Cheng Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Cheng Yang has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
A. Dong
Department of Biochemistry University of Toronto 1 King College circle M5S1A8 Toronto Ontario Canada
1 shared publicationE. Evdokimova
Midwest Center for Structural Genomics University of Toronto 112 College Street M5G1L6 Toronto Ontario Canada
1 shared publicationErik Brostromer
National Laboratory of Protein Engineering and Plant Genetic Engineering, College of Life Sciences, Peking University, Beijing 100871, People's Republic of China
1 shared publicationF. Joseph
Rigaku Americas Corp 9009 New Trails Dr. 77381 Woodlands TX USA
1 shared publicationJ. Pflugrath
Rigaku Americas Corp 9009 New Trails Dr. 77381 Woodlands TX USA
1 shared publicationJ. W. Pflugrath
Rigaku/MSC Inc., The Woodlands, TX 77381, USA
1 shared publication
Latest Publications
- 24 April 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (18) , 13027-13032
The coherent motions of thermal active Brownian particles
The active Brownian particle system undergoing motility-induced phase separation forms a high-density phase with both structural ordering and dynamical coherence.
- 24 April 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (18) , 13027-13032
The coherent motions of thermal active Brownian particles
The active Brownian particle system undergoing motility-induced phase separation forms a high-density phase with both structural ordering and dynamical coherence.
- 8 April 2013
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Analysis of Thermal Load for Dry Clutch under the Frequent Launching Condition
According to the structural features and working characteristics of the dry clutch, this study focuses on the factors that affect the performance and life of the dry clutch. The temperature rise caused by the clutch slipping was proved as the key factor. Dynamics model of the powertrain for the dry clutch in launching process was established, and friction work generated during the launching process was simulated and calculated. Based on the basic theory of heat transfer, this paper defined the boundary conditions of the temperature field and the finite element model for the dry clutch was built. The transient temperature field of the friction disk, temperature field changes under the frequent starting conditions and the effects of friction material on temperature rise were analyzed, and measures were proposed to reduce the temperature of dry clutch from its design, use and control.
- 8 April 2013
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Analysis of Thermal Load for Dry Clutch under the Frequent Launching Condition
According to the structural features and working characteristics of the dry clutch, this study focuses on the factors that affect the performance and life of the dry clutch. The temperature rise caused by the clutch slipping was proved as the key factor. Dynamics model of the powertrain for the dry clutch in launching process was established, and friction work generated during the launching process was simulated and calculated. Based on the basic theory of heat transfer, this paper defined the boundary conditions of the temperature field and the finite element model for the dry clutch was built. The transient temperature field of the friction disk, temperature field changes under the frequent starting conditions and the effects of friction material on temperature rise were analyzed, and measures were proposed to reduce the temperature of dry clutch from its design, use and control.
- 18 April 2009
- Published by International Union of Crystallography (IUCr) in Acta Crystallographica Section D Structural Biology
- Vol. 65 (5) , 440-448
Structure of a fatty acid-binding protein fromBacillus subtilisdetermined by sulfur-SAD phasing using in-house chromium radiation
Sulfur single-wavelength anomalous dispersion (S-SAD) and halide-soaking methods are increasingly being used for ab initio phasing. With the introduction of in-house Cr X-ray sources, these methods benefit from the enhanced anomalous scattering of S and halide atoms, respectively. Here, these methods were combined to determine the crystal structure of BsDegV, a DegV protein-family member from Bacillus subtilis. The protein was cocrystallized with bromide and low-redundancy data were collected to 2.5 A resolution using Cr Kalpha radiation. 17 heavy-atom sites (ten sulfurs and seven bromides) were located using standard methods. The anomalous scattering of some of the BsDegV S atoms and Br atoms was weak, thus neither sulfurs nor bromides could be used alone for structure determination using the collected data. When all 17 heavy-atom sites were used for SAD phasing, an easily interpretable electron-density map was obtained after density modification. The model of BsDegV was built automatically and a palmitate was found tightly bound in the active site. Sequence alignment and comparisons with other known DegV structures provided further insight into the specificity of fatty-acid selection and recognition within this protein family.
- 18 April 2009
- Published by International Union of Crystallography (IUCr) in Acta Crystallographica Section D Structural Biology
- Vol. 65 (5) , 440-448
Structure of a fatty acid-binding protein fromBacillus subtilisdetermined by sulfur-SAD phasing using in-house chromium radiation
Sulfur single-wavelength anomalous dispersion (S-SAD) and halide-soaking methods are increasingly being used for ab initio phasing. With the introduction of in-house Cr X-ray sources, these methods benefit from the enhanced anomalous scattering of S and halide atoms, respectively. Here, these methods were combined to determine the crystal structure of BsDegV, a DegV protein-family member from Bacillus subtilis. The protein was cocrystallized with bromide and low-redundancy data were collected to 2.5 A resolution using Cr Kalpha radiation. 17 heavy-atom sites (ten sulfurs and seven bromides) were located using standard methods. The anomalous scattering of some of the BsDegV S atoms and Br atoms was weak, thus neither sulfurs nor bromides could be used alone for structure determination using the collected data. When all 17 heavy-atom sites were used for SAD phasing, an easily interpretable electron-density map was obtained after density modification. The model of BsDegV was built automatically and a palmitate was found tightly bound in the active site. Sequence alignment and comparisons with other known DegV structures provided further insight into the specificity of fatty-acid selection and recognition within this protein family.
- Open Access
- 23 August 2008
- Published by International Union of Crystallography (IUCr) in Acta Crystallographica Section A Foundations of Crystallography
- Vol. 64 (a1) , C81
Sulfur-SAD phasing becomes a routine approach to solvede novostructures
- 23 August 2008
- Published by International Union of Crystallography (IUCr) in Acta Crystallographica Section A Foundations of Crystallography
- Vol. 64 (a1) , C81
Open AccessSulfur-SAD phasing becomes a routine approach to solvede novostructures
- Open Access
- 21 September 2001
- Published by International Union of Crystallography (IUCr) in Acta Crystallographica Section D Structural Biology
- Vol. 57 (10) , 1480-1490
Applications of anomalous scattering from S atoms for improved phasing of protein diffraction data collected at Cu Kα wavelength
The anomalous signal of S atoms is easily detected at the Cu Kα wavelength of a non-synchrotron source with current data-collection methods. The position of sulfur and other anomalous scatterers can be located through an anomalous difference Fourier map (F + − F −, φcalc − 90°). It has been discovered experimentally that even low-quality preliminary phases are often sufficient to find anomalous scatterers. Their anomalous signal in the native crystal can contribute to significant improvement in phase refinement. This technique has been applied to solve the crystal structures of orthorhombic lysozyme and thaumatin. Furthermore, the structure of trypsin was solved using only the diffraction data set from a native crystal collected at a single wavelength (Cu Kα) from a rotating-anode X-ray generator. The anomalous scattering of sulfur was essential to solve the structure of trypsin which was initially phased from a single intrinsic Ca2+ atom. The positions of the S atoms of lysozyme and thaumatin were found using the initial SIRAS phases and used in phase refinement. The overall figures of merit and those in each resolution shell were consistently improved. This resulted in much improved electron-density maps even when the diffraction data were limited to 2.5 Å resolution or worse. Furthermore, peaks from S atoms and other anomalous scatterers in anomalous difference Fourier maps can confirm the tracing of the peptide chain and also provide independent unbiased confirmation of molecular-replacement results. Thus, the anomalous signal of S atoms can contribute to many aspects of solving protein structures and should be used routinely.
- 21 September 2001
- Published by International Union of Crystallography (IUCr) in Acta Crystallographica Section D Structural Biology
- Vol. 57 (10) , 1480-1490
Open AccessApplications of anomalous scattering from S atoms for improved phasing of protein diffraction data collected at Cu Kα wavelength
The anomalous signal of S atoms is easily detected at the Cu Kα wavelength of a non-synchrotron source with current data-collection methods. The position of sulfur and other anomalous scatterers can be located through an anomalous difference Fourier map (F + − F −, φcalc − 90°). It has been discovered experimentally that even low-quality preliminary phases are often sufficient to find anomalous scatterers. Their anomalous signal in the native crystal can contribute to significant improvement in phase refinement. This technique has been applied to solve the crystal structures of orthorhombic lysozyme and thaumatin. Furthermore, the structure of trypsin was solved using only the diffraction data set from a native crystal collected at a single wavelength (Cu Kα) from a rotating-anode X-ray generator. The anomalous scattering of sulfur was essential to solve the structure of trypsin which was initially phased from a single intrinsic Ca2+ atom. The positions of the S atoms of lysozyme and thaumatin were found using the initial SIRAS phases and used in phase refinement. The overall figures of merit and those in each resolution shell were consistently improved. This resulted in much improved electron-density maps even when the diffraction data were limited to 2.5 Å resolution or worse. Furthermore, peaks from S atoms and other anomalous scatterers in anomalous difference Fourier maps can confirm the tracing of the peptide chain and also provide independent unbiased confirmation of molecular-replacement results. Thus, the anomalous signal of S atoms can contribute to many aspects of solving protein structures and should be used routinely.