KZKaitian Zhang

Kaitian Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Kaitian Zhang has a total of 22 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Metalorganic chemical vapor deposition of β-(Al)Ga2O3 on (001) β-Ga2O3 substrates

    by Mosarof Hossain Sarkar, Dong Su Yu, Kaitian Zhang, Sadikul Alam, Mehidi Hassan, Minhazul Islam, Jinwoo Hwang, Hongping Zhao

    β-Ga2O3 and its alloys are promising for next-generation high-power electronic devices, but realizing high-quality thick epitaxial layers with smooth morphology at high growth rates remains a major challenge. In this study, we systematically investigated the metalorganic chemical vapor deposition (MOCVD) growth of β-Ga2O3 on edge-defined film-fed growth (EFG, Sn doped) and vertical bridgman (VB, Fe doped) (001) β-Ga2O3 substrates. (001) β-Ga2O3 films grown on both substrates show similar cracking issue. Films grown on EFG substrates show lower atomic force microscopy roughness as compared to those grown on VB substrates. X-ray diffraction (XRD) measurements indicate lower crystalline quality in films grown on VB substrates compared to films grown on EFG substrates. XRD rocking curves also illustrate that films grown on VB substrates have higher structural anisotropy. From cross-sectional scanning transmission electron microscopy (STEM) imaging, surface reconstruction occurred at the growth interface for both EFG and VB substrates. MOCVD growth of β-(Al0.0625Ga0.9375)2O3 on (001) β-Ga2O3 substrates indicate crack-free layers can be grown up to 6 μm at a growth rate of 4.5 μm/h. STEM atomic-scale analysis revealed a uniform Al-distributed interfacial layer at the growth interface followed with an Al-segregated region aligning along the (1¯01) plane. Electrical measurements revealed low mobility in thick (001) AlGaO layers which is due to crystal rotation and Al segregation. These results provide understanding of MOCVD growth of (001) β-Ga2O3 and (001) β-(AlxGa1−x)2O3 films at fast growth rates and insights into the interplay of growth chemistry, substrate selection, and alloy incorporation.


  • Open Access

    Experimental analysis of potential origin of p-type conductivity in LiGa5O8

    by Kaitian Zhang, Vijay Gopal Thirupakuzi Vangipuram, Hongping Zhao

    Recently, LiGa5O8, with a bandgap of ∼5.4 eV, has been demonstrated as a p-type semiconductor, which can be used to form a pn junction with β-Ga2O3. However, the occurrence of the p-type conductivity remains undetermined. In this work, the influence of as-grown film compositions and post-growth annealing on the p-type conductivity were investigated. The results indicate that oxygen vacancies play an important role in achieving p-type conductivity, as films with lower oxygen content exhibit higher hole concentrations under Li-poor conditions. The impact of different annealing atmospheres was also studied, finding that argon annealing enhances hole conductivity without altering film composition, while oxygen annealing reduces p-conductivity. In addition, the uniformity of Li distribution in the films was confirmed via secondary ion mass spectrometry (SIMS) depth profiling. The effect of unintentional Cr impurity incorporation was probed via cathodoluminescence (CL), concluding that Cr impurity led to strong luminescence at 716 nm but did not show impact on p-type behavior. Results from this work provide a deeper understanding of the fundamental properties of LiGa5O8, paving the way for its integration into advanced power electronic devices.


  • Open Access

    Ultrawide bandgap LiGa5O8/β-Ga2O3 heterojunction p–n diodes

    by Vijay Gopal Thirupakuzi Vangipuram, Kaitian Zhang, Dong Su Yu, Lingyu Meng, Christopher Chae, Yibo Xu, Jinwoo Hwang, Wu Lu, Hongping Zhao

    Ultrawide bandgap (UWBG) semiconductor β-phase Ga2O3 has attracted significant interest for potential power electronics applications. This, however, is hindered by the lack of effective p-type dopants in β-Ga2O3. A p–n heterojunction utilizing the recently discovered UWBG p-type LiGa5O8 in conjunction with n-type (010) β-Ga2O3 is demonstrated in this work. Ohmic contacts to the UWBG p-type material, LiGa5O8, were achieved via a combinational Pt/Ni/Au metal stack. Obvious improvement in contact resistance was observed with annealing of the contact metal at 375 °C for 1 min in N2 ambient. Rectifying characteristics with a turn-on voltage of 5.46 V and an ideality factor of 2.78 were extracted from the p-LiGa5O8/n-Ga2O3 heterojunction. Current density change of more than 7 orders of magnitude was obtained between the off-state and on-state of the diodes measured. This work provides a potential pathway to fully utilize the high breakdown field associated with β-Ga2O3 for high power device applications with a p-type material that has an even wider bandgap (and therefore a potentially higher breakdown field) than β-Ga2O3.


  • Wet and dry etching of ultrawide bandgap LiGa5O8 and LiGaO2

    by Vijay Gopal Thirupakuzi Vangipuram, Kaitian Zhang, Hongping Zhao

    Crystalline thin films of LiGa5O8 have recently been realized through epitaxial growth via mist-chemical vapor deposition. The single crystal, spinel cubic LiGa5O8 films show promising fundamental material properties and, therefore, make LiGa5O8 a potential enabling material for power electronics. In this work, chemical resistance and etch susceptibility were investigated for the first time on crystalline LiGa5O8 thin films with various wet chemistries. It was found that LiGa5O8 is very chemically resistive to acid solutions, with no apparent etching effects observed when placed in concentrated acid solutions of HCl, H2SO4, HF, or H3PO4 at room temperature. In contrast, orthorhombic (010) LiGaO2 shows effective etching in HCl solutions at varying dilution concentrations, with etch rates measured between 8.6 [1000:1 (DI water: HCl concentration)] and 6092 nm/min (37 wt. % HCl). The inductively coupled plasma reactive ion etching (ICP-RIE) of LiGa5O8 using BCl3/Ar and CF4/Ar/O2 gas chemistries was investigated. The etching rate and surface morphology of etched surfaces were examined as a function of RIE and ICP power. Using a CF4/Ar/O2 gas chemistry with an RIE power of 75 W and an ICP power of 300 W resulted in smooth etched planar surfaces while maintaining an etch rate of ∼24.6 nm/min. Similar dry etching studies were performed for LiGaO2. It was found that the BCl3/Ar gas chemistry was better suited for LiGaO2 etching, with similar surface morphology quality being obtained after etching as prior etching when a RIE power of 15 W and an ICP power of 400 W is utilized.


  • Experimental determination of the band offsets at the UWBG p-LiGa5O8/Ga2O3 interface

    by Kaitian Zhang, Vijay Gopal Thirupakuzi Vangipuram, Christopher Chae, Jinwoo Hwang, Hongping Zhao

    LiGa5O8, a recently discovered ultrawide bandgap semiconductor exhibiting p-type conductivity at room temperature, is grown on (010) β-Ga2O3 substrate. Utilizing a mist chemical vapor deposition method, LiGa5O8 thin film grown on insulating Ga2O3 substrate exhibits hole concentration ∼2.31 × 1018 cm−3 and hole mobility ∼2.07 cm2/V s. The resulting heterostructure is characterized comprehensively. A smooth, uniform film growth was observed by scanning electron microscopy and atomic force microscopy imaging. Cross-sectional scanning transmission electron microscopy and x-ray diffraction confirm the growth of spinel cubic crystal structure of LiGa5O8 along the [110] direction. Moreover, the valence and conduction band offsets at p-LiGa5O8/β-Ga2O3 heterointerface were determined via x-ray photoelectron spectroscopy. The determined band alignments at LiGa5O8/β-Ga2O3 interface reveal the formation of a type-II (staggered) heterojunction. The experimental measurements provide valuable parameters of the band offsets at the heterointerface, addressing a crucial aspect for future power electronic device design and fabrication based on β-Ga2O3 ultrawide bandgap semiconductors.


  • Open Access

    Effect of varying threading dislocation densities on the optical properties of InGaN/GaN quantum wells with intentionally created V-shaped pits

    by Kaitian Zhang, Chenxi Hu, Vijay Gopal Thirupakuzi Vangipuram, Lingyu Meng, Christopher Chae, Menglin Zhu, Jinwoo Hwang, Kathleen Kash, Hongping Zhao

    The effect of varying threading dislocation densities on the internal quantum efficiencies (IQEs) of InGaN quantum wells (QWs), with and without intentionally created “V-pits,” is reported here. InGaN QW samples grown on GaN-on-sapphire templates with threading dislocation densities of <1 × 108 and <1 × 109 cm−2 are compared, with and without GaN/InGaN superlattice (SL) layers incorporated to intentionally open up the threading dislocation cores and form large-size “V-pits.” The formation of “V-pits” is confirmed by cross-sectional transmission electron microscopy to initiate from threading dislocations in the SL layers. The densities of the pits are confirmed by plan-view SEM to agree with the substrate threading dislocation densities. The experimental room temperature IQEs of the “V-pit” QW samples are enhanced to 15% ± 1% compared to 6% ± 2% for conventional QW samples. Both conventional and “V-pit” samples show insensitivity to the magnitude of the dislocation densities with respect to IQE performance, while the “V-pit” samples show shifts in the peak emission wavelengths compared to the conventional samples, attributed to strain modulation. This study provides additional understanding of the causes of the observed insensitivity of the IQEs to different threading dislocation densities.


  • Improved Design and Research of a New Type of Bubble Separation Device

    by Kaitian Zhang, Jing Liang, Hui Xue, Kang Liu, Mengnan Yao, Qiyue Guo

    With the improvement of living standards, the development of human industry has brought a lot of problems to the environment, especially soil and water pollution. Therefore, rapid detection of harmful substances is of great significance. At present, flow injection method is commonly used in the world, which can be used for rapid and accurate detection of water quality. One of the more important links is the separation of gas and liquid. Based on the existing gas-liquid separation devices on the market, this paper optimizes the design of a high-efficiency gas-liquid separation device for flow injection, which can quickly peel the gas from the liquid in the detection process. Through the analysis of the gas-liquid flow path, the separation mode and mechanism are studied, and the simulation of the gas-liquid separator and the real experiment test have achieved the ideal effect, thus verifying the feasibility of its optimal design. This paper describes the gas-liquid separation device including mechanical design, flow path analysis, simulation and experimental verification.

  • Open Access

    Investigation of carbon incorporation in laser-assisted MOCVD of GaN

    by Yuxuan Zhang, Vijay Gopal Thirupakuzi Vangipuram, Kaitian Zhang, Hongping Zhao

    Background carbon (C) impurity incorporation in metalorganic chemical vapor deposition (MOCVD) grown gallium nitride (GaN) represents one of the major issues in further improving GaN vertical power device performance. This work presents a laser-assisted MOCVD (LA-MOCVD) technique to address the high-C issue in MOCVD homoepitaxial GaN under different growth rate (Rg) regimes and studies the correlations between [C] and Rg. [C] in LA-MOCVD GaN is reduced by 50%–90% as compared to the conventional MOCVD GaN for a wide growth rate range between 1 and 16 μm/h. A mass-transport based model is developed to understand the C incorporation at different Rg regimes. The results obtained from the developed model are in good agreement with experimental data. The model further reveals that LA-MOCVD effectively suppresses C incorporation by reducing the active C species in the gas phase. Moreover, high step velocity in step flow growth mode can facilitate C incorporation at fast Rg, exhibiting steeper C increase. The theoretical model indicates that [C] can be suppressed below 1016 cm−3 with a fast growth rate (Rg) of 10 μm/h by utilizing higher power LA-MOCVD and freestanding GaN substrates with larger off-cut angles.