Davide Menegazzo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Davide Menegazzo has a total of 58 co-authors. Here are the top co-authors by number of shared publications:
- Laura Fedele
Istituto Per le Tecnologie Della Costruzione, Consiglio Nazionale Delle Ricerche (CNR) Padova Italy
12 shared publications - Sergio Bobbo
Istituto per le Tecnologie della Costruzione, Consiglio Nazionale delle Ricerche, Corso Stati Uniti 4, 35127 Padova, Italy
8 shared publications Giulia Lombardo
6 shared publications- Laura Vallese
National Research Council (CNR), Construction Technologies Institute, Padua, Italy
6 shared publications Sergio Bobbo
Construction Technology Institute, National Research Council, Padova, Italy
5 shared publications- Eleonora Baccega
Department of Architecture, University of Ferrara, Ferrara, Italy
2 shared publications
Latest Publications
- Open Access
- 29 November 2025
- Published by Elsevier in International Journal of Refrigeration
- Vol. 182, 188-201
Thermodynamic assessment of R1234yf + R1243zf + R600a ternary mixture for domestic heat pumps
- 29 November 2025
- Published by Elsevier in International Journal of Refrigeration
- Vol. 182, 188-201
Open AccessThermodynamic assessment of R1234yf + R1243zf + R600a ternary mixture for domestic heat pumps
- Open Access
- 30 October 2025
- Published by Acadlore Publishing Services Limited in International Journal of Computational Methods and Experimental Measurements
- Vol. 13 (3) , 588-596
Experimental Monitoring of an Air-to-Water Heat Pump Working with Low-GWP Refrigerant in a Zero Energy Building as Basis for AI Optimization
Heat pumps are widely recognized as the most cost-effective solution for decarbonizing the building sector. Their ability to provide both heating and cooling with a single system is especially relevant in today's context of rising temperatures due to global warming. This work describes a new experimental setup and presents initial results on the performance of an air-to-water heat pump operating with the low-GWP refrigerant R454B in a pilot Zero Energy Building. The system has been equipped with research-grade instrumentation to monitor key parameters in both the refrigerant and hydraulic loops. This paper presents the monitoring system and a thermodynamic model of the building based on RC analogy, which will be compared to the experimental data. These experimental results and the thermodynamic model will serve as the basis for training an AI tool dedicated to the optimal energy management of complex renewable energy systems, from single buildings to energy communities.
- 30 October 2025
- Published by Acadlore Publishing Services Limited in International Journal of Computational Methods and Experimental Measurements
- Vol. 13 (3) , 588-596
Open AccessExperimental Monitoring of an Air-to-Water Heat Pump Working with Low-GWP Refrigerant in a Zero Energy Building as Basis for AI Optimization
Heat pumps are widely recognized as the most cost-effective solution for decarbonizing the building sector. Their ability to provide both heating and cooling with a single system is especially relevant in today's context of rising temperatures due to global warming. This work describes a new experimental setup and presents initial results on the performance of an air-to-water heat pump operating with the low-GWP refrigerant R454B in a pilot Zero Energy Building. The system has been equipped with research-grade instrumentation to monitor key parameters in both the refrigerant and hydraulic loops. This paper presents the monitoring system and a thermodynamic model of the building based on RC analogy, which will be compared to the experimental data. These experimental results and the thermodynamic model will serve as the basis for training an AI tool dedicated to the optimal energy management of complex renewable energy systems, from single buildings to energy communities.
- Top Cited PapersOpen Access
- 6 August 2025
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 225
A comprehensive review of thermal energy storage technologies and their applications: Creation of a database
- 6 August 2025
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 225
Top Cited PapersOpen AccessA comprehensive review of thermal energy storage technologies and their applications: Creation of a database
- Open Access
- 3 February 2025
- Published by Springer Nature in International Journal of Thermophysics
- Vol. 46 (3) , 1-18
Experimental Compressed Liquid Density Measurements and Correlation of the Binary Mixture {n-Pentane (R601) + Trans-1-chloro-3,3,3-trifluoro-1-propene (R1233zd(E))}
Regulations like the F-gas Regulation (EU) 2024/573 and the Kigali Amendment to the Montreal Protocol, along with efforts to mitigate climate change, drive research into alternatives to fluorinated greenhouse gases for high-temperature heat pumps and power generation. Ideal refrigerants should have low GWP, high efficiency, non-flammability, non-toxicity, material compatibility and cost effectiveness. HCFOs have emerged as promising candidates, both as pure fluids and in mixtures with HCs. These blends show efficiency and potential non-flammability for high-temperature applications, but experimental data on their thermophysical properties remain scarce. This study presents the first experimental measurements on the {n-pentane (R601) + trans-1-chloro-3,3,3-trifluoro-1-propene (R1233zd(E))} binary system. In particular, the compressed liquid density of three mixture compositions have been measured employing a vibrating tube densimeter within the temperature range from 283.15 K to 423.15 K and at pressures ranging from 1 MPa to 12 MPa. A novel technique was applied to ensure a combined uncertainty (k=2) not greater than 0.0003 mol $$\cdot$$ mol $$^{-1}$$ in the mixture composition, leading to final combined uncertainty (k=2) on the liquid density of no more than 0.2%. Finally, a new mixture model based on the Helmholtz-energy-explicit Equation of State has been developed from such experimental data. This model accurately represents the behaviour of the binary mixture, enhancing the available understanding of its thermodynamic properties.- 3 February 2025
- Published by Springer Nature in International Journal of Thermophysics
- Vol. 46 (3) , 1-18
Open AccessExperimental Compressed Liquid Density Measurements and Correlation of the Binary Mixture {n-Pentane (R601) + Trans-1-chloro-3,3,3-trifluoro-1-propene (R1233zd(E))}
Regulations like the F-gas Regulation (EU) 2024/573 and the Kigali Amendment to the Montreal Protocol, along with efforts to mitigate climate change, drive research into alternatives to fluorinated greenhouse gases for high-temperature heat pumps and power generation. Ideal refrigerants should have low GWP, high efficiency, non-flammability, non-toxicity, material compatibility and cost effectiveness. HCFOs have emerged as promising candidates, both as pure fluids and in mixtures with HCs. These blends show efficiency and potential non-flammability for high-temperature applications, but experimental data on their thermophysical properties remain scarce. This study presents the first experimental measurements on the {n-pentane (R601) + trans-1-chloro-3,3,3-trifluoro-1-propene (R1233zd(E))} binary system. In particular, the compressed liquid density of three mixture compositions have been measured employing a vibrating tube densimeter within the temperature range from 283.15 K to 423.15 K and at pressures ranging from 1 MPa to 12 MPa. A novel technique was applied to ensure a combined uncertainty (k=2) not greater than 0.0003 mol $$\cdot$$ mol $$^{-1}$$ in the mixture composition, leading to final combined uncertainty (k=2) on the liquid density of no more than 0.2%. Finally, a new mixture model based on the Helmholtz-energy-explicit Equation of State has been developed from such experimental data. This model accurately represents the behaviour of the binary mixture, enhancing the available understanding of its thermodynamic properties. - Open Access
- 22 January 2025
- Published by Elsevier in International Journal of Refrigeration
- Vol. 172, 1-16
Compressed liquid density and speed of sound measurements and correlation of the binary mixture {carbon dioxide (CO) + 1,1-difluoroethene (R1132a)} at temperatures from 220 K to 350 K- 22 January 2025
- Published by Elsevier in International Journal of Refrigeration
- Vol. 172, 1-16
Open AccessCompressed liquid density and speed of sound measurements and correlation of the binary mixture {carbon dioxide (CO) + 1,1-difluoroethene (R1132a)} at temperatures from 220 K to 350 K - Open Access
- 21 January 2025
- Published by Elsevier in International Journal of Refrigeration
- Vol. 172, 64-74
Experimental compressed liquid density measurements and correlation of the binary mixture {3,3,3-trifuoropropene (R1243zf) + isobutane (R600a)}
- 21 January 2025
- Published by Elsevier in International Journal of Refrigeration
- Vol. 172, 64-74
Open AccessExperimental compressed liquid density measurements and correlation of the binary mixture {3,3,3-trifuoropropene (R1243zf) + isobutane (R600a)}
- Open Access
- 24 December 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 263
Evaluating the behaviour of a composite of CaCl2 and vermiculite for thermochemical adsorption energy storage: Experimental tests during the charging and discharging phases
- 24 December 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 263
Open AccessEvaluating the behaviour of a composite of CaCl2 and vermiculite for thermochemical adsorption energy storage: Experimental tests during the charging and discharging phases
- Open Access
A Technological Update on Heat Pumps for Industrial Applications
It is now widely confirmed by scientific evidence that greenhouse gas emissions must be reduced to counteract the effects of global warming. The production of heat for industrial purposes is responsible for 36.8% of world energy-related emissions due to the widespread use of fossil fuels. Heat pumps are a key technology in the transition towards more sustainable industrial processes. In this paper, a systematic review of the literature produced in the last 5 years in international journals regarding the integration of heat pumps in industrial processes is presented. Firstly, papers presenting innovative configurations for high temperature heat pumps (HTHP), i.e., heat pumps delivering temperatures in the range between 100 °C and 200 °C, suitable for many industrial processes but still under development, are reviewed. Then, papers reporting innovative solutions for the integration of heat pumps in specific industrial processes and sectors (e.g., distillation, drying, desalination, etc.) are analyzed. Finally, the literature about alternative low-GWP refrigerants for industrial heat pumps, both pure compounds and mixtures, is described. It is concluded that many progresses have been realized in the last 5 years (2020–2024) regarding the identification of innovative heat pumps for industrial applications, but further research is certainly required.
Open AccessA Technological Update on Heat Pumps for Industrial Applications
It is now widely confirmed by scientific evidence that greenhouse gas emissions must be reduced to counteract the effects of global warming. The production of heat for industrial purposes is responsible for 36.8% of world energy-related emissions due to the widespread use of fossil fuels. Heat pumps are a key technology in the transition towards more sustainable industrial processes. In this paper, a systematic review of the literature produced in the last 5 years in international journals regarding the integration of heat pumps in industrial processes is presented. Firstly, papers presenting innovative configurations for high temperature heat pumps (HTHP), i.e., heat pumps delivering temperatures in the range between 100 °C and 200 °C, suitable for many industrial processes but still under development, are reviewed. Then, papers reporting innovative solutions for the integration of heat pumps in specific industrial processes and sectors (e.g., distillation, drying, desalination, etc.) are analyzed. Finally, the literature about alternative low-GWP refrigerants for industrial heat pumps, both pure compounds and mixtures, is described. It is concluded that many progresses have been realized in the last 5 years (2020–2024) regarding the identification of innovative heat pumps for industrial applications, but further research is certainly required.
- Open Access
- 1 March 2024
- Published by Elsevier in International Journal of Refrigeration
- Vol. 161, 62-70
Isothermal (vapor + liquid) equilibrium measurements and correlation of the binary mixture 3,3,3-trifluoropropene (R1243zf) + isobutane (R600a) at temperatures from to K- 1 March 2024
- Published by Elsevier in International Journal of Refrigeration
- Vol. 161, 62-70
Open AccessIsothermal (vapor + liquid) equilibrium measurements and correlation of the binary mixture 3,3,3-trifluoropropene (R1243zf) + isobutane (R600a) at temperatures from to K