Hiroki Hayashi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hiroki Hayashi has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Kazuya Ando
Keio University
8 shared publications - Dongwook Go
Forschungszentrum Jülich and JARA
4 shared publications - Yuriy Mokrousov
Forschungszentrum Jülich
4 shared publications - Riko Fukunaga
Keio University
3 shared publications Satoshi Haku
Department of Applied Physics and Physico-Informatics, Keio University, Yokohama, Japan
3 shared publications- Frank Freimuth
Institute of Physics, Johannes Gutenberg University Mainz, Mainz, Germany
2 shared publications
Latest Publications
- 27 September 2024
- Published by Springer Nature in Nature Physics
- Vol. 20 (12) , 1896-1903
Control of dynamic orbital response in ferromagnets via crystal symmetry
- 27 September 2024
- Published by Springer Nature in Nature Physics
- Vol. 20 (12) , 1896-1903
Control of dynamic orbital response in ferromagnets via crystal symmetry
- Top Cited Papers
- 27 June 2024
- Published by Springer Nature in Nature Electronics
- Vol. 7 (8) , 646-652
Observation of orbital pumping
- 27 June 2024
- Published by Springer Nature in Nature Electronics
- Vol. 7 (8) , 646-652
Top Cited PapersObservation of orbital pumping
- 15 April 2024
- Published by American Physical Society (APS) in Physical Review B
- Vol. 109 (14) , 144412
Impact of crystallinity on orbital torque generation in ferromagnets
We investigate the impact of crystallinity on the generation of orbital torques in Ni, which is predicted to exhibit the strongest orbital response among conventional ferromagnetic metals. We show that the current-induced torques in Hf/Ni bilayers are primarily dominated by the orbital torque, arising from the orbital Hall effect in the Hf layer. We find that the orbital torque efficiency is enhanced by a factor of 2 when the stacking order of the Hf/Ni bilayer is altered. Through the examination of bulk and interfacial structural properties of the Ni and Hf layers, and by quantifying the torque efficiency in a symmetric Hf/Ni/Hf trilayer, we show that the orbital torque efficiency is strongly dependent on the crystallinity of the Ni layer. This dependence is in stark contrast to conventional spin-orbit torques, which arise from the spin Hall effect and are typically insensitive to the crystallinity of the ferromagnetic layer. These findings highlight the significant role of the crystalline structure of the ferromagnetic layer in its orbital response and illustrate the potential of crystal structure engineering in optimizing orbital torques.- 15 April 2024
- Published by American Physical Society (APS) in Physical Review B
- Vol. 109 (14) , 144412
Impact of crystallinity on orbital torque generation in ferromagnets
We investigate the impact of crystallinity on the generation of orbital torques in Ni, which is predicted to exhibit the strongest orbital response among conventional ferromagnetic metals. We show that the current-induced torques in Hf/Ni bilayers are primarily dominated by the orbital torque, arising from the orbital Hall effect in the Hf layer. We find that the orbital torque efficiency is enhanced by a factor of 2 when the stacking order of the Hf/Ni bilayer is altered. Through the examination of bulk and interfacial structural properties of the Ni and Hf layers, and by quantifying the torque efficiency in a symmetric Hf/Ni/Hf trilayer, we show that the orbital torque efficiency is strongly dependent on the crystallinity of the Ni layer. This dependence is in stark contrast to conventional spin-orbit torques, which arise from the spin Hall effect and are typically insensitive to the crystallinity of the ferromagnetic layer. These findings highlight the significant role of the crystalline structure of the ferromagnetic layer in its orbital response and illustrate the potential of crystal structure engineering in optimizing orbital torques.- 2 January 2024
- Published by AIP Publishing in Applied Physics Reviews
- Vol. 11 (1)
Two-dimensional Rashba superconductivity in Ni/Bi bilayers evidenced by nonreciprocal transport
When two different materials are brought together, a plethora of quantum phenomena and functionalities can emerge. A prominent example is the superconductivity in Ni/Bi bilayers, which arises from the artificial layered structure composed of the non-superconducting ferromagnetic and heavy metals. Although this system has been shown to exhibit unconventional superconducting properties, the underlying mechanism of the superconductivity remains elusive. Here, we provide experimental evidence of the microscopic coexistence of two-dimensional (2D) superconductivity and broken space-inversion symmetry in the Ni/Bi bilayer. The evidence is obtained from nonreciprocal transport around the superconducting transition temperature, where the resistance depends on the direction of an applied current and an external magnetic field. We find that the nonreciprocal superconducting transport is most pronounced around the Berezinskii–Kosterlitz–Thouless transition temperature. These observations support the 2D Rashba superconductivity in the Ni/Bi bilayer, which will serve as a basis for advancing the understanding of unconventional superconductivity.
- 2 January 2024
- Published by AIP Publishing in Applied Physics Reviews
- Vol. 11 (1)
Two-dimensional Rashba superconductivity in Ni/Bi bilayers evidenced by nonreciprocal transport
When two different materials are brought together, a plethora of quantum phenomena and functionalities can emerge. A prominent example is the superconductivity in Ni/Bi bilayers, which arises from the artificial layered structure composed of the non-superconducting ferromagnetic and heavy metals. Although this system has been shown to exhibit unconventional superconducting properties, the underlying mechanism of the superconductivity remains elusive. Here, we provide experimental evidence of the microscopic coexistence of two-dimensional (2D) superconductivity and broken space-inversion symmetry in the Ni/Bi bilayer. The evidence is obtained from nonreciprocal transport around the superconducting transition temperature, where the resistance depends on the direction of an applied current and an external magnetic field. We find that the nonreciprocal superconducting transport is most pronounced around the Berezinskii–Kosterlitz–Thouless transition temperature. These observations support the 2D Rashba superconductivity in the Ni/Bi bilayer, which will serve as a basis for advancing the understanding of unconventional superconductivity.
- Open Access
- 23 October 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (17)
Orbital Hall magnetoresistance in Ni/Ti bilayers
We report the observation of the orbital counterpart of the spin Hall magnetoresistance (SMR): the orbital Hall magnetoresistance (OMR). We measured angular-dependent longitudinal magnetoresistance for Ni/Ti bilayer and Ni single-layer films by rotating a magnetic field along three orthogonal planes. When the magnetic field is rotated in the plane perpendicular to the applied current direction, the angular dependence of the magnetoresistance in the Ni/Ti bilayers is consistent with the prediction of the SMR and OMR, whereas that in the Ni single-layer film can be attributed to the geometrical size effect of the anisotropic magnetoresistance. In the Ni/Ti bilayers, the magnetoresistance ratio is found to be five orders of magnitude larger than the prediction of the SMR, indicating that the OMR plays a dominant role in this system.
- 23 October 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (17)
Open AccessOrbital Hall magnetoresistance in Ni/Ti bilayers
We report the observation of the orbital counterpart of the spin Hall magnetoresistance (SMR): the orbital Hall magnetoresistance (OMR). We measured angular-dependent longitudinal magnetoresistance for Ni/Ti bilayer and Ni single-layer films by rotating a magnetic field along three orthogonal planes. When the magnetic field is rotated in the plane perpendicular to the applied current direction, the angular dependence of the magnetoresistance in the Ni/Ti bilayers is consistent with the prediction of the SMR and OMR, whereas that in the Ni single-layer film can be attributed to the geometrical size effect of the anisotropic magnetoresistance. In the Ni/Ti bilayers, the magnetoresistance ratio is found to be five orders of magnitude larger than the prediction of the SMR, indicating that the OMR plays a dominant role in this system.
- Open Access
- 21 August 2023
- Published by Springer Nature in Nature Nanotechnology
- Vol. 18 (10) , 1254
Publisher Correction: Time-domain observation of ballistic orbital-angular-momentum currents with giant relaxation length in tungsten
- 21 August 2023
- Published by Springer Nature in Nature Nanotechnology
- Vol. 18 (10) , 1254
Open AccessPublisher Correction: Time-domain observation of ballistic orbital-angular-momentum currents with giant relaxation length in tungsten
- Top Cited PapersOpen Access
- 7 August 2023
- Published by Springer Nature in Nature Nanotechnology
- Vol. 18 (10) , 1132-1138
Time-domain observation of ballistic orbital-angular-momentum currents with giant relaxation length in tungsten
The emerging field of orbitronics exploits the electron orbital momentum L. Compared to spin-polarized electrons, L may allow the transfer of magnetic information with considerably higher density over longer distances in more materials. However, direct experimental observation of L currents, their extended propagation lengths and their conversion into charge currents has remained challenging. Here, we optically trigger ultrafast angular-momentum transport in Ni|W|SiO2 thin-film stacks. The resulting terahertz charge-current bursts exhibit a marked delay and width that grow linearly with the W thickness. We consistently ascribe these observations to a ballistic L current from Ni through W with a giant decay length (~80 nm) and low velocity (~0.1 nm fs−1). At the W/SiO2 interface, the L flow is efficiently converted into a charge current by the inverse orbital Rashba–Edelstein effect, consistent with ab initio calculations. Our findings establish orbitronic materials with long-distance ballistic L transport as possible candidates for future ultrafast devices and an approach to discriminate Hall-like and Rashba–Edelstein-like conversion processes.
- 7 August 2023
- Published by Springer Nature in Nature Nanotechnology
- Vol. 18 (10) , 1132-1138
Top Cited PapersOpen AccessTime-domain observation of ballistic orbital-angular-momentum currents with giant relaxation length in tungsten
The emerging field of orbitronics exploits the electron orbital momentum L. Compared to spin-polarized electrons, L may allow the transfer of magnetic information with considerably higher density over longer distances in more materials. However, direct experimental observation of L currents, their extended propagation lengths and their conversion into charge currents has remained challenging. Here, we optically trigger ultrafast angular-momentum transport in Ni|W|SiO2 thin-film stacks. The resulting terahertz charge-current bursts exhibit a marked delay and width that grow linearly with the W thickness. We consistently ascribe these observations to a ballistic L current from Ni through W with a giant decay length (~80 nm) and low velocity (~0.1 nm fs−1). At the W/SiO2 interface, the L flow is efficiently converted into a charge current by the inverse orbital Rashba–Edelstein effect, consistent with ab initio calculations. Our findings establish orbitronic materials with long-distance ballistic L transport as possible candidates for future ultrafast devices and an approach to discriminate Hall-like and Rashba–Edelstein-like conversion processes.
- Top Cited PapersOpen Access
- 25 April 2023
- Published by American Physical Society (APS) in Physical Review Research
- Vol. 5 (2) , 023054
Orbital torque originating from orbital Hall effect in Zr
We investigate current-induced torques generated by Zr. We show that the generation efficiency of the current-induced torque increases with increasing the thickness of the Zr layer in and Ni/Zr bilayers, which indicates that the observed current-induced torque originates from the bulk of the Zr layer. We find that the sign of the current-induced torques is opposite to that expected from the spin Hall effect but is consistent with that expected from the orbital Hall effect in the Zr layer. Furthermore, we find that the torque efficiency increases with increasing the thickness of the ferromagnetic layer, which is consistent with the prediction of long-range orbital transport in ferromagnets. These observations demonstrate that the orbital Hall effect in the Zr layer is the main source of the current-induced torque. This finding highlights the important role of orbital transport in generating current-induced torques, advancing the understanding of angular momentum dynamics in solid-state devices with transition metals.- 25 April 2023
- Published by American Physical Society (APS) in Physical Review Research
- Vol. 5 (2) , 023054
Top Cited PapersOpen AccessOrbital torque originating from orbital Hall effect in Zr
We investigate current-induced torques generated by Zr. We show that the generation efficiency of the current-induced torque increases with increasing the thickness of the Zr layer in and Ni/Zr bilayers, which indicates that the observed current-induced torque originates from the bulk of the Zr layer. We find that the sign of the current-induced torques is opposite to that expected from the spin Hall effect but is consistent with that expected from the orbital Hall effect in the Zr layer. Furthermore, we find that the torque efficiency increases with increasing the thickness of the ferromagnetic layer, which is consistent with the prediction of long-range orbital transport in ferromagnets. These observations demonstrate that the orbital Hall effect in the Zr layer is the main source of the current-induced torque. This finding highlights the important role of orbital transport in generating current-induced torques, advancing the understanding of angular momentum dynamics in solid-state devices with transition metals.