JHJános Hegedüs

János Hegedüs

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


János Hegedüs has a total of 28 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • SUPPORT AND SUPPRESSION OF ANALOGUE NIGHT VISION DEVICES USING IR LEDS

    by János Hegedüs, Gusztáv Hantos, András Poppe

    Each generation of analogue night vision devices has significant technical differences. Basically, all parameters have improved on average during the generation changes. However, the significant difference in the wavelength-dependent characteristics of the sensitivity of photocathode materials represents a gap through which an active radiating source can be created with the help of an appropriate design process, which can even put the newer generations at a disadvantage compared to the old ones. For an active radiant source, infrared LEDs may be an obvious choice. Their operation is strongly temperature-dependent and even device aging may have to be taken into account, but nowadays suitable and fast circuit-simulation modelling solutions already exist to deal with such issues. The proposed device for supporting and suppressing analogue night vision devices requires system-level simulations with an Industry 4.0 approach. This paper discusses the design steps and theoretical results of such a procedure.

  • LIFETIME MULTI-DOMAIN MODELING OF MID-POWER LEDS

    by Márton Németh, János Hegedüs, Gusztáv Hantos, András Poppe

    This paper presents the LED modelling work carried out in the AI-TWILIGHT H2020 Ecsel project. The new multi-domain LED model was developed based on measurement results of a comprehensive aging test carried out by an international collaboration of three academic laboratories. In addition to elapsed operating time, the new model also considers past stress conditions, i.e. forward current and temperature profiles. The predictive power was tested by fitting the model to measurement results performed during a pre-defined minimum test time, then comparing the resulting simulation results with real measurement data obtained at later times. The power of modelling different stress conditions was also verified by swapping the stress conditions for 2 x 2 sets of LED samples under test and continuing the aging test in this manner, thereby mimicking a sudden change in the LED samples’ mission profiles resulting also in a change of the consumption rate of their lifetime-budget.


  • RESULTS OF THE JOINT LED AGING EXPERIMENT OF THREE UNIVERSITY LABORATORIES WITHIN THE AI-TWILIGHT PROJECT

    by Gusztáv Hantos, János Hegedüs, András Poppe, Alexander Herzog, Alessandro Caria, Matteo Buffolo, Carlo De Santi, Nicola Trivellin, Enrico Zanoni, Matteo Meneghini

    In this paper, a detailed description of the mid-power LED aging experiment carried out within the AI-TWILIGHT H2020 ECSEL project shall be provided. This was a mitigation action, called the JointLab project to provide detailed LED aging data to allow the creation of even LED-age dependent multi-domain models with the timeframe of the 3 years of AI-TWILIGHT. This was an extended LM-80 test with the collaboration of the laboratories of three academic partners, during which a large space of stress conditions applied during the aging process was covered and a set of measurements more detailed than usual in a standard LM-80 lifetime test had been performed at the predetermined intervals, more frequently than in most LM-80 tests. The goal was to create a so-called multi-domain circuit simulation model that could also describe the effect of LED aging as a function of the elapsed operating time and operating conditions.


  • Open Access

    Thermal Characterization Methods of Novel Substrate Materials Utilized in IGBT Modules

    by János Hegedüs, Péter Gábor Szabó, László Pohl, Gusztáv Hantos, Gyula Lipák, Andrea Reolon, Ferenc Ender

    In this article, thermal investigation methods for electrically insulating and thermally conductive substrate materials will be presented. The investigations were performed in their real-world application environment, i.e., in the form of IGBT (insulated gate bipolar transistor) module substrate plates. First, the overall thermal resistance and thermal structure function of the system in a multivariable parameter space were revealed using CFD (computational fluid dynamics) simulations. Afterwards, thermal transient testing was performed on real samples, with the help of which the thermal resistance values of the modules were determined using the thermal dual interface test method. The presented tests are not intended to determine material parameters, but to rank different substrate materials based on their thermal performance.


  • Open Access

    Parameter Extraction for a SPICE-like Delphi4LED Multi-Domain Chip-Level LED Model with an Improved Nelder–Mead Method

    by Márton Németh, János Hegedüs, Gusztáv Hantos, Ali Kareem Abdulrazzaq, András Poppe

    In this paper, a novel method is presented to estimate the parameters of the SPICE-like multi-domain model of light-emitting diode (LED) chips developed and proposed by the Delphi4LED project. The proposed estimation algorithm employs a modified Nelder-Mead method, as the gradient methods and the original version of Nelder-Mead fail to properly handle this problem. By using the new, modified Nelder-Mead method presented in this paper the parameters are estimated faster, compared to the previously used brute-force algorithm-based parameter extraction process, allowing the same precision of the SPICE-like multi-domain LED model. The modification of the parameter extraction procedure also allows speeding up and simplifying the multi-domain LED characterization method proposed earlier by the Delphi4LED project. The speed and robustness of the new model eliminate the need for time-consuming junction temperature control during measurements by employing a novel extraction strategy that seeks the global minimum, rather than relying on the composition of marginal minima.


  • Open Access

    Climatically Accelerated Material Processes Determining the Long-Term Reliability of Light-Emitting Diodes

    by Gabor Harsanyi, Andras Poppe, Janos Hegedüs, Gusztav Hantos, Peter Bojta, Robert Kovacs

    LEDs (Light-Emitting Diodes) are widely applied not only in decorative illumination but also in everyday lighting in buildings, flats, public areas, and automotive fields. These application areas often mean harsh environments, for example, regarding the humidity content of the surrounding air: besides outdoor and automotive illumination, even the household use cases (kitchen, bathroom, cellar) may represent extreme temperature and humidity variations (often reaching relative humidity levels close to 100%) for these devices; thus, their reliability behaviour in such circumstances should be better understood. Thermally activated processes were studied in several previous publications, but less information is available regarding high-humidity environmental tests. Moisture and temperature ageing tests with appropriate environmental parameter settings were performed as accelerated lifetime tests to investigate not only the effect of temperature but also that of humidity on the ageing and reliability of LED packages containing RGB (red green blue) chips and phosphor-converted white (pcW) LEDs. The ageing was followed not only through monitoring optical/electrical/spectral parameters but also with material analysis. Moisture–material interaction models were proposed and set up. It was found that humidity-accelerated ageing processes are more severe than expected from previous assumptions. RGB and pcW LEDs showed strongly different behaviour.


  • Lifetime Test of Pulsewidth Modulated LEDs Supplemented With Thermal Investigations

    by János Hegedüs, Gusztáv Hantos, Máté Lukács, Bence Bodnár, Gyula Lipák, András Poppe

    The ability to dim LEDs is a big advantage compared to previous light sources, but it can also lead to new aging mechanisms. Due to the different coefficients of thermal expansion of the individual structural layers, the temperature cycle can negatively affect the main thermal path. In this article, we investigate how different dimming frequencies influence the aging of LEDs and to what extent they impair the thermal conductivity of structural layers belonging to different thermal time constants. In this paper the methodology of the joint examination of the integral structure function and the time constant spectrum is described, i.e. the determination of the time constants and the frequency values that expose the individual structural layers to the most mechanical stress. The theoretical results are demonstrated using an LM-80 based LED lifetime test supplemented with thermal transient testing which is also presented in this paper.