Rasool Aghatehrani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Rasool Aghatehrani has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Rajesh G. Kavasseri † ~
Electrical and Computer Engg., North Dakota State University, Fargo, ND
2 shared publications - Afshin Pirouzi
Department of Engineering, Semirom Branch, Islamic Azad University, Semirom, Iran
1 shared publication - Hosein Hasan Shahi
Department of Electrical Engineering, Marvdasht Branch, Islamic Azad University, Marvdasht, Iran
1 shared publication - Mohammad-Reza Akbari-Zadeh
Department of Electrical Engineering, Technical and Vocational University (TVU), Tehran, Iran
1 shared publication - Morteza Jadidoleslam
Department of Electrical Engineering, Sirjan University of Technology, Sirjan, Iran
1 shared publication Ravi Chandra Thapa
Dept. of Electrical & Computer Engineering, North Dakota State University, Fargo, 58108, USA
1 shared publication
Latest Publications
- Open Access
- 26 April 2023
- Published by Wiley in International Transactions on Electrical Energy Systems
- Vol. 2023, 1-12
Presenting a Stochastic Model of Simultaneous Planning Problem of Distribution and Subtransmission Network Development considering the Reliability and Security Indicators
Consumption growth demands power system expansion, and changes in a network lead to changes in operation indices of the upstream network. Hence, to establish a reliable planning of the distribution network, simultaneous planning of the subtransmission network should also be taken into account. It is predicted that this planning impacts different technical indices; therefore, formulation of various technical indices need to be included in the planning model. Therefore, in this study, the stochastic problem model of simultaneous planning of distribution and super distribution network development considering the reliability and security indicators is presented. The aforementioned problem is in the form of an optimization problem whose objective function is to minimize the costs of construction, replacement, operation, maintenance, reliability, and security. Furthermore, the mentioned problem is bound to the equations of power distribution, reliability, and security of voltage in addition to the limitation of network indicators. It is worth mentioning that, in the proposed problem, the active and reactive loads in addition to the operating price are in the form of uncertainty. Thus, the mentioned problem is in the form of a stochastic problem in which the point estimation method is used to evaluate the scenarios. Simultaneous expansion planning of distribution and subtransmission networks along with the placement of distributed generations and capacitors, as well as modeling security and reliability indices, is the novelty of the proposed scheme. In the end, the proposed problem is applied to the test network by GAMS optimization software, and then the capabilities of the proposed problem are extracted. Accordingly, based on numerical results, the expansion of distribution networks imposes considerable cost. Moreover, expansion planning of both distribution and subtransmission networks helps voltage to be in its permissible range, lower power loss, and improve reliability and security to 100%.
- 26 April 2023
- Published by Wiley in International Transactions on Electrical Energy Systems
- Vol. 2023, 1-12
Open AccessPresenting a Stochastic Model of Simultaneous Planning Problem of Distribution and Subtransmission Network Development considering the Reliability and Security Indicators
Consumption growth demands power system expansion, and changes in a network lead to changes in operation indices of the upstream network. Hence, to establish a reliable planning of the distribution network, simultaneous planning of the subtransmission network should also be taken into account. It is predicted that this planning impacts different technical indices; therefore, formulation of various technical indices need to be included in the planning model. Therefore, in this study, the stochastic problem model of simultaneous planning of distribution and super distribution network development considering the reliability and security indicators is presented. The aforementioned problem is in the form of an optimization problem whose objective function is to minimize the costs of construction, replacement, operation, maintenance, reliability, and security. Furthermore, the mentioned problem is bound to the equations of power distribution, reliability, and security of voltage in addition to the limitation of network indicators. It is worth mentioning that, in the proposed problem, the active and reactive loads in addition to the operating price are in the form of uncertainty. Thus, the mentioned problem is in the form of a stochastic problem in which the point estimation method is used to evaluate the scenarios. Simultaneous expansion planning of distribution and subtransmission networks along with the placement of distributed generations and capacitors, as well as modeling security and reliability indices, is the novelty of the proposed scheme. In the end, the proposed problem is applied to the test network by GAMS optimization software, and then the capabilities of the proposed problem are extracted. Accordingly, based on numerical results, the expansion of distribution networks imposes considerable cost. Moreover, expansion planning of both distribution and subtransmission networks helps voltage to be in its permissible range, lower power loss, and improve reliability and security to 100%.
- 1 July 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19325517,p. 1-8
Sliding mode control approach for voltage regulation in microgrids with DFIG based wind generations
This paper presents a direct torque and reactive power control method which addresses the problem of voltage regulation in microgrids including doubly fed induction generator (DFIG) based wind generation. Due to significant line resistances in a microgrid, active power variations produced by wind turbines can lead to significant fluctuations in voltage magnitudes and results in power quality problems. This paper uses a nonlinear sliding mode control scheme to directly control torque and reactive power of a DFIG system. The control system adjusts the reactive power of DFIG to achieve voltage quality improvement in the important central bus of a microgrid. There is no decoupled proportional-integral (PI) control based method, therefore the control system is not highly dependent to the accuracy of the system parameters. Also, the method is local and can be implemented in the absence of a widespread communication system or remote measurement. The performance of the method is illustrated on the IEEE 13 bus distribution network. Dynamic models are considered for the DFIG, converters and internal controllers along with their operational limits. Stochastic fluctuations in wind speed are modeled with NREL TurbSim while accounting for the tower shadow and wind shear. Dynamic simulations are presented to assess the voltage fluctuation compensation and control system robustness.
- 1 July 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19325517,p. 1-8
Sliding mode control approach for voltage regulation in microgrids with DFIG based wind generations
This paper presents a direct torque and reactive power control method which addresses the problem of voltage regulation in microgrids including doubly fed induction generator (DFIG) based wind generation. Due to significant line resistances in a microgrid, active power variations produced by wind turbines can lead to significant fluctuations in voltage magnitudes and results in power quality problems. This paper uses a nonlinear sliding mode control scheme to directly control torque and reactive power of a DFIG system. The control system adjusts the reactive power of DFIG to achieve voltage quality improvement in the important central bus of a microgrid. There is no decoupled proportional-integral (PI) control based method, therefore the control system is not highly dependent to the accuracy of the system parameters. Also, the method is local and can be implemented in the absence of a widespread communication system or remote measurement. The performance of the method is illustrated on the IEEE 13 bus distribution network. Dynamic models are considered for the DFIG, converters and internal controllers along with their operational limits. Stochastic fluctuations in wind speed are modeled with NREL TurbSim while accounting for the tower shadow and wind shear. Dynamic simulations are presented to assess the voltage fluctuation compensation and control system robustness.
- 1 July 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 22 (19325517) , 1-6
Power smoothing of the DFIG wind turbine using a small energy storage device
The active power produced by wind generators is subject to fluctuations due to the stochastic nature of wind. Depending upon the size of the wind farm and the network to which it is connected, active power variations may result in frequency deviations. This can trigger frequency protection devices and lead to undesirable unit trippings. This paper proposes the addition of a small supercapacitor at the DC link in the power converted of a doubly fed induction generator (DFIG). Based on this, a new method is proposed which simultaneously balances the MPPT as well as output power smoothing objectives. Frequency variations in the range of 0.1-1 Hz are investigated considering variations in wind speed, tower shadow and wind shear effects. Numerical simulations are carried out in PSCAD/EMTDC to illustrate the effectiveness of the proposed method in limiting frequency deviations.
- 1 July 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 22 (19325517) , 1-6
Power smoothing of the DFIG wind turbine using a small energy storage device
The active power produced by wind generators is subject to fluctuations due to the stochastic nature of wind. Depending upon the size of the wind farm and the network to which it is connected, active power variations may result in frequency deviations. This can trigger frequency protection devices and lead to undesirable unit trippings. This paper proposes the addition of a small supercapacitor at the DC link in the power converted of a doubly fed induction generator (DFIG). Based on this, a new method is proposed which simultaneously balances the MPPT as well as output power smoothing objectives. Frequency variations in the range of 0.1-1 Hz are investigated considering variations in wind speed, tower shadow and wind shear effects. Numerical simulations are carried out in PSCAD/EMTDC to illustrate the effectiveness of the proposed method in limiting frequency deviations.