CPCheng Peng

Cheng Peng

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Cheng Peng has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Structure and Optical Properties of TiO2 Films Prepared by Electron Beam Evaporation of Al2O3-Doped Ti3O5

    by Cheng Peng, Xingqi Wang, Zhixia Shi, Huaying Duan, Bitian Zhang, Yanxi Yin

    The crystal structure regulation of Ti3O5 by Al2O3 doping and its effect on the optical properties of TiO2 films prepared by electron beam evaporation were systematically studied. Ti3O5 coating materials with different Al2O3 doping contents (0–50 at%) were prepared by vacuum melting, and the corresponding TiO2 films were deposited on K9 glass substrates via electron beam vacuum evaporation. The phase structure, phase transition temperature, chemical composition and optical properties of the materials and films were characterized by XRD, DSC, EDS, XPS, UV-Vis and AFM. Results show that Al2O3 doping induces the phase transition of Ti3O5 from a room-temperature stable β-phase to a high-temperature stable λ-phase, with complete transition at 5 at% doping. Al3+ with a smaller ionic radius causes lattice contraction and local distortion of Ti3O5, enabling stabilization at room temperature of the λ-phase. For TiO2 films, 12.5 at% doping is the optimal state with the stable composition transfer under this condition. With the increase in Al2O3 doping content, the refractive index and extinction coefficient of TiO2 films decrease continuously, while the optical band gap and surface roughness show an increasing trend. The changes in optical properties are mainly ascribed to the low refractive index of Al2O3, lattice compressive strain effect and oxygen vacancy passivation induced by Al3+. This study clarifies the regulation effect of Al2O3 doping on Ti3O5 phase transition and TiO2 film optical properties, and provides theoretical basis and experimental reference for the doping modification of TiO2 films and their practical applications in consumer electronics and optical filter devices.

  • Open Access

    Fabrication and Characterization of Mineral Hydrophilic Antifogging Film via Vacuum Evaporation Method

    by Shenyu Wei, Qi Zheng, Lei Wang, Cheng Peng, Xinglan Cui, Xiaokui Che, Wuyu Wang, Zeen Yu

    Natural silicate minerals have a wide range of applications as green, non-toxic and low-cost materials. In this paper, hydrophilic anti-fog films of silicate minerals were generated via a vacuum evaporation coating method using natural feldspar minerals as raw material. Thermogravimetric analysis shows that the feldspar changes its structure during the coating process, which in turn changes the roughness of the film and improves the hydrophilicity of the film. The hydrophilicity, anti-fogging properties, optical properties and surface morphology of the films were characterized by contact angle measurements, the hydrothermal method, UV-VIS spectrophotometer and atomic force microscopy, respectively. The results show that the mineral films have excellent hydrophilicity. The best anti-fog effect was achieved at a minimum contact angle of 22.3° with water when the thickness of the film was 100 nm. The anti-fog effect gradually decreased with the increasing thickness of the film. The optical transmittance test showed that the film material had a negligible effect on the transmittance of the substrate. When the film thickness was 100 nm, the maximum optical transmittance was 92.2%. This is 4.5% higher than when the film was uncoated, which has a specific visual transmittance effect.