Zhenqian Wu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Zhenqian Wu has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Youming Li
Ningbo University
4 shared publications Xiangpei Meng
Department of Basic, Ningbo University of Finance and Economics, Ningbo, China
3 shared publications- Xinrong Lv
College of Science and Technology, Ningbo University, Ningbo, China
2 shared publications Yonghong Wu
China Research Institute of Radiowave Propagation, Qingdao, China
2 shared publications- Menglei Sheng
College of Information Science and Engineering, Ningbo University, Ningbo, China
1 shared publication - Qiang Guo
College of Information and Communication Engineering, Harbin Engineering University, Harbin, China
1 shared publication
Latest Publications
- 2 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. 29 (1) , 190-194
User Localization for Reconfigurable Intelligent Surface-Assisted mmWave MIMO-OFDM Systems
We discuss the user localization problem assisted by reconfigurable intelligent surfaces (RIS) in millimeter-wave (mmWave) multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems. By exploring the inherent sparse scattering characteristics of mmWave channels, we propose a tensor decomposition based method to obtain the channel parameters (i.e. angle, delay) required for user localization. Specifically, the received signal is modeled as a low-rank third-order tensor fitting a typical polyhedral model which contains a factor matrix of channel parameters. Then, we design a structured tensor decomposition method to estimate the channel parameters by using the Vandermonde property of factor matrices. Finally, based on the least squares criterion, the location of user are obtained from the estimated channel parameters. Simulation results show that the proposed estimation scheme can achieve a centimeter-level resolution of user localization.
- 2 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. 29 (1) , 190-194
User Localization for Reconfigurable Intelligent Surface-Assisted mmWave MIMO-OFDM Systems
We discuss the user localization problem assisted by reconfigurable intelligent surfaces (RIS) in millimeter-wave (mmWave) multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems. By exploring the inherent sparse scattering characteristics of mmWave channels, we propose a tensor decomposition based method to obtain the channel parameters (i.e. angle, delay) required for user localization. Specifically, the received signal is modeled as a low-rank third-order tensor fitting a typical polyhedral model which contains a factor matrix of channel parameters. Then, we design a structured tensor decomposition method to estimate the channel parameters by using the Vandermonde property of factor matrices. Finally, based on the least squares criterion, the location of user are obtained from the estimated channel parameters. Simulation results show that the proposed estimation scheme can achieve a centimeter-level resolution of user localization.
- 29 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. 11 (22) , 36922-36932
Multiple Anchors and RIS-Aided Localization Method in Complex NLOS Environments
This paper addresses the localization problem of wireless sensor networks (WSNs) in complex non-line-of-sight (NLOS) environments where multiple regions are separated by the blockages. Reconfigurable intelligent surface (RIS) and ultrawideband (UWB) technology are exploited to form a novel multiple anchors and RIS-aided localization (MARL) method, in which anchors and RISs are deployed in pairs in each separated region. The method consists of two stages: a coarse stage and a fine stage. In the coarse stage, each RIS is dynamically adjusted in accordance with pre-designed conjugate orthogonal configuration sequence to extract the direct or reflected path components effectively from all anchors during each UWB pulse period. A coarse position of the target is then determined based on the time-delay estimation of the extracted path components, while NLOS bias is assumed to exist in each path. In this stage, the region where the target exists is also identified. In the fine stage, a reflection response vector estimation process is initiated by adjusting the RIS located in the identified region, which is used to formulate a minimum mean square error (MMSE) problem. The solution of the MMSE problem is calibrated with the path coefficient generated from the previously acquired coarse estimate. Then, a reflection vector that contains the true position of the target is obtained. Finally, an accurate estimate is achieved by using gradient descent search algorithm. Simulation results show that the proposed MARL method is a cost-effective scheme for target localization in NLOS environments of WSNs.
- 29 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. 11 (22) , 36922-36932
Multiple Anchors and RIS-Aided Localization Method in Complex NLOS Environments
This paper addresses the localization problem of wireless sensor networks (WSNs) in complex non-line-of-sight (NLOS) environments where multiple regions are separated by the blockages. Reconfigurable intelligent surface (RIS) and ultrawideband (UWB) technology are exploited to form a novel multiple anchors and RIS-aided localization (MARL) method, in which anchors and RISs are deployed in pairs in each separated region. The method consists of two stages: a coarse stage and a fine stage. In the coarse stage, each RIS is dynamically adjusted in accordance with pre-designed conjugate orthogonal configuration sequence to extract the direct or reflected path components effectively from all anchors during each UWB pulse period. A coarse position of the target is then determined based on the time-delay estimation of the extracted path components, while NLOS bias is assumed to exist in each path. In this stage, the region where the target exists is also identified. In the fine stage, a reflection response vector estimation process is initiated by adjusting the RIS located in the identified region, which is used to formulate a minimum mean square error (MMSE) problem. The solution of the MMSE problem is calibrated with the path coefficient generated from the previously acquired coarse estimate. Then, a reflection vector that contains the true position of the target is obtained. Finally, an accurate estimate is achieved by using gradient descent search algorithm. Simulation results show that the proposed MARL method is a cost-effective scheme for target localization in NLOS environments of WSNs.
- 2 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. 10 (22) , 19913-19924
A Minimum Joint Error Entropy-Based Localization Method in Mixed LOS/NLOS Environments
In this article, we address the time-of-arrival (TOA)-based source localization problem in mixed light-of-sight (LOS)/non-LOS (NLOS) environments, where localization accuracy is degraded by both measurement noise and NLOS error. A novel exponential optimization problem is formulated based on new minimum joint error entropy criteria and statistical characteristics of measurement noise. After that, a two-step relaxation method is proposed. In the first step, the original problem is relaxed into a nonexponential problem which maintains the consistency of the solution. The second step is to transform the nonexponential problem into a convex problem. Furthermore, we extend the method to asynchronous networks where the source and anchors are not time synchronized. Numerical results show that the proposed method can provide significant robust performance in synchronous or asynchronous networks, whether in sparse or dense NLOS scenarios.
- 2 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. 10 (22) , 19913-19924
A Minimum Joint Error Entropy-Based Localization Method in Mixed LOS/NLOS Environments
In this article, we address the time-of-arrival (TOA)-based source localization problem in mixed light-of-sight (LOS)/non-LOS (NLOS) environments, where localization accuracy is degraded by both measurement noise and NLOS error. A novel exponential optimization problem is formulated based on new minimum joint error entropy criteria and statistical characteristics of measurement noise. After that, a two-step relaxation method is proposed. In the first step, the original problem is relaxed into a nonexponential problem which maintains the consistency of the solution. The second step is to transform the nonexponential problem into a convex problem. Furthermore, we extend the method to asynchronous networks where the source and anchors are not time synchronized. Numerical results show that the proposed method can provide significant robust performance in synchronous or asynchronous networks, whether in sparse or dense NLOS scenarios.
- 8 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 23 (14) , 16051-16057
A Semidefinite Relaxation Approach for Mobile Target Localization Based on TOA and Doppler Frequency Shift Measurements
In this paper, we discuss mobile source localization using both time of arrival and Doppler frequency shift (TOA-DFS) measurements, where the source moves at a nonuniform velocity. To obtain the position of a mobile source, we first formulate the weighted least squares (WLS) problem by ignoring the second-order noise terms. Due to the non-convexity, we apply the convex relaxation technique to transform the problem into a semi-definite programming problem. However, ignoring the second-order noise terms is only reasonable in the case of small noise levels. In view of this, we then directly establish the maximum likelihood (ML) estimator based on the measurements model without ignoring the second-order noise terms. Since the ML estimator is a non-convex problem, we also propose implementable semidefinite relaxation (SDR) technique to tackle it. Finally, the Cramér-Rao lower bound (CRLB) analysis and results verify that the proposed methods based on the TOA-DFS measurements can significantly enhance localization accuracy.
- 8 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 23 (14) , 16051-16057
A Semidefinite Relaxation Approach for Mobile Target Localization Based on TOA and Doppler Frequency Shift Measurements
In this paper, we discuss mobile source localization using both time of arrival and Doppler frequency shift (TOA-DFS) measurements, where the source moves at a nonuniform velocity. To obtain the position of a mobile source, we first formulate the weighted least squares (WLS) problem by ignoring the second-order noise terms. Due to the non-convexity, we apply the convex relaxation technique to transform the problem into a semi-definite programming problem. However, ignoring the second-order noise terms is only reasonable in the case of small noise levels. In view of this, we then directly establish the maximum likelihood (ML) estimator based on the measurements model without ignoring the second-order noise terms. Since the ML estimator is a non-convex problem, we also propose implementable semidefinite relaxation (SDR) technique to tackle it. Finally, the Cramér-Rao lower bound (CRLB) analysis and results verify that the proposed methods based on the TOA-DFS measurements can significantly enhance localization accuracy.