Mokhtar K. Mohamed
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mokhtar K. Mohamed has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
Eman Kandeel
1 shared publicationEman M. Kandeel
Radiation Protection and Safety Department, Hot Laboratories and Waste Management Center, Egyptian Atomic Energy Authority, Cairo, Egypt
1 shared publicationMohamed R. Abass
Nuclear Fuel Technology Department, Hot Laboratories and Waste Management Center, Egyptian Atomic Energy Authority, Cairo, Egypt
1 shared publicationRiham A. Abou-Lilah
Nuclear Fuel Technology Department, Hot Laboratories and Waste Management Center, Egyptian Atomic Energy Authority, Cairo, Egypt
1 shared publication- Rofaida S. Abdelkader
Soil and Water Research Department, Nuclear Research Center, Egyption Atomic Energy Authority, Cairo, Egypt
1 shared publication - Yasmeen Ahmed Hasanien
Plant Research Department, Nuclear Research Center, Egyptian Atomic Energy Authority, Cairo, Egypt
1 shared publication
Latest Publications
- Open Access
- 6 January 2024
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 235 (1) , 1-20
Effective Biosorption of Cesium and Strontium Ions from Aqueous Solutions Using Silica Loaded with Aspergillus brasiliensis
In this study, the batch technique was used for the sorption of Sr(II) and Cs(I) onto silica loaded with Aspergillus brasiliensis (AB@S). The precipitation technique was used to synthesize the AB@S bio-sorbent, which was then evaluated using several analytical instruments such as XRD, FT-IR, and SEM. The results of this investigation revealed that the sorption process had a short equilibrium time (40 min). The distribution coefficient values have a sequence order Sr(II) ˃ Cs(I). AB@S sorbent has saturation capacity for Sr(II) and Cs(I) 72.2 and 26.1 mg g−1, respectively. The reaction kinetics follow the pseudo-second-order model with capacity values of 5.01 and 3.53 mg g−1 for Sr(II) and Cs(I), respectively. Applicability of Langmuir isotherms has capacity values of 66.3 and 23.38 mg g−1 for Sr(II) and Cs(I), respectively. Thermodynamics data are endothermic and spontaneous. The AB@S is a promising bio-sorbent for the removal of 85Sr and 134Cs from simulated radioactive waste (SRW). The investigation proved that the AB@S is suitable to adsorb Sr(II) and Cs(I) from aqueous solutions and could be considered potential material for the purification of effluent contaminated with these ions.
- 6 January 2024
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 235 (1) , 1-20
Open AccessEffective Biosorption of Cesium and Strontium Ions from Aqueous Solutions Using Silica Loaded with Aspergillus brasiliensis
In this study, the batch technique was used for the sorption of Sr(II) and Cs(I) onto silica loaded with Aspergillus brasiliensis (AB@S). The precipitation technique was used to synthesize the AB@S bio-sorbent, which was then evaluated using several analytical instruments such as XRD, FT-IR, and SEM. The results of this investigation revealed that the sorption process had a short equilibrium time (40 min). The distribution coefficient values have a sequence order Sr(II) ˃ Cs(I). AB@S sorbent has saturation capacity for Sr(II) and Cs(I) 72.2 and 26.1 mg g−1, respectively. The reaction kinetics follow the pseudo-second-order model with capacity values of 5.01 and 3.53 mg g−1 for Sr(II) and Cs(I), respectively. Applicability of Langmuir isotherms has capacity values of 66.3 and 23.38 mg g−1 for Sr(II) and Cs(I), respectively. Thermodynamics data are endothermic and spontaneous. The AB@S is a promising bio-sorbent for the removal of 85Sr and 134Cs from simulated radioactive waste (SRW). The investigation proved that the AB@S is suitable to adsorb Sr(II) and Cs(I) from aqueous solutions and could be considered potential material for the purification of effluent contaminated with these ions.
- Open Access
- 13 June 2023
- Published by Springer Nature in Journal of Cluster Science
- Vol. 34 (6) , 3147-3163
Experimental and Modeling Optimization of Strontium Adsorption on Microbial Nanocellulose, Eco-friendly Approach
Green synthesized cellulose nanocrystals (CNCs) was prepared using Neurospora intermedia, characterized, and used to remove Strontium ions (Sr2+) from an aqueous solution with high efficiency. The characterization of CNCs was performed using a UV-Vis Spectrophotometer, Dynamic Light Scattering (DLS), Zeta Potential (ZP), Fourier Transform Infrared Spectroscopy (FTIR), X-Ray Diffraction (XRD), and Scanning Electron Microscopy (SEM) mapping, EDX elemental analysis and BET surface analyzer. In this study, Response Surface Methodology (RSM) based on Box-Behnken Design (BBD) was successfully applied for the first time to optimize the dynamic adsorption conditions for the maximum removal of Sr2+ ions from aqueous solutions using CNCs as adsorbent. The effects of parameters, such as initial concentration of Sr2+ (50–500 ppm), adsorbent dosage (0.05–0.2 g/50ml), and contact time (15–120 min.) on removal efficiency were investigated. A mathematical model was studied to predict the removal performance. The significance and adequacy of the model were surveyed using the analysis of variance (ANOVA). The results showed that the second-order polynomial model is suitable for the prediction removal of Sr2+ with regression coefficient (R2 = 97.41%). The highest sorption capacity value of Sr2+ was obtained (281.89 mg/g) at the adsorbent dosage of 0.05 g/50 ml, contact time of 120 min., and the pollutant (Sr2+) concentration of 275 ppm.
- 13 June 2023
- Published by Springer Nature in Journal of Cluster Science
- Vol. 34 (6) , 3147-3163
Open AccessExperimental and Modeling Optimization of Strontium Adsorption on Microbial Nanocellulose, Eco-friendly Approach
Green synthesized cellulose nanocrystals (CNCs) was prepared using Neurospora intermedia, characterized, and used to remove Strontium ions (Sr2+) from an aqueous solution with high efficiency. The characterization of CNCs was performed using a UV-Vis Spectrophotometer, Dynamic Light Scattering (DLS), Zeta Potential (ZP), Fourier Transform Infrared Spectroscopy (FTIR), X-Ray Diffraction (XRD), and Scanning Electron Microscopy (SEM) mapping, EDX elemental analysis and BET surface analyzer. In this study, Response Surface Methodology (RSM) based on Box-Behnken Design (BBD) was successfully applied for the first time to optimize the dynamic adsorption conditions for the maximum removal of Sr2+ ions from aqueous solutions using CNCs as adsorbent. The effects of parameters, such as initial concentration of Sr2+ (50–500 ppm), adsorbent dosage (0.05–0.2 g/50ml), and contact time (15–120 min.) on removal efficiency were investigated. A mathematical model was studied to predict the removal performance. The significance and adequacy of the model were surveyed using the analysis of variance (ANOVA). The results showed that the second-order polynomial model is suitable for the prediction removal of Sr2+ with regression coefficient (R2 = 97.41%). The highest sorption capacity value of Sr2+ was obtained (281.89 mg/g) at the adsorbent dosage of 0.05 g/50 ml, contact time of 120 min., and the pollutant (Sr2+) concentration of 275 ppm.