Corrado Garlisi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Corrado Garlisi has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Giovanni Palmisano
Department of Chemical Engineering, Khalifa University of Science and Technology, P.O. Box 127788, Abu Dhabi, United Arab Emirates
2 shared publications Ahmed Yusuf
Department of Chemical Engineering, Khalifa University of Science and Technology, P.O. Box 127788, Abu Dhabi, United Arab Emirates
1 shared publication- Ahmed Yusuf
Department of Chemical Engineering, Khalifa University of Science and Technology, P.O. Box 127788, Abu Dhabi, United Arab Emirates
1 shared publication - Gianluca Li Puma
Loughborough University
1 shared publication Giovanni Palmisano
1 shared publicationRodrigo Peralta Muniz Moreira
1 shared publication
Latest Publications
- Open Access
- 29 July 2021
- Published by Bentham Science Publishers Ltd. in Journal of Photocatalysis
- Vol. 2 (2) , 97-104
Photocatalytic Degradation of 2-propanol Over TiO2-based Thin Films in a Simulated Pilot Microreactor
Background: Microreactor devices have attracted increasing attention over the last years due to their high surface-to-volume ratio, which ensures a high heat and mass transfer, short molecular diffusion distance and greater spatial illumination homogeneity compared to the traditional reactors. Objective: The aim of this study was to model the kinetics of photo-degradation of 2-propanol over TiO2-based thin films in a gas-phase batch-reactor and simulate their performance in a microreactor device. Methods: The reaction was carried out in a gas-phase batch-reactor, assessing the reactivity of singlelayer nitrogen (N)-doped TiO2 and a bilayer consisting of N-doped TiO2 as a bottom layer and copper (Cu)-doped TiO2 as a top layer. The kinetics of the photocatalytic process was modelled by Langmuir– Hinshelwood (LH) model. The constants obtained from the LH model were used to simulate the performance of the photocatalysts in a microreactor, operating in a continuous flow mode and investigating the effect of the volumetric flow rate (Q), initial concentration of pollutant (Co), number of microchannels (n) and microchannel length (l) on the photo-degradation of 2-propanol. Results: N-Cu-TiO2 exhibited a higher reactivity but a lower adsorption ability towards the target pollutant compared to N-TiO2. To maximize and leverage the advantages of a microreactor, optimal operating conditions for a continuous flow mode, at a steady-state, should be moderately low Q and Co, long l and n that minimizes flow maldistribution in parallel. Conclusion: The findings in this work could serve as a basis to design and fabricate efficient microreactors for the removal of VOC in air purification applications.
- 29 July 2021
- Published by Bentham Science Publishers Ltd. in Journal of Photocatalysis
- Vol. 2 (2) , 97-104
Open AccessPhotocatalytic Degradation of 2-propanol Over TiO2-based Thin Films in a Simulated Pilot Microreactor
Background: Microreactor devices have attracted increasing attention over the last years due to their high surface-to-volume ratio, which ensures a high heat and mass transfer, short molecular diffusion distance and greater spatial illumination homogeneity compared to the traditional reactors. Objective: The aim of this study was to model the kinetics of photo-degradation of 2-propanol over TiO2-based thin films in a gas-phase batch-reactor and simulate their performance in a microreactor device. Methods: The reaction was carried out in a gas-phase batch-reactor, assessing the reactivity of singlelayer nitrogen (N)-doped TiO2 and a bilayer consisting of N-doped TiO2 as a bottom layer and copper (Cu)-doped TiO2 as a top layer. The kinetics of the photocatalytic process was modelled by Langmuir– Hinshelwood (LH) model. The constants obtained from the LH model were used to simulate the performance of the photocatalysts in a microreactor, operating in a continuous flow mode and investigating the effect of the volumetric flow rate (Q), initial concentration of pollutant (Co), number of microchannels (n) and microchannel length (l) on the photo-degradation of 2-propanol. Results: N-Cu-TiO2 exhibited a higher reactivity but a lower adsorption ability towards the target pollutant compared to N-TiO2. To maximize and leverage the advantages of a microreactor, optimal operating conditions for a continuous flow mode, at a steady-state, should be moderately low Q and Co, long l and n that minimizes flow maldistribution in parallel. Conclusion: The findings in this work could serve as a basis to design and fabricate efficient microreactors for the removal of VOC in air purification applications.