Chunhua Xiao

The impact of supercooled water droplets is the cause of aircraft icing, and the acquisition of impingement characteristics is the key to icing prediction and the design of ice protection systems. The introduction of water droplet collection efficiency is required to obtain the characteristics for the Lagrangian method. In this work, a traditional flow tube method, a local flow tube method, and a statistical method are established to calculate the local collection efficiency, based on Lagrangian droplet trajectories. Through the numerical simulations of the air–droplet flow field around an NACA 0012 airfoil, the accuracies of the three methods in regard to collection efficiency are verified. Then, these three methods are applied to obtain the results for water droplet trajectories and the collection efficiency of an S-shaped duct, a 2D engine cone section and an icing wind tunnel. The results show that the distributions of water droplet collection efficiency obtained by the three methods are consistent and the three methods are all feasible when the water droplets do not overlap or cross before hitting the aircraft surfaces. When the water droplets are shadowed by upstream surfaces or blown by air injection, the droplet trajectories might overlap or even cross, and the local collection efficiencies obtained by the traditional flow tube method, local flow tube method, and statistical method might differ. The statistical method is relatively accurate. However, not all the droplet impingement characteristics obtained by the three methods are different due to these effects, and the non-crossing of the droplet trajectories is not a necessary condition for the use of the flow tube method. The effects of trajectory crossings are analyzed and discussed in detail in different situations for the three methods. This work is helpful for understanding and accurately calculating the droplet impingement characteristics and is of great significance for simulations of the aircraft icing process and anti/de-icing range.

Current research shows that the wavy shape can play an important role in drag reduction. Meanwhile, it also has the potential of noise reduction. In the present study, a kind of wavy shape of periodic cosine profile with a large spanwise wavelength and large aspect ratio was applied to the circular cylinder model. The experiments on the influence of various aspect ratios (ratio of wave wavelength to amplitude) on the far-field noise of the wavy cylinder were carried out in a 0.55 m × 0.4 m aeroacoustic wind tunnel. It is shown that the maximum decrease of the far-field SPL (Sound Pressure Level) between the wavy cylinder and baseline cylinder exceeded 37 dB within the frequency between 200 Hz and 1000 Hz. The noise reduction effect of the wavy cylinder will become better along with the increasing aspect ratio. However, there exists a critical aspect ratio near λ/a = 30. If the aspect ratio continues increasing, the noise reduction effect of the wavy cylinder will decrease instead of increasing. Finally, the computational fluid dynamics method is applied to reveal the noise reduction mechanism of this kind of wavy cylinder with a large spanwise wavelength and large aspect ratio. It is found that the periodic shedding vortex is disturbed and tends to be banded instead of showing alternate oscillation. The turbulence intensity and velocity fluctuation around the wavy cylinder will be also reduced. According to the vortex and sound theory, these changes are beneficial to the noise reduction. The large spanwise wavelength and large aspect ratio play a significant role in controlling the shedding vortex variation and adjusting the local flow field around the crest and trough of the wavy cylinder, which is the key factor to change the flow field and reduce the flow-noise of the wavy cylinder.