Kays A. Al-Tae'Y
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Kays A. Al-Tae'Y has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Ameer Abed Jaddoa
Electromechanical Engineering Department, University of Technology, Baghdad, Iraq
1 shared publication - Hussain Saad Abd
University of Technology
1 shared publication - Jalal M. Jalil
Electromechanical Engineering Department, University of Technology, Baghdad Iraq
1 shared publication Sammar J. Ismail
Electromechanical Engineering Department , University of Technology, Hay AL-Wahda , Baghdad , Iraq
1 shared publication
Latest Publications
- 1 May 2021
- Published by Yildiz Technical University in Journal of Thermal Engineering
- Vol. 7 (4) , 1030-1038
A LOOP THERMOSYPHON FOR LIQUID COOLED MINICHANNELS HEAT SINK WITH PULSATE SURFACE HEAT FLUX
The period operation of power electronic acts as switching element, where the power dissipated consists of pulses at certain duty cycle, the semiconductor temperature oscillates and varies as a waveform. In the present study, an experimental investigation was carried out for a loop thermosyphon order to evaluate the effect of pulsate surface heat flux on the single-phase buoyancy driven convection of ethylene glycol flow through a minichannels heat sink with hydraulic diameter 1.5 mm. An electric heater block is used to supply the heat flux to minichannels heat sink in a rectangle waveform. The study is done at different heat flux frequencies of 2.777×10-3 Hz, 8.333×10-4 Hz, 5.555×10-4 Hz and 4.166×10-4 Hz, while the heat flux amplitude (2 watt), Rayleigh number (1864) and duty cycle (50 %) are kept constant. The results revealed that for a range of the measured frequency for the complete power cycle and due to unsteady state operation conditions, the pulse heat flux pattern is close to a rectangle-wave, this generates the fluid outlet temperature pattern close to a triangle-wave. The fluid outlet temperature increases with the decreases of heat flux frequency and tends to reach to the fluid outlet temperature for a constant and continuous heat flux case. Due to closed-loop of thermosyphon, the fluid inlet temperature is changed in pattern like that the fluid outlet temperature change.
- 1 May 2021
- Published by Yildiz Technical University in Journal of Thermal Engineering
- Vol. 7 (4) , 1030-1038
A LOOP THERMOSYPHON FOR LIQUID COOLED MINICHANNELS HEAT SINK WITH PULSATE SURFACE HEAT FLUX
The period operation of power electronic acts as switching element, where the power dissipated consists of pulses at certain duty cycle, the semiconductor temperature oscillates and varies as a waveform. In the present study, an experimental investigation was carried out for a loop thermosyphon order to evaluate the effect of pulsate surface heat flux on the single-phase buoyancy driven convection of ethylene glycol flow through a minichannels heat sink with hydraulic diameter 1.5 mm. An electric heater block is used to supply the heat flux to minichannels heat sink in a rectangle waveform. The study is done at different heat flux frequencies of 2.777×10-3 Hz, 8.333×10-4 Hz, 5.555×10-4 Hz and 4.166×10-4 Hz, while the heat flux amplitude (2 watt), Rayleigh number (1864) and duty cycle (50 %) are kept constant. The results revealed that for a range of the measured frequency for the complete power cycle and due to unsteady state operation conditions, the pulse heat flux pattern is close to a rectangle-wave, this generates the fluid outlet temperature pattern close to a triangle-wave. The fluid outlet temperature increases with the decreases of heat flux frequency and tends to reach to the fluid outlet temperature for a constant and continuous heat flux case. Due to closed-loop of thermosyphon, the fluid inlet temperature is changed in pattern like that the fluid outlet temperature change.
- 28 April 2013
- Published by Taylor & Francis in Numerical Heat Transfer, Part A: Applications
- Vol. 64 (1) , 72-91
Natural Convection in an Enclosure with a Partially Active Magnetic Field
Chaotic natural convection flow of a molten gallium in a square enclosure with the upper and lower surfaces being insulated was studied by two-dimensional numerical simulation. Constant temperatures are imposed along the left and right walls of the enclosure with a volumetrically heated enclosure. In addition, a nonuniform partially active magnetic field is applied in a vertical direction. The flux lines spread out into a fringing field so the effective cross-sectional area of the gap is larger than that of the pole face. A chaotic regime is considered under steady state boundary condition. This study was done for an internal Rayleigh number of 107, external Rayleigh number of 105, and Prandtl number of 0.024. The study covers various magnet pole effect widths of 1/4, 1/2, and 3/4 from enclosure width and the magnetic field strength ranges 0.0 ≤ B o ≤ 10 Tesla. The transport equations for continuity, momentum, and energy are solved. The numerical results are reported for the effect of the partially active magnetic field on the velocity vectors, counters of temperature, streamline, and heat transfer coefficient. The numerical study shows that a magnetic field is damping chaotic oscillation behavior and decreases the amplitude of oscillation. Also, at a certain magnetic field strength the chaotic flow tend to becomes periodic flow at certain amplitude and frequency, and at high magnetic field strength the flow in the square enclosure flow tends to become steady laminar flow with stable average Nusselt number values; so, the random oscillation behavior disappeared. The effect of a nonuniform magnetic field tends to push the fluid to flow away from magnetic field region.
- 28 April 2013
- Published by Taylor & Francis in Numerical Heat Transfer, Part A: Applications
- Vol. 64 (1) , 72-91
Natural Convection in an Enclosure with a Partially Active Magnetic Field
Chaotic natural convection flow of a molten gallium in a square enclosure with the upper and lower surfaces being insulated was studied by two-dimensional numerical simulation. Constant temperatures are imposed along the left and right walls of the enclosure with a volumetrically heated enclosure. In addition, a nonuniform partially active magnetic field is applied in a vertical direction. The flux lines spread out into a fringing field so the effective cross-sectional area of the gap is larger than that of the pole face. A chaotic regime is considered under steady state boundary condition. This study was done for an internal Rayleigh number of 107, external Rayleigh number of 105, and Prandtl number of 0.024. The study covers various magnet pole effect widths of 1/4, 1/2, and 3/4 from enclosure width and the magnetic field strength ranges 0.0 ≤ B o ≤ 10 Tesla. The transport equations for continuity, momentum, and energy are solved. The numerical results are reported for the effect of the partially active magnetic field on the velocity vectors, counters of temperature, streamline, and heat transfer coefficient. The numerical study shows that a magnetic field is damping chaotic oscillation behavior and decreases the amplitude of oscillation. Also, at a certain magnetic field strength the chaotic flow tend to becomes periodic flow at certain amplitude and frequency, and at high magnetic field strength the flow in the square enclosure flow tends to become steady laminar flow with stable average Nusselt number values; so, the random oscillation behavior disappeared. The effect of a nonuniform magnetic field tends to push the fluid to flow away from magnetic field region.