Sergio A. Chillon

The COVID-19 pandemic has pointed to the need to increase our knowledge in fields related to human breathing. In the present study, temperature, relative humidity, carbon dioxide (CO₂) concentration, and median particle size diameter measurements were taken into account. These parameters were analyzed in a computer classroom with 15 subjects during a normal 90-minute class; all the subjects wore surgical masks. For measurements, Arduino YUN, Arduino UNO, and APS-3321 devices were used. Natural ventilation efficiency was checked in two different ventilation scenarios: only windows open and windows and doors open. The results show how ventilation affects the temperature, CO₂ concentration, and median particle diameter size parameters. By contrast, the relative humidity depends more on the outdoor meteorological conditions. Both ventilation scenarios tend to create the same room conditions in terms of temperature, humidity, CO₂ concentration, and particle size. Additionally, the evolution of CO₂ concentration as well as the particle size distribution along the time was studied. Finally, the particulate matter (PM_2.5) was investigated together with particle concentration. Both parameters showed a similar trend during the time of the experiments.

The coronavirus disease 2019 (COVID-19) outbreak has altered the lives of everyone on a global scale due to its high transmission rate. In the current work, the droplet dispersion and evaporation originated by a cough at different velocities is studied. A multiphase computational fluid dynamic model based on fully coupled Eulerian–Lagrangian techniques was used. The evaporation, breakup, mass transfer, phase change, and turbulent dispersion forces of droplets were taken into account. A computational domain imitating an elevator that with two individuals inside was modeled. The results showed that all droplets smaller than 150 μm evaporate before 10 s at different heights. Smaller droplets of <30 µm evaporate quickly, and their trajectories are governed by Brownian movements. Instead, the trajectories of medium-sized droplets (30–80 µm) are under the influence of inertial forces, while bigger droplets move according to inertial and gravitational forces. Smaller droplets are located in the top positions, while larger (i.e., heaviest) droplets are located at the bottom.

The increased demand for wind power is related to changes in the sizes of wind turbines and the development of flow control devices, such as vortex generators (VGs). In the present study, an analysis of the vortices generated by a vane-type VG is performed. To that end, the aerodynamic performance of a DU97W300 airfoil with and without VG is evaluated. The jBAY source term model was implemented for simulation of a triangular-shaped VG and the resolution of the fully meshed computational fluid dynamics (CFD) model. Reynolds-averaged Navier–Stokes (RANS) based simulations were used to calculate the effect of VGs in steady state, and the detached eddy simulation (DES) method was used for angles of attack (AoAs) around the stall situation. All jBAY based numerical simulations were carried out with a Reynolds number of Re = 2 × 10⁶ to analyze the influence of VGs with AoAs between 0 and 20° and were validated versus experimental wind tunnel results. The results show that setting up a VG device on an airfoil benefits its aerodynamic performance and that the use of the jBAY model for simulation is accurate and efficient.