LZLiyuan Zhang

Liyuan Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Liyuan Zhang has a total of 84 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Nanoscale CO2-oil miscibility and minimum miscibility pressure in tight reservoirs: nanofluidic slim-tube visualization coupled with thermodynamic modeling

    by Zeng-Ding Wang, Peng-Yang Zhao, Chao-Fu Peng, Shuo Liu, Jun Yao, Hai Sun, Yong-Fei Yang, Lei Zhang, Cun-Qi Jia, Li-Yuan Zhang, et al.


  • Study on the Synergistic Mechanism of Zwitterionic Surfactants and Nano-SiO 2 Particles in Oil Displacement

    by Zheng Wang, Jiawei Shi, Shuang Liu, Lingling Ren, Chenguang Wang, Guoxuan Ma, Lei Zhang, Lu Zhang, Liyuan Zhang

    Surfactants and nanoparticles play a crucial role in regulating the properties of the oil–water interface. However, their influence on the initiation and migration patterns of residual oil in pores remains insufficiently characterized. In this study, nanocompounded systems were prepared by dispersing hydrophobic silica nanoparticles (SiO2-N) in solutions of linear and branched alkylbenzenesulfonate betaines (ASB and XSB), respectively. The effects of these compounded systems on the oil/water/solid interface properties were determined through interfacial tension measurements, emulsion observations, and oil-film stripping tests. The results showed that the addition of SiO2-N enabled the ASB- and XSB-compounded systems to exhibit low interfacial tension characteristics and strong oil film stripping capabilities. Meanwhile, the linear ASB-compounded system demonstrated stronger emulsion stability and further reduced the water separation rate of the emulsion. Additionally, in microscopic-scale oil displacement experiments, the oil displacement efficiencies of the ASB- and XSB-compounded systems increased by 14.9% and 6.5%, respectively. The analysis of remaining oil images indicated that the nanocompounded systems better stripped the aggregated columnar remaining oil, increasing the proportion of liquid and droplet remaining oil. That is to say, the ultralow interfacial tension of the nanocompounded system at the oil/water interface prompts the remaining oil in the pores to transform from columnar to film-like and droplet-like; the improvement in emulsion stability enabled the emulsified oil droplets to have better migration capabilities; the enhanced oil film stripping improved the initiation and migration capabilities of remaining oil, thereby increasing the oil displacement efficiency. Therefore, this paper investigates the initiation and migration characteristics of crude oil in porous media by changing the hydrophobic groups of zwitterionic surfactants of both genders and reveals the synergistic oil displacement mechanism of the compounded system of straight-chain and branched zwitterionic surfactants and nano-SiO2 particles.

  • Open Access

    Ion-triggered reconfigurable hydrogels with salt-enhanced mechanical and swelling properties via network topological adaptation

    by Lingling Ren, Guoxuan Ma, Zheng Wang, Shuang Liu, Haoran Cheng, David A. Weitz, Liyuan Zhang

    Hydrogels typically deteriorate under high-salinity conditions because electrostatic screening and reduced polymer-solvent affinity suppress swelling and weaken load-bearing network connectivity. Here, we report a double-network hydrogel that strengthens while swelling in brine. Compared with its behavior in water, the network undergoes an ion-triggered topological reconfiguration upon salt exposure. The intrachain zwitterionic ion pairs open and reform as inter-network SBVI+-AMPS- bridges, increasing effective bridge density at lower polymer fraction. The hydrogel exhibits 1.63-fold tensile strength and 1.21-fold swelling ratio in 200 g/L NaCl compared to deionized water. SAXS and XPS confirm salt-induced structural homogenization and charge redistribution. Density functional theory calculations support strengthened ionic association under saline conditions between SBVI and AMPS. Free energy analysis reveals that reduced loop fraction and increased connectivity enable associative stabilization to compensate for elastic swelling penalties. Core-flooding demonstrates robust injectability in high-salinity porous rock. This mechanism provides design rules for salt-adaptive hydrogels.


  • Open Access

    Long-term sustained release of small molecular surfactants using microcapsules

    by Shuang Liu, Ling-Ling Ren, Zheng Wang, Jia-Wei Shi, Chen-Guang Wang, Jia-Hui Guo, Lu Zhang, Hao-Ran Cheng, Li-Yuan Zhang


  • Open Access

    Ion-Triggered Reconfigurable Hydrogel with Salt-Enhanced Mechanical and Swelling Properties via Network Topological Adaptation

    by Liyuan Zhang, Lingling Ren, Guoxuan Ma, Zheng Wang, Shuang Liu, Haoran Cheng, David Weitz

    Hydrogels typically deteriorate in high salinity due to electrostatic screening and solvent-quality loss. Here, we report a double network hydrogel, composed of poly(AMPS)(2-acrylamido-2-methylpropane sulfonic acid) and zwitterionic AM-SBVI (acrylamide-sulfobetaine vinylimidazole) that strengthens while swelling in brine. Upon salt exposure, the network undergoes ion-triggered topological reconfiguration, the intrachain zwitterionic loops open and re-form as inter-network SBVI + -AMPS − bridges, which yields a higher effective bridge density v e , at lower polymer fraction(Φ). The hydrogel demonstrates a 3.4-fold increase in tensile strength and a 2.1-fold enhancement in equilibrium swelling ratio in 200 g/L NaCl compared to deionized water. Small-angle X-ray scattering (SAXS) and X-ray photoelectron spectroscopy (XPS) confirm the ion-mediated decoupling of crosslinking domains and redistribution of charge density. Moreover, simulation calculation suggests a more strong interaction between SBVI and AMPS under high salinity water. Coreflooding experiment demonstrates robust injectability and flow-resistance characteristics under high salinity porous rock. A deep analysis concerts swelling/rheology into three descriptors, v ₑ, χ (Flory-Rehner inversion), and f loop (loop fraction from bridge capacity). We find that salt contents raise and depress f loop toward zero. This, the elastic cost term, F el increases but is compensated by F assoc (stabilization from loop to bridge), while F diss from Donnan partioning is small. F mix that related to χ shifts quite small indicated a strong interaction between the hydrogel with brine. This quantitative mechanism explains the simultaneous gains in swelling and modulus and provides rational design rules to engineer salt-adaptive hydrogels for subsurface and biointerfaces.

  • Tough Hybrid Hydrogels with Exceptional Swollen-State Mechanical Robustness via Nanocrystalline Domain Engineering

    by Lingling Ren, Jiawei Shi, Shuang Liu, Zheng Wang, Shuaicheng Qiao, David A. Weitz, Liyuan Zhang


  • Stiff hydrogel encapsulation retains mesenchymal stem cell stemness for regenerative medicine

    by Bo Li, Liyuan Zhang, Yuan Yin, Anqi Chen, Bo Ri Seo, Junzhe Lou, David J. Mooney, David A. Weitz


  • Nanoparticle-Enhanced Water-Based-Emulsion Fracturing Fluid for Improved Imbibition Recovery in Unconventional Reservoirs: Performance and Mechanism

    by Mengjiao Cao, Ruoyu Wang, Yuchen Li, Caili Dai, Xiang Yan, Liyuan Zhang, Yining Wu

    Summary: The conventional friction reducer, typically a water-in-oil (W/O) emulsion, used in slickwater, encounters challenges related to poor environmental friendliness, limited stability, and low activity, hindering its widespread applicability. In this study, we synthesized a water-based emulsion through water dispersion polymerization, incorporating nanoparticles (NPs) into the process to enhance the stability and activity of the polymer emulsion. The result is an environmentally friendly, oil-phase-free, instantly dissolution, and highly efficient friction reducer, intended to optimize the utilization efficiency of slickwater. The NP-enhanced water-based emulsion demonstrated a consistent and spherical dispersion, featuring an average particle size of ~10 μm, maintaining stability for more than 6 months. With rapid dissolution in water, achieved within a mere 38 seconds, it facilitated continuous on-the-fly mixing. Slickwater composed of this emulsion exhibited outstanding application performance, yielding a remarkable 76% reduction in pipeline friction. The presence of NPs and specific monomers facilitated the formation of a spatial network structure that maintains high temperature/shear resistance even after prolonged shear. Moreover, the system exhibited an exceptional capacity for imbibition oil production. Indoor spontaneous imbibition experiments showed a final recovery rate of 32.41% in tight oil cores (~10% higher than conventional systems), and imbibition depth reached 40.2 mm (1.2-fold increase compared with traditional systems). Field experiments were conducted in a tight oil reservoir to validate practical applications; the results further validated the effectiveness of the novel system. The treated wells showcased rapid oil production, reaching an average daily production rate of 55.8 t/d and water content as low as ~31%, satisfying the predicted production target.


  • Open Access

    Revolutionizing targeting precision: microfluidics-enabled smart microcapsules for tailored delivery and controlled release

    by Lingling Ren, Shuang Liu, Junjie Zhong, Liyuan Zhang

    Microfluidic-enabled smart microcapsules as delivery systems from droplet fabrication to tailored delivery and controlled release.


  • Development of Novel Delayed Swelling Polymer Gel Particles with Salt Resistance for Enhanced In-Depth Permeability Control

    by Yining Wu, Haiqing Zhang, Liyuan Zhang, Yongping Huang, Mingwei Zhao, Caili Dai

    Summary: Prolonged waterflooding or polymer flooding in oil fields often exacerbates reservoir heterogeneity, leading to premature water breakthrough and high water cut, which significantly hinders efficient oilfield development. To address this issue, polymer gel particles have been prescribed to enhance sweep efficiency and augment waterflooding recovery by plugging preferential pathways within the reservoir. However, inherent weaknesses of polymer gel particles, such as fast water absorption and expansion rates in the initial stage and low post-expansion rates, make it difficult to balance in-depth transportation and plugging performance. Additionally, these gel particles are sensitive to ions in the formation water, resulting in reduced expansion rates under high-salinity conditions. Therefore, there are still challenges in the application of polymer gel particles for in-depth permeability control. In this study, a new type of delayed swelling and salt-resistant polymer gel particle was synthesized through inverse emulsion copolymerization. To achieve delayed swelling, we use a degradable crosslinker and hydrophobic monomer to enhance the crosslinked network density and hydrophobicity of gel particles. Our double crosslinked gel particles keep their original size until Day 2, then gradually swell up to 20 days in NaCl solution with a concentration of 15×104 mg·L−1 at 90°C. In comparison, the traditional single crosslinked gel particles show significant disparities in swelling behaviors and quickly swell when just dispersed in a 15×104 mg·L−1 NaCl solution at 90°C, maintaining roughly the same size over the testing period. Coreflooding experiments demonstrate that the residual resistance before and after aging increases from 2.37 to 6.82. The newly synthesized delayed swelling and salt-resistant polymer gel particles exhibit promising potential for overcoming the challenges associated with reservoir heterogeneity and high salinity.