Aydın Çiçek
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Aydın Çiçek has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Ali Cemal Benim
Düsseldorf University of Applied Sciences
4 shared publications - Ali Koçyiğit
Active Tectonics and Earthquake Research Unit, Geological Engineering Department, Middle East Technical University, Ankara, Turkey
3 shared publications - Norbert Klitzsch
RWTH Aachen University
3 shared publications - Alper Baba
Department of International Water Resources, Izmir Institute of Technology, İzmir, Türkiye
1 shared publication - Ebru Bayar
Düsseldorf University of Applied Sciences
1 shared publication - Şule Gürboğa
Department of Geological Engineering Faculty of Mines İstanbul Technical University İstanbul Turkiye
1 shared publication
Latest Publications
- 15 May 2026
- Published by Central Library of the Slovak Academy of Sciences in Geologica Carpathica
- Vol. 77 (3)
Tanyeri–Yedisu seismic gap along the Erzincan–Varto section of the North Anatolian Fault: Age, displacement, slip rate and return period in Eastern Türkiye
The study area is situated in the easternmost segment of the North Anatolian Fault System (NAFS), including the Karlıova triple junction (KTJ) where the NAFS intersects the East Anatolian Fault System (EAFS). The regional angular unconformity between intensely deformed pre-Quaternary rocks and the overlying undeformed neotectonic deposits clearly indicates that the onset of the strike-slip neotectonic regime and the formation of the related structures, namely the NAFS and EAFS, occurred in the early Quaternary (2.588 Myr). The present study focuses on the long-term (241-year) Tanyeri–Yedisu seismic gap, the onset age of the strike-slip neotectonic regime, and several key parameters of the Erzincan–Varto section of the NAFS. These are total dextral displacement, average slip rate, and the return period of the peak earthquake expected from the Tanyeri–Yedisu seismic gap. New field data, obtained from the detailed field geological mapping of the region, using the displacement of the Inner Tauride Suture as a structural marker and the Yedisu River as a geographic marker, clearly show that the total dextral displacement is 57 km. This offset was accumulated over an approximately a 2.6 Myr time interval. These values correspond to an average slip rate of 22 mm/yr and a return period of 205 ± 50 years for the peak earthquake originating from the Tanyeri–Yedisu seismic gap.
- 15 May 2026
- Published by Central Library of the Slovak Academy of Sciences in Geologica Carpathica
- Vol. 77 (3)
Tanyeri–Yedisu seismic gap along the Erzincan–Varto section of the North Anatolian Fault: Age, displacement, slip rate and return period in Eastern Türkiye
The study area is situated in the easternmost segment of the North Anatolian Fault System (NAFS), including the Karlıova triple junction (KTJ) where the NAFS intersects the East Anatolian Fault System (EAFS). The regional angular unconformity between intensely deformed pre-Quaternary rocks and the overlying undeformed neotectonic deposits clearly indicates that the onset of the strike-slip neotectonic regime and the formation of the related structures, namely the NAFS and EAFS, occurred in the early Quaternary (2.588 Myr). The present study focuses on the long-term (241-year) Tanyeri–Yedisu seismic gap, the onset age of the strike-slip neotectonic regime, and several key parameters of the Erzincan–Varto section of the NAFS. These are total dextral displacement, average slip rate, and the return period of the peak earthquake expected from the Tanyeri–Yedisu seismic gap. New field data, obtained from the detailed field geological mapping of the region, using the displacement of the Inner Tauride Suture as a structural marker and the Yedisu River as a geographic marker, clearly show that the total dextral displacement is 57 km. This offset was accumulated over an approximately a 2.6 Myr time interval. These values correspond to an average slip rate of 22 mm/yr and a return period of 205 ± 50 years for the peak earthquake originating from the Tanyeri–Yedisu seismic gap.
- Open Access
- 5 March 2026
- Published by Elsevier in SSRN Electronic Journal
A Detailed Thermohydraulic EGS Modeling of the Sivrihisar-Bozköy Geothermal Field (SBGF) (Aksaray), Türkiye using Water and CO2
The Sivrihisar-Bozköy Geothermal Field (SBGF) in Central Türkiye hosts the country’s highest recorded bottom-hole temperature of 341 °C at 3,850 m with two unproductive wells. It makes the field a strong candidate for Enhanced Geothermal Systems (EGS). This study presents the first 3D transient thermo-hydraulic model of the field, supported by new laboratory data and preliminary income analysis using a feed-in-tariff of 10.5 $/kWh. Twenty-year simulations compare H2O and supercritical CO2 (sCO2) circulation at 50 to 150 kg/s.Laboratory measurements on Paleozoic basement samples provided porosity, density, thermal conductivity, and heat capacity under reservoir conditions. Sensitivity analyses show that the fracture properties dominate system performance over matrix and fluid properties. Fracture geometry, spacing, permeability anisotropy, injection temperature, and rock thermal conductivity strongly control production temperature. Reduced vertical permeability or increased horizontal permeability parallel to the flow direction accelerates thermal drawdown, whereas higher vertical permeability improves heat extraction. Radiogenic heat has almost no impact on production temperatures.Water yields higher initial power but faster cooling, while sCO2 offers more stable long-term temperatures. Results suggest that the flow rates between 75-125 kg/s seem optimum. A 20-stage, 300 m × 200 m × 4 m fracture design with ~80 m full-spacing and 5,100 m wells coupled with a double-flash power plant appears technically feasible, confirming SBGF’s high-enthalpy EGS potential.
- 5 March 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessA Detailed Thermohydraulic EGS Modeling of the Sivrihisar-Bozköy Geothermal Field (SBGF) (Aksaray), Türkiye using Water and CO2
The Sivrihisar-Bozköy Geothermal Field (SBGF) in Central Türkiye hosts the country’s highest recorded bottom-hole temperature of 341 °C at 3,850 m with two unproductive wells. It makes the field a strong candidate for Enhanced Geothermal Systems (EGS). This study presents the first 3D transient thermo-hydraulic model of the field, supported by new laboratory data and preliminary income analysis using a feed-in-tariff of 10.5 $/kWh. Twenty-year simulations compare H2O and supercritical CO2 (sCO2) circulation at 50 to 150 kg/s.Laboratory measurements on Paleozoic basement samples provided porosity, density, thermal conductivity, and heat capacity under reservoir conditions. Sensitivity analyses show that the fracture properties dominate system performance over matrix and fluid properties. Fracture geometry, spacing, permeability anisotropy, injection temperature, and rock thermal conductivity strongly control production temperature. Reduced vertical permeability or increased horizontal permeability parallel to the flow direction accelerates thermal drawdown, whereas higher vertical permeability improves heat extraction. Radiogenic heat has almost no impact on production temperatures.Water yields higher initial power but faster cooling, while sCO2 offers more stable long-term temperatures. Results suggest that the flow rates between 75-125 kg/s seem optimum. A 20-stage, 300 m × 200 m × 4 m fracture design with ~80 m full-spacing and 5,100 m wells coupled with a double-flash power plant appears technically feasible, confirming SBGF’s high-enthalpy EGS potential.
- 14 February 2026
- Published by Springer Nature
- p. 298-308
Enhanced Geothermal Systems (EGS) Potential Estimation Using Monte Carlo Method: Bozköy Geothermal Field, Aksaray, Central Türkiye
- 14 February 2026
- Published by Springer Nature
- p. 298-308
Enhanced Geothermal Systems (EGS) Potential Estimation Using Monte Carlo Method: Bozköy Geothermal Field, Aksaray, Central Türkiye
- 14 February 2026
- Published by Springer Nature
- p. 287-297
Thermohydraulic Modeling of the Bozköy EGS Field (Aksaray), Türkiye
- 14 February 2026
- Published by Springer Nature
- p. 287-297
Thermohydraulic Modeling of the Bozköy EGS Field (Aksaray), Türkiye
- Open Access
- 1 March 2025
- Published by Springer Nature in Mediterranean Geoscience Reviews
- Vol. 7 (1) , 181-184
Correction: Episodic evolution and active tectonics of the Karamık Graben in the apex of Isparta Angle, SW Türkiye
- 1 March 2025
- Published by Springer Nature in Mediterranean Geoscience Reviews
- Vol. 7 (1) , 181-184
Open AccessCorrection: Episodic evolution and active tectonics of the Karamık Graben in the apex of Isparta Angle, SW Türkiye
- 1 December 2024
- Published by Springer Nature in Mediterranean Geoscience Reviews
- Vol. 6 (4) , 615-638
Episodic evolution and active tectonics of the Karamık Graben in the apex of Isparta Angle, SW Türkiye
- 1 December 2024
- Published by Springer Nature in Mediterranean Geoscience Reviews
- Vol. 6 (4) , 615-638
Episodic evolution and active tectonics of the Karamık Graben in the apex of Isparta Angle, SW Türkiye
- Open Access
- 27 April 2023
- Published by Bulletin of the Mineral Research and Exploration in Bulletin Of The Mineral Research and Exploration
- p. 1
Comparative analysis of water and carbon dioxide injection for the thermohydraulics of an EGS project in Dikili Geothermal Field, Türkiye
A comparative numerical analysis of the thermohydraulics of an enhanced geothermal system (EGS) project in Türkiye in Dikili area is presented. The fractured granodiorite is modelled as porous media, utilizing the numerically suggested data of other authors for the corresponding hydraulic characteristics. As the heat transmission fluid, two different mediums are alternatively considered. These are the more classical medium, water and the supercritical Carbon Dioxide (sCO2). Transient calculations are performed for a time period of twenty years, comparing the temporally developing results obtained for water and sCO2 with each other. Based on modeling parameters and assumptions, higher production temperatures are observed with sCO2, in comparison to water, implying an advantage for sCO2 usage as a working fluid in EGS. This is accompanied by the further advantage of a lower pressure drop for sCO2. On the other hand, the temperature advantage is relativized by the lower specific heat capacity of sCO2 causing a decrease in the production thermal power. In general, the present re found to be encouraging for a further and more detailed analysis of the employment of sCO2 as working fluid in EGS.
- 27 April 2023
- Published by Bulletin of the Mineral Research and Exploration in Bulletin Of The Mineral Research and Exploration
- p. 1
Open AccessComparative analysis of water and carbon dioxide injection for the thermohydraulics of an EGS project in Dikili Geothermal Field, Türkiye
A comparative numerical analysis of the thermohydraulics of an enhanced geothermal system (EGS) project in Türkiye in Dikili area is presented. The fractured granodiorite is modelled as porous media, utilizing the numerically suggested data of other authors for the corresponding hydraulic characteristics. As the heat transmission fluid, two different mediums are alternatively considered. These are the more classical medium, water and the supercritical Carbon Dioxide (sCO2). Transient calculations are performed for a time period of twenty years, comparing the temporally developing results obtained for water and sCO2 with each other. Based on modeling parameters and assumptions, higher production temperatures are observed with sCO2, in comparison to water, implying an advantage for sCO2 usage as a working fluid in EGS. This is accompanied by the further advantage of a lower pressure drop for sCO2. On the other hand, the temperature advantage is relativized by the lower specific heat capacity of sCO2 causing a decrease in the production thermal power. In general, the present re found to be encouraging for a further and more detailed analysis of the employment of sCO2 as working fluid in EGS.