A. Harish Kumar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
A. Harish Kumar has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Diana Daniel
The Oxford Dental College, Rajiv Gandhi University of Health Science, Bengaluru, India
1 shared publication - Gwen R. J. Swennen
Division of Maxillo-Facial Surgery, Department of Surgery, General Hospital St-Jan Bruges, Ruddershove, Bruges, Belgium
1 shared publication - Jerin Jose
Nurture Multispeciality Dental Clinic - Panathur Bangalore, Bengaluru, India
1 shared publication - Supriya Bhandage
Department of Oral and Maxillofacial Surgery, The Oxford Dental College, Bangalore, India
1 shared publication - Vinayaka T. Banakar
Department of Oral and Maxillofacial Surgery, The Oxford Dental College, Bangalore, India
1 shared publication
Latest Publications
- 7 September 2023
- Published by Springer Nature in Journal of Maxillofacial and Oral Surgery
- Vol. 22 (4) , 856-860
Resistance and Stress Analysis of 3D Plate and Locking Plate Fixation in Bilateral Sagittal Split Osteotomy: A Comparative Finite Element Study
Aim This study evaluates the biomechanical properties of 3D plates and compares it with locking plates, in both set back and advancement models of bilateral sagittal split osteotomy (BSSO) using finite element model analysis. Design A stereolithography model of mandibular structure was imported to hypermesh to create 3D solid finite model. A BSSO was simulated on hemimandibular model and advancement and setback simulations were carried out for a distance of 4, 6, and 8 mm each. 3D plates for the right side and locking plates for the left side were simulated for fixation. Meshing of the model was carried out. After meshing, the model was imported to Ansys V18.1 for analysis of it. Forces simulating the masticatory muscles were applied on both sides. The values for stress and resistance in the screws and plates were measured and the lowest and highest deformation regions were estimated using von Mises analysis. Results The results suggest that the tension and resistance as measured through were better distributed in 3D plates when compared with that of locking plates; the stress concentration was shown to be higher in the locking plates and deformation resistance was greater in 3D plates. Conclusion The application of 3D plating system has found its place in the field of maxillofacial trauma. However, its application in the field of orthognathic surgery is yet to be explored and this study encourages us to conduct in vivo studies.
- 7 September 2023
- Published by Springer Nature in Journal of Maxillofacial and Oral Surgery
- Vol. 22 (4) , 856-860
Resistance and Stress Analysis of 3D Plate and Locking Plate Fixation in Bilateral Sagittal Split Osteotomy: A Comparative Finite Element Study
Aim This study evaluates the biomechanical properties of 3D plates and compares it with locking plates, in both set back and advancement models of bilateral sagittal split osteotomy (BSSO) using finite element model analysis. Design A stereolithography model of mandibular structure was imported to hypermesh to create 3D solid finite model. A BSSO was simulated on hemimandibular model and advancement and setback simulations were carried out for a distance of 4, 6, and 8 mm each. 3D plates for the right side and locking plates for the left side were simulated for fixation. Meshing of the model was carried out. After meshing, the model was imported to Ansys V18.1 for analysis of it. Forces simulating the masticatory muscles were applied on both sides. The values for stress and resistance in the screws and plates were measured and the lowest and highest deformation regions were estimated using von Mises analysis. Results The results suggest that the tension and resistance as measured through were better distributed in 3D plates when compared with that of locking plates; the stress concentration was shown to be higher in the locking plates and deformation resistance was greater in 3D plates. Conclusion The application of 3D plating system has found its place in the field of maxillofacial trauma. However, its application in the field of orthognathic surgery is yet to be explored and this study encourages us to conduct in vivo studies.
- 20 November 2019
- Published by Springer Nature in Journal of Maxillofacial and Oral Surgery
- Vol. 20 (1) , 83-89
Is Salivary Sialic Acid a Reliable Biomarker in the Detection of Oral Potentially Malignant Disorder and Oral Squamous Cell Carcinoma
Purpose Glycoprotein is an important constituent of saliva, and the observed increase in salivary glycoproteins such as sialic acid in oral potentially malignant disorder (OPMDs) and OSCC has stimulated the interest of researchers to explore it as a possible biomarker. Methods The study used 60 subjects, who were divided into three groups: Group I—20 subjects who were clinically and histopathologically diagnosed with OSCC; Group II—20 subjects who were clinically and histopathologically diagnosed with OPMDs; and Group III—20 healthy subjects with good oral hygiene and with no systemic disorders detected. Two millilitres of unstimulated salivary samples was collected in a pre-sterilized container to analyse total salivary sialic acid (TSA) levels using a sialic acid kit and UV spectrophotometer. Results The TSA levels in OSCC (545.45 ± 100.04) were much higher when compared to the level in OPMDs (169.80 ± 66.43) and in healthy subjects (25.45 ± 16.07). Statically significant correlation was observed between different grades of OSCC. Moreover, sialic acid showed 100% sensitivity and specificity between all the three groups. Statistical analysis was done with Kruskal–Wallis, followed by Mann–Whitney post hoc test at P < 0.05. The results suggested the utility of sialic acid as an efficient biomarker.
- 20 November 2019
- Published by Springer Nature in Journal of Maxillofacial and Oral Surgery
- Vol. 20 (1) , 83-89
Is Salivary Sialic Acid a Reliable Biomarker in the Detection of Oral Potentially Malignant Disorder and Oral Squamous Cell Carcinoma
Purpose Glycoprotein is an important constituent of saliva, and the observed increase in salivary glycoproteins such as sialic acid in oral potentially malignant disorder (OPMDs) and OSCC has stimulated the interest of researchers to explore it as a possible biomarker. Methods The study used 60 subjects, who were divided into three groups: Group I—20 subjects who were clinically and histopathologically diagnosed with OSCC; Group II—20 subjects who were clinically and histopathologically diagnosed with OPMDs; and Group III—20 healthy subjects with good oral hygiene and with no systemic disorders detected. Two millilitres of unstimulated salivary samples was collected in a pre-sterilized container to analyse total salivary sialic acid (TSA) levels using a sialic acid kit and UV spectrophotometer. Results The TSA levels in OSCC (545.45 ± 100.04) were much higher when compared to the level in OPMDs (169.80 ± 66.43) and in healthy subjects (25.45 ± 16.07). Statically significant correlation was observed between different grades of OSCC. Moreover, sialic acid showed 100% sensitivity and specificity between all the three groups. Statistical analysis was done with Kruskal–Wallis, followed by Mann–Whitney post hoc test at P < 0.05. The results suggested the utility of sialic acid as an efficient biomarker.