Shashidhar Gangavarapu
Shashidhar Gangavarapu has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Kamanio Chattopadhyay
Interdisciplinary Centre for Energy Research, Indian Institute of Science, Bangalore, India
2 shared publications Manas Paliwal
2 shared publicationsSurendra Kumar Makineni
Indian Institute of Science
2 shared publicationsAjit Tharoor
AALTD, Port Louis, Mauritius
1 shared publicationAnil Nair
AALTD, Port Louis, Mauritius
1 shared publication- Anton Hohenwarter
Department of Materials Science, Montanuniversität Leoben, Leoben, Austria
1 shared publication
Latest Publications
- Open Access
- 28 August 2026
- Published by Elsevier in SSRN Electronic Journal
Annealing Induced Hardening in Severe Plastically Deformed Ti-modified CoCrNi-based Alloy
The present study reports the annealing induced hardening phenomenon in CoCrNi and (CoCrNi)96Ti4 (in at%) alloys processed by high-pressure torsion (HPT). Micro-Vickers hardness measurement of annealed samples showed >20% increase in hardness at 500⁰C for both compositions. While the hardness increment is retained in (CoCrNi)96Ti4 till 240 hours (h) of annealing, it reduced significantly in CoCrNi alloy after 100h. Detailed microstructural evaluations with synchrotron X-ray diffraction, SEM, TEM and APT showed formation of a HCP phase and a metastable Cr-rich BCC phase in both alloys. An additional (Ni,Co)3Ti HCP phase is formed in (CoCrNi)96Ti4. ThermoCalc based calculations proves the importance of non-equilibrium defects on stabilization of BCC phase which in turn stabilizes the nanocrystalline microstructure. The presence of Ti delays the recrystallization and thus extends the stability of BCC phase to higher temperature.
- 28 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessAnnealing Induced Hardening in Severe Plastically Deformed Ti-modified CoCrNi-based Alloy
The present study reports the annealing induced hardening phenomenon in CoCrNi and (CoCrNi)96Ti4 (in at%) alloys processed by high-pressure torsion (HPT). Micro-Vickers hardness measurement of annealed samples showed >20% increase in hardness at 500⁰C for both compositions. While the hardness increment is retained in (CoCrNi)96Ti4 till 240 hours (h) of annealing, it reduced significantly in CoCrNi alloy after 100h. Detailed microstructural evaluations with synchrotron X-ray diffraction, SEM, TEM and APT showed formation of a HCP phase and a metastable Cr-rich BCC phase in both alloys. An additional (Ni,Co)3Ti HCP phase is formed in (CoCrNi)96Ti4. ThermoCalc based calculations proves the importance of non-equilibrium defects on stabilization of BCC phase which in turn stabilizes the nanocrystalline microstructure. The presence of Ti delays the recrystallization and thus extends the stability of BCC phase to higher temperature.
- 21 July 2026
- Published by Elsevier in Scripta Materialia
- Vol. 284
First-principles and experimental investigation into the site occupancy of Si in the C14 Fe2Nb Laves phase
- 21 July 2026
- Published by Elsevier in Scripta Materialia
- Vol. 284
First-principles and experimental investigation into the site occupancy of Si in the C14 Fe2Nb Laves phase
- 13 May 2026
- Published by SAGE Publications in Corrosion Engineering, Science and Technology: The International Journal of Corrosion Processes and Corrosion Control
Methanolic corrosion behaviour of 5052 Al–Mg alloys sheets under dry and moist conditions
This study presents a comprehensive investigation of the corrosion behaviour of Aluminium 5052 in methanol under dry conditions and examines the influence of water content on this process. A marked difference in corrosion characteristics was observed between the two environments. The transition in mechanism from dry alcoholate-induced pitting corrosion to wet uniform corrosion was established through detailed analysis of corrosion products using advanced microscopic (including electron microscopy) and spectroscopic techniques. Under dry conditions, corrosion proceeds via methoxide formation followed by its decomposition to Al 2 O 3 , leading to localised pitting. Cracks could be observed at the bottom of these pits. In contrast, the addition of water to methanol promotes the formation of a uniform and stable Al(OH) 3 film, significantly altering the corrosion mode. Notably, introducing as little as 0.5 vol% water into methanol, while exerting negligible impact on combustion properties, substantially mitigates pit and crack formation associated with corrosion.
- 13 May 2026
- Published by SAGE Publications in Corrosion Engineering, Science and Technology: The International Journal of Corrosion Processes and Corrosion Control
Methanolic corrosion behaviour of 5052 Al–Mg alloys sheets under dry and moist conditions
This study presents a comprehensive investigation of the corrosion behaviour of Aluminium 5052 in methanol under dry conditions and examines the influence of water content on this process. A marked difference in corrosion characteristics was observed between the two environments. The transition in mechanism from dry alcoholate-induced pitting corrosion to wet uniform corrosion was established through detailed analysis of corrosion products using advanced microscopic (including electron microscopy) and spectroscopic techniques. Under dry conditions, corrosion proceeds via methoxide formation followed by its decomposition to Al 2 O 3 , leading to localised pitting. Cracks could be observed at the bottom of these pits. In contrast, the addition of water to methanol promotes the formation of a uniform and stable Al(OH) 3 film, significantly altering the corrosion mode. Notably, introducing as little as 0.5 vol% water into methanol, while exerting negligible impact on combustion properties, substantially mitigates pit and crack formation associated with corrosion.
- 10 May 2023
- Published by Elsevier in Scripta Materialia
- Vol. 234
Atomic-scale investigation of H-trapping by fine NbC precipitates in a low C ferritic steel
- 10 May 2023
- Published by Elsevier in Scripta Materialia
- Vol. 234
Atomic-scale investigation of H-trapping by fine NbC precipitates in a low C ferritic steel