha Atomic Research Centre, Variable Energy Cyclotron Centre, 1/AF Bidhannagar, Kolkata 700064, India
3 shared publications - Sandipan Dasgupta
Analytical Chemistry Division, Bhabha Atomic Research Centre, Variable Energy Cyclotron Centre, 1/AF Bidhannagar, Kolkata 700064, India
3 shared publications - Sukhendu Saha
Saha Institute of Nuclear Physics, 1/AF, Bidhannagar, Kolkata-700064, India
3 shared publications - Tanmoy Bar
Saha Institute of Nuclear Physics, 1/AF Bidhannagar, Saltlake, Kolkata - 700064, India
3 shared publications
Latest Publications
- 30 May 2025
- Published by IOP Publishing in Journal of Physics G: Nuclear and Particle Physics
- Vol. 52 (6) , 065101
Proton induced reaction on 108Cd for astrophysical p-process studies
The proton capture cross-section of the least abundant proton-rich stable isotope of cadmium, 108Cd (natural abundance 0.89%), has been measured near the Gamow window corresponding to a temperature range of 3–4 GK. The measurement of the total capture reaction cross-section of 108Cd(p,γ)109In was conducted using the activation technique with 66.3% isotopically enriched targets. The cross-section at the lowest energy point of T 9 = 3, E p Lab = 2.26 ± 0.12 MeV, has been reported for the first time. The astrophysical S-factor was measured in the energy range relevant to the astrophysical p-process, between E p Lab = 2.26 ± 0.12 and 6.84 ± 0.03 MeV. The experimental results have been compared with theoretical predictions of Hauser-Feshbach statistical model calculations using TALYS-1.96. A calculated proton-optical potential was implemented to achieve better fitting, with different combinations of available nuclear level densities (NLDs) and γ-ray strength functions in TALYS-1.96. The calculations provided satisfactory agreement with the experimental results. The reaction rate was extrapolated using the calculated potential in TALYS-1.96 and compared with the values provided in the REACLIB database.
- 30 May 2025
- Published by IOP Publishing in Journal of Physics G: Nuclear and Particle Physics
- Vol. 52 (6) , 065101
Proton induced reaction on 108Cd for astrophysical p-process studies
The proton capture cross-section of the least abundant proton-rich stable isotope of cadmium, 108Cd (natural abundance 0.89%), has been measured near the Gamow window corresponding to a temperature range of 3–4 GK. The measurement of the total capture reaction cross-section of 108Cd(p,γ)109In was conducted using the activation technique with 66.3% isotopically enriched targets. The cross-section at the lowest energy point of T 9 = 3, E p Lab = 2.26 ± 0.12 MeV, has been reported for the first time. The astrophysical S-factor was measured in the energy range relevant to the astrophysical p-process, between E p Lab = 2.26 ± 0.12 and 6.84 ± 0.03 MeV. The experimental results have been compared with theoretical predictions of Hauser-Feshbach statistical model calculations using TALYS-1.96. A calculated proton-optical potential was implemented to achieve better fitting, with different combinations of available nuclear level densities (NLDs) and γ-ray strength functions in TALYS-1.96. The calculations provided satisfactory agreement with the experimental results. The reaction rate was extrapolated using the calculated potential in TALYS-1.96 and compared with the values provided in the REACLIB database.
- 1 March 2025
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 20 (03) , P03010
Fabrication of 108Cd target for the astrophysical p-process studies
The detailed procedure for preparing enriched 108Cd targets (66.3% enrichment) on Mylar and Cu backings using the vacuum evaporation technique is outlined. Given the low melting point and high vapour pressure of Cd, modifications were made to the Telemark multipocket e--beam setup. The target thickness was determined by measuring α-particle energy loss from a triple α-source. Multiple 108Cd targets, with thicknesses ranging from 244 ± 22 μg/cm2 to 659 ± 55 μg/cm2, were prepared. The non-uniformity of these targets was measured and found to be approximately 10%. X-ray Photoelectron Spectroscopy (XPS) and X-ray Fluorescence (XRF) analyses were performed to detect impurities and evaluate surface morphology, phase, and chemical composition. These targets were subsequently used in experiments to measure the proton capture cross-section at energies well below the Coulomb barrier, contributing to astrophysical p-process studies.
- 1 March 2025
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 20 (03) , P03010
Fabrication of 108Cd target for the astrophysical p-process studies
The detailed procedure for preparing enriched 108Cd targets (66.3% enrichment) on Mylar and Cu backings using the vacuum evaporation technique is outlined. Given the low melting point and high vapour pressure of Cd, modifications were made to the Telemark multipocket e--beam setup. The target thickness was determined by measuring α-particle energy loss from a triple α-source. Multiple 108Cd targets, with thicknesses ranging from 244 ± 22 μg/cm2 to 659 ± 55 μg/cm2, were prepared. The non-uniformity of these targets was measured and found to be approximately 10%. X-ray Photoelectron Spectroscopy (XPS) and X-ray Fluorescence (XRF) analyses were performed to detect impurities and evaluate surface morphology, phase, and chemical composition. These targets were subsequently used in experiments to measure the proton capture cross-section at energies well below the Coulomb barrier, contributing to astrophysical p-process studies.
- 30 December 2024
- Published by American Physical Society (APS) in Physical Review C
- Vol. 110 (6)
Experimental study of -induced reactions on for the astrophysical process- 30 December 2024
- Published by American Physical Society (APS) in Physical Review C
- Vol. 110 (6)
Experimental study of -induced reactions on for the astrophysical process- Open Access
Lithium fluoride (LiF) target preparation for nuclear physics experiment
The LiF target preparation on self-supporting Ag backing (LiF/Ag) is discussed in a detailed manner using vacuum evaporation process. The target thickness is measured using the energy loss of three line alpha source. 183.74 {\mu}g/cm 2 thickness of LiF is achieved through the evaporation process. Good uniformity of targets is observed. Non-uniformity in targets is found within 6 %. The XPS analysis confirms the presence of both the F and Li atoms on sample surface.
Open AccessLithium fluoride (LiF) target preparation for nuclear physics experiment
The LiF target preparation on self-supporting Ag backing (LiF/Ag) is discussed in a detailed manner using vacuum evaporation process. The target thickness is measured using the energy loss of three line alpha source. 183.74 {\mu}g/cm 2 thickness of LiF is achieved through the evaporation process. Good uniformity of targets is observed. Non-uniformity in targets is found within 6 %. The XPS analysis confirms the presence of both the F and Li atoms on sample surface.
- Open Access
- 22 December 2021
- Published by World Scientific Pub Co Pte Ltd in International Journal of Modern Physics E
- Vol. 30 (12)
Direct reaction contribution in the very low-energy 19F(p,α0) reaction
- 22 December 2021
- Published by World Scientific Pub Co Pte Ltd in International Journal of Modern Physics E
- Vol. 30 (12)
Open AccessDirect reaction contribution in the very low-energy 19F(p,α0) reaction