Sachin Balasaheb Shinde
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sachin Balasaheb Shinde has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Lalit Kumar
Indian Institute of Technology Bombay
5 shared publications - Aniruddha Sanyal
Department of Chemical Engineering, Indian Institute of Technology Roorkee , Roorkee 247667, Uttarakhand, India
1 shared publication - Farah Ansari
Department of Energy Science and Engineering, Indian Institute of Technology Bombay, Mumbai 400076, Maharashtra, India
1 shared publication - Kapil Dev Kumawat
IIT Bombay, IIT Area
1 shared publication Lomesh Tikariha
Department of Energy Science and Engineering, Indian Institute of Technology Bombay, Mumbai 400076, Maharashtra, India
1 shared publication
Latest Publications
- 29 January 2025
- Published by Society of Rheology in Journal of Rheology
- Vol. 69 (2) , 69-94
Startup flow with and without wall slip in a pipe plugged with weakly compressible complex fluids—A new insight
The present article explains the nontrivial synergetic effect of wall slip, compressibility, and thixotropy in a pressurized flow startup operation of various structured fluids. Opposite to intuition, experimental and numerical simulations suggest that the wall slip (adhesive failure) facilitates gel degradation (cohesive failure), revealing a new flow startup mechanism. The irreversible thixotropic rheological model, along with the static slip-based model, is utilized to describe the structural degradation kinetics in the bulk phenomenon and the near-wall phenomenon, respectively. The near-wall transient variations in axial velocity or strain evolution and the initial pressure propagation mechanism along the axis of the circular pipe explain the essence of the aforementioned synergy. Finally, a comparative study of the effect of wall slip on the pressure propagation mechanisms and startup flow of generalized Newtonian fluids, viscoelastic based thixotropic fluids, and viscoelastic solids is also performed. Wall slip can convert no-steady-state thixotropic elasto-viscoplastic flow cases into a steady-state fluid flow, whereas it causes viscoelastic solids to move with a slip velocity. Additionally, our study revealed that stick-slip phenomena occur at an acoustic time scale. It requires a compressive wave to travel with information of stick position to the outlet and again back to the inlet, concomitantly causing the release of additional fluid, thereby converting the stick to a slip regime. Conventionally, stick-slip phenomena were mainly associated with nonlinearity. Hence, our study opened a new direction. Finally, concomitant with the experimental observations, we found that stick-slip phenomena disappear when the fluid is uniformly compressed and a steady state is reached.
- 29 January 2025
- Published by Society of Rheology in Journal of Rheology
- Vol. 69 (2) , 69-94
Startup flow with and without wall slip in a pipe plugged with weakly compressible complex fluids—A new insight
The present article explains the nontrivial synergetic effect of wall slip, compressibility, and thixotropy in a pressurized flow startup operation of various structured fluids. Opposite to intuition, experimental and numerical simulations suggest that the wall slip (adhesive failure) facilitates gel degradation (cohesive failure), revealing a new flow startup mechanism. The irreversible thixotropic rheological model, along with the static slip-based model, is utilized to describe the structural degradation kinetics in the bulk phenomenon and the near-wall phenomenon, respectively. The near-wall transient variations in axial velocity or strain evolution and the initial pressure propagation mechanism along the axis of the circular pipe explain the essence of the aforementioned synergy. Finally, a comparative study of the effect of wall slip on the pressure propagation mechanisms and startup flow of generalized Newtonian fluids, viscoelastic based thixotropic fluids, and viscoelastic solids is also performed. Wall slip can convert no-steady-state thixotropic elasto-viscoplastic flow cases into a steady-state fluid flow, whereas it causes viscoelastic solids to move with a slip velocity. Additionally, our study revealed that stick-slip phenomena occur at an acoustic time scale. It requires a compressive wave to travel with information of stick position to the outlet and again back to the inlet, concomitantly causing the release of additional fluid, thereby converting the stick to a slip regime. Conventionally, stick-slip phenomena were mainly associated with nonlinearity. Hence, our study opened a new direction. Finally, concomitant with the experimental observations, we found that stick-slip phenomena disappear when the fluid is uniformly compressed and a steady state is reached.
- 17 June 2024
- Published by Society of Rheology in Journal of Rheology
- Vol. 68 (4) , 603-622
Influence of the thermal shrinkage-induced volume contraction on the yielding behavior of waxy oil
The present article investigates the effect of thermal shrinkage on the yielding behavior of waxy oil gel. The paper compares constant gap and constant normal force measurement protocols to examine the effect of measurement protocol on the rheological behavior of thermoreversible gel. The findings of this study reveal that the extent of stress overshoot and yield stress in a constant shear-rate start-up flow shows a lower magnitude in a constant gap protocol compared to a constant normal force protocol. The decrease in gel strength in the former protocol is mainly attributed to the formation of voids. These voids cause localized fractures within the crystal network. In contrast, in the constant normal force measurement protocol, gel contraction is compensated by utilizing a variable gap setting. Variable gaps compensate for the lower specific volume of the gel after crystallization, minimizing void formation and subsequent rupture of the crystal network. Hence, the gel network formed using the constant normal force protocol is more homogeneous, eliminating the uncertainties in yield stress measurement. Finally, the effect of thermal history, wax content, and aging period on the yield stress values highlights notable findings. Contrary to the conventionally accepted results, the aging period is found to impact the yield stress negatively, and a nonmonotonic relationship between the cooling rate and yield stress is noticed under the constant gap protocol. Thus, the results obtained under the constant normal force protocol are more reliable and can help in developing a fundamental understanding of the yielding behavior.
- 17 June 2024
- Published by Society of Rheology in Journal of Rheology
- Vol. 68 (4) , 603-622
Influence of the thermal shrinkage-induced volume contraction on the yielding behavior of waxy oil
The present article investigates the effect of thermal shrinkage on the yielding behavior of waxy oil gel. The paper compares constant gap and constant normal force measurement protocols to examine the effect of measurement protocol on the rheological behavior of thermoreversible gel. The findings of this study reveal that the extent of stress overshoot and yield stress in a constant shear-rate start-up flow shows a lower magnitude in a constant gap protocol compared to a constant normal force protocol. The decrease in gel strength in the former protocol is mainly attributed to the formation of voids. These voids cause localized fractures within the crystal network. In contrast, in the constant normal force measurement protocol, gel contraction is compensated by utilizing a variable gap setting. Variable gaps compensate for the lower specific volume of the gel after crystallization, minimizing void formation and subsequent rupture of the crystal network. Hence, the gel network formed using the constant normal force protocol is more homogeneous, eliminating the uncertainties in yield stress measurement. Finally, the effect of thermal history, wax content, and aging period on the yield stress values highlights notable findings. Contrary to the conventionally accepted results, the aging period is found to impact the yield stress negatively, and a nonmonotonic relationship between the cooling rate and yield stress is noticed under the constant gap protocol. Thus, the results obtained under the constant normal force protocol are more reliable and can help in developing a fundamental understanding of the yielding behavior.
- 16 December 2023
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (1) , 105-116
Analyzing the Role of Wax Crystal Morphology in Wax Inhibition Using Polymeric Additive
- 16 December 2023
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (1) , 105-116
Analyzing the Role of Wax Crystal Morphology in Wax Inhibition Using Polymeric Additive
- Open Access
- 11 July 2023
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 8 (29) , 25972-25987
Experimental and Numerical Investigation of the Degelation Behavior and Non-Isothermal Flow Restart of a Waxy Oil Pipeline
Flow assurance challenges associated with waxy crude oil precipitation at low ambient conditions are significant concerns for oil industries during production, transportation, and storage. Numerous methods have been employed to mitigate wax deposition and gelation issues. Since wax precipitation is temperature-sensitive, heating has emerged as a promising method to enhance oil flowability. The present work intends to examine the degelation behavior of waxy oil using rheometry, differential scanning calorimetry, and microscopy techniques. In addition, a non-isothermal flow restart simulation is performed using an in-house numerical simulator consisting of a rheological model of sol-gel transition developed in the current work. A numerical simulation of a preheated gelled pipeline demonstrates the significance of the degelation temperature. The effects of the wax concentration, initial gel temperature, and aging period on the degelation temperature are examined. The observed degelation temperature is higher than the gelation temperature, leading to thermal hysteresis. The extent of thermal hysteresis reduces with a decrease in the heating rate. The numerical simulation uses the finite volume method with variables placed on a staggered grid. The gel heated above and below the degelation temperature shows a significant variation in axial velocity profiles. However, further heating does not affect the velocity profiles. A shear banding type of effect is observed in the axial velocity profile above the degelation temperature. Heating the gelled oil to the degelation temperature instead of the wax disappearance temperature saves excessive heating energy during storage and transport operations.
- 11 July 2023
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 8 (29) , 25972-25987
Open AccessExperimental and Numerical Investigation of the Degelation Behavior and Non-Isothermal Flow Restart of a Waxy Oil Pipeline
Flow assurance challenges associated with waxy crude oil precipitation at low ambient conditions are significant concerns for oil industries during production, transportation, and storage. Numerous methods have been employed to mitigate wax deposition and gelation issues. Since wax precipitation is temperature-sensitive, heating has emerged as a promising method to enhance oil flowability. The present work intends to examine the degelation behavior of waxy oil using rheometry, differential scanning calorimetry, and microscopy techniques. In addition, a non-isothermal flow restart simulation is performed using an in-house numerical simulator consisting of a rheological model of sol-gel transition developed in the current work. A numerical simulation of a preheated gelled pipeline demonstrates the significance of the degelation temperature. The effects of the wax concentration, initial gel temperature, and aging period on the degelation temperature are examined. The observed degelation temperature is higher than the gelation temperature, leading to thermal hysteresis. The extent of thermal hysteresis reduces with a decrease in the heating rate. The numerical simulation uses the finite volume method with variables placed on a staggered grid. The gel heated above and below the degelation temperature shows a significant variation in axial velocity profiles. However, further heating does not affect the velocity profiles. A shear banding type of effect is observed in the axial velocity profile above the degelation temperature. Heating the gelled oil to the degelation temperature instead of the wax disappearance temperature saves excessive heating energy during storage and transport operations.
- 22 May 2023
- Published by Springer Nature
- p. 769-778
Experimental Investigation of Bubble Rising in Newtonian and Non-Newtonian Fluids: A Comparative Assessment
- 22 May 2023
- Published by Springer Nature
- p. 769-778
Experimental Investigation of Bubble Rising in Newtonian and Non-Newtonian Fluids: A Comparative Assessment