Nurulhuda Abdullah
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Nurulhuda Abdullah has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Aziana Abu Hassan
Malaysian Rubber Board, RRIM Research Station, Sungai Buloh, Malaysia
2 shared publications Kok Lang Mok
Technology and Engineering Division, Malaysian Rubber Board, Sungai Buloh, Malaysia
2 shared publicationsNurul Hayati Yusof
Technology and Engineering Division, Malaysian Rubber Board, Sungai Buloh, Malaysia
2 shared publicationsA. H. Aziana
Malaysian Rubber Board, RRIM Research Station
1 shared publicationA. Nur Aziah
Malaysian Rubber Board, RRIM Research Station
1 shared publicationA. R. Norazreen
Malaysian Rubber Board, RRIM Research Station
1 shared publication
Latest Publications
- 15 May 2025
- Published by Springer Nature in Journal of Rubber Research
- Vol. 28 (2) , 239-253
Parameter manipulation study in producing thinner natural rubber films via response surface methodology
- 15 May 2025
- Published by Springer Nature in Journal of Rubber Research
- Vol. 28 (2) , 239-253
Parameter manipulation study in producing thinner natural rubber films via response surface methodology
- Open Access
- 2 June 2024
- Published by Akademia Baru Publishing in Journal of Advanced Research in Applied Mechanics
- Vol. 118 (1) , 1-12
Preparation and Characterization of Poly(Methyl Methacrylate) Grafted Natural Rubber Latex Films
Poly(methyl methacrylate) (PMMA) grafted natural rubber (NR) latex was successfully prepared and solely exploited even at high MMA concentration (1.5 mol/kg-rubber) to make coherent and uniform vulcanized films without blending with other polymer to achieve excellent physical properties. High ammonia natural rubber (HANR) latex was subjected to graft-copolymerization with methyl methacrylate (MMA) monomer in the presence of tert-butyl hydroperoxide (TBHP) and tetraethylenepentamine (TEPA). High conversion, i.e., 85.12 mol%, and grafting efficiency, i.e., 92.70 mol%, were obtained at 1.5 mol/kg-rubber MMA. The resulting gross PMMA grafted NR (1.5PMMA) latex was then compounded, dipped, and vulcanized to produce thin films. The tensile strength and modulus at 300 percent (M300) of vulcanized 1.5PMMA film were superior to vulcanized HANR film by 1-fold. While elongation at break (EB) was identical to each other due to the high gel content in both vulcanized films. Besides, the vulcanized 1.5PMMA film absorbed less oil compared to HANR film. The thermal stability of vulcanized 1.5PMMA film was found to be higher than that of vulcanized HANR film. Hence, it can be deduced that controlling the graft-copolymerization of PMMA in NR latex is the key to produce coherent thin films with improved properties at higher PMMA content.
- 2 June 2024
- Published by Akademia Baru Publishing in Journal of Advanced Research in Applied Mechanics
- Vol. 118 (1) , 1-12
Open AccessPreparation and Characterization of Poly(Methyl Methacrylate) Grafted Natural Rubber Latex Films
Poly(methyl methacrylate) (PMMA) grafted natural rubber (NR) latex was successfully prepared and solely exploited even at high MMA concentration (1.5 mol/kg-rubber) to make coherent and uniform vulcanized films without blending with other polymer to achieve excellent physical properties. High ammonia natural rubber (HANR) latex was subjected to graft-copolymerization with methyl methacrylate (MMA) monomer in the presence of tert-butyl hydroperoxide (TBHP) and tetraethylenepentamine (TEPA). High conversion, i.e., 85.12 mol%, and grafting efficiency, i.e., 92.70 mol%, were obtained at 1.5 mol/kg-rubber MMA. The resulting gross PMMA grafted NR (1.5PMMA) latex was then compounded, dipped, and vulcanized to produce thin films. The tensile strength and modulus at 300 percent (M300) of vulcanized 1.5PMMA film were superior to vulcanized HANR film by 1-fold. While elongation at break (EB) was identical to each other due to the high gel content in both vulcanized films. Besides, the vulcanized 1.5PMMA film absorbed less oil compared to HANR film. The thermal stability of vulcanized 1.5PMMA film was found to be higher than that of vulcanized HANR film. Hence, it can be deduced that controlling the graft-copolymerization of PMMA in NR latex is the key to produce coherent thin films with improved properties at higher PMMA content.
- 18 April 2023
- Published by Springer Nature in Journal of Rubber Research
- Vol. 26 (2) , 125-137
An experimental study using 3-aminoproplymethyldiethoxysilane (APMDS) to improve biocompatibility of NR latex film
- 18 April 2023
- Published by Springer Nature in Journal of Rubber Research
- Vol. 26 (2) , 125-137
An experimental study using 3-aminoproplymethyldiethoxysilane (APMDS) to improve biocompatibility of NR latex film
- 8 January 2022
- Published by Elsevier in Industrial Crops and Products
- Vol. 177, 114470
Lysozymes from natural rubber latex (Hevea brasiliensis): Assay development and recovery using ammonium sulphate and surfactant precipitations
- 8 January 2022
- Published by Elsevier in Industrial Crops and Products
- Vol. 177, 114470
Lysozymes from natural rubber latex (Hevea brasiliensis): Assay development and recovery using ammonium sulphate and surfactant precipitations
- 13 June 2019
- Published by Springer Nature in Journal of Rubber Research
- Vol. 22 (2) , 99-107
Urea as a single denaturing agent in deproteinisation of natural rubber latex
- 13 June 2019
- Published by Springer Nature in Journal of Rubber Research
- Vol. 22 (2) , 99-107
Urea as a single denaturing agent in deproteinisation of natural rubber latex
- 13 July 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1985 (1) , 040001
Implication of enzymatic and chemical treatment on high ammoniated natural rubber latex
Enzymatic treatment is commonly applied in natural rubber latex (NRL) to produce deproteinized natural rubber (DPNR). The enzyme plays an essential role in degrading the protein molecules into smaller fragments thus easily removed during processing. The DPNR is an alternative raw material of rubber with minimal amount of protein and other non-rubber components which enhances the value of rubber in certain specialized products. Application of DPNR for latex dipped products was initiated as an option to tackle the allergenic issue of NRL glove. However, these ‘low protein latex’ or DPNR-Latex (DPNR-L) have been reported to give uncertain and at times poorer mechanical property and stability. The destabilization of NRL occurs from a build-up of volatile fatty acids (VFA) resulted from microbial metabolic activities. Hence, ammonia is used to stabilize the NRL. In this study, the fundamental approach of making DPNR-L from high ammoniated NRL (HA-NRL) via enzymatic (alcalase and pepsin) and chemical (urea) treatment was conducted. Effect of alcalase, pepsin and urea on the protein content and allergenicity in HA-NRL were studied and discussed. The mechanical property and stability were also evaluated to determine the suitability of the treated HA-NRL use for latex dipped product. Efficiency of alcalase in deactivation of allergenicity was rather good. However alteration in the protein biological structure is detrimental to the latex mechanical property. Meanwhile, the presence of pepsin in HA-NRL caused protein aggregations. As a consequent, insignificant increment of allergenic proteins was detected. Interestingly, the mechanical strength of HA-NRL treated with pepsin was 20% higher than the untreated latex. Treatment with urea shows approximately similar effect as pepsin. Unfortunately, none of these materials could stand alone as protein denaturing agent and mechanical property booster. However, these results proved that the presence of proteins is crucial to NRL mechanical property and that the enzymes and urea could be used to treat HA-NRL based on the purpose of the product application.
- 13 July 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1985 (1) , 040001
Implication of enzymatic and chemical treatment on high ammoniated natural rubber latex
Enzymatic treatment is commonly applied in natural rubber latex (NRL) to produce deproteinized natural rubber (DPNR). The enzyme plays an essential role in degrading the protein molecules into smaller fragments thus easily removed during processing. The DPNR is an alternative raw material of rubber with minimal amount of protein and other non-rubber components which enhances the value of rubber in certain specialized products. Application of DPNR for latex dipped products was initiated as an option to tackle the allergenic issue of NRL glove. However, these ‘low protein latex’ or DPNR-Latex (DPNR-L) have been reported to give uncertain and at times poorer mechanical property and stability. The destabilization of NRL occurs from a build-up of volatile fatty acids (VFA) resulted from microbial metabolic activities. Hence, ammonia is used to stabilize the NRL. In this study, the fundamental approach of making DPNR-L from high ammoniated NRL (HA-NRL) via enzymatic (alcalase and pepsin) and chemical (urea) treatment was conducted. Effect of alcalase, pepsin and urea on the protein content and allergenicity in HA-NRL were studied and discussed. The mechanical property and stability were also evaluated to determine the suitability of the treated HA-NRL use for latex dipped product. Efficiency of alcalase in deactivation of allergenicity was rather good. However alteration in the protein biological structure is detrimental to the latex mechanical property. Meanwhile, the presence of pepsin in HA-NRL caused protein aggregations. As a consequent, insignificant increment of allergenic proteins was detected. Interestingly, the mechanical strength of HA-NRL treated with pepsin was 20% higher than the untreated latex. Treatment with urea shows approximately similar effect as pepsin. Unfortunately, none of these materials could stand alone as protein denaturing agent and mechanical property booster. However, these results proved that the presence of proteins is crucial to NRL mechanical property and that the enzymes and urea could be used to treat HA-NRL based on the purpose of the product application.
- 1 January 2017
- Published by AIP Publishing in AIP Conference Proceedings
Effect of different concentrations of sodium dodecyl sulfate and additional anionic surfactant on properties of low protein natural rubber latex
This paper describes the chemical deproteinization process of natural rubber latex (NRL) using chemical denaturants namely urea and sodium dodecyl sulfate (SDS). Commercial high ammoniated natural rubber latex (HANRL) was incubated with both denaturants – urea and SDS for selected period of time before centrifugation and characterization. The role of SDS in NRL deproteinization process was further elucidated by manipulating the concentration of SDS at 0.3 phr and 0.5 phr during the incubation process. It was found that the physical properties of NRL especially stability, were governed by the amount of SDS, whereby higher concentration of SDS used led to greater NRL stability. However, too much concentration of SDS in the system might cause detrimental effect on the properties of low protein NRL. The effects of additional anionic surfactant namely potassium laurate on the physical properties of low protein NRL and its stabilization were also scrutinized. Characterizations include nitrogen determination by Kjeldahl method, zeta potential, and morphological analysis by Field Emission Scanning Electron Microscopy (FESEM).
- 1 January 2017
- Published by AIP Publishing in AIP Conference Proceedings
Effect of different concentrations of sodium dodecyl sulfate and additional anionic surfactant on properties of low protein natural rubber latex
This paper describes the chemical deproteinization process of natural rubber latex (NRL) using chemical denaturants namely urea and sodium dodecyl sulfate (SDS). Commercial high ammoniated natural rubber latex (HANRL) was incubated with both denaturants – urea and SDS for selected period of time before centrifugation and characterization. The role of SDS in NRL deproteinization process was further elucidated by manipulating the concentration of SDS at 0.3 phr and 0.5 phr during the incubation process. It was found that the physical properties of NRL especially stability, were governed by the amount of SDS, whereby higher concentration of SDS used led to greater NRL stability. However, too much concentration of SDS in the system might cause detrimental effect on the properties of low protein NRL. The effects of additional anionic surfactant namely potassium laurate on the physical properties of low protein NRL and its stabilization were also scrutinized. Characterizations include nitrogen determination by Kjeldahl method, zeta potential, and morphological analysis by Field Emission Scanning Electron Microscopy (FESEM).