Yi Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yi Wang has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Bao Wang
Key Laboratory for Ferrous Metallurgy and Resources Utilization of Ministry of Education, Wuhan University of Science and Technology, Wuhan 430081, China
1 shared publication - Bin Liu
Engineering Research Center of Metallurgical Automation and Measurement Technology, Ministry of Education, Wuhan University of Science and Technology, Wuhan 430081, China
1 shared publication - Haijun Zhang
State Key Laboratory of Advanced Refractories Wuhan University of Science and Technology Wuhan China
1 shared publication Jian Yang
Wuhan Research Institute of Metallurgical Construction, MCC Wuhan China
1 shared publication- Jianan Zhou
Key Laboratory for Ferrous Metallurgy and Resources Utilization of Ministry of Education, Wuhan University of Science and Technology, Wuhan 430081, China
1 shared publication - Jianan Zhou
The State Key Laboratory of Refractories and Metallurgy Wuhan University of Science and Technology Wuhan China
1 shared publication
Latest Publications
- 10 April 2024
- Published by Elsevier in Separation and Purification Technology
- Vol. 346, 127452
Waste control by waste: Extraction of valuable metals from mixed metallurgical dust by boiling furnace roasting
- 10 April 2024
- Published by Elsevier in Separation and Purification Technology
- Vol. 346, 127452
Waste control by waste: Extraction of valuable metals from mixed metallurgical dust by boiling furnace roasting
- 17 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 314-319
Attacks Detection Against Two-Channel Partial FDI in CPS: A Moving Target Defense Method
In this paper, a problem of detection method based on moving target defense is studied for two-channel partial FDI attacks in CPS. Firstly, a two-channel partial FDI attack strategy is designed and its stealthiness is analyzed. Then, the detection mechanism is designed by weighting the time before and after the control signal of the system. Secondly, the analysis and deduction show that there exists a difference between the system residual under attack and the normal residual, which proves that the residual detection index after attack is divergent. Unlike the existing physical watermarking methods, the moving target item introduced only need to utilize the control amount of the previous moment, and do not need additional calculation and injection of the watermarking signal. It will not affect the residual of the system in normal operation, and can reduce the performance loss of the system. The feasibility and validity of the proposed method are verified through numerical simulation.
- 17 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 314-319
Attacks Detection Against Two-Channel Partial FDI in CPS: A Moving Target Defense Method
In this paper, a problem of detection method based on moving target defense is studied for two-channel partial FDI attacks in CPS. Firstly, a two-channel partial FDI attack strategy is designed and its stealthiness is analyzed. Then, the detection mechanism is designed by weighting the time before and after the control signal of the system. Secondly, the analysis and deduction show that there exists a difference between the system residual under attack and the normal residual, which proves that the residual detection index after attack is divergent. Unlike the existing physical watermarking methods, the moving target item introduced only need to utilize the control amount of the previous moment, and do not need additional calculation and injection of the watermarking signal. It will not affect the residual of the system in normal operation, and can reduce the performance loss of the system. The feasibility and validity of the proposed method are verified through numerical simulation.
- 2 May 2023
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 20 (5) , 3183-3193
A low bulk density, low thermal conductivity permanent lining castable for tundish obtained by adding pearlescent sand
The precise control of molten steel temperature in tundish is a key factor to ensure the quality of the cast billets, so it is important to develop permanent lining castables for tundish with low thermal conductivity and bulk density. In this work, the hydrophobic modification of pearlescent sand was carried out with hydrogen silicone oil, and 3% of modified pearlescent sand was added to mullite‐bauxite castable to realize its low thermal conductivity and light weight. It is found that modified pearlescent sand still has good hydrophobicity at 350°C, the addition of modified pearlescent sand effectively increases the apparent porosity and reduces the bulk density of the castable. At 1500°C, the bulk density of modified pearlescent sand‐castable is 25.54% less than that of conventional castable. Compared with conventional castable, the mechanical properties and thermal shock resistance of modified pearlescent sand castable are worse, but they are sufficient to meet the use conditions of tundish permanent lining castable. At 600–1000°C, the thermal conductivity of the modified pearlescent sand castable is about 30% lower than that of the conventional castable, which proves that the addition of modified pearlescent sand can significantly improve the thermal insulation performance of mullite‐bauxite castable.
- 2 May 2023
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 20 (5) , 3183-3193
A low bulk density, low thermal conductivity permanent lining castable for tundish obtained by adding pearlescent sand
The precise control of molten steel temperature in tundish is a key factor to ensure the quality of the cast billets, so it is important to develop permanent lining castables for tundish with low thermal conductivity and bulk density. In this work, the hydrophobic modification of pearlescent sand was carried out with hydrogen silicone oil, and 3% of modified pearlescent sand was added to mullite‐bauxite castable to realize its low thermal conductivity and light weight. It is found that modified pearlescent sand still has good hydrophobicity at 350°C, the addition of modified pearlescent sand effectively increases the apparent porosity and reduces the bulk density of the castable. At 1500°C, the bulk density of modified pearlescent sand‐castable is 25.54% less than that of conventional castable. Compared with conventional castable, the mechanical properties and thermal shock resistance of modified pearlescent sand castable are worse, but they are sufficient to meet the use conditions of tundish permanent lining castable. At 600–1000°C, the thermal conductivity of the modified pearlescent sand castable is about 30% lower than that of the conventional castable, which proves that the addition of modified pearlescent sand can significantly improve the thermal insulation performance of mullite‐bauxite castable.
- Open Access
- 1 August 2021
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 831 (1) , 012060
Evolution of agricultural urban land-use and dynamic evaluation of benefits
This paper starts from the characteristics and driving factors of the land-use evolution in Jianli. The improved TOPSIS method is used to study the dynamic changes, including construction land, agricultural land, and waters and the facilities in Jianli from 2005-2020. Moreover, this paper uses the coupling harmonious degree model to evaluate the degree of coordination of each subsystem. Finally, this paper wants to promote sustainable, coordinated development land-use from domestic circulation in Jianli.
- 1 August 2021
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 831 (1) , 012060
Open AccessEvolution of agricultural urban land-use and dynamic evaluation of benefits
This paper starts from the characteristics and driving factors of the land-use evolution in Jianli. The improved TOPSIS method is used to study the dynamic changes, including construction land, agricultural land, and waters and the facilities in Jianli from 2005-2020. Moreover, this paper uses the coupling harmonious degree model to evaluate the degree of coordination of each subsystem. Finally, this paper wants to promote sustainable, coordinated development land-use from domestic circulation in Jianli.