Ryo Someya
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ryo Someya has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- Hiroshi Tanabe
Graduate School of Frontier Sciences, The University of Tokyo
3 shared publications - Yasushi Ono
Graduate School of Frontier Sciences, The University of Tokyo
3 shared publications Yunhan Cai
Graduate School of Frontier Sciences, The University of Tokyo
2 shared publications- Adrian Rengle
Tokamak Energy Ltd, Abingdon, Oxfordshire, UNITED KINGDOM OF GREAT BRITAIN AND NORTHERN IRELAND
1 shared publication - Dmitry Osin
Tokamak Energy Ltd
1 shared publication - Hannah Victoria Willett
Tokamak Energy Ltd, Abingdon, Oxfordshire, UNITED KINGDOM OF GREAT BRITAIN AND NORTHERN IRELAND
1 shared publication
Latest Publications
- Open Access
- 16 October 2026
- Published by Elsevier in SSRN Electronic Journal
Millimeter Wave Absorption Measurement of TiO2 Coating for Low Reflection Dummy Load
Accurate reflectivity data of millimeter wave absorber materials are essential for predicting heat-flux distributions and optimizing the design of dummy loads (DLs) used in electron cyclotron resonance heating (ECRH) systems. However, conventional millimeter wave reflectivity measurements typically exhibit uncertainties of approximately ±5%, which are insufficient for reliable design. In this study, a high-accuracy reflectivity measurement was developed and applied to thermally sprayed TiO2 coatings. Measurements were performed at 110 GHz, corresponding to the operating frequency of the JT-60SA ECRH system. To improve measurement accuracy, an HE11-mode launcher was employed to suppress beam divergence during free-space propagation, and a two-dimensional scanning measurement was performed to capture the full reflected-wave intensity distribution. In addition, a reference-based calibration method using a copper reflector eliminated the need for direct estimation of the incident wave intensity and reduced the influence of source-power fluctuations. Reflectivities were measured for incident angles between 30° and 65° under both S- and P-polarized conditions, achieving an uncertainty of less than ±0.8%. The measured data were successfully approximated using a Fresnel-based model with a single fitting parameter. The resulting reflectivities were implemented in ray-tracing and thermal analyses and validated through comparisons with infrared-camera and calorimetric measurements obtained during 500 kW high-power experiments. Good agreement was obtained for temperature-rise distributions, temporal temperature evolution, and absorbed-power fractions. These results demonstrate that the proposed method provides reliable reflectivity data for predicting heat-flux distributions and power-absorption characteristics and serves as a powerful tool for the design and optimization of low-reflection DLs.
- 16 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessMillimeter Wave Absorption Measurement of TiO2 Coating for Low Reflection Dummy Load
Accurate reflectivity data of millimeter wave absorber materials are essential for predicting heat-flux distributions and optimizing the design of dummy loads (DLs) used in electron cyclotron resonance heating (ECRH) systems. However, conventional millimeter wave reflectivity measurements typically exhibit uncertainties of approximately ±5%, which are insufficient for reliable design. In this study, a high-accuracy reflectivity measurement was developed and applied to thermally sprayed TiO2 coatings. Measurements were performed at 110 GHz, corresponding to the operating frequency of the JT-60SA ECRH system. To improve measurement accuracy, an HE11-mode launcher was employed to suppress beam divergence during free-space propagation, and a two-dimensional scanning measurement was performed to capture the full reflected-wave intensity distribution. In addition, a reference-based calibration method using a copper reflector eliminated the need for direct estimation of the incident wave intensity and reduced the influence of source-power fluctuations. Reflectivities were measured for incident angles between 30° and 65° under both S- and P-polarized conditions, achieving an uncertainty of less than ±0.8%. The measured data were successfully approximated using a Fresnel-based model with a single fitting parameter. The resulting reflectivities were implemented in ray-tracing and thermal analyses and validated through comparisons with infrared-camera and calorimetric measurements obtained during 500 kW high-power experiments. Good agreement was obtained for temperature-rise distributions, temporal temperature evolution, and absorbed-power fractions. These results demonstrate that the proposed method provides reliable reflectivity data for predicting heat-flux distributions and power-absorption characteristics and serves as a powerful tool for the design and optimization of low-reflection DLs.
- Open Access
- 18 May 2026
- Published by IOP Publishing in Nuclear Fusion
- Vol. 66 (7)
Ion and electron heating via magnetic reconnection during merging/compression plasma startup in ST40
Here we report the latest results on the high-field application of merging/compression (M/C) plasma startup in the ST40 spherical tokamak, using 96-channel 2D ion Doppler tomography and 30-channel Thomson scattering diagnostics installed over the past three years. The new findings and achievements are summarized as follows: (i) the new 96-channel 2D ion Doppler tomography clearly revealed ion heating in the downstream of the reconnection jet and its confinement/transport process. (ii) Electron density also increases in the same region, while electrons are heated around the X-point (or magnetic axis) and electron temperature profile forms a peaked profile. (iii) Quasi-steady sustainment/confinement of M/C startup plasma current and ion temperature has been demonstrated. (iv) Based on a series of M/C experiments, I p ∝ I MC scaling was increased to I p ~ 600kA. (v) Full pressure profile measurement leads to the evaluation of energy conversion ratio of the dissipated magnetic energy of reconnecting field B rec and it was found that ~ 30% of released magnetic energy was converted to ion thermal energy. (vi) The previously demonstrated ΔT i ∝ B rec 2 scaling has successfully been upgraded to ΔU i = 1.5Δ(n e κ B T i ) ∝ B rec 2 for the first time and ΔU i ~ 10kJ/m 3 which was 10 times higher than the previous record in MAST was explored.
- 18 May 2026
- Published by IOP Publishing in Nuclear Fusion
- Vol. 66 (7)
Open AccessIon and electron heating via magnetic reconnection during merging/compression plasma startup in ST40
Here we report the latest results on the high-field application of merging/compression (M/C) plasma startup in the ST40 spherical tokamak, using 96-channel 2D ion Doppler tomography and 30-channel Thomson scattering diagnostics installed over the past three years. The new findings and achievements are summarized as follows: (i) the new 96-channel 2D ion Doppler tomography clearly revealed ion heating in the downstream of the reconnection jet and its confinement/transport process. (ii) Electron density also increases in the same region, while electrons are heated around the X-point (or magnetic axis) and electron temperature profile forms a peaked profile. (iii) Quasi-steady sustainment/confinement of M/C startup plasma current and ion temperature has been demonstrated. (iv) Based on a series of M/C experiments, I p ∝ I MC scaling was increased to I p ~ 600kA. (v) Full pressure profile measurement leads to the evaluation of energy conversion ratio of the dissipated magnetic energy of reconnecting field B rec and it was found that ~ 30% of released magnetic energy was converted to ion thermal energy. (vi) The previously demonstrated ΔT i ∝ B rec 2 scaling has successfully been upgraded to ΔU i = 1.5Δ(n e κ B T i ) ∝ B rec 2 for the first time and ΔU i ~ 10kJ/m 3 which was 10 times higher than the previous record in MAST was explored.
- Open Access
- 1 January 2025
- Published by Japan Society of Plasma Science and Nuclear Fusion Research in Plasma and Fusion Research
- Vol. 20, 1402041
Direct Measurement of Reconnection Outflow Profile by Glass-Tube-Pair Type Doppler Probes in Tokamak Merging Experiments
The reconnection outflow velocity under high guide field was directly measured using the 1D array of ion Doppler probes and was compared with the E × B, gradient B, and curvature drift velocity calculated from 2D profile measurements of electric and magnetic fields for the first time. It was found that the measured ion velocity profile agrees well with the profile of E × B drift velocity which is much larger than the other drift velocities. The poloidal flux-line velocity is almost equal to the E × B drift and ion flow velocities, probably because magnetic flux is almost frozen into ions due to its large Lundquist number of 102.
- 1 January 2025
- Published by Japan Society of Plasma Science and Nuclear Fusion Research in Plasma and Fusion Research
- Vol. 20, 1402041
Open AccessDirect Measurement of Reconnection Outflow Profile by Glass-Tube-Pair Type Doppler Probes in Tokamak Merging Experiments
The reconnection outflow velocity under high guide field was directly measured using the 1D array of ion Doppler probes and was compared with the E × B, gradient B, and curvature drift velocity calculated from 2D profile measurements of electric and magnetic fields for the first time. It was found that the measured ion velocity profile agrees well with the profile of E × B drift velocity which is much larger than the other drift velocities. The poloidal flux-line velocity is almost equal to the E × B drift and ion flow velocities, probably because magnetic flux is almost frozen into ions due to its large Lundquist number of 102.
- Open Access
- 1 June 2023
- Published by AIP Publishing in Physics of Plasmas
- Vol. 30 (6)
1D profile measurement of ion velocity distribution with glass-tube-pair type Doppler probe array
We developed a glass-tube-pair type Doppler probe array for ion velocity distribution function measurement with high spatial and time resolution. By four mirrors and four optical fibers fixed in two parallel glass tubes, the light from ions in each measurement area (3.2 × 2.5 × 1.0 cm3) between tubes is collected in three different directions, and the fibers are led to a Czerny–Turner spectrometer and finally to an ICCD camera (the exposure time of 2 μs) for Doppler spectra measurements with high time resolution. Since the Doppler spectrum profile in each viewing line represents the distribution of the ion velocity component in the line, we can reconstruct 2D velocity distribution by the measured spectra in three viewing lines with tomography techniques. We tested the accuracy of some reconstruction methods from spectra to velocity distribution in numerical simulation and chose the iterative method as the best one. By use of this new diagnostic, we successfully measured the radial profile of ion velocity distribution during magnetic reconnection of merging spherical tokamak plasmas and revealed that their ions have anisotropic velocity distributions.
- 1 June 2023
- Published by AIP Publishing in Physics of Plasmas
- Vol. 30 (6)
Open Access1D profile measurement of ion velocity distribution with glass-tube-pair type Doppler probe array
We developed a glass-tube-pair type Doppler probe array for ion velocity distribution function measurement with high spatial and time resolution. By four mirrors and four optical fibers fixed in two parallel glass tubes, the light from ions in each measurement area (3.2 × 2.5 × 1.0 cm3) between tubes is collected in three different directions, and the fibers are led to a Czerny–Turner spectrometer and finally to an ICCD camera (the exposure time of 2 μs) for Doppler spectra measurements with high time resolution. Since the Doppler spectrum profile in each viewing line represents the distribution of the ion velocity component in the line, we can reconstruct 2D velocity distribution by the measured spectra in three viewing lines with tomography techniques. We tested the accuracy of some reconstruction methods from spectra to velocity distribution in numerical simulation and chose the iterative method as the best one. By use of this new diagnostic, we successfully measured the radial profile of ion velocity distribution during magnetic reconnection of merging spherical tokamak plasmas and revealed that their ions have anisotropic velocity distributions.
- Open Access
- 7 June 2021
- Published by Japan Society of Plasma Science and Nuclear Fusion Research in Plasma and Fusion Research
- Vol. 16, 1202078
Development of Glass-Tube-Pair Type Doppler Probe Array for 1D Profile Measurement of Two Component Ion-Flow Vector
We developed a new glass-tube-pair type Doppler probe array for 1D ion velocity vector and temperature measurement. It needs just two parallel glass-tube insertion, realizing low plasma perturbation and 1D ion flow vector measurement on a single discharge. Using four mirrors and optical fibers for one measurement point, this system can measure ion local light emissions of each measurement volume from four different directions, enabling us to measure local ion flow vector and temperature. All set of mirrors and optical fibers are aligned in the two parallel glass tubes for 1D measurement by a single discharge. This system measured successfully ion outflow speed of two merging tokamak plasmas, about 80% of poloidal Alfvén speed in agreement with recent reconnection experiments and theory.
- 7 June 2021
- Published by Japan Society of Plasma Science and Nuclear Fusion Research in Plasma and Fusion Research
- Vol. 16, 1202078
Open AccessDevelopment of Glass-Tube-Pair Type Doppler Probe Array for 1D Profile Measurement of Two Component Ion-Flow Vector
We developed a new glass-tube-pair type Doppler probe array for 1D ion velocity vector and temperature measurement. It needs just two parallel glass-tube insertion, realizing low plasma perturbation and 1D ion flow vector measurement on a single discharge. Using four mirrors and optical fibers for one measurement point, this system can measure ion local light emissions of each measurement volume from four different directions, enabling us to measure local ion flow vector and temperature. All set of mirrors and optical fibers are aligned in the two parallel glass tubes for 1D measurement by a single discharge. This system measured successfully ion outflow speed of two merging tokamak plasmas, about 80% of poloidal Alfvén speed in agreement with recent reconnection experiments and theory.