GÖGülsüm Öztürk

Gülsüm Öztürk

*This is an algorithmically generated author record based on publicly available information.

Gülsüm Öztürk has a total of 5 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • In Vitro Organogenesis and Micropropagation of Ornithogalum sigmoideum

    by Muhammet Anil Aydin, Gülsüm Öztürk

    Ornithogalum sigmoideum L., is a common species in Anatolia, grows in gardens in the Black Sea region and is consumed as a vegetable. Ornithogalum sigmoideum L. bulbs can be used in many areas such as commercial production, ornamental plants and secondary metabolites for medicine. In the study, the bulbs of Ornithogalum sigmoideum is one of the geophytes of Türkiye, were used as genetic material and were cultured in in vitro. The objective of the study was to investigate of Kinetin (Kn) and 6-Benzylaminopurine (BAP) as plant growth regulators and combination with 0.2 mg L-1 NAA (α-naphthalene acetic acid) and 0.2 mg L-1 GA3 (Gibberellic acid) for whole plant regeneration and bulb from shoot cultured of Ornithogalum sigmoideum L. Supporting of Kn at 2.0 mg L-1 concentration had the highest shoot number as 7.0. Similarly, BAP combination with NAA promoted direct adventitious shoot proliferation. On the other hand, different concentrations of indole-3-butyric acid (IBA) considerably improved root formation for full plant. Media of 1.0 mg L-1 IBA had the highest mean in terms of root number (4.0) and root length (3.5 cm). 2.0 mg L-1 IBA had the highest mean for shoot length with 5.1 cm.

  • Open Access

    The Potato Clones Selected for High and Low Plant Yield in the F1 Generation of Atlantic × 101 (Nif) Cross

    by Muhammet Anil Aydin, Gülsüm Öztürk, Metin Birkan Yildirim

    The study aimed to compare the performances of clones selected for high low single plant yield in the greenhouse growing in the progeny test run in seedbed growing. A total of 104 plants were randomly selected among 1104 F1 plants and tuber yield of each plant was measured and the tubers were kept as clone. Assuming a normal distribution, the truncated selection was applied at the highest (Q1) and lowest (Q4) quartiles of the normal distribution at the s = 0.05; 0.10; 0.15; 0.20 and 0.25 selection pressures. Clones selected were grown in a seedbed nursery as progeny testing. The results can be summarized as follows: The progeny population could be separated into two distinct groups with mean values of 5.16 g and 1.35 g, at the s = 0.25 selection pressure. In the greenhouse the highest quartile at the s = 0.05 selection pressure had the highest mean of 6.40 g and reduced to 5.16 g at the 0.25 level. In the lowest quartile the lowest mean was 0.60 g at the s = 0.05 level and increased up to 1.35 g in the s = 0.25 level. The highest quartile (Q1) had the mean 49.51 g at s = 0.05 and reduced to 35.53 g in the s = 0.25. The lowest mean was obtained in the lowest quartile (Q4) at the s = 0.05 with a value of 24.30 g and increased up to 33.85 g at the s = 0.25 level. The highest amount of the difference between the highest and the lowest selection was obtained as 25.21 g at the s = 0.05 pressure level in the seedbeds.


  • Open Access

    Agrotechnical Characteristics of Some Vegetable Seeds Commonly Grown in Denizli-Acıpayam

    by Zeynep Dumanoğlu, Gülsüm Öztürk

    Vegetables are not only consumed fresh but also have an important place in nutrition in terms of vitamins, carbohydrates, fats and proteins. Parts of these plants such as roots, stems, leaves, fruits and seeds are used and consumed. This study was carried out in the laboratories of Bingol and Ege Universities in 2022. In the study, some physical properties (length, width, surface area, mean arithmetic and geometric diameters, and sphericity) of seeds belonging to five different vegetables (dill, lettuce, parsley, arugula and tongue grass) were investigated. Since the seeds examined in the study are "heirloom seeds", the values obtained will enable sowing operations to be carried out with minimum seed loss by making use of mechanization applications in small and narrow areas as well as breeding studies.

  • Klon 6/7 X 101 Patates (Solanum tuberosum L.) Melezinin İlk Generasyonunda Verim Komponentlerine Dayalı Klon Seleksiyonu

    by Muhammet Anıl Aydın, Gülsüm Öztürk

    Ege Üniversitesi Ziraat Fakültesi Tarla Bitkileri Bölümü’nde yürütülen patates ıslahı çalışmalarından seçilmiş olan iki patates (Solanum tuberosum L.) genotipinin melezinden (6/7 klonu x 101 (Nif)) elde edilen gerçek tohumlar 2019 yılında serada plastik saksılarda yetiştirilmiş ve hasat sonrasında klonların yumru sayısı, tek yumru ağırlığı ve tek bitki verimi değerleri ölçülmüştür. Seçilen klonlar 2020 yılında fideliklerde kontrol popülasyonu olarak yetiştirilmiştir. İncelenen 133 klona ait özellikler için varsayılan normal dağılış parametreleri saptanmış ve farklı seleksiyon şiddeti oranı (ì) seviyelerine ait popülasyon oluşturularak bu popülasyonlar tek aşamalı seleksiyon metoduna göre 2020 yılında fide yastıklarında yetiştirilmiş yumru sayısı, tek yumru ağırlığı ve bitki verimi özellikleri ölçülerek ortalamalar elde edilmiştir. Kontrol popülasyonu ortalamaları ile başlangıç popülasyonundaki ortalamalar karşılaştırılmış ve kazançlar bulunmuştur. Yapılan karşılaştırma ve değerlendirmeler sonucu elde edilen bulgulara göre; iki popülasyon arasında yumru sayısı, tek yumru ağırlığı ve bitki verimi için korelasyon değerlerinin seleksiyonuı olumlu etkileyeceği kabul edilebilir. 2. uygulanan seleksiyon sonucu, yumru sayısı için p=0,05 oranında en yüksek seleksiyon diferansiyeli başlangıç popülasyonu ve kontrol popülasyonu ortalaması ile kazanç sırasıyla 4,8; 8,9 ve 4,1 olarak elde edilmiştir. 3. tek yumru ağırlığı için en yüksek seleksiyon diferansiyeli, fidelik popülasyonu ortalaması ve kazanç sırasıyla düşük düzeydeki p=0,20’de 1,4 g; 10,9 g ve 9,5 ve p=0,25 oranında sırasıyla 1,2 g; 12,1 g ve 10,9 olmuştur. 4. bitki verimi için en yüksek seleksiyon diferansiyeli, fidelik popülasyonu ortalaması ve kazanç, p=0,10 oranında seleksiyonda sırasıyla 6,7 g; 94,9 g ve 8,2 ve p=0,15 oranında ise sırasıyla 5,9 g; 125,4 g ve 119,5 olmuştur. Sonuç olarak yumru sayısı ve bitki verimi için yüksek ve orta şiddette p=0,05; p=0,10 ve p=0,15 seviyelerinde uygulanacak seleksiyonun başarılı olduğu ortaya çıkmıştır. Tek yumru ağırlığı için düşük düzeyde uygulanan örneğin p=0,20 ve p=0,25 seviyelerde uygulanan seleksiyon başarılı görülmüştür. Patates ıslahında tek bitki verimi için uygulanan seleksiyonda orta düzeyde (p=0,15) seleksiyon ile yüksek verim elde edilmektedir.


  • Open Access

    YIELD PERFORMANCES OF PELLETED TRUE POTATO (TPS) SEEDS IN OUTDOOR SEEDBED GROWING

    by Gülsüm Öztürk, Zeynep Dumanoğlu

    Yield performances of pelleted true potato seeds were tested in the outdoor seedbed growing at BornovaIzmir, Turkey in 2017 and 2018. Micro yield trial was arranged in a Completely Randomized Design (CRD) with following treatments: seedling from pelleted seed (SPS), seedling from non-pelleted seed (SNPS), pelleted single seed (PSS), pelleted two (double) seed (PDS), pelleted three (triple) seed (PTS), non-pelleted seed (NS) and minituber (MT). The following results were obtained the PTS had the highest tuber number (9.1); the PDS had the highest single tuber weight similar to the control MT; the PTS had the highest plant yield (182.3 g); the PTS had the highest plot yield (1.0 kg) with the MT (Control); the PDS had the highest tuber width (3.4 cm) similar to the MT (control) and the PDS had the highest tuber length (4.2 cm) similar to the MT (4.1 cm) and PSS (4.0 cm) The high mean for the agronomical traits indicated that pelleted potato seeds could be successfully used in the outdoor seedbed growing.


  • Some Physical Properties of True Potato (Solanum tuberosum L.) Seed 101 (Nif) and Different Hybrids

    by Zeynep Dumanoğlu, Gülsüm Öztürk

    Patates (Solanum tuberosum L.) dünya tarafından sevilerek üretilen ve tüketilen bir endüstri bitkisidir. Hem yumru hem de tohum olarak değerlendirilebilme özelliğine sahiptir. Ancak günümüzde patates üretiminde karşılaşılan sorunlar nedeniyle yumrudan üretimden tohumdan üretim ön plana çıkmaktadır. Bu çalışma 2019-2020 yılları arasında laboratuvar ortamında gerçekleştirilmiştir. Ege Üniversitesi Ziraat Fakültesi Tarla Bitkileri Bölümü tarafından tescil edilen101 (Nif) genotipi ile bu genotipin farklı melez kombinasyonlarından elde edilen gerçek patates tohumlarının bazı fiziksel özellikleri (şekil-boyut, yüzey alan, izdüşüm alanı, ortalama aritmetik çap-geometrik çap, küresellik, bin dane ağırlığı) belirlenerek, istatistiki olarak karşılaştırılmıştır. Elde edilen verilere göre ebeveyn olarak kullanılan 101 (Nif) genotipinin özeliklerinin iyileştiği ve melezlerinin mevcut diğer özelliklerinin de korunduğu belirlenmiştir. Ulaşılan bu sonuçların ileride yapılacak ıslah çalışmalarına ve mekanizasyon uygulamalarına alt yapı oluşturması amaçlanmıştır.

  • Relationship Among Some Agronomical Characteristics in Potatoes

    by Gülsüm Öztürk, Mizgin Mehmet

    The purpose of the study was to estimate simple correlation coefficients between morphological and agronomical characteristics of potato clones to be used in the early generations of a potato breeding program to be conducted in the coastal Aegean Region. A total of 21 potato clones and 2 control clones derived from meristem cultures were grown in the seedbeds in 2020. The design of the experiment was a Completely Randomized Design (CRD) with 2 replications. The trial was planted on March 22, 2020 in the seedbeds in the Department of Field Crops of the Ege University. One single row plot 1.5 m length and 50 cm apart was used and four tubers were grown 30 cm in row spacing. The standard procedures of agricultural practices were applied and the trial was harvested on July 8, 2020. Variances of morphological and agronomical characteristics were obtained by applying variance analysis and controlled with the F test. When the morphological characteristics were evaluated; Clone 177 had highest means for plant height (74.9 cm) and stem number (4.5 number). The highest mean for branch number was obtained Clone 159 such as 10.0. The highest leaves number (73 number) was obtained from Clone 90 Clone 87 had the highest value for leaves length (5.0 cm). When the agronomical characteristics were evaluated; Clone 6/7 gave the highest mean for tuber number (20 number). While Clone 51 (65.6 g) had the highest for single tuber weight; Clone 159 had the highest value in terms of plant yield (795.4 g), plot yield (2.2 kg) and tuber width (4.7 cm). Clone 185 (5.8 cm) had the highest value for tuber length. Since morphological and agronomical characteristics had statistically significant variances, correlation coefficients to show the linear relationship between them were estimated and tested for significance. The following results were obtained: there were significant and positive r correlation coefficient between morphological and agronomical traits such as tuber number and plant yield (0.82), plot yield (0.65), plant height (0.45) between single tuber weight and plant yield (0.52) and plot yield (0.78), plant height (0.58), branch number (0.59). These positive and significant relationships can be used in selections for yield as an early generation test in a potato breeding.

  • VARIOUS GIBBERELLIN TREATMENTS ON PARTHENOCARPIC FRUIT DEVELOPMENT IN 'DEVECI' AND 'ANKARA' PEAR CULTIVARS

    by G. Öztürk, M.A. Aşkin

    ISHS XII International Pear Symposium VARIOUS GIBBERELLIN TREATMENTS ON PARTHENOCARPIC FRUIT DEVELOPMENT IN 'DEVECI' AND 'ANKARA' PEAR CULTIVARS