Christopher D. Curtis
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Christopher D. Curtis has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Sebastian M. Torres
Cooperative Institute for Severe and High-Impact Weather Research and Operations, The University of Oklahoma, Norman, OK, USA
4 shared publications - David A. Warde
Cooperative Institute for Severe and High-Impact Weather Research and Operations, The University of Oklahoma, and NOAA/OAR National Severe Storms Laboratory, Norman, OK, USA
1 shared publication - David Schvartzman
Advanced Radar Research Center University of Oklahoma Norman OK USA
1 shared publication - Feng Nai
Cooperative Institute for Severe and High-Impact Weather Research and Operations, The University of Oklahoma, USA
1 shared publication James M. Kurdzo
Massachusetts Institute of Technology Lincoln Laboratory, Lexington, MA, USA
1 shared publication- Rakshith Jagannath
Cooperative Institute for Severe and High-Impact Weather Research and Operations, The University of Oklahoma and NOAA/OAR National Severe Storms Laboratory, Norman, OK, USA
1 shared publication
Latest Publications
- 6 May 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Radar Systems
- Vol. 4, 930-942
Addressing Boundary Artifacts When Using Radar Imaging on Phased Array Weather Radars
Radar imaging is a method for using spoiled transmit beams with multiple receive beams to speed up data collection with phased array radars. It introduces trade-offs in sensitivity and angular resolution and can also lead to data artifacts along beam cluster boundaries (boundaries between radar data obtained with adjacent spoiled transmit beams). We show that these data artifacts are due to asymmetric edge beams that occur when the spoiled transmit beam is too narrow for a given set of receive beams. We use both simulations and derivations to quantify the bias in reflectivity gradients along beam cluster boundaries. The derivations are also used to develop design criteria to ensure that the spoiled transmit beam is wide enough to produce symmetric edge beams that mitigate data artifacts.We use data collected with the Advanced Technology Demonstrator to show the presence of data artifacts when the spoiled transmit beam is too narrow and the absence of artifacts when the spoiled transmit beam is wide enough to produce symmetric edge beams. We also use a quantitative evaluation of the reflectivity-gradient biases in collected weather data to validate both our simulations and derivations.
- 6 May 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Radar Systems
- Vol. 4, 930-942
Addressing Boundary Artifacts When Using Radar Imaging on Phased Array Weather Radars
Radar imaging is a method for using spoiled transmit beams with multiple receive beams to speed up data collection with phased array radars. It introduces trade-offs in sensitivity and angular resolution and can also lead to data artifacts along beam cluster boundaries (boundaries between radar data obtained with adjacent spoiled transmit beams). We show that these data artifacts are due to asymmetric edge beams that occur when the spoiled transmit beam is too narrow for a given set of receive beams. We use both simulations and derivations to quantify the bias in reflectivity gradients along beam cluster boundaries. The derivations are also used to develop design criteria to ensure that the spoiled transmit beam is wide enough to produce symmetric edge beams that mitigate data artifacts.We use data collected with the Advanced Technology Demonstrator to show the presence of data artifacts when the spoiled transmit beam is too narrow and the absence of artifacts when the spoiled transmit beam is wide enough to produce symmetric edge beams. We also use a quantitative evaluation of the reflectivity-gradient biases in collected weather data to validate both our simulations and derivations.
- 21 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Radar Systems
- Vol. 4, 463-472
Adaptive Focused Observations on the Advanced Technology Demonstrator Phased-Array Radar
The Advanced Technology Demonstrator (ATD) is a full-scale, S-band, dual-polarization phased-array radar (PAR) developed as a proof-of-concept to evaluate the capabilities of electronically scanned radars for weather observation. Recent upgrades to the ATD have introduced a closed-loop adaptive scanning framework and an implementation of the Adaptive Digital Signal-Processing Algorithm for PAR Timely Scans (ADAPTS) to enable adaptive focused observations. ADAPTS leverages the radar’s beam agility to dynamically concentrate measurements in regions with significant weather returns, reducing the total scan time while preserving data quality and meaningful volumetric coverage. The algorithm selectively enables (disables) beams with (without) significant weather echoes, enables beams in a neighborhood of beams with significant weather echoes to account for storm advection and growth, and periodically reactivates disabled beams to detect new storm development. Performance evaluations using archived and real-time data demonstrate substantial reductions in scan time, rapid detection of storm initiation, and high-fidelity coverage of active weather regions. These results highlight the potential of adaptive scanning strategies for improving weather observations using PAR systems.
- 21 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Radar Systems
- Vol. 4, 463-472
Adaptive Focused Observations on the Advanced Technology Demonstrator Phased-Array Radar
The Advanced Technology Demonstrator (ATD) is a full-scale, S-band, dual-polarization phased-array radar (PAR) developed as a proof-of-concept to evaluate the capabilities of electronically scanned radars for weather observation. Recent upgrades to the ATD have introduced a closed-loop adaptive scanning framework and an implementation of the Adaptive Digital Signal-Processing Algorithm for PAR Timely Scans (ADAPTS) to enable adaptive focused observations. ADAPTS leverages the radar’s beam agility to dynamically concentrate measurements in regions with significant weather returns, reducing the total scan time while preserving data quality and meaningful volumetric coverage. The algorithm selectively enables (disables) beams with (without) significant weather echoes, enables beams in a neighborhood of beams with significant weather echoes to account for storm advection and growth, and periodically reactivates disabled beams to detect new storm development. Performance evaluations using archived and real-time data demonstrate substantial reductions in scan time, rapid detection of storm initiation, and high-fidelity coverage of active weather regions. These results highlight the potential of adaptive scanning strategies for improving weather observations using PAR systems.
- 23 July 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. PP (01962892) , 1
A Constrained Capon Adaptive Beamforming Technique for Phased-Array Weather Radars
Phased-array radar (PAR) is being considered as a candidate for the next generation of weather radars in the United States because it can provide unique capabilities to observe severe and non-severe weather. PAR’s scanning flexibility is key to produce radar data with rapid volumetric updates; one way to achieve this is to use a purposely wider (or spoiled) transmit beam and to form several simultaneous receive beams. One of the key trade-offs of using spoiled transmit beams is an increase in the two-way beam-pattern sidelobes, which can cause increased contamination that biases the estimated radar variables (referred to as “sidelobe contamination”). Adaptive beamforming can be used to mitigate the increased sidelobe contamination from the use of spoiled transmit beams. However, adaptive beamforming methods designed for point targets can result in beam patterns that cannot be calibrated for weather radars because the beam pattern violates key assumptions. In this work, we propose constraints to the conventional Capon adaptive beamforming technique to preserve the shape of the beam-pattern main lobe such that weather radar calibration is the same as for conventional pencil beams. Our simulation results show that the proposed constrained Capon beamforming can mitigate sidelobe contamination while maintaining weather radar calibration.
- 23 July 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. PP (01962892) , 1
A Constrained Capon Adaptive Beamforming Technique for Phased-Array Weather Radars
Phased-array radar (PAR) is being considered as a candidate for the next generation of weather radars in the United States because it can provide unique capabilities to observe severe and non-severe weather. PAR’s scanning flexibility is key to produce radar data with rapid volumetric updates; one way to achieve this is to use a purposely wider (or spoiled) transmit beam and to form several simultaneous receive beams. One of the key trade-offs of using spoiled transmit beams is an increase in the two-way beam-pattern sidelobes, which can cause increased contamination that biases the estimated radar variables (referred to as “sidelobe contamination”). Adaptive beamforming can be used to mitigate the increased sidelobe contamination from the use of spoiled transmit beams. However, adaptive beamforming methods designed for point targets can result in beam patterns that cannot be calibrated for weather radars because the beam pattern violates key assumptions. In this work, we propose constraints to the conventional Capon adaptive beamforming technique to preserve the shape of the beam-pattern main lobe such that weather radar calibration is the same as for conventional pencil beams. Our simulation results show that the proposed constrained Capon beamforming can mitigate sidelobe contamination while maintaining weather radar calibration.
- 22 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 61 (01962892) , 1-12
Generalized Multi-Lag Estimators (GMLE) for Polarimetric Weather Radar Observations
Observations of weather phenomenon by polarimetric pulsed-Doppler weather radars are employed worldwide to monitor impending severe storms, flash-floods, and other weather related public hazards. The basis for processing received meteorological signals from pulsed-radar waveforms relies on stochastic processes where the accurate estimation of radar variables from received signals in additive white noise is essential for meaningful interpretation of weather phenomena and algorithm-derived products. For polarimetric weather radars, these estimates are calculated from signal correlations in time and across the horizontal and vertical polarization channels. Conventional estimators only use 1 or 2 signal correlation time-lags and may not utilize all the available information intrinsic in the received signals. Weather-variable estimates could benefit from the use of all intrinsic characteristics in the received data; accordingly, more complex estimators use multiple lags to extract additional information. However, not all estimates are improved by the use of more lags; in fact, improvement in estimates depends on signal characteristics and requires that the additional correlation lags provide new information. In this article, we derive and examine general multi-lag estimators for reflectivity, differential reflectivity, polarimetric cross-correlation coefficient, and Doppler spectrum width. We compare the performance of these proposed estimators against conventional estimators using Monte-Carlo simulations on different meteorological signal characteristics to find estimators that can improve the quality of certain radar-variable estimates.
- 22 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 61 (01962892) , 1-12
Generalized Multi-Lag Estimators (GMLE) for Polarimetric Weather Radar Observations
Observations of weather phenomenon by polarimetric pulsed-Doppler weather radars are employed worldwide to monitor impending severe storms, flash-floods, and other weather related public hazards. The basis for processing received meteorological signals from pulsed-radar waveforms relies on stochastic processes where the accurate estimation of radar variables from received signals in additive white noise is essential for meaningful interpretation of weather phenomena and algorithm-derived products. For polarimetric weather radars, these estimates are calculated from signal correlations in time and across the horizontal and vertical polarization channels. Conventional estimators only use 1 or 2 signal correlation time-lags and may not utilize all the available information intrinsic in the received signals. Weather-variable estimates could benefit from the use of all intrinsic characteristics in the received data; accordingly, more complex estimators use multiple lags to extract additional information. However, not all estimates are improved by the use of more lags; in fact, improvement in estimates depends on signal characteristics and requires that the additional correlation lags provide new information. In this article, we derive and examine general multi-lag estimators for reflectivity, differential reflectivity, polarimetric cross-correlation coefficient, and Doppler spectrum width. We compare the performance of these proposed estimators against conventional estimators using Monte-Carlo simulations on different meteorological signal characteristics to find estimators that can improve the quality of certain radar-variable estimates.
- Open Access
- 1 July 2017
- Published by American Meteorological Society in Journal of Atmospheric and Oceanic Technology
- Vol. 34 (7) , 1607-1623
Adaptive Range Oversampling Processing for Nontraditional Radar-Variable Estimators
Adaptive range oversampling processing can be used either to reduce the variance of radar-variable estimates without increasing scan times or to reduce scan times without increasing the variance of estimates. For example, an implementation of adaptive pseudowhitening on the National Weather Radar Testbed Phased-Array Radar (NWRT PAR) led to a twofold reduction in scan times. Conversely, a proposed implementation of adaptive pseudowhitening the U.S. Next Generation Weather Radar (NEXRAD) network would reduce the variance of dual-polarization estimates while keeping current scan times. However, the original version of adaptive pseudowhitening is not compatible with radar-variable estimators for which an explicit variance expression is not readily available. One such nontraditional estimator is the hybrid spectrum-width estimator, which is currently used in the NEXRAD network. In this paper, an extension of adaptive pseudowhitening is proposed that utilizes lookup tables (rather than analytical solutions based on explicit variance expressions) to obtain range oversampling transformations. After describing this lookup table (LUT) adaptive pseudowhitening technique, its performance is compared to that of the original version of adaptive pseudowhitening using traditional radar-variable estimators. LUT adaptive pseudowhitening is then applied to the hybrid spectrum-width estimator, and simulation results are confirmed with a qualitative analysis of radar data.
- 1 July 2017
- Published by American Meteorological Society in Journal of Atmospheric and Oceanic Technology
- Vol. 34 (7) , 1607-1623
Open AccessAdaptive Range Oversampling Processing for Nontraditional Radar-Variable Estimators
Adaptive range oversampling processing can be used either to reduce the variance of radar-variable estimates without increasing scan times or to reduce scan times without increasing the variance of estimates. For example, an implementation of adaptive pseudowhitening on the National Weather Radar Testbed Phased-Array Radar (NWRT PAR) led to a twofold reduction in scan times. Conversely, a proposed implementation of adaptive pseudowhitening the U.S. Next Generation Weather Radar (NEXRAD) network would reduce the variance of dual-polarization estimates while keeping current scan times. However, the original version of adaptive pseudowhitening is not compatible with radar-variable estimators for which an explicit variance expression is not readily available. One such nontraditional estimator is the hybrid spectrum-width estimator, which is currently used in the NEXRAD network. In this paper, an extension of adaptive pseudowhitening is proposed that utilizes lookup tables (rather than analytical solutions based on explicit variance expressions) to obtain range oversampling transformations. After describing this lookup table (LUT) adaptive pseudowhitening technique, its performance is compared to that of the original version of adaptive pseudowhitening using traditional radar-variable estimators. LUT adaptive pseudowhitening is then applied to the hybrid spectrum-width estimator, and simulation results are confirmed with a qualitative analysis of radar data.