KHKazutoshi Haraguchi

Kazutoshi Haraguchi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Kazutoshi Haraguchi has a total of 41 co-authors. Here are the top co-authors by number of shared publications:

  • Dharmesh Varade

    Material Chemistry Laboratory, Kawamura Institute of Chemical Research, 631 Sakado, Sakura, Chiba 285-0078, Japan

    7 shared publications
  • Guang Li

    State Key Laboratory for Modification of Chemical Fibers and Polymer Materials, College of Materials Science Engineering Donghua University Shanghai 201620 China

    6 shared publications
  • Liyuan Song

    5 shared publications
  • Kazutaka Murata

    Material Chemistry Laboratory Kawamura Institute of Chemical Research 631 Sakado Sakura Chiba 285‐0078 Japan

    4 shared publications
  • Meifang Zhu

    College of Materials Science and Engineering, Donghua University, Shanghai 200051, China

    4 shared publications
  • Tetsuo Takada

    LS Project, Central Research Laboratory, DIC Corporation, Sakado, Sakura, Chiba 285-8668, Japan

    4 shared publications

Latest Publications

  • Open Access

    Association Behavior of Amphiphilic ABA Triblock Copolymer Composed of Poly(2-methoxyethyl acrylate) (A) and Poly(ethylene oxide) (B) in Aqueous Solution

    by Yoko Mizoue, Ema Onodera, Kazutoshi Haraguchi, Shin-Ichi Yusa

    Poly(2-methoxyethyl acrylate) (PMEA) and poly(ethylene oxide) (PEO) have protein-antifouling properties and blood compatibility. ABA triblock copolymers (PMEAl-PEO11340-PMEAm (MEOMn; n is average value of l and m)) were prepared using single-electron transfer-living radical polymerization (SET-LRP) using a bifunctional PEO macroinitiator. Two types of MEOMn composed of PMEA blocks with degrees of polymerization (DP = n) of 85 and 777 were prepared using the same PEO macroinitiator. MEOMn formed flower micelles with a hydrophobic PMEA (A) core and hydrophilic PEO (B) loop shells in diluted water with a similar appearance to petals. The hydrodynamic radii of MEOM85 and MEOM777 were 151 and 108 nm, respectively. The PMEA block with a large DP formed a tightly packed core. The aggregation number (Nagg) of the PMEA block in a single flower micelle for MEOM85 and MEOM777 was 156 and 164, respectively, which were estimated using a light scattering technique. The critical micelle concentrations (CMCs) for MEOM85 and MEOM777 were 0.01 and 0.002 g/L, respectively, as determined by the light scattering intensity and fluorescence probe techniques. The size, Nagg, and CMC for MEOM85 and MEOM777 were almost the same independent of hydrophobic DP of the PMEA block.


  • Open Access

    Gelation and anomalous viscosity dynamics in aqueous dispersions of synthetic hectorite

    by Yuji Kimura, Shoichi Shimizu, Kazutoshi Haraguchi

    Exfoliated clay nanosheets (CNSs) of synthetic hectorite (s-hectorite) have been used for synthesizing advanced functional materials and gels that exhibit high transparency, high mechanical toughness, and many unprecedented characteristics like optical anisotropy, cell harvesting, instant strong adhesion, and self-healing. Therefore, it is important to determine the rheological properties of aqueous s-hectorite dispersions in terms of the CNS microstructures formed in the dispersion. Herein, viscosity changes in aqueous dispersions of s-hectorite were determined using a vibration viscometer to measure viscosity under agitated and static conditions. Upon varying the pH and salt concentration, aqueous dispersions of s-hectorite exhibited a maximum viscosity accompanied by gelation. Additionally, the aqueous dispersion with maximum viscosity exhibited large and complex time-dependent viscosity changes in the static state after cessation of stirring. The anomalous viscosity dynamics depended on the types of clay, acid (salt), temperature, repetitions, and agitation conditions used. The mechanisms for viscosity dynamics have been discussed in terms of variations in the CNS microstructures. It is inferred that anomalous viscosity dynamics are a general phenomenon in multicomponent dispersion systems containing CNSs.


  • New Aqueous Solutions with Lower Viscosities than Water

    by Kazutoshi Haraguchi, Yuji Kimura

    Liquid water exhibits many anomalous physical properties because of its unique structure and hydrogen bonding networks, which were mostly established at the beginning of the 20th century. Because of its interesting properties and microstructures under various conditions and in aqueous solutions, understanding the behavior of water is important, but remains scientifically challenging. Regarding the viscosity of aqueous solutions, despite the discovery 147 years ago that very small amounts of certain salts decrease the viscosity of water slightly, there has been no significant progress to date. Herein, we report new aqueous solutions, with low additive fractions and much lower viscosities than pure water, which exhibit unique viscosity−composition curves. The findings should spark renewed interest in scientific research on water, which may greatly impact numerous industries.


  • Instant Strong Adhesive Behavior of Nanocomposite Gels toward Hydrophilic Porous Materials

    by Kazutoshi Haraguchi, Shoichi Shimizu, Satoshi Tanaka

    We investigated the adhesion behavior of nanocomposite hydrogels (NC gels), consisting of unique organic (polymer)-inorganic (clay) network structures, toward inorganic and organic materials. The NC gels exhibit instant and strong adhesion to inorganic and organic substrates with hydrophilic porous surfaces. The NC gels instantly adhere to hydrophilic porous substrates (e.g., unglazed ceramic surfaces and polymer membranes) through simple light contact. In addition, a small piece of NC gel effectively joined two substrate samples (e.g., concrete blocks and bricks) through lamination of the interposing NC gel. The resulting conjoined materials were unable to be separated at the gel-substrate interface, rather the gel itself fractured upon separation, which indicates that the adhesive strength at the interface is greater than the tensile strength of the NC gel. With the exception of NC gels with very high clay concentrations (Cclays), instant strong adhesion was achieved for almost all NC gels composed of different polymers or different Cclay values. A thermoresponsive NC gel was reversibly adhered and could be peeled from the surface by stretching at a temperature above its transition temperature. The mechanism of instant strong adhesion or reversible adhesion are discussed based on dangling chains that exist on the surfaces of the NC gels composed of polymer-clay networks. The cut surface of an NC gel generally exhibited a higher adhesive strength than that of the as-prepared surface due to longer dangling chains.


  • Reversible generation of large retractive tensile forces in isometric chemo-mechanical actuators composed of nanocomposite hydrogels and aqueous NaCl solutions

    by Kazutoshi Haraguchi, Yuji Kimura, Shouichi Shimizu

    This article addresses the generation of large mechanical forces in muscle-like isometric actuator systems composed of stimuli-responsive nanocomposite hydrogels (NC gels) and aqueous NaCl solutions. NC gels with poly(N-isopropylacrylamide)–clay (PNIPA–clay) network structures exhibit high mechanical toughnesses and reversible swelling/deswelling behavior in the absence/presence of NaCl. NC gels constrained to constant lengths in brine generate enhanced contractive forces due to the salt-induced coil-to-globule transitions that are more than ten times larger than those induced thermally. A retractive tensile force (4 N/170 kPa), comparable to that of human muscle, was repeatedly generated at 20 °C using an appropriately composed NC gel (clay: 2 mol%, PNIPA: 2 M), and by alternating the NaCl concentration between 0 and 5 M. This phenomenon is attributed to the combined effects of enhanced deswelling behavior resulting from the salt-induced coil-to-globule transition of PNIPA and the high stiffness of the deswollen gel due to the NaCl-strengthened PNIPA–clay network.


  • Clay–Alcohol–Water Dispersions: Anomalous Viscosity Changes Due to Network Formation of Clay Nanosheets Induced by Alcohol Clustering

    by Yuji Kimura, Kazutoshi Haraguchi

    Clay–alcohol–water ternary dispersions were compared with alcohol–water binary mixtures in terms of viscosity and optical absorbance. Aqueous clay dispersions to which lower alcohols (ethanol, 1-propanol, 2-propanol, and tert-butanol) were added exhibited significant viscosity anomalies (maxima) when the alcohol content was 30–55 wt %, as well as optical absorbance anomalies (maxima). The maximum viscosity (ηmax) depended strongly on the clay content and varied between 300 and 8000 mPa·s, making it remarkably high compared with the viscosity anomalies (2 mPa·s) observed in alcohol–water binary mixtures. The alcohol content at ηmax decreased as the hydrophobicity of the alcohol increased. The ternary dispersions with viscosity anomalies exhibited thixotropic behaviors. The effects of other hydrophilic solvents (glycols) and other kinds of clays were also clarified. Based on these findings and the average particle size changes, the viscosity anomalies in the ternary dispersions were explained by alcohol-clustering-induced network formation of the clay nanosheets. It was estimated that 0.9, 1.7, and 2.5 H2O molecules per alcohol molecule were required to stabilize the ethanol, 2-propanol, and tert-butanol, respectively, in the clay–alcohol–water dispersions.


  • Changes in the Properties and Self‐Healing Behaviors of Zwitterionic Nanocomposite Gels Across Their UCST Transition

    by Kazutoshi Haraguchi, Jinyan Ning, Guang Li

    Summary: Characteristic properties of zwitterionic nanocomposite (NC) gels consisting of a sulfobetaine copolymer and inorganic clay were investigated. The zwitterionic NC gels were synthesized with different ratios of monomer (x) and clay content (n) by the in situ free‐radical polymerization of two monomers, a sulfobetaine monomer (A3) and acrylamide derivative (D), in the presence of exfoliated clay in aqueous media. The resulting zwitterionic A3Dx‐NCn gels were all structurally uniform and mechanically tough because of the polymer–clay network. A3Dx‐NCn gels exhibited a thermoresponsive phase transition with an upper critical solution temperature (UCST) for x ≤ 10 and n ≤ 5. The changes in the property of the A3D10‐NC3 gel across the UCST transition were elucidated in terms of optical transmittance, gel volume, dynamic viscoelasticity, and tensile mechanical properties, in addition to the change in self‐healing behavior.