Vandana Kumari
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Vandana Kumari has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Manoj Saxena
Deen Dayal Upadhyaya College, University of Delhi
27 shared publications - Mridula Gupta
University of Delhi South Campus
18 shared publications - Ritesh Gupta
Department of Electronics and Communication Engineering, Maharaja Agrasen Institute of Technology, New Delhi, India
6 shared publications - Khushwant Sehra
University of Delhi
5 shared publications - Mridula Gupta
Semiconductor Devices Research Laboratory, Department of Electronic Science, University of Delhi South Campus, New Delhi 110021, India
5 shared publications D. S. Rawal
Solid State Physics Laboratory, Defence Research & Development Organization
2 shared publications
Latest Publications
- 1 November 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (21) , 215333
Reliability evaluation of DG JL and DG IM MOSFETs under oxide trap-induced degradation
In this paper, a reliability based comparative analysis between conventional double gate inversion mode (DG IM) and junctionless (DG JL) MOSFET has been presented using the Silvaco TCAD. By altering the gate workfunction, the devices are tuned to have the same threshold voltage for fair comparison. Later on, the interface trap charges are included at the oxide/silicon channel interface and the reliability of both devices is assessed by calculating the shift in the threshold voltage brought up by the applied gate voltage stress and sweeping the voltage from 0 to 2 V and then 2 to 0 V. Apart from this, the change in the trans conductance ( g m ), drain conductance ( g d ) and device gain ( g m / g d ) has also been computed by applying the gate and drain voltage stress. According to the computed results, the DG JL MOSFET shows a substantially lesser variation in the calculated V TH after changing the trap density and energy (during forward gate voltage sweep) than the DG IM MOSFET. Additionally, the impact of varying parameters such as temperature, oxide thickness, channel doping, trap density, and its location (energy level) on the shift in the device parameters has been determined. The research also calculates and presents the impact of bias stress on the device breakdown voltage.
- 1 November 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (21) , 215333
Reliability evaluation of DG JL and DG IM MOSFETs under oxide trap-induced degradation
In this paper, a reliability based comparative analysis between conventional double gate inversion mode (DG IM) and junctionless (DG JL) MOSFET has been presented using the Silvaco TCAD. By altering the gate workfunction, the devices are tuned to have the same threshold voltage for fair comparison. Later on, the interface trap charges are included at the oxide/silicon channel interface and the reliability of both devices is assessed by calculating the shift in the threshold voltage brought up by the applied gate voltage stress and sweeping the voltage from 0 to 2 V and then 2 to 0 V. Apart from this, the change in the trans conductance ( g m ), drain conductance ( g d ) and device gain ( g m / g d ) has also been computed by applying the gate and drain voltage stress. According to the computed results, the DG JL MOSFET shows a substantially lesser variation in the calculated V TH after changing the trap density and energy (during forward gate voltage sweep) than the DG IM MOSFET. Additionally, the impact of varying parameters such as temperature, oxide thickness, channel doping, trap density, and its location (energy level) on the shift in the device parameters has been determined. The research also calculates and presents the impact of bias stress on the device breakdown voltage.
- 1 October 2026
- Published by Springer Nature in Microsystem Technologies
- Vol. 32 (12) , 189
Simulation-based optimization of InAlN/GaN HEMT for ultraviolet sensing applications
- 1 October 2026
- Published by Springer Nature in Microsystem Technologies
- Vol. 32 (12) , 189
Simulation-based optimization of InAlN/GaN HEMT for ultraviolet sensing applications
- 2 September 2026
- Published by Springer Nature
- p. 671-683
Impact of γ-Ray Irradiation on Π-Shaped Gate AlGaN/GaN HEMTs
- 2 September 2026
- Published by Springer Nature
- p. 671-683
Impact of γ-Ray Irradiation on Π-Shaped Gate AlGaN/GaN HEMTs
- 24 July 2025
- Published by Springer Nature
- p. 133-139
γ-Ray Induced Effects on COTS E-Mode p-GaN AlGaN/GaN HEMTs
- 24 July 2025
- Published by Springer Nature
- p. 133-139
γ-Ray Induced Effects on COTS E-Mode p-GaN AlGaN/GaN HEMTs
- 1 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (9) , 5289-5295
RF Performance Augmentation Using DG-InAlN/GaN HEMT
The work presented in this study examines the behavior of InAlN/GaN high electron mobility transistor (HEMT) by scaling down the device geometry, including the gate length and barrier thickness, at various operating temperatures. Extensive simulation has been performed using Silvaco’s Victory TCAD simulator tool to analyze the dc and RF performance of InAlN HEMT in terms of ${I}_{\text {on}}/{I}_{\text {off}}$ , intrinsic gain, DIBL, and cutoff frequency. To strengthen the RF performance at increased device length, dual gate (DG) architecture [i.e., Gate 1 (G1) and Gate 2 (G2)] has been adopted, and different gate biasing combinations have been used to investigate the device performance. A tradeoff among intrinsic gain and cutoff frequency is noted from the results. An increment in the cutoff frequency of nearly 57% has been obtained with the introduction of DG along with a deterioration in intrinsic gain.
- 1 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (9) , 5289-5295
RF Performance Augmentation Using DG-InAlN/GaN HEMT
The work presented in this study examines the behavior of InAlN/GaN high electron mobility transistor (HEMT) by scaling down the device geometry, including the gate length and barrier thickness, at various operating temperatures. Extensive simulation has been performed using Silvaco’s Victory TCAD simulator tool to analyze the dc and RF performance of InAlN HEMT in terms of ${I}_{\text {on}}/{I}_{\text {off}}$ , intrinsic gain, DIBL, and cutoff frequency. To strengthen the RF performance at increased device length, dual gate (DG) architecture [i.e., Gate 1 (G1) and Gate 2 (G2)] has been adopted, and different gate biasing combinations have been used to investigate the device performance. A tradeoff among intrinsic gain and cutoff frequency is noted from the results. An increment in the cutoff frequency of nearly 57% has been obtained with the introduction of DG along with a deterioration in intrinsic gain.
- 25 July 2024
- Published by Springer Nature in Microsystem Technologies
- Vol. 31 (11) , 3041-3053
Assessing single event upset susceptibility of InAlN HEMT with cap layer under heavy-ion environment
- 25 July 2024
- Published by Springer Nature in Microsystem Technologies
- Vol. 31 (11) , 3041-3053
Assessing single event upset susceptibility of InAlN HEMT with cap layer under heavy-ion environment
- 19 June 2024
- Published by Elsevier in Materials Science and Engineering: B
- Vol. 307
Exploring linearity & radiation characteristics in Slant Field Plate MISHEMT (SFP-MISHEMT)
- 19 June 2024
- Published by Elsevier in Materials Science and Engineering: B
- Vol. 307
Exploring linearity & radiation characteristics in Slant Field Plate MISHEMT (SFP-MISHEMT)
- 31 May 2024
- Published by Springer Nature
- p. 127-140
Comparative Investigation of Single and Double Channel AlGaN/GaN HEMTs for LNAs
- 31 May 2024
- Published by Springer Nature
- p. 127-140
Comparative Investigation of Single and Double Channel AlGaN/GaN HEMTs for LNAs
- 16 May 2023
- Published by Springer Nature in Silicon
- Vol. 15 (14) , 6215-6228
Investigation of SiNx Passivated Dual Field Plate AlGaN/GaN HEMTs on Silicon Carbide and Sapphire Substrates Under Radiation Environment
- 16 May 2023
- Published by Springer Nature in Silicon
- Vol. 15 (14) , 6215-6228
Investigation of SiNx Passivated Dual Field Plate AlGaN/GaN HEMTs on Silicon Carbide and Sapphire Substrates Under Radiation Environment
- 28 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 23 (1) , 308-316
Sensitivity Investigation of Planer Ground Plane Junctionless Transistor (GP-JLT) for UVA Photodetector
In the present work, the suitability of bulk junctionless transistors (JLTs) having a ground plane (GP) layer within buried oxide (BOX) (i.e., HfO2 as oxide material) has been demonstrated for detecting long-wavelength ultraviolet (UVA) light (i.e., in the range of 315–400 nm). Comparisons have been performed with the conventional bulk silicon on insulator (SOI) JLT to explore the suitability of the incorporated GP in the high- ${k}$ BOX region for the detection of UVA light. The incorporated GP in the SOI JLT (having high- ${k}$ BOX) spreads the electric field (EF) toward the drain side, which further signifies diminished leakage current (at zero gate bias) and hence higher sensitivity against the UVA light. Improvement in the device sensitivity against the UVA light has also been observed by tuning the GP depth ( ${d}_{\text {GP}}{)}$ (i.e., lower ${d}_{\text {GP}}$ results in improved sensitivity ( $3\times 10^{{3}}$ to $1\times 10^{{5}}{)}$ and higher ${I}_{\text {on}}/{I}_{\text {off}}{)}$ . The doping of the GP layer at ${d}_{\text {GP}} =10$ nm further helps in improving the device sensitivity, especially from $3.4\times 10^{{3}}$ to 1.73 $\times 10^{{5}}$ which is almost similar to the sensitivity achieved from the device at ${d}_{\text {GP}} =$ 4 nm (i.e., $2.2\times 10^{{5}}{)}$ . Using S/D having a workfunction of 3.9 eV, further improvement in sensitivity has been achieved, which is significantly high at ${d}_{\text {GP}} =10$ nm (almost double) when compared to ${d}_{\text {GP}} =$ 4 nm (18% improvement in the ${I}_{\text {light}}/{I}_{\text {dark}}$ ratio). The high- ${k}$ gate oxide also enhances the device sensitivity at the cost of increased decay time (i.e., when the device is completely turned off). Results also demonstrated that the impact of parameter variation is lower at ${d}_{\text {GP}} =$ 4 nm compared to ${d}_{\text {GP}} =10$ nm.
- 28 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 23 (1) , 308-316
Sensitivity Investigation of Planer Ground Plane Junctionless Transistor (GP-JLT) for UVA Photodetector
In the present work, the suitability of bulk junctionless transistors (JLTs) having a ground plane (GP) layer within buried oxide (BOX) (i.e., HfO2 as oxide material) has been demonstrated for detecting long-wavelength ultraviolet (UVA) light (i.e., in the range of 315–400 nm). Comparisons have been performed with the conventional bulk silicon on insulator (SOI) JLT to explore the suitability of the incorporated GP in the high- ${k}$ BOX region for the detection of UVA light. The incorporated GP in the SOI JLT (having high- ${k}$ BOX) spreads the electric field (EF) toward the drain side, which further signifies diminished leakage current (at zero gate bias) and hence higher sensitivity against the UVA light. Improvement in the device sensitivity against the UVA light has also been observed by tuning the GP depth ( ${d}_{\text {GP}}{)}$ (i.e., lower ${d}_{\text {GP}}$ results in improved sensitivity ( $3\times 10^{{3}}$ to $1\times 10^{{5}}{)}$ and higher ${I}_{\text {on}}/{I}_{\text {off}}{)}$ . The doping of the GP layer at ${d}_{\text {GP}} =10$ nm further helps in improving the device sensitivity, especially from $3.4\times 10^{{3}}$ to 1.73 $\times 10^{{5}}$ which is almost similar to the sensitivity achieved from the device at ${d}_{\text {GP}} =$ 4 nm (i.e., $2.2\times 10^{{5}}{)}$ . Using S/D having a workfunction of 3.9 eV, further improvement in sensitivity has been achieved, which is significantly high at ${d}_{\text {GP}} =10$ nm (almost double) when compared to ${d}_{\text {GP}} =$ 4 nm (18% improvement in the ${I}_{\text {light}}/{I}_{\text {dark}}$ ratio). The high- ${k}$ gate oxide also enhances the device sensitivity at the cost of increased decay time (i.e., when the device is completely turned off). Results also demonstrated that the impact of parameter variation is lower at ${d}_{\text {GP}} =$ 4 nm compared to ${d}_{\text {GP}} =10$ nm.