Abdelghani Mouzai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Abdelghani Mouzai has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
A. Kheroufi
Laboratoire de Génie Agro-Alimentaire (GENIAAL), Équipe Génie des Procédés Alimentaires, Biodiversité et Agroenvironnement (GPABAE), INATAA Université frères Mentouri Constantine 1, Constantine, 25000, Algeria
1 shared publication- Afaf Kheroufi
Laboratoire de Génie Agro-Alimentaire (GENIAAL), Équipe Génie des Procédés Alimentaires, Biodiversité et Agroenvironnement (GPABAE), INATAA Université Frères Mentouri Constantine 1, Constantine 25000, Algeria
1 shared publication - Anna Mituniewicz-Małek
Department of Toxicology, Dairy Technology and Food Storage, Faculty of Food Sciences and Fisheries, West Pomeranian University of Technology, Papieża Pawła VI St. no. 3, 71-459 Szczecin, Poland
1 shared publication H. Boughellout
Laboratoire de Génie Agro-Alimentaire (GENIAAL), Équipe Génie des Procédés Alimentaires, Biodiversité et Agroenvironnement (GPABAE), INATAA Université frères Mentouri Constantine 1, Constantine, 25000, Algeria
1 shared publication- Halima Boughellout
Agri-Food Engineering (GENIAAL) Laboratory, Food Process Engineering, Biodiversity and Agro-Environment Team, Institute of Nutrition, Food and Agri-Food Technology (INATAA), Frères Mentouri Constantine 1 University (UFMC1), Constantine 25017, Algeria
1 shared publication - Izabela Dmytrów
Department of Toxicology, Dairy Technology and Food Storage, Faculty of Food Sciences and Fisheries, West Pomeranian University of Technology in Szczecin, Pawła VI Street No. 3, 71-459 Szczecin, Poland
1 shared publication
Latest Publications
- Open Access
- 30 March 2026
- Published by MDPI AG in Applied Sciences
- Vol. 16 (7) , 3323
Impact of the Drying Agents Maltodextrin and Gelatin Used in Whey Powders on the Quality Characteristics of Yogurt
Drying agents used in the process of spray drying whey enhance the quality of whey powders and may consequently improve the properties of yogurts to which these powders are added. This study examined the quality characteristics of yogurts enriched with whey powders using maltodextrin or gelatin as drying agents. The following yogurt variants were produced: a control (C) without whey powder; W with whey powder but without a drying agent; M with whey powder containing maltodextrin; and G with gelatin as a drying agent. Whey powders were added at a concentration of 1.5% (w/w). The samples were tested after 3, 6, 10 and 14 days of refrigerated storage (4 ± 1 °C), and analyses were performed in 3–6 repetitions. Enrichment of milk with powdered whey had a noticeable impact on the quality characteristics of yogurts. Fortified yogurts exhibited a significantly higher total solids content (11.43–12.22% in the control; 12.45–13.33% in W, G and M) and higher acetaldehyde concentration (0.31–1.11 ppm in the control; 0.44–1.82 ppm in W, G and M) than the control. Titratable acidity and pH varied among samples. However, the syneresis index was lower in the control yogurt (39.09–46.74%) than in yogurts with powdered whey (53.71–58.48%). Significant differences were observed in color parameters (L, a*, b*, WI, YI). The texture properties (firmness, consistency, cohesiveness, index of viscosity) of samples with whey powders had higher values than the control. In sensory evaluation, yogurts with whey powders obtained high scores. The study demonstrated that the use of maltodextrin or gelatin not only supports the process of spray drying whey but also alters the characteristics of the resulting yogurts. The impact of the study comes from the fact that it bridges the gap between whey processing (spray drying) and the formulation of the final product.
- 30 March 2026
- Published by MDPI AG in Applied Sciences
- Vol. 16 (7) , 3323
Open AccessImpact of the Drying Agents Maltodextrin and Gelatin Used in Whey Powders on the Quality Characteristics of Yogurt
Drying agents used in the process of spray drying whey enhance the quality of whey powders and may consequently improve the properties of yogurts to which these powders are added. This study examined the quality characteristics of yogurts enriched with whey powders using maltodextrin or gelatin as drying agents. The following yogurt variants were produced: a control (C) without whey powder; W with whey powder but without a drying agent; M with whey powder containing maltodextrin; and G with gelatin as a drying agent. Whey powders were added at a concentration of 1.5% (w/w). The samples were tested after 3, 6, 10 and 14 days of refrigerated storage (4 ± 1 °C), and analyses were performed in 3–6 repetitions. Enrichment of milk with powdered whey had a noticeable impact on the quality characteristics of yogurts. Fortified yogurts exhibited a significantly higher total solids content (11.43–12.22% in the control; 12.45–13.33% in W, G and M) and higher acetaldehyde concentration (0.31–1.11 ppm in the control; 0.44–1.82 ppm in W, G and M) than the control. Titratable acidity and pH varied among samples. However, the syneresis index was lower in the control yogurt (39.09–46.74%) than in yogurts with powdered whey (53.71–58.48%). Significant differences were observed in color parameters (L, a*, b*, WI, YI). The texture properties (firmness, consistency, cohesiveness, index of viscosity) of samples with whey powders had higher values than the control. In sensory evaluation, yogurts with whey powders obtained high scores. The study demonstrated that the use of maltodextrin or gelatin not only supports the process of spray drying whey but also alters the characteristics of the resulting yogurts. The impact of the study comes from the fact that it bridges the gap between whey processing (spray drying) and the formulation of the final product.
- 19 June 2023
- Published by Akademiai Kiado Zrt. in Acta Alimentaria
- Vol. 52 (2) , 220-234
Optimisation of spray drying parameters using mixed flow in whey powder production using response surface methodology (RSM)
This work explored the impact of mixed flow spray drying on the physical and functional properties of whey powder without any subsequently added drying agent to increase whey utilisation. Spray drying was performed on a pilot scale using a mixed flow spray dryer. The effects of the inlet air temperature (150–210 °C) and feed flow rate (2–7 L h−1) on several responses such as moisture content, yield, dispersibility, bulk density, and outlet air temperature were investigated using response surface methodology. In addition, with the optimised parameters, Carr index, Hausner ratio, solubility, wettability, hygroscopicity, degree of caking, crystallinity, and morphology of the obtained whey powder were determined. The investigation revealed that feed flow rate is the main parameter influencing all responses. The inlet air temperature significantly affected the bulk, tapped density, and outlet air temperature. The optimal inlet air temperature and feed flow rate for the production of whey powder were 182 °C and 3.2 L h−1, respectively. Under these parameters the moisture content, yield, bulk density, hygroscopicity, and degree of caking of the obtained product were 28.6, 1.80%, 0.24 g cm−3, 16.10 g H2O/g powder, and 85.56%, respectively.
- 19 June 2023
- Published by Akademiai Kiado Zrt. in Acta Alimentaria
- Vol. 52 (2) , 220-234
Optimisation of spray drying parameters using mixed flow in whey powder production using response surface methodology (RSM)
This work explored the impact of mixed flow spray drying on the physical and functional properties of whey powder without any subsequently added drying agent to increase whey utilisation. Spray drying was performed on a pilot scale using a mixed flow spray dryer. The effects of the inlet air temperature (150–210 °C) and feed flow rate (2–7 L h−1) on several responses such as moisture content, yield, dispersibility, bulk density, and outlet air temperature were investigated using response surface methodology. In addition, with the optimised parameters, Carr index, Hausner ratio, solubility, wettability, hygroscopicity, degree of caking, crystallinity, and morphology of the obtained whey powder were determined. The investigation revealed that feed flow rate is the main parameter influencing all responses. The inlet air temperature significantly affected the bulk, tapped density, and outlet air temperature. The optimal inlet air temperature and feed flow rate for the production of whey powder were 182 °C and 3.2 L h−1, respectively. Under these parameters the moisture content, yield, bulk density, hygroscopicity, and degree of caking of the obtained product were 28.6, 1.80%, 0.24 g cm−3, 16.10 g H2O/g powder, and 85.56%, respectively.