Navita Jakhar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Navita Jakhar has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Dinesh Kumar Kedia
Department of Physics, Indian Institute of Science Education and Research , Dr. Homi Bhabha Road, Pune 411 008, India
4 shared publications - Surjeet Singh
Department of Physics Indian Institute of Science Education and Research 411008 Pune Maharashtra India
4 shared publications - Ankit Kumar
School of Engineering, University of Warwick, Coventry, CV4 7AL, UK
2 shared publications Ankit Kumar
Department of Physics, Indian Institute of Science Education and Research Pune , Dr. Homi Bhabha Road, Pune 411008, India
1 shared publication- Ankita Katre
Department of Scientific Computing, Modeling and Simulation, SP Pune University, Pune 411007, India
1 shared publication - Kumar Saurabh
Department of Physics, Indian Institute of Science Education and Research, Dr. Homi Bhabha Road, Pune 411 008, India
1 shared publication
Latest Publications
- 1 March 2025
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 96 (3)
Advancing precision in Hall effect through localized heating with a compact design
We have developed a versatile, fully automated Hall measurement setup for operations between room temperature and 750 K and in magnetic fields up to ±10 kOe. Our compact sample holder design with localized heating and minimal heat losses enables precise temperature stability (better than ±10 mK at 750 K) and low power consumption (20–25 W). The setup is housed within a 26 mm air gap between the pole pieces of an electromagnet. The sample holder, enclosed in a quartz tube for a controlled atmosphere, can accommodate various sample shapes and sizes, which can be contacted using adjustable pressure-point contacts. Despite its compact size, bulk thermoelectric samples measuring up to 10 mm laterally can be analyzed successfully. A phase-sensitive lock-in technique and electromagnetic shielding ensure excellent sensitivity, allowing nanovolt Hall signal measurements in high-carrier-concentration samples. We have successfully applied this setup to diverse materials, including a lightly doped germanium (1014 cm−3), degenerate semiconductors from the half-Heusler family (1021 cm−3), and superionic thermoelectrics (1018 cm−3), demonstrating its versatility and reliability. Our results align well with those from commercial systems where available.
- 1 March 2025
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 96 (3)
Advancing precision in Hall effect through localized heating with a compact design
We have developed a versatile, fully automated Hall measurement setup for operations between room temperature and 750 K and in magnetic fields up to ±10 kOe. Our compact sample holder design with localized heating and minimal heat losses enables precise temperature stability (better than ±10 mK at 750 K) and low power consumption (20–25 W). The setup is housed within a 26 mm air gap between the pole pieces of an electromagnet. The sample holder, enclosed in a quartz tube for a controlled atmosphere, can accommodate various sample shapes and sizes, which can be contacted using adjustable pressure-point contacts. Despite its compact size, bulk thermoelectric samples measuring up to 10 mm laterally can be analyzed successfully. A phase-sensitive lock-in technique and electromagnetic shielding ensure excellent sensitivity, allowing nanovolt Hall signal measurements in high-carrier-concentration samples. We have successfully applied this setup to diverse materials, including a lightly doped germanium (1014 cm−3), degenerate semiconductors from the half-Heusler family (1021 cm−3), and superionic thermoelectrics (1018 cm−3), demonstrating its versatility and reliability. Our results align well with those from commercial systems where available.
- Open Access
- 27 November 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (22)
Erratum: “Grain boundary engineering in metavalent SnTe: A simplified approach” [Appl. Phys. Lett. 123, 173901 (2023)]
Note that in Ref. 1, in Fig. 3(f), the legends are incorrect. The corrected Fig. 3(f) is shown below.
- 27 November 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (22)
Open AccessErratum: “Grain boundary engineering in metavalent SnTe: A simplified approach” [Appl. Phys. Lett. 123, 173901 (2023)]
Note that in Ref. 1, in Fig. 3(f), the legends are incorrect. The corrected Fig. 3(f) is shown below.
- Open Access
- 23 October 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (17)
Grain boundary engineering in metavalent SnTe: A simplified approach
The metavalently bonded SnTe has gathered enormous attention recently as an environmentally friendly alternative to PbTe. While some of the issues with SnTe, including its small bandgap and large valence band offset, have largely been resolved, its relatively high lattice thermal conductivity (κl) has remained a matter of concern. Here, we show that the temperature-induced vacancy migration in SnTe results in the growth of SnTe nanoparticles in the intergrain region. The enhanced grain boundary scattering due to this led to a highly reduced κl and increased carrier mobility, enhancing the zT of our SnTe by almost 70% over the zT of various SnTe ingot samples from this and several previous studies. The validity of this approach was further confirmed for a 3% Ag-doped SnTe sample, a composition well-investigated in the past. The simplicity and effectiveness of our approach enhance the prospect of SnTe for practical applications.
- 23 October 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (17)
Open AccessGrain boundary engineering in metavalent SnTe: A simplified approach
The metavalently bonded SnTe has gathered enormous attention recently as an environmentally friendly alternative to PbTe. While some of the issues with SnTe, including its small bandgap and large valence band offset, have largely been resolved, its relatively high lattice thermal conductivity (κl) has remained a matter of concern. Here, we show that the temperature-induced vacancy migration in SnTe results in the growth of SnTe nanoparticles in the intergrain region. The enhanced grain boundary scattering due to this led to a highly reduced κl and increased carrier mobility, enhancing the zT of our SnTe by almost 70% over the zT of various SnTe ingot samples from this and several previous studies. The validity of this approach was further confirmed for a 3% Ag-doped SnTe sample, a composition well-investigated in the past. The simplicity and effectiveness of our approach enhance the prospect of SnTe for practical applications.
- Open Access
- 17 April 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (16)
Reproducible high thermoelectric figure of merit in Ag2Se
Ag2Se is a potentially useful material with interesting magnetoresistive and thermoelectric properties. In several recent studies, the thermoelectric figure of merit (zT) of Ag2Se has been shown to approach 1 near 380 K (i.e., about 25 K below its superionic transition temperature). However, what plagues the use of Ag2Se in real life applications is its sample dependence and very poor reproducibility. In a recent work, it is clearly established that the root cause of this is Ag migration during high-temperature sintering or melting. Here, we show that high-density Ag2Se samples with high and reproducible zT (0.92 at 370 K) can be prepared by simple all-room-temperature techniques. The ease of sample preparation and high zT along with excellent reproducibility make Ag2Se a promising material for near-room-temperature applications.
- 17 April 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (16)
Open AccessReproducible high thermoelectric figure of merit in Ag2Se
Ag2Se is a potentially useful material with interesting magnetoresistive and thermoelectric properties. In several recent studies, the thermoelectric figure of merit (zT) of Ag2Se has been shown to approach 1 near 380 K (i.e., about 25 K below its superionic transition temperature). However, what plagues the use of Ag2Se in real life applications is its sample dependence and very poor reproducibility. In a recent work, it is clearly established that the root cause of this is Ag migration during high-temperature sintering or melting. Here, we show that high-density Ag2Se samples with high and reproducible zT (0.92 at 370 K) can be prepared by simple all-room-temperature techniques. The ease of sample preparation and high zT along with excellent reproducibility make Ag2Se a promising material for near-room-temperature applications.
- Open Access
Synergistic approach towards reproducible high zT in superionic thermoelectric Ag2Te
Recently, the superionic thermoelectrics, which typify the novel `phonon-liquid electron-crystal' concept, have attracted enormous attention due to their ultralow thermal conductivity and high figure-of-merit (zT). However, their high zT is generally obtained deep inside the superionic phase, e.g., near 1000~K in the Cu$_2$X (X: chalcogen atom) family where the superionic transition is close to 400~K. At such high temperatures, the liquid-like flow of the metal ions under an electric field or a temperature gradient, both of which are integral to the working of a thermoelectric device, results in device degradation. To harness the full potential of the superionic thermoelectrics, it is, therefore, necessary to reach high zT at low temperatures where the metal-ion diffusion is not an issue. Here, we present a novel all-room-temperature route to fabricate 100\% dense, nanostructured Ag$_2$Te with highly reproducible thermoelectric properties and a high zT of 1.2 at 570~K, i.e., merely 150~K above its superionic transition. The samples show a broad particle-size distribution ranging from a few nm to a few $\mu$m. This hierarchical nanostructuring is shown to suppress the thermal conductivity of Ag$_2$Te beyond the phonon-liquid electron-crystal limit to ultralow values, leading to a remarkable enhancement of 87\% in the zT over that of the ingot sample. These values supersede the zT of any Ag$_2$Te previously reported. Our results are supported by first-principles density functional theory calculations of the electronic and thermal properties.
Open AccessSynergistic approach towards reproducible high zT in superionic thermoelectric Ag2Te
Recently, the superionic thermoelectrics, which typify the novel `phonon-liquid electron-crystal' concept, have attracted enormous attention due to their ultralow thermal conductivity and high figure-of-merit (zT). However, their high zT is generally obtained deep inside the superionic phase, e.g., near 1000~K in the Cu$_2$X (X: chalcogen atom) family where the superionic transition is close to 400~K. At such high temperatures, the liquid-like flow of the metal ions under an electric field or a temperature gradient, both of which are integral to the working of a thermoelectric device, results in device degradation. To harness the full potential of the superionic thermoelectrics, it is, therefore, necessary to reach high zT at low temperatures where the metal-ion diffusion is not an issue. Here, we present a novel all-room-temperature route to fabricate 100\% dense, nanostructured Ag$_2$Te with highly reproducible thermoelectric properties and a high zT of 1.2 at 570~K, i.e., merely 150~K above its superionic transition. The samples show a broad particle-size distribution ranging from a few nm to a few $\mu$m. This hierarchical nanostructuring is shown to suppress the thermal conductivity of Ag$_2$Te beyond the phonon-liquid electron-crystal limit to ultralow values, leading to a remarkable enhancement of 87\% in the zT over that of the ingot sample. These values supersede the zT of any Ag$_2$Te previously reported. Our results are supported by first-principles density functional theory calculations of the electronic and thermal properties.