Feng Qian
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Feng Qian has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Jianwei Zhao
School of Electrical Engineering, Nantong University, Nantong, China
2 shared publications - Jinru Cheng
School of Electrical Engineering, Nantong University, Nantong, China
2 shared publications - Wei Zhang
School of Electrical Engineering and Automation, Nantong University, Nantong, China
2 shared publications - Xiaobin Xu
School of Electrical Engineering, Nantong University, Nantong, China
2 shared publications - Baoxian Liu
Department of Medical Ultrasonics, Division of Interventional Ultrasound, Sun Yat-sen University, the First Affiliated Hospital, Guangzhou.
1 shared publication Kai Zhen
CATARC
1 shared publication
Latest Publications
- Open Access
- 13 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 68452
Corrections to “Design and Optimization of Axial Field Flux-Switching Magnetic Gear Composite Motor Based on Varying-Network Magnetic Circuit”
In the above article [1] , we identified some mistakes which may cause confusion for readers but had no influence on the discussion and conclusion of the article.
- 13 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 68452
Open AccessCorrections to “Design and Optimization of Axial Field Flux-Switching Magnetic Gear Composite Motor Based on Varying-Network Magnetic Circuit”
In the above article [1] , we identified some mistakes which may cause confusion for readers but had no influence on the discussion and conclusion of the article.
- Open Access
- 11 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 53749-53759
Design and Optimization of Axial Field Flux-Switching Magnetic Gear Composite Motor Based on Varying-Network Magnetic Circuit
Axial field flux-switching magnetic gear composite motor (AFFSMGCM) combines the advantages of axial field flux-switching permanent magnet machine (AFFSPMM) and magnetic gear (MG). In order to reduce the time and cost of design and optimization due to the complicated structure of AFFSMGCM, the nonlinear varying-network magnetic circuit (VNMC) is researched and developed for the machine. First, the topology of AFFSMGCM is introduced in details. Then, the accurate VNMC model is established with consideration of magnetic saturation and leakage flux. Finally, multi-objective optimization of AFFSMGCM based on VNMC is carried out to obtain large torque and low torque ripple. Meanwhile, the finite element analysis (FEA) method is used to validate the VNMC model. It is shown that the calculation results based on VNMC model are similar to those of FEA. The proposed VNMC improves the efficiency and accuracy of the design and optimization of the machine.
- 11 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 53749-53759
Open AccessDesign and Optimization of Axial Field Flux-Switching Magnetic Gear Composite Motor Based on Varying-Network Magnetic Circuit
Axial field flux-switching magnetic gear composite motor (AFFSMGCM) combines the advantages of axial field flux-switching permanent magnet machine (AFFSPMM) and magnetic gear (MG). In order to reduce the time and cost of design and optimization due to the complicated structure of AFFSMGCM, the nonlinear varying-network magnetic circuit (VNMC) is researched and developed for the machine. First, the topology of AFFSMGCM is introduced in details. Then, the accurate VNMC model is established with consideration of magnetic saturation and leakage flux. Finally, multi-objective optimization of AFFSMGCM based on VNMC is carried out to obtain large torque and low torque ripple. Meanwhile, the finite element analysis (FEA) method is used to validate the VNMC model. It is shown that the calculation results based on VNMC model are similar to those of FEA. The proposed VNMC improves the efficiency and accuracy of the design and optimization of the machine.
- 6 April 2021
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Analysis on Emission Characteristics of Urban Buses Based on Remote Online Monitoring
In this study, a new system of assessment method was developed to evaluate the characteristics of urban buses based on remote online monitoring. Four types of buses, including China V emission standards diesel bus, lean-burn CNG bus, air-fuel equivalence ratio combustion CNG bus and gas-electric hybrid bus, were chosen as samples to analyze the emission characteristics of urban buses with different engine types in urban scenario. Based on the traffic conditions in Beijing, the actual emission characteristics of buses under newly-built driving conditions were analyzed. Moreover, the emission factor database of urban buses in Beijing was established to analyze the characteristics of excess emission. The research results are shown as follows. 1) Compared with other types of buses, NOX emission factor and emission rate of lean-burn CNG bus are much higher. The equivalent air-fuel ratio CNG engine combined with TWC catalytic converter and hybrid power technology can better reduce NOX emission. 2) There is difference between the type certification under standard operating conditions and the emission results in actual operation to a varying degree. The evaluation of emission performance based on actual operation can more truly reflect the actual performance of the bus. The BJ-FPC (Beijing flat peak cycle) developed in this paper is closer to the actual operating conditions of the sample bus in terms of VSP Bin proportional distribution. 3) As to weighted NOX emission factors, the BJ-HPC (Beijing high peak cycle) of different types of buses are higher than BJ-FPC and actual operating conditions. 4) Based on the excessive emission method assessment, the NOX of China V diesel bus easily exceeds the emissions limits, and the NOx concentration of lean-burn CNG bus is high, and both the NOx over-limit ratio and the quantity of excessive emission buses are also high. Gas-electric hybrid bus can better reduce the NOX emission and the excessive emission frequency under the urban operating condition.
- 6 April 2021
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Analysis on Emission Characteristics of Urban Buses Based on Remote Online Monitoring
In this study, a new system of assessment method was developed to evaluate the characteristics of urban buses based on remote online monitoring. Four types of buses, including China V emission standards diesel bus, lean-burn CNG bus, air-fuel equivalence ratio combustion CNG bus and gas-electric hybrid bus, were chosen as samples to analyze the emission characteristics of urban buses with different engine types in urban scenario. Based on the traffic conditions in Beijing, the actual emission characteristics of buses under newly-built driving conditions were analyzed. Moreover, the emission factor database of urban buses in Beijing was established to analyze the characteristics of excess emission. The research results are shown as follows. 1) Compared with other types of buses, NOX emission factor and emission rate of lean-burn CNG bus are much higher. The equivalent air-fuel ratio CNG engine combined with TWC catalytic converter and hybrid power technology can better reduce NOX emission. 2) There is difference between the type certification under standard operating conditions and the emission results in actual operation to a varying degree. The evaluation of emission performance based on actual operation can more truly reflect the actual performance of the bus. The BJ-FPC (Beijing flat peak cycle) developed in this paper is closer to the actual operating conditions of the sample bus in terms of VSP Bin proportional distribution. 3) As to weighted NOX emission factors, the BJ-HPC (Beijing high peak cycle) of different types of buses are higher than BJ-FPC and actual operating conditions. 4) Based on the excessive emission method assessment, the NOX of China V diesel bus easily exceeds the emissions limits, and the NOx concentration of lean-burn CNG bus is high, and both the NOx over-limit ratio and the quantity of excessive emission buses are also high. Gas-electric hybrid bus can better reduce the NOX emission and the excessive emission frequency under the urban operating condition.