Bruce Bumble
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Bruce Bumble has a total of 45 co-authors. Here are the top co-authors by number of shared publications:
- Andrew D. Beyer
Jet Propulsion Laboratory, California Institute of Technology, Pasadena, CA, USA
6 shared publications - Boris Korzh
University of Geneva
6 shared publications - Jason P. Allmaras
Jet Propulsion Laboratory, California Institute of Technology 1 , Pasadena, California 91109
6 shared publications - Alexander B. Walter
Jet Propulsion Laboratory, California Institute of Technology, 4800 Oak Grove Dr., Pasadena, CA, USA
5 shared publications - Emma E. Wollman
Jet Propulsion Laboratory, California Institute of Technology 1 , Pasadena, California 91109
5 shared publications - Matthew David Shaw
Australian Museum, Sydney, Australia
5 shared publications
Latest Publications
- 15 June 2023
- Published by SPIE-Intl Soc Optical Eng
- Vol. PC12512, PC1251205-4
Extending the sensitivity of superconducting nanowire single-photon detectors to infrared wavelengths
Superconducting nanowire single-photon detectors (SNSPDs) have long been the detector of choice for photon-counting applications in the near-infrared that demand high efficiency, high timing resolution and low dark counts. Extending the operation of these detectors to mid-infrared wavelengths above 2 µm would enable a host of applications in the fields of chemical and remote sensing, LIDAR and quantum optics. Pushing the range of these detectors deeper into the mid-infrared would also be of interest to the astronomical and dark matter communities. In this work we demonstrate long-wavelength sensitivity in SNSPDs by careful material and device optimization. We also show work towards efficient, low jitter devices in the mid-infrared.
- 15 June 2023
- Published by SPIE-Intl Soc Optical Eng
- Vol. PC12512, PC1251205-4
Extending the sensitivity of superconducting nanowire single-photon detectors to infrared wavelengths
Superconducting nanowire single-photon detectors (SNSPDs) have long been the detector of choice for photon-counting applications in the near-infrared that demand high efficiency, high timing resolution and low dark counts. Extending the operation of these detectors to mid-infrared wavelengths above 2 µm would enable a host of applications in the fields of chemical and remote sensing, LIDAR and quantum optics. Pushing the range of these detectors deeper into the mid-infrared would also be of interest to the astronomical and dark matter communities. In this work we demonstrate long-wavelength sensitivity in SNSPDs by careful material and device optimization. We also show work towards efficient, low jitter devices in the mid-infrared.
- Open Access
- 12 June 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (24)
Large active-area superconducting microwire detector array with single-photon sensitivity in the near-infrared
Superconducting nanowire single photon detectors (SNSPDs) are the highest-performing technology for time-resolved single-photon counting from the UV to the near-infrared. The recent discovery of single-photon sensitivity in micrometer-scale superconducting wires is a promising pathway to explore for large active area devices with application to dark matter searches and fundamental physics experiments. We present 8-pixel 1 mm2 superconducting microwire single photon detectors (SMSPDs) with 1 μm-wide wires fabricated from WSi and MoSi films of various stoichiometries using electron-beam and optical lithography. Devices made from all materials and fabrication techniques show saturated internal detection efficiency at 1064 nm in at least one pixel, and the best performing device made from silicon-rich WSi shows single-photon sensitivity in all eight pixels and saturated internal detection efficiency in 6/8 pixels. This detector is the largest reported active-area SMSPD or SNSPD with near-IR sensitivity, and it extends the SMSPD to an array format. By further optimizing the photolithography techniques presented in this work, a viable pathway exists to realize larger devices with cm2-scale active area and beyond.
- 12 June 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (24)
Open AccessLarge active-area superconducting microwire detector array with single-photon sensitivity in the near-infrared
Superconducting nanowire single photon detectors (SNSPDs) are the highest-performing technology for time-resolved single-photon counting from the UV to the near-infrared. The recent discovery of single-photon sensitivity in micrometer-scale superconducting wires is a promising pathway to explore for large active area devices with application to dark matter searches and fundamental physics experiments. We present 8-pixel 1 mm2 superconducting microwire single photon detectors (SMSPDs) with 1 μm-wide wires fabricated from WSi and MoSi films of various stoichiometries using electron-beam and optical lithography. Devices made from all materials and fabrication techniques show saturated internal detection efficiency at 1064 nm in at least one pixel, and the best performing device made from silicon-rich WSi shows single-photon sensitivity in all eight pixels and saturated internal detection efficiency in 6/8 pixels. This detector is the largest reported active-area SMSPD or SNSPD with near-IR sensitivity, and it extends the SMSPD to an array format. By further optimizing the photolithography techniques presented in this work, a viable pathway exists to realize larger devices with cm2-scale active area and beyond.
- 28 April 2023
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 19 (4) , 044093
Impedance-Matched Differential Superconducting Nanowire Detectors
Superconducting nanowire single-photon detectors (SNSPDs) are the highest-performing photon-counting technology in the near-infrared region. Because of delay-line effects, large-area SNSPDs typically trade off timing resolution and detection efficiency. This unavoidable fundamental constraint might limit their future deployment in demanding scientific applications. Here we introduce a detector design based on transmission-line engineering and differential readout for device-level signal conditioning, enabling a high system detection efficiency and a low detector jitter simultaneously. To make our differential detectors compatible with single-ended time taggers, we also engineer analog differential-to-single-ended readout electronics, with minimal impact on the system timing resolution. Our best niobium nitride differential SNSPD achieves a system detection efficiency of at and at . The lowest system jitter is at and at , limited by intrinsic contributions. These detectors also achieve sub-100-ps timing response at 1/100 of the maximum level, at 775 nm and at , enabling time-correlated single-photon counting with high-dynamic-range response functions. Furthermore, because of the differential impedance-matched design, our detectors exhibit delay-line imaging capabilities and photon-number resolution. The properties and high-performance metrics achieved by our system make it a versatile photon-detection solution for quantum computing, quantum communication, and many other scientific applications.- 28 April 2023
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 19 (4) , 044093
Impedance-Matched Differential Superconducting Nanowire Detectors
Superconducting nanowire single-photon detectors (SNSPDs) are the highest-performing photon-counting technology in the near-infrared region. Because of delay-line effects, large-area SNSPDs typically trade off timing resolution and detection efficiency. This unavoidable fundamental constraint might limit their future deployment in demanding scientific applications. Here we introduce a detector design based on transmission-line engineering and differential readout for device-level signal conditioning, enabling a high system detection efficiency and a low detector jitter simultaneously. To make our differential detectors compatible with single-ended time taggers, we also engineer analog differential-to-single-ended readout electronics, with minimal impact on the system timing resolution. Our best niobium nitride differential SNSPD achieves a system detection efficiency of at and at . The lowest system jitter is at and at , limited by intrinsic contributions. These detectors also achieve sub-100-ps timing response at 1/100 of the maximum level, at 775 nm and at , enabling time-correlated single-photon counting with high-dynamic-range response functions. Furthermore, because of the differential impedance-matched design, our detectors exhibit delay-line imaging capabilities and photon-number resolution. The properties and high-performance metrics achieved by our system make it a versatile photon-detection solution for quantum computing, quantum communication, and many other scientific applications.- Open Access
High-speed detection of 1550 nm single photons with superconducting nanowire detectors
Superconducting nanowire single photon detectors are a key technology for quantum information and science due to their high efficiency, low timing jitter, and low dark counts. In this work, we present a detector for single 1550 nm photons with up to 78% detection efficiency, timing jitter below 50 ps FWHM, 158 counts/s dark count rate - as well as a world-leading maximum count rate of 1.5 giga-counts/s at 3 dB compression. The PEACOQ detector (Performance-Enhanced Array for Counting Optical Quanta) comprises a linear array of 32 straight superconducting niobium nitride nanowires which span the mode of an optical fiber. This design supports high count rates with minimal penalties for detection efficiency and timing jitter. We show how these trade-offs can be mitigated by implementing independent read-out for each nanowire and by using a temporal walk correction technique to reduce count-rate dependent timing jitter. These detectors make quantum communication practical on a 10 GHz clock.
Open AccessHigh-speed detection of 1550 nm single photons with superconducting nanowire detectors
Superconducting nanowire single photon detectors are a key technology for quantum information and science due to their high efficiency, low timing jitter, and low dark counts. In this work, we present a detector for single 1550 nm photons with up to 78% detection efficiency, timing jitter below 50 ps FWHM, 158 counts/s dark count rate - as well as a world-leading maximum count rate of 1.5 giga-counts/s at 3 dB compression. The PEACOQ detector (Performance-Enhanced Array for Counting Optical Quanta) comprises a linear array of 32 straight superconducting niobium nitride nanowires which span the mode of an optical fiber. This design supports high count rates with minimal penalties for detection efficiency and timing jitter. We show how these trade-offs can be mitigated by implementing independent read-out for each nanowire and by using a temporal walk correction technique to reduce count-rate dependent timing jitter. These detectors make quantum communication practical on a 10 GHz clock.
- 1 January 2022
- Published by Optica Publishing Group
- Vol. 14, FM4C.3
Large-area SNSPDs for up to 7.4 μm wavelengths
We demonstrate large-area superconducting nanowire single-photon detectors (SNSPDs) for operation in the mid-IR band, up to 7.4 μm.
- 1 January 2022
- Published by Optica Publishing Group
- Vol. 14, FM4C.3
Large-area SNSPDs for up to 7.4 μm wavelengths
We demonstrate large-area superconducting nanowire single-photon detectors (SNSPDs) for operation in the mid-IR band, up to 7.4 μm.
- Open Access
- 1 January 2021
- Published by Optica Publishing Group
- Vol. 7, FW2P.1
Impedance-matched differential SNSPDs for practical photon counting with sub-10 ps timing jitter
We demonstrate large-area superconducting nanowire single-photon detectors (SNSPDs) with simultaneous high system detection efficiency and low system jitter. We describe the device architecture and discuss optimal readout setup for practical applications.
- 1 January 2021
- Published by Optica Publishing Group
- Vol. 7, FW2P.1
Open AccessImpedance-matched differential SNSPDs for practical photon counting with sub-10 ps timing jitter
We demonstrate large-area superconducting nanowire single-photon detectors (SNSPDs) with simultaneous high system detection efficiency and low system jitter. We describe the device architecture and discuss optimal readout setup for practical applications.