Emma A. B. Davis
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Emma A. B. Davis has a total of 1000 co-authors. Here are the top co-authors by number of shared publications:
A. Brzostowicz
University of Colorado at Boulder, Boulder, CO 80309-0390, USA
1 shared publication- A. J. Croteau
University of Colorado at Boulder, Boulder, CO 80309-0390, USA
1 shared publication A. J. Garscadden
University of Colorado at Boulder, Boulder, CO 80309-0390, USA
1 shared publicationAbbey Erickson
University of Colorado at Boulder, Boulder, CO 80309-0390, USA
1 shared publicationAbby Barmore
University of Colorado at Boulder, Boulder, CO 80309-0390, USA
1 shared publicationAbdulaziz Naqi
University of Colorado at Boulder, Boulder, CO 80309-0390, USA
1 shared publication
Latest Publications
- 16 March 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (11)
High-throughput microwave package for precise superconducting device measurement
Cryogenic microwave measurement of superconducting quantum devices is complicated by the packaging required to connect devices to control and read out circuitry. In this work, we outline the design and experimental demonstration of a wirebond-free, PCB-free, drop-in microwave package for on-chip superconducting quantum devices. Once a chip is prepared for installation, the proposed package enables device exchange in about 1 min, with no special equipment required. The package is composed of a superconducting aluminum enclosure with a suspended tungsten transmission pin which couples to on-chip resonators in a hanger-style geometry, enabling broadband transmission measurements without on-chip feedlines or wirebonds. The fundamental package cavity mode is far detuned from the 4 to 8 GHz band of interest and does not participate in resonator readout. We demonstrate the use of this package to extract the loss tangent of superconducting ring resonators, measuring a value of (1.10±0.09)×10−6, which agrees with measurements of λ/4 resonators in wirebond-based packaging. This high-throughput measurement system will allow the rapid generation of large datasets for improving superconducting qubit performance, and facilitate time-sensitive surface passivation and oxide regrowth studies.
- 16 March 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (11)
High-throughput microwave package for precise superconducting device measurement
Cryogenic microwave measurement of superconducting quantum devices is complicated by the packaging required to connect devices to control and read out circuitry. In this work, we outline the design and experimental demonstration of a wirebond-free, PCB-free, drop-in microwave package for on-chip superconducting quantum devices. Once a chip is prepared for installation, the proposed package enables device exchange in about 1 min, with no special equipment required. The package is composed of a superconducting aluminum enclosure with a suspended tungsten transmission pin which couples to on-chip resonators in a hanger-style geometry, enabling broadband transmission measurements without on-chip feedlines or wirebonds. The fundamental package cavity mode is far detuned from the 4 to 8 GHz band of interest and does not participate in resonator readout. We demonstrate the use of this package to extract the loss tangent of superconducting ring resonators, measuring a value of (1.10±0.09)×10−6, which agrees with measurements of λ/4 resonators in wirebond-based packaging. This high-throughput measurement system will allow the rapid generation of large datasets for improving superconducting qubit performance, and facilitate time-sensitive surface passivation and oxide regrowth studies.
- Open Access
- 1 May 2023
- Published by American Astronomical Society in The Astrophysical Journal
- Vol. 948 (2) , 71
Coronal Heating as Determined by the Solar Flare Frequency Distribution Obtained by Aggregating Case Studies
Flare frequency distributions represent a key approach to addressing one of the largest problems in solar and stellar physics: determining the mechanism that counterintuitively heats coronae to temperatures that are orders of magnitude hotter than the corresponding photospheres. It is widely accepted that the magnetic field is responsible for the heating, but there are two competing mechanisms that could explain it: nanoflares or Alfvén waves. To date, neither can be directly observed. Nanoflares are, by definition, extremely small, but their aggregate energy release could represent a substantial heating mechanism, presuming they are sufficiently abundant. One way to test this presumption is via the flare frequency distribution, which describes how often flares of various energies occur. If the slope of the power law fitting the flare frequency distribution is above a critical threshold, α = 2 as established in prior literature, then there should be a sufficient abundance of nanoflares to explain coronal heating. We performed >600 case studies of solar flares, made possible by an unprecedented number of data analysts via three semesters of an undergraduate physics laboratory course. This allowed us to include two crucial, but nontrivial, analysis methods: preflare baseline subtraction and computation of the flare energy, which requires determining flare start and stop times. We aggregated the results of these analyses into a statistical study to determine that α = 1.63 ± 0.03. This is below the critical threshold, suggesting that Alfvén waves are an important driver of coronal heating.
- 1 May 2023
- Published by American Astronomical Society in The Astrophysical Journal
- Vol. 948 (2) , 71
Open AccessCoronal Heating as Determined by the Solar Flare Frequency Distribution Obtained by Aggregating Case Studies
Flare frequency distributions represent a key approach to addressing one of the largest problems in solar and stellar physics: determining the mechanism that counterintuitively heats coronae to temperatures that are orders of magnitude hotter than the corresponding photospheres. It is widely accepted that the magnetic field is responsible for the heating, but there are two competing mechanisms that could explain it: nanoflares or Alfvén waves. To date, neither can be directly observed. Nanoflares are, by definition, extremely small, but their aggregate energy release could represent a substantial heating mechanism, presuming they are sufficiently abundant. One way to test this presumption is via the flare frequency distribution, which describes how often flares of various energies occur. If the slope of the power law fitting the flare frequency distribution is above a critical threshold, α = 2 as established in prior literature, then there should be a sufficient abundance of nanoflares to explain coronal heating. We performed >600 case studies of solar flares, made possible by an unprecedented number of data analysts via three semesters of an undergraduate physics laboratory course. This allowed us to include two crucial, but nontrivial, analysis methods: preflare baseline subtraction and computation of the flare energy, which requires determining flare start and stop times. We aggregated the results of these analyses into a statistical study to determine that α = 1.63 ± 0.03. This is below the critical threshold, suggesting that Alfvén waves are an important driver of coronal heating.