Mohamed Sereez
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Mohamed Sereez has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Mikhail Goman
Faculty of Computing, Engineering and Media, De Montfort University, Leicester LE1 9BH, UK
3 shared publications - Nikolay Abramov
Faculty of Computing, Engineering and Media, De Montfort University, Leicester LE1 9BH, UK
3 shared publications - Caroline Lambert
Future Transport Engineering, Coventry University, Coventry CV1 5FB, UK
1 shared publication M. Goman
School of Engineering and Sustainable Development, De Montfort University, Leicester, UK
1 shared publicationMikhail Goman
FRAeS, De Montfort University, Leicester, UK
1 shared publication- N. Abramov
School of Engineering and Sustainable Development, De Montfort University, Leicester, UK
1 shared publication
Latest Publications
- Open Access
Numerical Simulation of Self-Sustained Roll Oscillations of an 80-Degree Delta Wing Caused by Leading-Edge Vortices
Numerical simulations of an 80-degree delta wing in free-to-roll motion are performed by applying the dynamic fluid–body interaction (DFBI) model and the overlap/chimera method using the URANS equations. The capabilities of modern computational fluid dynamics methods for predicting wing-rock phenomena over a wide range of angles of attack at low Mach numbers and strong wing–vortex interaction, including the vortex breakdown phenomenon, were investigated by comparing simulation results with wind tunnel test data. At low angles of attack, delays in the strength and position of the leading-edge vortices above the wing have a destabilizing effect on it, leading to the emergence of self-sustained limit-cycle oscillations. At high angles of attack, where vortex breakdown occurs, the available wind tunnel data show that there are two modes of wing self-oscillations in free-to-roll motion, namely, regular large-amplitude oscillations and irregular small-amplitude oscillations, where the excitation of the latter mode depends on the angle of attack and the initial roll angle of the wing motion. The performed numerical simulation also shows the existence of these two self-oscillatory modes in roll, qualitatively and quantitatively matching the experimental data.
Open AccessNumerical Simulation of Self-Sustained Roll Oscillations of an 80-Degree Delta Wing Caused by Leading-Edge Vortices
Numerical simulations of an 80-degree delta wing in free-to-roll motion are performed by applying the dynamic fluid–body interaction (DFBI) model and the overlap/chimera method using the URANS equations. The capabilities of modern computational fluid dynamics methods for predicting wing-rock phenomena over a wide range of angles of attack at low Mach numbers and strong wing–vortex interaction, including the vortex breakdown phenomenon, were investigated by comparing simulation results with wind tunnel test data. At low angles of attack, delays in the strength and position of the leading-edge vortices above the wing have a destabilizing effect on it, leading to the emergence of self-sustained limit-cycle oscillations. At high angles of attack, where vortex breakdown occurs, the available wind tunnel data show that there are two modes of wing self-oscillations in free-to-roll motion, namely, regular large-amplitude oscillations and irregular small-amplitude oscillations, where the excitation of the latter mode depends on the angle of attack and the initial roll angle of the wing motion. The performed numerical simulation also shows the existence of these two self-oscillatory modes in roll, qualitatively and quantitatively matching the experimental data.
- Open Access
CFD Simulations and Phenomenological Modelling of Aerodynamic Stall Hysteresis of NACA 0018 Wing
Computational simulations of three-dimensional flow around a NACA 0018 wing with an aspect ratio of were carried out by using the Unsteady Reynolds-Averaged Navier–Stokes (URANS) equations with the Shear-Stress Transport turbulence model closure. Simulations were performed to capture aerodynamic stall hysteresis by using the developed pseudo-transient continuation (PTC) method based on a dual-time step approach in CFD OpenFOAM code. The flow was characterized by incompressible Mach number and moderate Reynolds number . The results obtained indicate the presence of noticeable aerodynamic hysteresis in the static dependencies of the force and moment coefficients, as well as the manifestation of bi-stable flow separation patterns, accompanied by the development of asymmetry in the stall zone. The URANS simulation results are in good agreement with the experimental data obtained for the NACA 0018 finite-aspect-ratio wing in the low-speed wind tunnel under the same test conditions. A new phenomenological bifurcation model of aerodynamic stall hysteresis under static and dynamic conditions is formulated and is proven to be able to closely match the experimental data.Open AccessCFD Simulations and Phenomenological Modelling of Aerodynamic Stall Hysteresis of NACA 0018 Wing
Computational simulations of three-dimensional flow around a NACA 0018 wing with an aspect ratio of were carried out by using the Unsteady Reynolds-Averaged Navier–Stokes (URANS) equations with the Shear-Stress Transport turbulence model closure. Simulations were performed to capture aerodynamic stall hysteresis by using the developed pseudo-transient continuation (PTC) method based on a dual-time step approach in CFD OpenFOAM code. The flow was characterized by incompressible Mach number and moderate Reynolds number . The results obtained indicate the presence of noticeable aerodynamic hysteresis in the static dependencies of the force and moment coefficients, as well as the manifestation of bi-stable flow separation patterns, accompanied by the development of asymmetry in the stall zone. The URANS simulation results are in good agreement with the experimental data obtained for the NACA 0018 finite-aspect-ratio wing in the low-speed wind tunnel under the same test conditions. A new phenomenological bifurcation model of aerodynamic stall hysteresis under static and dynamic conditions is formulated and is proven to be able to closely match the experimental data. - Open Access
- 20 February 2024
- Published by MDPI AG in Preprints.org
CFD Simulations and Phenomenological Modelling of Aerodynamic Stall Hysteresis of NACA 0018 Wing
Computational simulations of three-dimensional flow around a NACA 0018 wing with an aspect ratio of AR=5 are carried out using the Unsteady Reynolds-Averaged Navier-Stokes (URANS) equations with the Shear-Stress Transport turbulence model closure. Simulations were performed to capture the aerodynamic stall hysteresis using a developed Pseudo-Transient Continuation (PTC) method based on a dual time step approach in the CFD code OpenFOAM. The flow was characterized by an incompressible Mach number of M=0.12 and a moderate Reynolds number Re=0.67×10^6. The results obtained indicate the presence of a noticeable aerodynamic hysteresis in the static dependencies of the force and moment coefficients, as well as the manifestation of bi-stable flow separation patterns, accompanied by the development of asymmetry in the stall zone. The URANS simulation results are in good agreement with the experimental data obtained for the NACA 0018 finite aspect ratio wing from the low-speed wind tunnel under the same test conditions. A new phenomenological bifurcation model of aerodynamic stall hysteresis under static and dynamic conditions is formulated, which is proven to be able to closely match the experimental data.
- 20 February 2024
- Published by MDPI AG in Preprints.org
Open AccessCFD Simulations and Phenomenological Modelling of Aerodynamic Stall Hysteresis of NACA 0018 Wing
Computational simulations of three-dimensional flow around a NACA 0018 wing with an aspect ratio of AR=5 are carried out using the Unsteady Reynolds-Averaged Navier-Stokes (URANS) equations with the Shear-Stress Transport turbulence model closure. Simulations were performed to capture the aerodynamic stall hysteresis using a developed Pseudo-Transient Continuation (PTC) method based on a dual time step approach in the CFD code OpenFOAM. The flow was characterized by an incompressible Mach number of M=0.12 and a moderate Reynolds number Re=0.67×10^6. The results obtained indicate the presence of a noticeable aerodynamic hysteresis in the static dependencies of the force and moment coefficients, as well as the manifestation of bi-stable flow separation patterns, accompanied by the development of asymmetry in the stall zone. The URANS simulation results are in good agreement with the experimental data obtained for the NACA 0018 finite aspect ratio wing from the low-speed wind tunnel under the same test conditions. A new phenomenological bifurcation model of aerodynamic stall hysteresis under static and dynamic conditions is formulated, which is proven to be able to closely match the experimental data.
- Open Access
- 20 October 2023
- Published by Cambridge University Press (CUP) in The Aeronautical Journal
- Vol. 128 (1324) , 1-17
Prediction of aerodynamic characteristics of high-lift Common Research Model in ground effect
Reynolds Averaged Navier-Stokes (RANS) simulations are performed to investigate the aerodynamic characteristics of the NASA Common Research Model (CRM) in its high-lift (HL) configuration in close proximity to the ground. The RANS simulations are conducted at a moderate Reynolds number of with the use of the Spalart-Allmaras (SA) turbulence model. out of ground effect (OGE) simulation results are validated against available wind tunnel data before proceeding to in ground effect (IGE) simulations. The obtained computational results in the immediate vicinity of the ground with asymmetric aircraft attitudes demonstrate significant changes in the longitudinal and lateral-directional aerodynamic characteristics, which should be taken into account in flight dynamics analysis of aircraft during take-off and landing in crosswind conditions.
- 20 October 2023
- Published by Cambridge University Press (CUP) in The Aeronautical Journal
- Vol. 128 (1324) , 1-17
Open AccessPrediction of aerodynamic characteristics of high-lift Common Research Model in ground effect
Reynolds Averaged Navier-Stokes (RANS) simulations are performed to investigate the aerodynamic characteristics of the NASA Common Research Model (CRM) in its high-lift (HL) configuration in close proximity to the ground. The RANS simulations are conducted at a moderate Reynolds number of with the use of the Spalart-Allmaras (SA) turbulence model. out of ground effect (OGE) simulation results are validated against available wind tunnel data before proceeding to in ground effect (IGE) simulations. The obtained computational results in the immediate vicinity of the ground with asymmetric aircraft attitudes demonstrate significant changes in the longitudinal and lateral-directional aerodynamic characteristics, which should be taken into account in flight dynamics analysis of aircraft during take-off and landing in crosswind conditions.
- Open Access
- 29 March 2023
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
- Vol. 237 (12) , 2887-2904
A modified dual time integration technique for aerodynamic quasi-static and dynamic stall hysteresis
Simulation of the aerodynamic stall phenomenon in both quasi-static and dynamic conditions requires expensive computational resources. The computations become even more costly for static stall hysteresis using an unsteady solver with very slow variation of angle of attack at low reduced frequencies. In an explicit time-marching solver that satisfies the low Courant number condition, that is, [ ], the computational cost for such simulations becomes prohibitive, especially at higher Reynolds numbers due to the presence of thin-stretched cells with large aspect ratio in the boundary layer. In this paper, a segregated solver method such as the Semi-Implicit Method for Pressure-Linked Equations (SIMPLE) is modified as a dual pseudo-time marching method so that the unsteady problem at each time step is reformulated as a steady state problem. The resulting system of equations in the discretized finite volume formulation is then reduced to zero or near-zero residuals using available convergence acceleration methods such as local time stepping, multi-grid acceleration and residual smoothing. The performance and accuracy of the implemented algorithm was tested for three different airfoils at low to moderate Reynolds numbers in both incompressible and compressible flow conditions covering both attached and separated flow regimes. The results obtained are in close agreement with the published experimental and computational results for both quasi-static and dynamic stall and have demonstrated significant savings in computational time.
- 29 March 2023
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
- Vol. 237 (12) , 2887-2904
Open AccessA modified dual time integration technique for aerodynamic quasi-static and dynamic stall hysteresis
Simulation of the aerodynamic stall phenomenon in both quasi-static and dynamic conditions requires expensive computational resources. The computations become even more costly for static stall hysteresis using an unsteady solver with very slow variation of angle of attack at low reduced frequencies. In an explicit time-marching solver that satisfies the low Courant number condition, that is, [ ], the computational cost for such simulations becomes prohibitive, especially at higher Reynolds numbers due to the presence of thin-stretched cells with large aspect ratio in the boundary layer. In this paper, a segregated solver method such as the Semi-Implicit Method for Pressure-Linked Equations (SIMPLE) is modified as a dual pseudo-time marching method so that the unsteady problem at each time step is reformulated as a steady state problem. The resulting system of equations in the discretized finite volume formulation is then reduced to zero or near-zero residuals using available convergence acceleration methods such as local time stepping, multi-grid acceleration and residual smoothing. The performance and accuracy of the implemented algorithm was tested for three different airfoils at low to moderate Reynolds numbers in both incompressible and compressible flow conditions covering both attached and separated flow regimes. The results obtained are in close agreement with the published experimental and computational results for both quasi-static and dynamic stall and have demonstrated significant savings in computational time.