Bomi Jeong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Bomi Jeong has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Ayesha Siddiqa
Wireless and Mobile Internet Laboratory, School of Computer Science and Engineering, Kyungpook National University, Daegu, South Korea
4 shared publications - Dongkyun Kim
School of Computer Science and Engineering, Kyungpook National University, Daegu, Republic of Korea
3 shared publications - Junho Seo
Kyungpook National University, School of Computer Science and Engineering, South Korea
3 shared publications - Mahnoor Ajmal
School of Computer Science and Engineering, Kyungpook National University, Daegu, Republic of Korea
3 shared publications Dongkyun Kim
1 shared publication- Malik Muhammad Saad
Kyungpook National University, Daegu, Republic of Korea
1 shared publication
Latest Publications
- Open Access
- 2 November 2023
- Published by Elsevier in ICT Express
- Vol. 10 (1) , 194-212
Cell-free massive multiple-input multiple-output challenges and opportunities: A survey
- 2 November 2023
- Published by Elsevier in ICT Express
- Vol. 10 (1) , 194-212
Open AccessCell-free massive multiple-input multiple-output challenges and opportunities: A survey
- Open Access
- 6 August 2023
- Published by Association for Computing Machinery (ACM)
- p. 1-7
Experimental Analysis of Handover Process in Cell-Free Networks
With the emergence of services that require a high level of data usage, wireless networks are required to support higher data rates and greater capacity. To satisfy these requests, 5G architecture supports a high-frequency band. However, a high frequency occurs small range resulting in a need for numerous base stations (BSs). Deploying numerous BSs can be considered practically impossible due to high costs. To address the cost issue, instead of BSs, access points (APs) are used in Cell-free networks. That is, Cell-free networks that offer promising coverage gain and enhanced data rates consist of multiple APs and a single central process unit (CPU). This coverage of multiple APs' is much smaller than BS's. As a result, this small coverage can lead to frequent handovers. To overcome this frequent handover, an optimized handover scheme for the Cell-free network is required. Despite this optimization requirement, many studies in the Cell-free network field remain at the physical layer stage. No basic handover process is optimized for Cell-free networks, and no protocol for upper layers is defined. We consider that existing technologies will continue to be used in Cell-free networks, even if the protocols optimized for Cellfree networks are developed and used. For these reasons, we construct a Cell-free network architecture similar to the 5G structure for the handover process. In this paper, we investigate the handover process in 5G architecture and extend it to a Cellfree network environment. In our simulations, APs initiate and perform the handover process based on measurement reports from users. We analyzed and discussed the performance matrices of the handover in a Cell-free network environment, such as handover delay and throughput.
- 6 August 2023
- Published by Association for Computing Machinery (ACM)
- p. 1-7
Open AccessExperimental Analysis of Handover Process in Cell-Free Networks
With the emergence of services that require a high level of data usage, wireless networks are required to support higher data rates and greater capacity. To satisfy these requests, 5G architecture supports a high-frequency band. However, a high frequency occurs small range resulting in a need for numerous base stations (BSs). Deploying numerous BSs can be considered practically impossible due to high costs. To address the cost issue, instead of BSs, access points (APs) are used in Cell-free networks. That is, Cell-free networks that offer promising coverage gain and enhanced data rates consist of multiple APs and a single central process unit (CPU). This coverage of multiple APs' is much smaller than BS's. As a result, this small coverage can lead to frequent handovers. To overcome this frequent handover, an optimized handover scheme for the Cell-free network is required. Despite this optimization requirement, many studies in the Cell-free network field remain at the physical layer stage. No basic handover process is optimized for Cell-free networks, and no protocol for upper layers is defined. We consider that existing technologies will continue to be used in Cell-free networks, even if the protocols optimized for Cellfree networks are developed and used. For these reasons, we construct a Cell-free network architecture similar to the 5G structure for the handover process. In this paper, we investigate the handover process in 5G architecture and extend it to a Cellfree network environment. In our simulations, APs initiate and perform the handover process based on measurement reports from users. We analyzed and discussed the performance matrices of the handover in a Cell-free network environment, such as handover delay and throughput.
- Open Access
- 27 March 2023
- Published by Association for Computing Machinery (ACM)
- p. 1766-1771
Scalable Simultaneous Connectivity with Multiple APs and Virtual UEs in CF-Networks
Cellular massive multiple-input multiple-output (mMIMO) enables several access points (APs) to cooperatively serve multiple user equipment (UEs) using dynamic cooperative clustering (DCC) in a single cell. As the UE moves away from the cell center, it creates intercell signal interference (ISI) on cell edges which degrades the network performance. To overcome this issue, the cell-free (CF) networks remove the cell boundaries and randomly distribute the APs equipped with a variable number of antennas. CF aims to enable several APs to jointly serve the UEs in the network to improve the data rate. The scalable CF networks have been proposed for practical implementation, but it enables a single master AP (MAP) to communicate with UEs. It creates signal overhead on fronthaul in large networks and degrades spectral Efficiency (SE). To overcome this issue, we proposed a scalable scheme to enable simultaneous connectivity between multiple APs and UEs using virtualization. Each UE create virtual network interface card (vNIC) ids and integrate them with UE physical id to separately identify each signal in the network. The novel UE ids can independently identify each id as a separate UE in the network. A novel channel gain-based AP selection methodology on UE has been proposed. Moreover, space division multiple access (SDMA) has been utilized for simultaneous uplink/downlink connections. The goal of the work is to enable UEs to maintain multiple AP connections without increasing their physical capacity. The proposed scheme simulation results are compared with other proposed schemes and it shows promising improvement in the network.
- 27 March 2023
- Published by Association for Computing Machinery (ACM)
- p. 1766-1771
Open AccessScalable Simultaneous Connectivity with Multiple APs and Virtual UEs in CF-Networks
Cellular massive multiple-input multiple-output (mMIMO) enables several access points (APs) to cooperatively serve multiple user equipment (UEs) using dynamic cooperative clustering (DCC) in a single cell. As the UE moves away from the cell center, it creates intercell signal interference (ISI) on cell edges which degrades the network performance. To overcome this issue, the cell-free (CF) networks remove the cell boundaries and randomly distribute the APs equipped with a variable number of antennas. CF aims to enable several APs to jointly serve the UEs in the network to improve the data rate. The scalable CF networks have been proposed for practical implementation, but it enables a single master AP (MAP) to communicate with UEs. It creates signal overhead on fronthaul in large networks and degrades spectral Efficiency (SE). To overcome this issue, we proposed a scalable scheme to enable simultaneous connectivity between multiple APs and UEs using virtualization. Each UE create virtual network interface card (vNIC) ids and integrate them with UE physical id to separately identify each signal in the network. The novel UE ids can independently identify each id as a separate UE in the network. A novel channel gain-based AP selection methodology on UE has been proposed. Moreover, space division multiple access (SDMA) has been utilized for simultaneous uplink/downlink connections. The goal of the work is to enable UEs to maintain multiple AP connections without increasing their physical capacity. The proposed scheme simulation results are compared with other proposed schemes and it shows promising improvement in the network.
- Open Access
- 9 February 2023
- Published by MDPI AG in Electronics
- Vol. 12 (4) , 889
Junction Selection Based on Optimal-Weighted Multiple Attributes for VANETs
Vehicle ad hoc networks (VANETs) is an emerging ad hoc network technology with a promising future but significant limitations, particularly in communication networks. An effective routing system can significantly enhance the performance of VANETs. However, creating an effective routing protocol in an urban context to transport the data packet to the destination is still challenging due to complex road conditions, sporadic connectivity among vehicles, frequent disconnections, and quick changes in network topology. To enhance the accuracy of routing decisions in an urban setting, we propose a novel “multiple attributes decision-making junction selection routing (MADMJSR)” routing protocol based on vehicle position for VANETs. Formerly, most of the research was focused on static weight-based attribute selection for communication rather than optimal values, which led to a drop in junction decision-making accuracy. Our proposed scheme considers the multiple attribute selection and the optimal weight value assigned to each attribute, which significantly improves the routing decision accuracy. The results show a high packet delivery ratio (PDR) gain within minimum latency and less network load. Furthermore, a thorough discussion of the functioning of our proposed protocol is presented along with a detailed performance evaluation in comparison to other protocols.
- 9 February 2023
- Published by MDPI AG in Electronics
- Vol. 12 (4) , 889
Open AccessJunction Selection Based on Optimal-Weighted Multiple Attributes for VANETs
Vehicle ad hoc networks (VANETs) is an emerging ad hoc network technology with a promising future but significant limitations, particularly in communication networks. An effective routing system can significantly enhance the performance of VANETs. However, creating an effective routing protocol in an urban context to transport the data packet to the destination is still challenging due to complex road conditions, sporadic connectivity among vehicles, frequent disconnections, and quick changes in network topology. To enhance the accuracy of routing decisions in an urban setting, we propose a novel “multiple attributes decision-making junction selection routing (MADMJSR)” routing protocol based on vehicle position for VANETs. Formerly, most of the research was focused on static weight-based attribute selection for communication rather than optimal values, which led to a drop in junction decision-making accuracy. Our proposed scheme considers the multiple attribute selection and the optimal weight value assigned to each attribute, which significantly improves the routing decision accuracy. The results show a high packet delivery ratio (PDR) gain within minimum latency and less network load. Furthermore, a thorough discussion of the functioning of our proposed protocol is presented along with a detailed performance evaluation in comparison to other protocols.