Rooma Waqar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Rooma Waqar has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Abdul Samad Mumtaz
Department of Plant Sciences, Quaid-i-Azam University, Islamabad, Pakistan
3 shared publications - Lubna Anjum Minhas
Department of Plant Sciences, Faculty of Biological Sciences, Quaid-i-Azam University, Islamabad, Pakistan
3 shared publications Banzeer Ahsan Abbasi
Rawalpindi Women University
2 shared publicationsGhulam Murtaza
Yunnan University
2 shared publicationsJaved Iqbal
Bacha Khan University
2 shared publications- Javed Iqbal
Department of Botany, Bacha Khan University, Charsadda 24420, Khyber Pakhtunkhwa, Pakistan
2 shared publications
Latest Publications
- 22 April 2025
- Published by Springer Nature
- p. 177-204
Insights from Genome Editing into Tomato Germplasm: Current Status and Future Perspective
- 22 April 2025
- Published by Springer Nature
- p. 177-204
Insights from Genome Editing into Tomato Germplasm: Current Status and Future Perspective
- 22 April 2025
- Published by Springer Nature
- p. 17-53
Molecular Strategies for Confronting Abiotic Stress Tolerance in Tomatoes
- 22 April 2025
- Published by Springer Nature
- p. 17-53
Molecular Strategies for Confronting Abiotic Stress Tolerance in Tomatoes
- Open Access
- 27 July 2023
- Published by MDPI AG in Sustainability
- Vol. 15 (15) , 11634
Biosorption Potential of Desmodesmus sp. for the Sequestration of Cadmium and Lead from Contaminated Water
Industrialization, urbanization, and natural processes have potentially accelerated the pace and level of heavy metals in the aquatic environment. Recently, modern strategies for heavy metal treatment in wastewater have received the specific attention of the scientific community. The present study aimed to assess the amorphous biomass of Desmodesmus sp. as a low-cost adsorbent to remove the cadmium (Cd) and lead (Pb) from aqueous solutions. It involved the optimization of pH, contact time, initial concentration of metal ions, and the dosage of biosorbent. Data collation revealed that an optimum contact time for both metals was 60 min, with an adsorption capacity of 63% for Cd and 66% for Pb. Different models were applied to the equilibrium data. The pseudo 2nd order described the best adsorption of Cd and Pb. The equilibrium data were computed with various isotherms. Langmuir isotherms better suit the adsorption of the above-mentioned metals. Hence, the maximum adsorption capacity of Desmodesmus sp. for Cd and Pb was 64.1 and 62.5 mg/g, respectively. The mechanism of biosorption was validated through a comparative FT-IR and Scanning Electron Microscopy of raw and metal-loaded algal biomass based on cell morphological changes. In order to study the reusability of adsorbent, adsorption-desorption of Cd and Pb ions was repeated three times using HCl. These results did not noticeably change in adsorption capacity during the three cycles. Using HCl (0.1 M), desorption of both metals was achieved up to 90% in three cycles. This work presented a long-term bioremediation approach for heavy metal pollutants in wastewater. This research could be seen as an interdisciplinary approach to large-scale heavy metal remediation. In addition, growing microalgae in wastewater produces animal feed and biodiesel. When compared to other conventional methods for environmental remediation and the manufacture of valuable products, the use of microalgae is a more efficient and cost-effective method.
- 27 July 2023
- Published by MDPI AG in Sustainability
- Vol. 15 (15) , 11634
Open AccessBiosorption Potential of Desmodesmus sp. for the Sequestration of Cadmium and Lead from Contaminated Water
Industrialization, urbanization, and natural processes have potentially accelerated the pace and level of heavy metals in the aquatic environment. Recently, modern strategies for heavy metal treatment in wastewater have received the specific attention of the scientific community. The present study aimed to assess the amorphous biomass of Desmodesmus sp. as a low-cost adsorbent to remove the cadmium (Cd) and lead (Pb) from aqueous solutions. It involved the optimization of pH, contact time, initial concentration of metal ions, and the dosage of biosorbent. Data collation revealed that an optimum contact time for both metals was 60 min, with an adsorption capacity of 63% for Cd and 66% for Pb. Different models were applied to the equilibrium data. The pseudo 2nd order described the best adsorption of Cd and Pb. The equilibrium data were computed with various isotherms. Langmuir isotherms better suit the adsorption of the above-mentioned metals. Hence, the maximum adsorption capacity of Desmodesmus sp. for Cd and Pb was 64.1 and 62.5 mg/g, respectively. The mechanism of biosorption was validated through a comparative FT-IR and Scanning Electron Microscopy of raw and metal-loaded algal biomass based on cell morphological changes. In order to study the reusability of adsorbent, adsorption-desorption of Cd and Pb ions was repeated three times using HCl. These results did not noticeably change in adsorption capacity during the three cycles. Using HCl (0.1 M), desorption of both metals was achieved up to 90% in three cycles. This work presented a long-term bioremediation approach for heavy metal pollutants in wastewater. This research could be seen as an interdisciplinary approach to large-scale heavy metal remediation. In addition, growing microalgae in wastewater produces animal feed and biodiesel. When compared to other conventional methods for environmental remediation and the manufacture of valuable products, the use of microalgae is a more efficient and cost-effective method.
- Open Access
- 30 March 2023
- Published by MDPI AG in Sustainability
- Vol. 15 (7) , 6024
Kinetic and Equilibrium Studies on the Adsorption of Lead and Cadmium from Aqueous Solution Using Scenedesmus sp.
The current study aimed to investigate the viability and characteristics of Scenedesmus sp. as an adsorbent system to remove lead (Pb) and cadmium (Cd) through an in vitro exposure to a metal solution. In batch sorption experiments, the effects of pH, contact time, initial concentration of metal ions, and sorbent dosage on the adsorption process were trialed. The ideal biosorption conditions for each of the two metals were recorded. The biosorption process was quick, and the equilibrium times for the above-mentioned metals were recorded as 90 and 60 min, with removal percentages of 85% and 83%, respectively. The point zero charge of algal biomass was 4.5, which indicates a negative charge on the surface of the biosorbent. The model-based assessment of the biosorption process was revealed to have followed pseudo-second-order kinetics. The adsorption isotherms for lead and cadmium achieved a best fit with the Langmuir model, with monolayer biosorption capacities of 102 and 128 mg g−1, respectively. The desorption of both metals achieved more than 70% by using HCl. The FT-IR revealed the presence of hydroxyl and amine groups on the surface of the adsorbent that are involved in the biosorption process, and morphological changes were assessed by SEM. Hence, Scenedesmus sp. from a Himalayan provenance showed considerable promise as an alternate sorbent for the treatment of heavy-metal-contaminated wastewater.
- 30 March 2023
- Published by MDPI AG in Sustainability
- Vol. 15 (7) , 6024
Open AccessKinetic and Equilibrium Studies on the Adsorption of Lead and Cadmium from Aqueous Solution Using Scenedesmus sp.
The current study aimed to investigate the viability and characteristics of Scenedesmus sp. as an adsorbent system to remove lead (Pb) and cadmium (Cd) through an in vitro exposure to a metal solution. In batch sorption experiments, the effects of pH, contact time, initial concentration of metal ions, and sorbent dosage on the adsorption process were trialed. The ideal biosorption conditions for each of the two metals were recorded. The biosorption process was quick, and the equilibrium times for the above-mentioned metals were recorded as 90 and 60 min, with removal percentages of 85% and 83%, respectively. The point zero charge of algal biomass was 4.5, which indicates a negative charge on the surface of the biosorbent. The model-based assessment of the biosorption process was revealed to have followed pseudo-second-order kinetics. The adsorption isotherms for lead and cadmium achieved a best fit with the Langmuir model, with monolayer biosorption capacities of 102 and 128 mg g−1, respectively. The desorption of both metals achieved more than 70% by using HCl. The FT-IR revealed the presence of hydroxyl and amine groups on the surface of the adsorbent that are involved in the biosorption process, and morphological changes were assessed by SEM. Hence, Scenedesmus sp. from a Himalayan provenance showed considerable promise as an alternate sorbent for the treatment of heavy-metal-contaminated wastewater.