N. Raja
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
N. Raja has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- B. Sundarakannan
Manonmaniam Sundaranar University
3 shared publications - Prabhahari Veeramani
Centre for Nanoscience and Technology, Madanjeet School of Green Energy Technologies
3 shared publications Akila Prabhudessai
1 shared publicationAndrews Nirmala Grace
1 shared publicationD Murali
Indian Institute of Information Technology Design and Manufacturing, Kurnool, Andhra Pradesh 518002, India
1 shared publicationD.E. Jain Ruth
1 shared publication
Latest Publications
- Open Access
- 10 March 2026
- Published by Elsevier in Next Materials
- Vol. 11
Influence of copper substitution on the electronic structure and magnetic properties of SnO2 quantum dots: An experimental and DFT insights
- 10 March 2026
- Published by Elsevier in Next Materials
- Vol. 11
Open AccessInfluence of copper substitution on the electronic structure and magnetic properties of SnO2 quantum dots: An experimental and DFT insights
- 30 January 2026
- Published by Elsevier in Ceramics International
- Vol. 52 (9) , 12810-12825
Structural, electronic, and magnetic correlations governing multiferroic and magnetoelectric response in charge-compensated La-Nd co-substituted BiFeO3 with DFT insights
- 30 January 2026
- Published by Elsevier in Ceramics International
- Vol. 52 (9) , 12810-12825
Structural, electronic, and magnetic correlations governing multiferroic and magnetoelectric response in charge-compensated La-Nd co-substituted BiFeO3 with DFT insights
- Open Access
- 28 August 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (8)
Tuning bandgap and controlling oxygen vacancy in BiFeO3 via Ba(Fe1/2Nb1/2)O3 substitution for enhanced bulk ferroelectric photovoltaic response in Al/BFO–BFN/Ag solar cell
The generation of above-bandgap photovoltage, referred to as the anomalous photovoltaic effect (APV), is an extraordinary characteristic sought after property in bulk ferroelectric photovoltaic devices. Despite the fact that the relatively narrow bandgap of BiFeO3 (BFO) (2.7 eV) induces a comparatively larger generation of photocurrent than other ferroelectric photovoltaic, it falls short in producing an anomalous photovoltage (Eg ≪ Voc) and exhibits leaky ferroelectric hysteresis due to unavoidable oxygen vacancies. This work revealed a reduction in oxygen vacancies through the substitution of Ba(Fe1/2Nb1/2)O3 in BFO, leading to improved structural, morphological, synchrotron XPS, and electrical properties. This reduction in oxygen vacancies has resulted in an impressive above-bandgap photovoltage (APV) of 4.41 V for 80BFO–20BFN with greater ferroelectric polarization (Pr = 20.45 μC/cm2) observed at the co-existence of polar and non-polar phases. Moreover, both theoretical and experimental optical analyses have demonstrated a significant decrease in the bandgap to 1.92 eV, effectively extending the visible region close to 653 nm. As a result, a larger population of photoexcited charge carriers is generated, enabling the attainment of a high current density (Jsc) of 0.75 μA/cm2 under 100 mW/cm2 light irradiation.
- 28 August 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (8)
Open AccessTuning bandgap and controlling oxygen vacancy in BiFeO3 via Ba(Fe1/2Nb1/2)O3 substitution for enhanced bulk ferroelectric photovoltaic response in Al/BFO–BFN/Ag solar cell
The generation of above-bandgap photovoltage, referred to as the anomalous photovoltaic effect (APV), is an extraordinary characteristic sought after property in bulk ferroelectric photovoltaic devices. Despite the fact that the relatively narrow bandgap of BiFeO3 (BFO) (2.7 eV) induces a comparatively larger generation of photocurrent than other ferroelectric photovoltaic, it falls short in producing an anomalous photovoltage (Eg ≪ Voc) and exhibits leaky ferroelectric hysteresis due to unavoidable oxygen vacancies. This work revealed a reduction in oxygen vacancies through the substitution of Ba(Fe1/2Nb1/2)O3 in BFO, leading to improved structural, morphological, synchrotron XPS, and electrical properties. This reduction in oxygen vacancies has resulted in an impressive above-bandgap photovoltage (APV) of 4.41 V for 80BFO–20BFN with greater ferroelectric polarization (Pr = 20.45 μC/cm2) observed at the co-existence of polar and non-polar phases. Moreover, both theoretical and experimental optical analyses have demonstrated a significant decrease in the bandgap to 1.92 eV, effectively extending the visible region close to 653 nm. As a result, a larger population of photoexcited charge carriers is generated, enabling the attainment of a high current density (Jsc) of 0.75 μA/cm2 under 100 mW/cm2 light irradiation.
- 10 May 2024
- Published by IOP Publishing in Physica Scripta
- Vol. 99 (6) , 065406
Unravelling the La dopant induced physicochemical changes and the electrical behaviour on BaFeO3 under oxidising and reducing atmospheres
Electroceramic oxides like La-doped BaFeO3 garner greater interest owing to their tunability of mixed ionic conduction. However, reports on the effect of La on the microstructural changes, the type of conduction mechanism under different atmospheres and the negative charge transfer influenced by the Fe-O hybridization in Ba1−xLaxFeO3−δ are hardly available. Doping La induces cation vacancies and Fe reduction, creating nanorod decorated surface after the high-temperature treatment. Conductivity studies expose the rate-limiting steps for hydrogen oxidation reaction (HOR) and oxygen reduction reaction (ORR) as the ohmic resistances and Ba segregation effects. Among the samples studied, Ba0.9La0.1FeO3−δ performs better at 800 °C with an activation energy of ∼0.35 eV under both oxidizing and reducing atmospheres. Surface analysis after EIS reveals Fe and O with different oxidation states that enhance the total conductivity. The amount of hydroxyl species retained (23.66% for Ba0.9La0.1FeO3−δ ) and the ratio of the adsorbed to the lattice oxygen (15.33% for Ba0.9La0.1FeO3−δ ) gives insight on HOR and ORR activities. Also, computational studies validated the negative charge transfer mechanism of the samples under thermally assisted oxidation. The results indicate Ba0.9La0.1FeO3−δ as a tuneable electrode for solid oxide cells.
- 10 May 2024
- Published by IOP Publishing in Physica Scripta
- Vol. 99 (6) , 065406
Unravelling the La dopant induced physicochemical changes and the electrical behaviour on BaFeO3 under oxidising and reducing atmospheres
Electroceramic oxides like La-doped BaFeO3 garner greater interest owing to their tunability of mixed ionic conduction. However, reports on the effect of La on the microstructural changes, the type of conduction mechanism under different atmospheres and the negative charge transfer influenced by the Fe-O hybridization in Ba1−xLaxFeO3−δ are hardly available. Doping La induces cation vacancies and Fe reduction, creating nanorod decorated surface after the high-temperature treatment. Conductivity studies expose the rate-limiting steps for hydrogen oxidation reaction (HOR) and oxygen reduction reaction (ORR) as the ohmic resistances and Ba segregation effects. Among the samples studied, Ba0.9La0.1FeO3−δ performs better at 800 °C with an activation energy of ∼0.35 eV under both oxidizing and reducing atmospheres. Surface analysis after EIS reveals Fe and O with different oxidation states that enhance the total conductivity. The amount of hydroxyl species retained (23.66% for Ba0.9La0.1FeO3−δ ) and the ratio of the adsorbed to the lattice oxygen (15.33% for Ba0.9La0.1FeO3−δ ) gives insight on HOR and ORR activities. Also, computational studies validated the negative charge transfer mechanism of the samples under thermally assisted oxidation. The results indicate Ba0.9La0.1FeO3−δ as a tuneable electrode for solid oxide cells.
- 1 April 2024
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 683
Structural phase coexistence enhances the energy storage density of (Bi0.5Na0.5)0.8Ba0.2Ti1-ySnyO3 lead-free ceramics
- 1 April 2024
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 683
Structural phase coexistence enhances the energy storage density of (Bi0.5Na0.5)0.8Ba0.2Ti1-ySnyO3 lead-free ceramics
- Open Access
- 1 June 2023
- Published by IOP Publishing in Materials Research Express
- Vol. 10 (6) , 065504
Y doping of BaZrO3 may lead to optimum conditions for proton conduction at operating temperature of solid oxide fuel cells: a first principles study
First-principle calculations are performed to investigate Y substitutional defects at ground state and at 1000 K, for Ba- and Zr-rich chemical environments. In dependence on the Fermi level, at ground state singly positively charged Y may be potentially stable on Ba site ( Y B a 1 + ) and neutral as well as singly negatively charged Y on Zr site ( Y Z r 0 and Y Z r 1 − ). However, using recent results for the doubly positively charged oxygen vacancy ( V O 2 + ) and taking account charge compensation, Fermi level pinning occurs, so that under Ba-rich conditions Y Zr 1 − and V O 2 + are really stable. A similar consideration yields Y Ba 1 + and Y Zr 1 − as stable defects in the Zr-rich case. Concerning V O 2 + , which occurrence is a prerequisite to obtain a good proton conductor, by Y doping, at ground state only in the Ba-rich case a moderate concentration can be formed. At 1000 K the situation is improved importantly. The consideration of vibrational contributions to the free formation energy of Y on Zr site shows an increase of the stability of Y Zr 0 and Y Zr 1 − . Under Ba-rich conditions Fermi level pinning results in a free formation energy for the doubly positively charged O vacancy of 0.481 eV which corresponds to a high V O 2 + concentration and optimum conditions for proton conduction. In Zr-rich case the respective value is 0.863 eV which leads also to relatively high V O 2 + occurrence but the situation is less favourable than for the Ba-rich environment.
- 1 June 2023
- Published by IOP Publishing in Materials Research Express
- Vol. 10 (6) , 065504
Open AccessY doping of BaZrO3 may lead to optimum conditions for proton conduction at operating temperature of solid oxide fuel cells: a first principles study
First-principle calculations are performed to investigate Y substitutional defects at ground state and at 1000 K, for Ba- and Zr-rich chemical environments. In dependence on the Fermi level, at ground state singly positively charged Y may be potentially stable on Ba site ( Y B a 1 + ) and neutral as well as singly negatively charged Y on Zr site ( Y Z r 0 and Y Z r 1 − ). However, using recent results for the doubly positively charged oxygen vacancy ( V O 2 + ) and taking account charge compensation, Fermi level pinning occurs, so that under Ba-rich conditions Y Zr 1 − and V O 2 + are really stable. A similar consideration yields Y Ba 1 + and Y Zr 1 − as stable defects in the Zr-rich case. Concerning V O 2 + , which occurrence is a prerequisite to obtain a good proton conductor, by Y doping, at ground state only in the Ba-rich case a moderate concentration can be formed. At 1000 K the situation is improved importantly. The consideration of vibrational contributions to the free formation energy of Y on Zr site shows an increase of the stability of Y Zr 0 and Y Zr 1 − . Under Ba-rich conditions Fermi level pinning results in a free formation energy for the doubly positively charged O vacancy of 0.481 eV which corresponds to a high V O 2 + concentration and optimum conditions for proton conduction. In Zr-rich case the respective value is 0.863 eV which leads also to relatively high V O 2 + occurrence but the situation is less favourable than for the Ba-rich environment.